Skip to content
worldfires
TR · Türkiye · →

Midyat fire, 2 August 2016 Midyat, Gercüş

Out · last detection 2 Aug 2016, 22:25 UTC

The fire started on 2 August 2016 in Midyat, Türkiye, and satellites saw it burning for 1 day. Copernicus mapped a burnt perimeter of 882 hectares from satellite imagery, spread across 2 municipalities.

It is the 29th largest in Mardin since 2016 (of 131 with a page). Number 37 in Türkiye in 2016, of 223.

The power measured by the satellite is low (21.7 MW in the strongest hotspot), more typical of grass or stubble burning, or a slow surface fire, than of a large crown fire.

Burnt area
882ha
Copernicus perimeter
Duration
1day
2 Aug 2016 – 2 Aug 2016
Municipalities hit
2
districts
Started on
2 Aug
2016
Heat detections
8
in a single hotspot: 22 MW
Danger at start
53
Extreme · FWI index
Energy released
53MW
sum of detected power

Where it burned

HOTSPOTS BY DAY 2 Aug2 Aug

How it evolved, day by day

2

Fire radiative power detected each day, in megawatts, and number of hotspots. The magenta bar marks the peak day.

The weather it burned in

38°high
25km/h · peak gust
8%lowest humidity

It had gone 43 days without rain (1 mm or more) when it started.

This area had burned before

No earlier perimeters overlap this fire since 2016, when the satellite record begins.

What happened to each town

  1. Midyat 118,625 inhabitants · 15.0 km from the town where it started
    884 ha reached on 2 Aug
    0.8 %
  2. Gercüş 20,484 inhabitants · 16.1 km from the town
    1 ha
    0.0 %

Burnt area inside each municipality, from crossing the official perimeter with administrative boundaries. The distance is from the town centre to the nearest fire: staying a kilometre away does not mean it reached the houses.

What burned

  • Agricultural areas79 %
  • Other natural land21 %

Land cover inside the perimeter according to Corine Land Cover, as reported by Copernicus.

The weather day by day

ECMWF ERA5 reanalysis at the fire location, the standard reference for past weather, and the Canadian Fire Weather Index (the same system Copernicus uses), computed by WorldFires from that data. Days after the fire run until the first rain.

Open-Meteo.com (CC BY 4.0) · Copernicus Climate Change Service (ERA5)

Day High Min. humidity Peak gust Rain Danger (FWI)
2 Aug 38.3 °C 8 % 25 km/h 0.0 mm Extreme 53
3 Aug after 38.1 °C 10 % 22 km/h 0.0 mm Extreme 54
4 Aug after 39.6 °C 9 % 20 km/h 0.0 mm Extreme 54
5 Aug after 38.0 °C 15 % 42 km/h 0.0 mm Extreme 62
6 Aug after 38.0 °C 14 % 38 km/h 0.0 mm Extreme 61
7 Aug after 36.0 °C 19 % 26 km/h 0.0 mm Very high 47
8 Aug after 36.9 °C 17 % 24 km/h 0.0 mm Very high 46
9 Aug after 38.8 °C 14 % 23 km/h 0.0 mm Very high 47
10 Aug after 38.8 °C 12 % 35 km/h 0.0 mm Extreme 58
11 Aug after 36.6 °C 17 % 32 km/h 0.0 mm Extreme 53
12 Aug after 35.9 °C 24 % 27 km/h 0.0 mm Very high 47

Before and after, from space

Drag the line to compare the same ground before the fire and after it.

Before · 26 Jul 2016
After · 9 Aug 2016

If the day is cloudy, change the date: each satellite passes once a day. In false colour the burnt ground looks brown or red.

The smoke

CAMS · Copernicus

On 4 August 2016 the air beside the fire reached 19 µg/m³ of PM2.5. That day averaged 17: 1.1 times the WHO daily guideline (15).

PM2.5 peak19 µg/m³
Days over the guideline2 days
PM1025 µg/m³
3112345
Good Fair Moderate Poor Very poor Extremely poor

Particles from the Copernicus CAMS model at the centre of the perimeter; these are not measurements in each town. The pale bar is the worst hour, the solid one the daily average.

Open-Meteo.com (CC BY 4.0) · Copernicus Atmosphere Monitoring Service (CAMS)

Detections table · 8Every satellite heat detection, one by one, with time, satellite, power and coordinates.
⬇ Download CSV Times in UTC. Each detection is a 375 m pixel: a large fire yields hundreds per pass.
Date and timeSatelliteFRP (MW)LatLon

Other fires nearby

All fires in Türkiye ›

Frequently asked questions

How long did the Midyat fire last?
Copernicus dates it between 2 August 2016 and 2 August 2016: 1 day between the first and last image with fire.
How much area did it burn?
The perimeter Copernicus measured from satellite imagery is 882 hectares (8.8 km²). Official national figures may differ.
Which municipalities burned?
The fire entered 2 municipalities: Midyat (884 ha, 0.8 %); Gercüş (1 ha, 0.0 %).
Did the fire reach a town?
The closest fire to a town centre came within 15.0 km of Midyat. That is the distance to the perimeter or nearest hotspot; it does not mean it entered the houses.
What was the weather like?
During the fire the temperature reached 38.3 °C, humidity dropped to 8 % and gusts hit 25 km/h. The fire danger index (FWI) reached 53, class Extreme.
Where does this data come from?
From the EFFIS (Copernicus) burnt perimeter, NASA FIRMS VIIRS hotspots and the administrative boundaries of Türkiye (geoBoundaries). It is not an official report.

Where to verify it

A satellite detection is not an official report. Final figures and the fire’s status are published by each country’s emergency service.

Emergency number: 112

Satellite cross-check

Does something look wrong on this page?

This page is built from satellite data and official records, and it sometimes gets things wrong: the wrong dates, the wrong town, two fires merged into one, or something that was not a wildfire at all. If you know this fire first-hand (you live nearby, saw it, fought it or reported on it), tell us what really happened and we will check it.

Report an error
What do you think is wrong?

We will only use your email to reply about this report. Privacy. This is not an emergency service: if there is a fire now, call 112.

Where this data comes from

The perimeter and land cover come from the Copernicus European Forest Fire Information System (EFFIS), measured on MODIS and Sentinel-2 imagery and published under CC BY 4.0. Heat detections come from the VIIRS sensors aboard Suomi-NPP and NOAA-20, distributed by NASA FIRMS at 375 m resolution. Municipal boundaries come from geoBoundaries ADM2 (Open Data Commons Open Database License 1.0). The area per municipality is computed by WorldFires by crossing the perimeter with those boundaries, so it may differ slightly from each country’s official figure.