Skip to content
worldfires
MZ · Mozambique · →

Mossuril fire, 4 October 2026 Mossuril, Mogincual

Dying down · last detection 28 Oct 2026, 11:55 UTC

The fire started on 4 October 2026 in Mossuril, Mozambique, and satellites saw it burning for 25 days. Copernicus’s global GWIS system rebuilt a burnt perimeter of 9,699 hectares from heat detections, spread across 2 municipalities.

It is the 47th largest in Nampula since 2016 (of 392 with a page). Number 94 in Mozambique in 2026, of 540.

Compare with…

Is it still active?

No detections since 28 Oct 2026, 11:55 UTC. That usually means no flame is visible from space any more, although hotspots may remain. Satellites pass a few times a day and cloud or smoke can hide the fire: a lack of detections is not an official extinction. Each country’s emergency service declares a fire contained or out.

Burnt area
9,699ha
GWIS perimeter (Copernicus)
Duration
25days
4 Oct 2026 – 28 Oct 2026
Municipalities hit
2
districts
Started on
4 Oct
2026
Heat detections
347
in a single hotspot: 103 MW
Danger at start
1
Very low · FWI index
Average daily power
147MW
detected power per day, on average

Where it burned

HOTSPOTS BY DAY 4 Oct28 Oct
28 Oct 2026

How it evolved, day by day

4 Oct 2026 · 285 MW · 9 5 Oct 2026 · 31 MW · 6 6 Oct 2026 · 343 MW · 37 7 Oct 2026 · 239 MW · 16 8 Oct 2026 · 158 MW · 11 9 Oct 2026 · 142 MW · 19 10 Oct 2026 · 34 MW · 4 11 Oct 2026 · 155 MW · 10 13 Oct 2026 · 0 MW · 0 14 Oct 2026 · 143 MW · 24 15 Oct 2026 · 145 MW · 17 16 Oct 2026 · 212 MW · 14 17 Oct 2026 · 53 MW · 6 18 Oct 2026 · 127 MW · 15 19 Oct 2026 · 274 MW · 37 20 Oct 2026 · 246 MW · 32 21 Oct 2026 · 96 MW · 13 22 Oct 2026 · 36 MW · 6 23 Oct 2026 · 165 MW · 20 24 Oct 2026 · 233 MW · 19 25 Oct 2026 · 151 MW · 15 26 Oct 2026 · 18 MW · 2 27 Oct 2026 · 19 MW · 2 28 Oct 2026 · 88 MW · 13
4 Oct 6 Oct 8 Oct 13 Oct 17 Oct 21 Oct 25 Oct

Fire radiative power detected each day, in megawatts, and number of hotspots. The magenta bar marks the peak day.

The weather it burned in

39°high
48km/h · peak gust
26%lowest humidity

It had gone 0 days without rain (1 mm or more) when it started.

This area had burned before

38% of the perimeter overlaps earlier fires recorded since 2016: 1,444 ha in 2016, 1,187 ha in 2017, 1,819 ha in 2019, 3,251 ha in 2020, 3,015 ha in 2021, 1,108 ha in 2022, 2,351 ha in 2023, 740 ha in 2024, 3,242 ha in 2025. Part of it burned more than once, so the yearly figures add up to more than the 3,697 ha that had burned before.

How big is it?

10 km
It burned the equivalent of 6.1% of the area of London (97 km² against 1,583 km²).

London boundary: geoBoundaries · Office for National Statistics (Open Government Licence v3.0).

This compares size, not location: both shapes are at the same scale, north up, centred on each other.

What happened to each town

  1. Mossuril where it started
    6,487 ha reached on 4 Oct
    1.9 %
  2. 3,279 ha reached on 5 Oct
    1.4 %

Burnt area inside each municipality, from crossing the GWIS perimeter with administrative boundaries. The distance runs from the point marking the centre of each area to the nearest fire: staying a kilometre away does not mean it reached the houses.

People and buildings inside the perimeter

GHSL 2025
Built-up area6.4 ha
Residents≈ 1,000

Inside the perimeter there were about 6.4 hectares of built-up land and about 1,000 residents (GHSL 2025, satellite-based estimate).

This is an estimate on 100 m cells, made from satellite imagery and census data: it does not mean that homes burned or that anyone was harmed. The perimeter also contains land that never burned. The GHSL 2025 epoch is a projection made from 2020 and earlier data.

Source: Global Human Settlement Layer (GHS-BUILT-S and GHS-POP R2023A), European Commission Joint Research Centre (JRC), © European Union, CC BY 4.0. Sum inside the perimeter computed by WorldFires. human-settlement.emergency.copernicus.eu

The weather day by day

ECMWF ERA5 reanalysis at the fire location, the standard reference for past weather, and the Canadian Fire Weather Index (the same system Copernicus uses), computed by WorldFires from that data. Days after the fire run until the first rain.

Open-Meteo.com (CC BY 4.0) · forecast models, provisional until the ERA5 reanalysis arrives

