Skip to content
worldfires
MX · Mexico · –

Chilpancingo de los Bravo fire, May 2022 Chilpancingo de los Bravo, Leonardo Bravo

Out · last detection 13 May 2022, 19:05 UTC

The fire started on 2 May 2022 in Chilpancingo de los Bravo, Mexico, and satellites saw it burning for 12 days. Copernicus’s global GWIS system rebuilt a burnt perimeter of 5,399 hectares from heat detections, spread across 2 municipalities.

It is the 80th largest in Guerrero since 2016 (of 582 with a page). Number 20 in Mexico in 2022, of 232.

The power measured by the satellite is low (22.7 MW in the strongest hotspot), more typical of grass or stubble burning, or a slow surface fire, than of a large crown fire.

Burnt area
5,399ha
GWIS perimeter (Copernicus)
Duration
12days
2 May 2022 – 13 May 2022
Municipalities hit
2
municipalities
Started on
2 May
2022
Heat detections
252
in a single hotspot: 23 MW
Danger at start
17
Moderate · FWI index
Average daily power
117MW
detected power per day, on average

Where it burned

HOTSPOTS BY DAY 2 May13 May
13 May 2022

How it evolved, day by day

4 May 2022 · 86 MW · 9 5 May 2022 · 28 MW · 8 6 May 2022 · 174 MW · 29 7 May 2022 · 60 MW · 26 8 May 2022 · 226 MW · 31 9 May 2022 · 204 MW · 42 10 May 2022 · 170 MW · 30 11 May 2022 · 94 MW · 34 12 May 2022 · 102 MW · 39 13 May 2022 · 23 MW · 4
4 May 6 May 8 May 10 May 12 May

Fire radiative power detected each day, in megawatts, and number of hotspots. The magenta bar marks the peak day.

The weather it burned in

33°high
43km/h · peak gust
25%lowest humidity

It had gone 3 days without rain (1 mm or more) when it started. Rain came after the fire: 3.4 mm on 14 May.

This area had burned before

98% of the perimeter overlaps earlier fires recorded since 2016: 1,616 ha in 2016, 3,897 ha in 2017, 1,599 ha in 2018, 3,416 ha in 2019, 127 ha in 2020. Part of it burned more than once, so the yearly figures add up to more than the 5,309 ha that had burned before.

How big is it?

10 km
It burned the equivalent of 3.4% of the area of London (54 km² against 1,583 km²).

London boundary: geoBoundaries · Office for National Statistics (Open Government Licence v3.0).

This compares size, not location: both shapes are at the same scale, north up, centred on each other.

What happened to each town

  1. Chilpancingo de los Bravo 283,354 inhabitants where it started
    5,417 ha reached on 4 May
    2.5 %
  2. 13 ha
    0.0 %

Burnt area inside each municipality, from crossing the GWIS perimeter with administrative boundaries. The distance runs from the point marking the centre of each area to the nearest fire: staying a kilometre away does not mean it reached the houses.

People and buildings inside the perimeter

GHSL 2020
Built-up area< 0.1 ha
Residents< 20

Inside the perimeter there was no noticeable built-up land and almost nobody lived there (GHSL 2020, satellite-based estimate).

This is an estimate on 100 m cells, made from satellite imagery and census data: it does not mean that homes burned or that anyone was harmed. The perimeter also contains land that never burned.

Source: Global Human Settlement Layer (GHS-BUILT-S and GHS-POP R2023A), European Commission Joint Research Centre (JRC), © European Union, CC BY 4.0. Sum inside the perimeter computed by WorldFires. human-settlement.emergency.copernicus.eu

Official record

Several official records match this area

According to CONAFOR, 2 fires started inside this perimeter on these dates, totalling 3,255 ha (the satellite measured 5,399 ha). The two figures differ a lot, so these may not be exactly the same fire: take them as nearby records.

CONAFOR records each fire that started at a different time or place separately; the satellite sees a single burned area, so this page groups them together. The numbers on the map show where each one started.

