Caldas de Reis fire, October 2017
Caldas de Reis, Catoira, Valga
Out · last measured on 15 Oct 2017
The fire started on 15 October 2017 in Caldas de Reis, Spain, and satellites saw it burning for 1 day. Copernicus mapped a burnt perimeter of 706 hectares from satellite imagery, spread across 3 municipalities.
It is the 8th largest in Pontevedra since 2016 (of 33 with a page). Number 39 in Spain in 2017, of 144.
matches the official recordwith caveatssatellite onlymodel
When copying, the sentence is
Tick the figures you want: they make up the lede and the CSV.
Burned area
with caveats
706ha
Perimeter published by EFFIS (Copernicus).
This page706EGIF (MITECO)1,068
Source
EFFIS (Copernicus)
Date
perimeter revised on 26 January 2022
+− cross-check
EGIF (MITECO): 1,068 ha (matched records: 1). Difference between the page and the official record: −33.9%. Matched on 15 November 2026. The two figures differ a lot, so these may not be exactly the same fire: take them as nearby records.
Duration by satellite
satellite only
1day
15 Oct 2017 to 15 Oct 2017: first and last day with fire on the page.
Source
EFFIS (Copernicus) · NASA FIRMS · VIIRS
Date
15 Oct 2017 – 15 Oct 2017
+− cross-check
Satellites pass a few times a day and cloud or smoke can hide the fire: a lack of detections is not an official extinction. Each country’s emergency service declares a fire contained or out.
Start
satellite only
15 Oct 2017
First day with fire seen by the satellites or the perimeter.
Source
EFFIS (Copernicus) · NASA FIRMS · VIIRS
Date
15 Oct 2017
+− cross-check
The two figures differ a lot, so these may not be exactly the same fire: take them as nearby records.
Danger at the start
model
32.2FWI · high
Fire Weather Index (Canadian system) computed by WorldFires for the day the fire started. Consecutive days without rain before: 20.
This is an index computed from weather model data, not a measurement of the fire nor an official warning. Danger warnings are issued by each country’s authority. Emergency number and official warnings ›
Weather during the fire
model
27.8°C · 29% RH
High of 27.8 °C and minimum humidity of 29% on 15 October 2017; gusts of 66 km/h on 15 October 2017.
These are model values for a cell of about 25 km, not from a weather station: they may differ from what was measured on the ground.
ⓘThis page’s change log has been kept since 24 October 2026: every night what it publishes is compared and the difference is logged. Anything earlier is reconstructed from each source’s date and marked as reconstructed.
Show
· reconstructedofficial
Matched with the official EGIF (MITECO) record
Nearby records with very different figures: 1,068 ha (records: 1).
A version keeps the area, dates, name and official record; the area as it was logged (changes under 2% are not logged). The map, hotspots and weather always show today’s data.
Citation
A lede of about 60 words figures only, no adjectives
We have the Copernicus perimeter for this fire, but the VIIRS sensors did not capture it in enough detail: no day-by-day evolution, but the split by municipality is there.
Burnt area
706ha
Copernicus perimeter
Duration
1day
15 Oct 2017 – 15 Oct 2017
Municipalities hit
3
municipalities
Started on
15 Oct
2017
Danger at start
32
High · FWI index
Where it burned
The weather it burned in
28°high
66km/h · peak gust
29%lowest humidity
It had gone 20 days without rain (1 mm or more) when it started. Rain came after the fire: 11.1 mm on 16 Oct.
This area had burned before
No earlier perimeters overlap this fire since 2016, when the satellite record begins.
How big is it?
It burned the equivalent of 0.4% of the area of London (7.1 km² against 1,583 km²).
London boundary: geoBoundaries · Office for National Statistics (Open Government Licence v3.0).
It burned the equivalent of 1.2% of the area of Madrid (7.1 km² against 604 km²).
Madrid boundary: geoBoundaries · Open Data ESRI, IGN Central Registry of Cartography Area (CC BY 4.0).
It burned the equivalent of 6.7% of the area of Paris (7.1 km² against 105 km²).
Paris boundary: geoBoundaries · Institut national de l'information géographique et forestière (IGN-F) (Etalab Open License 2.0).
It burned the equivalent of 0.8% of the area of Berlin (7.1 km² against 892 km²).
Berlin boundary: geoBoundaries · Federal Agency for Cartography and Geodesy (dl-de/by-2-0).
Fire perimeterLondon
This compares size, not location: both shapes are at the same scale, north up, centred on each other.
What happened to each town
Caldas de Reis9,615 inhabitants · 4.3 km from the centrewhere it started
Burnt area inside each municipality, from crossing the official perimeter with administrative boundaries. The distance runs from the point marking the centre of each area to the nearest fire: staying a kilometre away does not mean it reached the houses.
What burned
Scrub and transitional woodland56 %
Coniferous forest33 %
Broadleaved forest10 %
Mixed forest1.1 %
Land cover inside the perimeter according to Corine Land Cover, as reported by Copernicus.
Official record
According to EGIF (MITECO), this fire started on 15 October 2017 and burned 1,068 ha (the satellite measured 706 ha). The two figures differ a lot, so these may not be exactly the same fire: take them as nearby records.
Caldas de ReisPazo (O)15 October 2017 · 20:151,068 ha· extinguished on 18 October 2017· cause: arson
ECMWF ERA5 reanalysis at the fire location, the standard reference for past weather, and the Canadian Fire Weather Index (the same system Copernicus uses), computed by WorldFires from that data. Days after the fire run until the first rain.
Open-Meteo.com (CC BY 4.0) · Copernicus Climate Change Service (ERA5)
It started with an FWI of 32.2, a minimum humidity of 29% and 20 days without rain. Fires in the area that started in weather like this since 2016: 24.