Day High Min. humidity Peak gust Rain Danger (FWI)
4 Oct 30.2 °C 64 % 34 km/h 2.9 mm Very low 1
5 Oct 30.8 °C 55 % 33 km/h 3.3 mm Very low 1
6 Oct 34.2 °C 38 % 34 km/h 0.0 mm Low 8
7 Oct 35.4 °C 36 % 40 km/h 0.0 mm Moderate 13
8 Oct 33.9 °C 43 % 32 km/h 1.1 mm Low 9
9 Oct 32.8 °C 45 % 37 km/h 0.5 mm Moderate 12
10 Oct 32.5 °C 44 % 40 km/h 0.0 mm Moderate 14
11 Oct 32.4 °C 39 % 42 km/h 0.1 mm Moderate 16
12 Oct 32.0 °C 44 % 37 km/h 0.0 mm Moderate 15
13 Oct 33.5 °C 34 % 38 km/h 0.5 mm Moderate 19
14 Oct 33.5 °C 36 % 41 km/h 1.7 mm Moderate 14
15 Oct 33.9 °C 34 % 35 km/h 2.1 mm Low 11
16 Oct 32.7 °C 39 % 35 km/h 0.5 mm Moderate 16
17 Oct 31.8 °C 38 % 34 km/h 4.9 mm Very low 4
18 Oct 33.7 °C 33 % 35 km/h 0.7 mm Moderate 16
19 Oct 36.3 °C 35 % 48 km/h 0.0 mm High 22
20 Oct 39.1 °C 26 % 48 km/h 0.0 mm High 29
21 Oct 38.3 °C 30 % 45 km/h 0.0 mm High 31
22 Oct 38.4 °C 31 % 43 km/h 0.0 mm High 31
23 Oct 38.0 °C 29 % 42 km/h 0.0 mm High 31
24 Oct 33.8 °C 48 % 33 km/h 0.9 mm Moderate 15
25 Oct 33.8 °C 42 % 45 km/h 0.3 mm High 23
26 Oct 33.0 °C 43 % 34 km/h 0.0 mm Moderate 20
27 Oct 36.1 °C 41 % 36 km/h 3.2 mm Moderate 11
28 Oct 39.3 °C 22 % 43 km/h 0.1 mm High 34

Before and after, from space

Drag the line to compare the same ground before the fire and after it.

Before · 27 Sept 2026
After · 28 Oct 2026

If the day is cloudy, change the date: each satellite passes once a day. In false colour the burnt ground looks brown or red.

The smoke

CAMS · Copernicus

On 9 October 2026 the air beside the fire reached 56 µg/m³ of PM2.5. That day averaged 28: 1.9 times the WHO daily guideline (15).

PM2.5 peak56 µg/m³
Days over the guideline5 days
PM1058 µg/m³
Optical depth0.43
234567891011121314151617
Good Fair Moderate Poor Very poor Extremely poor

Particles from the Copernicus CAMS model at the centre of the perimeter; these are not measurements in each town. The pale bar is the worst hour, the solid one the daily average.

Open-Meteo.com (CC BY 4.0) · Copernicus Atmosphere Monitoring Service (CAMS)

Detections table · 347Every satellite heat detection, one by one, with time, satellite, power and coordinates.
⬇ Download CSV Times in UTC. Each detection is a 375 m pixel: a large fire yields hundreds per pass.
Date and timeSatelliteFRP (MW)LatLon

Other fires nearby

All fires in Mozambique ›

Frequently asked questions

How long did the Mossuril fire last?
According to the heat detections seen by satellite inside the perimeter, it burned from 4 October 2026 to 28 October 2026 (25 days). The perimeter dates it from 4 October 2026 to 27 October 2026.
How much area did it burn?
The perimeter GWIS (Copernicus) rebuilt from heat detections is 9,699 hectares (97.0 km²). It is an estimate: official national figures may differ.
Which municipalities burned?
The fire entered 2 municipalities: Mossuril (6,487 ha, 1.9 %); Mogincual (3,279 ha, 1.4 %).
Is the Mossuril fire still active?
No fire detections since 28 Oct 2026, 11:55 UTC. A lack of detections is not an official extinction.
What was the weather like?
During the fire the temperature reached 39.1 °C, humidity dropped to 26 % and gusts hit 48 km/h. The fire danger index (FWI) reached 31, class High.
Where does this data come from?
From the GWIS (Copernicus) burnt perimeter, NASA FIRMS VIIRS hotspots and the administrative boundaries of Mozambique (geoBoundaries). It is not an official report.

Where to verify it

A satellite detection is not an official report. Final figures and the fire’s status are published by each country’s emergency service.

Satellite cross-check

History of this page · 2 Changes in area, dates, name, official record or merged pages, compared every night since 24 October 2026.
  1. Area: 9,102 → 9,699 ha.
  2. Area: 8,831 → 9,102 ha.

RSS Changes to this page

Does something look wrong on this page?

This page is built from satellite data and official records, and it sometimes gets things wrong: the wrong dates, the wrong town, two fires merged into one, or something that was not a wildfire at all. If you know this fire first-hand (you live nearby, saw it, fought it or reported on it), tell us what really happened and we will check it.

Report an error
What do you think is wrong?

We will only use your email to reply about this report. Privacy.

How we know this
  • Perimeter: GWIS (Copernicus), rebuilt from heat detections rather than mapped on imagery; 2 polygons grouped in this page.
  • Dates adjusted with the VIIRS detections inside the perimeter, which said 4 October 2026 to 27 October 2026. 347 Suomi-NPP VIIRS detections on those dates.
  • We have not matched this page with any official record.
  • Weather: ECMWF IFS model, provisional until the ERA5 reanalysis arrives.
  • Built-up area and population come from the JRC Global Human Settlement Layer (epoch 2025, 100 m cells), summed inside the perimeter: an estimate of what was there, not a damage count.

How we build fire pages: methodology ›

Where this data comes from

The perimeter comes from the Copernicus Global Wildfire Information System (GWIS), which rebuilds it from MODIS and VIIRS heat detections and publishes it under CC BY 4.0. It is not measured on imagery as in Europe, so it is an estimate. Heat detections come from the VIIRS sensors aboard Suomi-NPP and NOAA-20, distributed by NASA FIRMS at 375 m resolution. Municipal boundaries come from geoBoundaries ADM2 (Creative Commons Attribution 3.0 Intergovernmental Organisations (CC BY 3.0 IGO)). The area per municipality is computed by WorldFires by crossing the perimeter with those boundaries, so it may differ from each country’s official figure.