When each one burned

1 750 ha 2 2,505 ha
3 May14 May
negligence arson
  1. 1 Chilpancingo de los Bravo Chautipan 3 May 2022 750 ha · extinguished on 9 May 2022 · cause: negligence
  2. 2 Chilpancingo de los Bravo Chautipan 5 May 2022 2,505 ha · extinguished on 15 May 2022 · cause: arson

Total according to CONAFOR: 3,255 ha, 60 % of the 5,399 ha in the satellite perimeter.

CONAFOR (Comisión Nacional Forestal), estadística de incendios forestales en datos.gob.mx (CC BY 4.0). This is the agency’s consolidated statistic: it measures the area in its own way, which is why it can differ from the satellite.

The weather day by day

ECMWF ERA5 reanalysis at the fire location, the standard reference for past weather, and the Canadian Fire Weather Index (the same system Copernicus uses), computed by WorldFires from that data. Days after the fire run until the first rain.

Open-Meteo.com (CC BY 4.0) · Copernicus Climate Change Service (ERA5)

Day High Min. humidity Peak gust Rain Danger (FWI)
2 May 30.8 °C 39 % 36 km/h 0.0 mm Moderate 17
3 May 31.3 °C 36 % 34 km/h 0.0 mm Moderate 16
4 May 33.0 °C 32 % 37 km/h 0.2 mm Moderate 19
5 May 32.1 °C 29 % 43 km/h 0.0 mm High 23
6 May 31.3 °C 32 % 41 km/h 0.0 mm High 23
7 May 32.4 °C 37 % 36 km/h 0.3 mm Moderate 19
8 May 31.5 °C 42 % 37 km/h 2.8 mm Moderate 20
9 May 31.8 °C 39 % 41 km/h 0.3 mm Low 6
10 May 33.3 °C 33 % 40 km/h 0.0 mm Moderate 16
11 May 32.2 °C 34 % 40 km/h 0.0 mm Moderate 20
12 May 32.7 °C 25 % 37 km/h 0.0 mm High 24
13 May 30.9 °C 40 % 32 km/h 0.9 mm Moderate 15
14 May after 29.2 °C 52 % 31 km/h 3.4 mm Moderate 16

Its twins: fires that started in the same weather

It started with an FWI of 17.4, a minimum humidity of 39% and 3 days without rain. Fires in the area that started in weather like this since 2016: 27.

FWI at the start 17.4
Minimum humidity 39 %
Days without rain 3
this fire chosen twins rest of the area
Almost identicalSimilar

Outlines of the closest twins

Técpan de Galeana fire, May 2023
1,786 ha 19 days FWI 17.5 Min. humidity 39 % 87 km away, in 2023

First rain (1 mm or more) after it ended: 15.9 mm on 26 May.

What happened to them

10 days
median duration
2,297 ha
median area
100 %
went past 1,000 ha
2.6 mm
rain at the end (median; 24 of 27 had it)

It was 2.4 times larger than the median of its twins and lasted 12 days, against 10 days.

Only 3 of its 27 twins burned more. The weather on the first day does not explain everything: the wind in the following days, the fuel and the firefighting also count. In 3 of 27, not even 1 mm fell in the ten days after the end: they went out without rain. In the rest, the first rainy day brought a median of 2.6 mm.

This is a bank of analogues: it shows what usually happens, not what will happen. With fewer than 15 twins we give no figures. How we calculate it

How it ended

3.4 mmfirst rain
14 Maythe day after it ended
43km/h · max. gust

It was considered over on 13 May, and on 14 May 3.4 mm fell. We do not know whether the rain or the firefighters put it out. Twins with rain when they ended: 24 of 27, with a median of 2.6 mm.

Weather on this page: Open-Meteo.com (CC BY 4.0) · Copernicus Climate Change Service (ERA5)

How a twin is chosen

  • Same area: fires that have already ended, less than 250 km from this one, since 2016.
  • Same start: we compare the FWI on the first day, the minimum humidity that day and the run of days without rain before it. The slider sets how much they may differ.
  • Only pages with final weather data (ERA5 reanalysis) calculated in the same way as this fire’s; agricultural and grass burns and pages with data under review are left out.
  • Fires burning at the same time as this one (a week before or after) are left out: they share the same spell of weather and do not count as a precedent.
  • They are sorted by similarity, and the outlines of the first five are drawn.