FWI at the start32.2
Minimum humidity29 %
Days without rain20
this firechosen twinsrest of the area
Almost identicalSimilar
Outlines of the closest twins
This fire · Caldas de Reis fire, October 2017
706 ha1 dayFWI 32.2Min. humidity 29 %
Póvoa de Lanhoso fire, September 2018
207 ha1 dayFWI 32.7Min. humidity 30 %123 km away, in 2018
First rain (1 mm or more) after it ended: none in the following ten days.
It was 3.2 times larger than the median of its twins and lasted 1 day, against 2 days.
Only 6 of its 24 twins burned more. The weather on the first day does not explain everything: the wind in the following days, the fuel and the firefighting also count. In 12 of 24, not even 1 mm fell in the ten days after the end: they went out without rain. In the rest, the first rainy day brought a median of 7.4 mm.
This is a bank of analogues: it shows what usually happens, not what will happen. With fewer than 15 twins we give no figures. How we calculate it
How it ended
11.1 mmfirst rain
16 Octthe day after it ended
66km/h · max. gust
It was considered over on 15 Oct, and on 16 Oct 11.1 mm fell. We do not know whether the rain or the firefighters put it out. Twins with rain when they ended: 12 of 24, with a median of 7.4 mm.
Weather on this page: Open-Meteo.com (CC BY 4.0) · Copernicus Climate Change Service (ERA5)
How a twin is chosen
Same area: fires that have already ended, less than 250 km from this one, since 2016.
Same start: we compare the FWI on the first day, the minimum humidity that day and the run of days without rain before it. The slider sets how much they may differ.
Only pages with final weather data (ERA5 reanalysis) calculated in the same way as this fire’s; agricultural and grass burns and pages with data under review are left out.
Fires burning at the same time as this one (a week before or after) are left out: they share the same spell of weather and do not count as a precedent.
They are sorted by similarity, and the outlines of the first five are drawn.
Drag the line to compare the same ground before the fire and after it.
↔
Before · 8 Oct 2017
After · 22 Oct 2017
Sentinel-2 did not pass over on that day. Try another date, or use false colour, which is daily.
If the day is cloudy, change the date: each satellite passes once a day. In false colour the burnt ground looks brown or red.
The smoke
CAMS · Copernicus
On 15 October 2017 the air beside the fire reached 65 µg/m³ of PM2.5. That day averaged 46: 3.0 times the WHO daily guideline (15).
PM2.5 peak65µg/m³
Days over the guideline4days
PM10105µg/m³
WHO 15
13 Oct15 Oct17 Oct
GoodFairModeratePoorVery poorExtremely poor
Particles from the Copernicus CAMS model at the centre of the perimeter; these are not measurements in each town. The pale bar is the worst hour, the solid one the daily average.
Open-Meteo.com (CC BY 4.0) · Copernicus Atmosphere Monitoring Service (CAMS)
Copernicus dates it between 15 October 2017 and 15 October 2017: 1 day between the first and last image with fire.
How much area did it burn?
The perimeter Copernicus measured from satellite imagery is 706 hectares (7.1 km²). Official national figures may differ.
Which municipalities burned?
The fire entered 3 municipalities: Caldas de Reis (428 ha, 6.3 %); Catoira (275 ha, 9.4 %); Valga (3 ha, 0.1 %).
Did the fire reach a town?
The fire came within 2.5 km of the centre of Catoira, the closest of the areas it touched. That is the distance from the perimeter, or the nearest hotspot, to the point marking the centre; it does not mean it entered the houses.
What was the weather like?
During the fire the temperature reached 27.8 °C, humidity dropped to 29 % and gusts hit 66 km/h. The fire danger index (FWI) reached 32, class High.
Where does this data come from?
From the EFFIS (Copernicus) burnt perimeter, NASA FIRMS VIIRS hotspots and the administrative boundaries of Spain (geoBoundaries). It is not an official report.
How did the fires that started in similar weather in this area end?
Fires less than 250 km away that started since 2016 with a similar FWI, humidity and dry spell: 24. Their median duration was 2 days and their median area 221 ha; 17 % went past 1,000 ha. Only 6 of its 24 twins burned more. The weather on the first day does not explain everything: the wind in the following days, the fuel and the firefighting also count. In 12 of 24, not even 1 mm fell in the ten days after the end: they went out without rain. In the rest, the first rainy day brought a median of 7.4 mm.
Where to verify it
A satellite detection is not an official report. Final figures and the fire’s status are published by each country’s emergency service.
This page is built from satellite data and official records, and it sometimes gets things wrong: the wrong dates, the wrong town, two fires merged into one, or something that was not a wildfire at all. If you know this fire first-hand (you live nearby, saw it, fought it or reported on it), tell us what really happened and we will check it.
⚑Report an errorHow we know this›
Perimeter: EFFIS (Copernicus), mapped on satellite imagery.
Dates from the perimeter: the VIIRS detections inside it did not change them. No Suomi-NPP VIIRS detections on those dates.
Compared with EGIF (MITECO): 1,068 official ha against 706 ha of perimeter; similar, but with reservations.
Weather: Copernicus ERA5 reanalysis at the fire location, in cells of about 25 km.
The perimeter and land cover come from the Copernicus European Forest Fire Information System (EFFIS), measured on MODIS and Sentinel-2 imagery and published under CC BY 4.0. Heat detections come from the VIIRS sensors aboard Suomi-NPP and NOAA-20, distributed by NASA FIRMS at 375 m resolution. Municipal boundaries come from geoBoundaries ADM3 (Creative Commons Attribution 4.0 International (CC BY 4.0)). The area per municipality is computed by WorldFires by crossing the perimeter with those boundaries, so it may differ slightly from each country’s official figure.