Skip to content
worldfires
TR · Türkiye · →

Güçlükonak fire, June 2021 Güçlükonak

Out · last detection 29 Jun 2021, 10:04 UTC

The fire started on 28 June 2021 in Güçlükonak, Türkiye, and satellites saw it burning for 2 days. Copernicus mapped a burnt perimeter of 250 hectares from satellite imagery, spread across a single municipality.

It is the 100th largest in Şırnak since 2016 (of 192 with a page). Number 73 in Türkiye in 2021, of 138.

The power measured by the satellite is low (11.8 MW in the strongest hotspot), more typical of grass or stubble burning, or a slow surface fire, than of a large crown fire.

Compare with…
Burnt area
250ha
Copernicus perimeter
Duration
2days
28 Jun 2021 – 29 Jun 2021
Municipalities hit
1
districts
Started on
28 Jun
2021
Heat detections
5
in a single hotspot: 12 MW
Danger at start
56
Extreme · FWI index
Average daily power
17MW
detected power per day, on average

Where it burned

HOTSPOTS BY DAY 28 Jun29 Jun
29 Jun 2021

How it evolved, day by day

28 Jun 2021 · 4 MW · 2 29 Jun 2021 · 31 MW · 3
28 Jun 29 Jun

Fire radiative power detected each day, in megawatts, and number of hotspots. The magenta bar marks the peak day.

The weather it burned in

40°high
55km/h · peak gust
10%lowest humidity

It had gone 49 days without rain (1 mm or more) when it started.

This area had burned before

51% of the perimeter overlaps earlier fires recorded since 2016: 58 ha in 2018, 84 ha in 2020. Part of it burned more than once, so the yearly figures add up to more than the 127 ha that had burned before.

What happened to each town

  1. Güçlükonak 13,091 inhabitants · 18.4 km from the centre where it started
    250 ha reached on 28 Jun
    0.5 %

Burnt area inside each municipality, from crossing the official perimeter with administrative boundaries. The distance runs from the point marking the centre of each area to the nearest fire: staying a kilometre away does not mean it reached the houses.

What burned

  • Mixed forest50 %
  • Agricultural areas33 %
  • Other natural land14 %
  • Scrub and transitional woodland2.8 %

Land cover inside the perimeter according to Corine Land Cover, as reported by Copernicus.

The weather day by day

ECMWF ERA5 reanalysis at the fire location, the standard reference for past weather, and the Canadian Fire Weather Index (the same system Copernicus uses), computed by WorldFires from that data. Days after the fire run until the first rain.

Open-Meteo.com (CC BY 4.0) · Copernicus Climate Change Service (ERA5)

Day High Min. humidity Peak gust Rain Danger (FWI)
28 Jun 39.9 °C 11 % 38 km/h 0.0 mm Extreme 56
29 Jun 38.4 °C 10 % 55 km/h 0.0 mm Extreme 66
30 Jun after 40.0 °C 9 % 47 km/h 0.0 mm Extreme 58
1 Jul after 40.0 °C 11 % 35 km/h 0.0 mm Extreme 55
2 Jul after 39.2 °C 14 % 28 km/h 0.0 mm Extreme 50
3 Jul after 39.2 °C 14 % 47 km/h 0.0 mm Extreme 61
4 Jul after 35.5 °C 13 % 55 km/h 0.0 mm Extreme 64
5 Jul after 35.5 °C 15 % 37 km/h 0.0 mm Extreme 54
6 Jul after 35.3 °C 16 % 47 km/h 0.0 mm Extreme 56
7 Jul after 36.7 °C 13 % 48 km/h 0.0 mm Extreme 58
8 Jul after 38.3 °C 12 % 28 km/h 0.0 mm Very high 49
9 Jul after 39.0 °C 12 % 40 km/h 0.0 mm Extreme 54

Before and after, from space

Drag the line to compare the same ground before the fire and after it.

Before · 21 Jun 2021
After · 6 Jul 2021

If the day is cloudy, change the date: each satellite passes once a day. In false colour the burnt ground looks brown or red.

The smoke

CAMS · Copernicus

On 2 July 2021 the air beside the fire reached 23 µg/m³ of PM2.5. That day averaged 18: 1.2 times the WHO daily guideline (15).

PM2.5 peak23 µg/m³
Days over the guideline5 days
PM1042 µg/m³
262728293012
Good Fair Moderate Poor Very poor Extremely poor

Particles from the Copernicus CAMS model at the centre of the perimeter; these are not measurements in each town. The pale bar is the worst hour, the solid one the daily average.

Open-Meteo.com (CC BY 4.0) · Copernicus Atmosphere Monitoring Service (CAMS)

Detections table · 5Every satellite heat detection, one by one, with time, satellite, power and coordinates.
⬇ Download CSV Times in UTC. Each detection is a 375 m pixel: a large fire yields hundreds per pass.
Date and timeSatelliteFRP (MW)LatLon

Other fires nearby

All fires in Türkiye ›

Frequently asked questions

How long did the Güçlükonak fire last?
Copernicus dates it between 28 June 2021 and 29 June 2021: 2 days between the first and last image with fire.
How much area did it burn?
The perimeter Copernicus measured from satellite imagery is 250 hectares (2.5 km²). Official national figures may differ.
Which municipalities burned?
The fire only entered Güçlükonak (250 ha, 0.5 %).
Did the fire reach a town?
The fire started in Güçlükonak and came within 18.4 km of its centre. That is the distance from the perimeter, or the nearest hotspot, to the point marking the centre; it does not mean it entered the houses.
What was the weather like?
During the fire the temperature reached 39.9 °C, humidity dropped to 10 % and gusts hit 55 km/h. The fire danger index (FWI) reached 66, class Extreme.
Where does this data come from?
From the EFFIS (Copernicus) burnt perimeter, NASA FIRMS VIIRS hotspots and the administrative boundaries of Türkiye (geoBoundaries). It is not an official report.

Where to verify it

A satellite detection is not an official report. Final figures and the fire’s status are published by each country’s emergency service.

Emergency number: 112 · Emergency number and official warnings ›

Satellite cross-check

History of this page Changes in area, dates, name, official record or merged pages, compared every night since 24 October 2026.

No changes since 24 October 2026.

RSS Changes to this page

Does something look wrong on this page?

This page is built from satellite data and official records, and it sometimes gets things wrong: the wrong dates, the wrong town, two fires merged into one, or something that was not a wildfire at all. If you know this fire first-hand (you live nearby, saw it, fought it or reported on it), tell us what really happened and we will check it.

Report an error
What do you think is wrong?

We will only use your email to reply about this report. Privacy. This is not an emergency service: if there is a fire now, call 112.

How we know this
  • Perimeter: EFFIS (Copernicus), mapped on satellite imagery.
  • Dates from the perimeter: the VIIRS detections inside it did not change them. 5 Suomi-NPP VIIRS detections on those dates.
  • We have not matched this page with any official record.
  • Weather: Copernicus ERA5 reanalysis at the fire location, in cells of about 25 km.

How we build fire pages: methodology ›

Where this data comes from

The perimeter and land cover come from the Copernicus European Forest Fire Information System (EFFIS), measured on MODIS and Sentinel-2 imagery and published under CC BY 4.0. Heat detections come from the VIIRS sensors aboard Suomi-NPP and NOAA-20, distributed by NASA FIRMS at 375 m resolution. Municipal boundaries come from geoBoundaries ADM2 (Open Data Commons Open Database License 1.0). The area per municipality is computed by WorldFires by crossing the perimeter with those boundaries, so it may differ slightly from each country’s official figure.