Skip to content
worldfires
TR · Türkiye · →

Serik fire, 6 September 2026 Serik

Out · last detection 6 Sept 2026, 23:46 UTC

The fire started on 6 September 2026 in Serik, Türkiye, and satellites saw it burning for 1 day. Copernicus mapped a burnt perimeter of 183 hectares from satellite imagery, spread across a single municipality.

It is the 19th largest in Antalya since 2016 (of 26 with a page). Number 60 in Türkiye in 2026, of 106.

The power measured by the satellite is low (5.4 MW in the strongest hotspot), more typical of grass or stubble burning, or a slow surface fire, than of a large crown fire.

Burnt area
183ha
Copernicus perimeter
Duration
1day
6 Sept 2026 – 6 Sept 2026
Municipalities hit
1
districts
Started on
6 Sept
2026
Heat detections
7
in a single hotspot: 5 MW
Danger at start
46
Very high · FWI index
Energy released
24MW
sum of detected power

Where it burned

HOTSPOTS BY DAY 6 Sept6 Sept

How it evolved, day by day

6

Fire radiative power detected each day, in megawatts, and number of hotspots. The magenta bar marks the peak day.

The weather it burned in

40°high
31km/h · peak gust
17%lowest humidity

It had gone 19 days without rain (1 mm or more) when it started. Rain came after the fire: 1.7 mm on 16 Sept.

This area had burned before

No earlier perimeters overlap this fire since 2016, when the satellite record begins.

What happened to each town

  1. Serik 124,335 inhabitants · 12.4 km from the town where it started
    183 ha reached on 6 Sept
    0.2 %

Burnt area inside each municipality, from crossing the official perimeter with administrative boundaries. The distance is from the town centre to the nearest fire: staying a kilometre away does not mean it reached the houses.

What burned

  • Scrub and transitional woodland70 %
  • Coniferous forest22 %
  • Other natural land3.8 %
  • Agricultural areas3.3 %

Land cover inside the perimeter according to Corine Land Cover, as reported by Copernicus.

The weather day by day

ECMWF ERA5 reanalysis at the fire location, the standard reference for past weather, and the Canadian Fire Weather Index (the same system Copernicus uses), computed by WorldFires from that data. Days after the fire run until the first rain.

Open-Meteo.com (CC BY 4.0) · Copernicus Climate Change Service (ERA5)

Day High Min. humidity Peak gust Rain Danger (FWI)
6 Sept 39.7 °C 17 % 31 km/h 0.0 mm Very high 46
7 Sept after 38.0 °C 13 % 52 km/h 0.0 mm Extreme 56
8 Sept after 36.4 °C 17 % 38 km/h 0.0 mm Very high 50
9 Sept after 35.3 °C 19 % 36 km/h 0.0 mm Very high 49
10 Sept after 34.7 °C 25 % 38 km/h 0.0 mm Very high 44
11 Sept after 36.3 °C 27 % 39 km/h 0.0 mm Very high 46
12 Sept after 38.0 °C 23 % 42 km/h 0.0 mm Very high 46
13 Sept after 34.4 °C 40 % 36 km/h 0.0 mm High 34
14 Sept after 32.2 °C 48 % 32 km/h 0.1 mm High 28
15 Sept after 32.9 °C 34 % 36 km/h 0.0 mm High 31
16 Sept after 31.3 °C 46 % 37 km/h 1.7 mm Moderate 16

Before and after, from space

Drag the line to compare the same ground before the fire and after it.

Before · 30 Aug 2026
After · 13 Sept 2026

If the day is cloudy, change the date: each satellite passes once a day. In false colour the burnt ground looks brown or red.

The smoke

CAMS · Copernicus

On 9 September 2026 the air beside the fire reached 12 µg/m³ of PM2.5, but no daily average passed the WHO guideline (15).

PM2.5 peak12 µg/m³
Days over the guideline0 days
PM1019 µg/m³
Optical depth0.37
456789
Good Fair Moderate Poor Very poor Extremely poor

Particles from the Copernicus CAMS model at the centre of the perimeter; these are not measurements in each town. The pale bar is the worst hour, the solid one the daily average.

Open-Meteo.com (CC BY 4.0) · Copernicus Atmosphere Monitoring Service (CAMS)

Detections table · 7Every satellite heat detection, one by one, with time, satellite, power and coordinates.
⬇ Download CSV Times in UTC. Each detection is a 375 m pixel: a large fire yields hundreds per pass.
Date and timeSatelliteFRP (MW)LatLon

Other fires nearby

All fires in Türkiye ›

Frequently asked questions

How long did the Serik fire last?
Copernicus dates it between 6 September 2026 and 6 September 2026: 1 day between the first and last image with fire.
How much area did it burn?
The perimeter Copernicus measured from satellite imagery is 183 hectares (1.8 km²). Official national figures may differ.
Which municipalities burned?
The fire only entered Serik (183 ha, 0.2 %).
Did the fire reach a town?
The closest fire to a town centre came within 12.4 km of Serik. That is the distance to the perimeter or nearest hotspot; it does not mean it entered the houses.
What was the weather like?
During the fire the temperature reached 39.7 °C, humidity dropped to 17 % and gusts hit 31 km/h. The fire danger index (FWI) reached 46, class Very high.
Where does this data come from?
From the EFFIS (Copernicus) burnt perimeter, NASA FIRMS VIIRS hotspots and the administrative boundaries of Türkiye (geoBoundaries). It is not an official report.

Where to verify it

A satellite detection is not an official report. Final figures and the fire’s status are published by each country’s emergency service.

Emergency number: 112

Satellite cross-check

Does something look wrong on this page?

This page is built from satellite data and official records, and it sometimes gets things wrong: the wrong dates, the wrong town, two fires merged into one, or something that was not a wildfire at all. If you know this fire first-hand (you live nearby, saw it, fought it or reported on it), tell us what really happened and we will check it.

Report an error
What do you think is wrong?

We will only use your email to reply about this report. Privacy. This is not an emergency service: if there is a fire now, call 112.

Where this data comes from

The perimeter and land cover come from the Copernicus European Forest Fire Information System (EFFIS), measured on MODIS and Sentinel-2 imagery and published under CC BY 4.0. Heat detections come from the VIIRS sensors aboard Suomi-NPP and NOAA-20, distributed by NASA FIRMS at 375 m resolution. Municipal boundaries come from geoBoundaries ADM2 (Open Data Commons Open Database License 1.0). The area per municipality is computed by WorldFires by crossing the perimeter with those boundaries, so it may differ slightly from each country’s official figure.