How we calculate it

Before and after, from space

Drag the line to compare the same ground before the fire and after it.

Before · 25 Apr 2022
After · 20 May 2022

If the day is cloudy, change the date: each satellite passes once a day. In false colour the burnt ground looks brown or red.

Detections table · 252Every satellite heat detection, one by one, with time, satellite, power and coordinates.
⬇ Download CSV Times in UTC. Each detection is a 375 m pixel: a large fire yields hundreds per pass.
Date and timeSatelliteFRP (MW)LatLon

Other fires nearby

All fires in Mexico

Frequently asked questions

How long did the Chilpancingo de los Bravo fire last?
According to the heat detections seen by satellite inside the perimeter, it burned from 2 May 2022 to 13 May 2022 (12 days). The perimeter dates it from 4 May 2022 to 13 May 2022.
How much area did it burn?
The perimeter GWIS (Copernicus) rebuilt from heat detections is 5,399 hectares (54.0 km²). It is an estimate: official national figures may differ.
Which municipalities burned?
The fire entered 2 municipalities: Chilpancingo de los Bravo (5,417 ha, 2.5 %); Leonardo Bravo (13 ha, 0.0 %).
What was the weather like?
During the fire the temperature reached 33.3 °C, humidity dropped to 25 % and gusts hit 43 km/h. The fire danger index (FWI) reached 24, class High.
Where does this data come from?
From the GWIS (Copernicus) burnt perimeter, NASA FIRMS VIIRS hotspots and the administrative boundaries of Mexico (geoBoundaries). It is not an official report.
How did the fires that started in similar weather in this area end?
Fires less than 250 km away that started since 2016 with a similar FWI, humidity and dry spell: 27. Their median duration was 10 days and their median area 2,297 ha; 100 % went past 1,000 ha. Only 3 of its 27 twins burned more. The weather on the first day does not explain everything: the wind in the following days, the fuel and the firefighting also count. In 3 of 27, not even 1 mm fell in the ten days after the end: they went out without rain. In the rest, the first rainy day brought a median of 2.6 mm.

Where to verify it

A satellite detection is not an official report. Final figures and the fire’s status are published by each country’s emergency service.

Emergency number: 911 · Emergency number and official warnings

Satellite cross-check

History of this page Changes in area, dates, name, official record or merged pages, compared every night since 24 October 2026.

Does something look wrong on this page?

This page is built from satellite data and official records, and it sometimes gets things wrong: the wrong dates, the wrong town, two fires merged into one, or something that was not a wildfire at all. If you know this fire first-hand (you live nearby, saw it, fought it or reported on it), tell us what really happened and we will check it.

Report an error
What do you think is wrong?

We will only use your email to reply about this report. Privacy. This is not an emergency service: if there is a fire now, call 911.

How we know this
  • Perimeter: GWIS (Copernicus), rebuilt from heat detections rather than mapped on imagery.
  • Dates adjusted with the VIIRS detections inside the perimeter, which said 4 May 2022 to 13 May 2022. 252 Suomi-NPP VIIRS detections on those dates.
  • Compared with CONAFOR: 3,255 official ha against 5,399 ha of perimeter; similar, but with reservations.
  • Weather: Copernicus ERA5 reanalysis at the fire location, in cells of about 25 km.
  • Built-up area and population come from the JRC Global Human Settlement Layer (epoch 2020, 100 m cells), summed inside the perimeter: an estimate of what was there, not a damage count.

How we build fire pages: methodology

Where this data comes from

The perimeter comes from the Copernicus Global Wildfire Information System (GWIS), which rebuilds it from MODIS and VIIRS heat detections and publishes it under CC BY 4.0. It is not measured on imagery as in Europe, so it is an estimate. Heat detections come from the VIIRS sensors aboard Suomi-NPP and NOAA-20, distributed by NASA FIRMS at 375 m resolution. Municipal boundaries come from geoBoundaries ADM2 (Creative Commons Attribution 4.0 (CC BY 4.0)). The area per municipality is computed by WorldFires by crossing the perimeter with those boundaries, so it may differ from each country’s official figure.