Skip to content
worldfires
TR · Türkiye · →

Nusaybin fire, 21 August 2016 Nusaybin

Out · last detection 23 Aug 2016, 22:31 UTC

The fire started on 21 August 2016 in Nusaybin, Türkiye, and satellites saw it burning for 2 days. Copernicus mapped a burnt perimeter of 5,040 hectares from satellite imagery, spread across a single municipality.

It is the 5th largest in Mardin since 2016 (of 131 with a page). Number 3 in Türkiye in 2016, of 223.

The power measured by the satellite is low (14.1 MW in the strongest hotspot), more typical of grass or stubble burning, or a slow surface fire, than of a large crown fire.

Burnt area
5,040ha
Copernicus perimeter
Duration
2days
21 Aug 2016 – 22 Aug 2016
Municipalities hit
1
districts
Started on
21 Aug
2016
Heat detections
59
in a single hotspot: 14 MW
Danger at start
58
Extreme · FWI index
Energy released
331MW
sum of detected power

Where it burned

23 Aug 2016
HOTSPOTS BY DAY 21 Aug22 Aug

How it evolved, day by day

212223

Fire radiative power detected each day, in megawatts, and number of hotspots. The magenta bar marks the peak day.

The weather it burned in

41°high
44km/h · peak gust
8%lowest humidity

It had gone more than two months without rain (1 mm or more) when it started.

This area had burned before

No earlier perimeters overlap this fire since 2016, when the satellite record begins.

What happened to each town

  1. Nusaybin 105,856 inhabitants · 7.3 km from the town where it started
    5,049 ha reached on 21 Aug
    4.4 %

Burnt area inside each municipality, from crossing the official perimeter with administrative boundaries. The distance is from the town centre to the nearest fire: staying a kilometre away does not mean it reached the houses.

What burned

  • Other natural land96 %
  • Agricultural areas2.9 %
  • Scrub and transitional woodland1.1 %

Land cover inside the perimeter according to Corine Land Cover, as reported by Copernicus.

The weather day by day

ECMWF ERA5 reanalysis at the fire location, the standard reference for past weather, and the Canadian Fire Weather Index (the same system Copernicus uses), computed by WorldFires from that data. Days after the fire run until the first rain.

Open-Meteo.com (CC BY 4.0) · Copernicus Climate Change Service (ERA5)

Day High Min. humidity Peak gust Rain Danger (FWI)
21 Aug 40.8 °C 9 % 35 km/h 0.0 mm Extreme 58
22 Aug 39.8 °C 9 % 37 km/h 0.0 mm Extreme 58
23 Aug after 40.8 °C 8 % 41 km/h 0.0 mm Extreme 66
24 Aug after 40.8 °C 8 % 44 km/h 0.0 mm Very extreme 71
25 Aug after 40.3 °C 9 % 44 km/h 0.0 mm Extreme 63
26 Aug after 39.7 °C 11 % 40 km/h 0.1 mm Extreme 65
27 Aug after 39.9 °C 14 % 46 km/h 0.0 mm Extreme 68
28 Aug after 38.9 °C 11 % 42 km/h 0.0 mm Extreme 66
29 Aug after 38.9 °C 12 % 41 km/h 0.0 mm Extreme 65
30 Aug after 39.9 °C 13 % 39 km/h 0.0 mm Extreme 64
31 Aug after 39.5 °C 14 % 47 km/h 0.0 mm Very extreme 70
1 Sept after 36.6 °C 14 % 31 km/h 0.0 mm Extreme 54
2 Sept after 35.4 °C 13 % 35 km/h 0.0 mm Extreme 57
3 Sept after 33.1 °C 20 % 42 km/h 0.0 mm Extreme 54

Before and after, from space

Drag the line to compare the same ground before the fire and after it.

Before · 14 Aug 2016
After · 29 Aug 2016

If the day is cloudy, change the date: each satellite passes once a day. In false colour the burnt ground looks brown or red.

The smoke

CAMS · Copernicus

On 19 August 2016 the air beside the fire reached 41 µg/m³ of PM2.5. That day averaged 35: 2.3 times the WHO daily guideline (15).

PM2.5 peak41 µg/m³
Days over the guideline9 days
PM1055 µg/m³
192021222324252627
Good Fair Moderate Poor Very poor Extremely poor

Particles from the Copernicus CAMS model at the centre of the perimeter; these are not measurements in each town. The pale bar is the worst hour, the solid one the daily average.

Open-Meteo.com (CC BY 4.0) · Copernicus Atmosphere Monitoring Service (CAMS)

Detections table · 59Every satellite heat detection, one by one, with time, satellite, power and coordinates.
⬇ Download CSV Times in UTC. Each detection is a 375 m pixel: a large fire yields hundreds per pass.
Date and timeSatelliteFRP (MW)LatLon

Other fires nearby

All fires in Türkiye ›

Frequently asked questions

How long did the Nusaybin fire last?
Copernicus dates it between 21 August 2016 and 22 August 2016: 2 days between the first and last image with fire.
How much area did it burn?
The perimeter Copernicus measured from satellite imagery is 5,040 hectares (50.4 km²). Official national figures may differ.
Which municipalities burned?
The fire only entered Nusaybin (5,049 ha, 4.4 %).
Did the fire reach a town?
The closest fire to a town centre came within 7.3 km of Nusaybin. That is the distance to the perimeter or nearest hotspot; it does not mean it entered the houses.
What was the weather like?
During the fire the temperature reached 40.8 °C, humidity dropped to 8 % and gusts hit 44 km/h. The fire danger index (FWI) reached 71, class Very extreme.
Where does this data come from?
From the EFFIS (Copernicus) burnt perimeter, NASA FIRMS VIIRS hotspots and the administrative boundaries of Türkiye (geoBoundaries). It is not an official report.

Where to verify it

A satellite detection is not an official report. Final figures and the fire’s status are published by each country’s emergency service.

Emergency number: 112

Satellite cross-check

Does something look wrong on this page?

This page is built from satellite data and official records, and it sometimes gets things wrong: the wrong dates, the wrong town, two fires merged into one, or something that was not a wildfire at all. If you know this fire first-hand (you live nearby, saw it, fought it or reported on it), tell us what really happened and we will check it.

Report an error
What do you think is wrong?

We will only use your email to reply about this report. Privacy. This is not an emergency service: if there is a fire now, call 112.

Where this data comes from

The perimeter and land cover come from the Copernicus European Forest Fire Information System (EFFIS), measured on MODIS and Sentinel-2 imagery and published under CC BY 4.0. Heat detections come from the VIIRS sensors aboard Suomi-NPP and NOAA-20, distributed by NASA FIRMS at 375 m resolution. Municipal boundaries come from geoBoundaries ADM2 (Open Data Commons Open Database License 1.0). The area per municipality is computed by WorldFires by crossing the perimeter with those boundaries, so it may differ slightly from each country’s official figure.