Skip to content
worldfires
TR · Türkiye · →

Serik fire, 7 September 2026 Serik

Out · last detection 8 Sept 2026, 01:07 UTC

The fire started on 7 September 2026 in Serik, Türkiye, and satellites saw it burning for 2 days. Copernicus mapped a burnt perimeter of 108 hectares from satellite imagery, spread across a single municipality.

It is the 26th largest in Antalya since 2016 (of 26 with a page). Number 101 in Türkiye in 2026, of 106.

The power measured by the satellite is low (19.2 MW in the strongest hotspot), more typical of grass or stubble burning, or a slow surface fire, than of a large crown fire.

Burnt area
108ha
Copernicus perimeter
Duration
2days
7 Sept 2026 – 8 Sept 2026
Municipalities hit
1
districts
Started on
7 Sept
2026
Heat detections
11
in a single hotspot: 19 MW
Danger at start
56
Extreme · FWI index
Energy released
108MW
sum of detected power

Where it burned

8 Sept 2026
HOTSPOTS BY DAY 7 Sept8 Sept

How it evolved, day by day

78

Fire radiative power detected each day, in megawatts, and number of hotspots. The magenta bar marks the peak day.

The weather it burned in

38°high
52km/h · peak gust
13%lowest humidity

It had gone 20 days without rain (1 mm or more) when it started. Rain came after the fire: 1.7 mm on 16 Sept.

This area had burned before

No earlier perimeters overlap this fire since 2016, when the satellite record begins.

What happened to each town

  1. Serik 124,335 inhabitants · 6.3 km from the town where it started
    108 ha reached on 7 Sept
    0.1 %

Burnt area inside each municipality, from crossing the official perimeter with administrative boundaries. The distance is from the town centre to the nearest fire: staying a kilometre away does not mean it reached the houses.

What burned

  • Other natural land51 %
  • Agricultural areas30 %
  • Scrub and transitional woodland19 %

Land cover inside the perimeter according to Corine Land Cover, as reported by Copernicus.

The weather day by day

ECMWF ERA5 reanalysis at the fire location, the standard reference for past weather, and the Canadian Fire Weather Index (the same system Copernicus uses), computed by WorldFires from that data. Days after the fire run until the first rain.

Open-Meteo.com (CC BY 4.0) · Copernicus Climate Change Service (ERA5)

Day High Min. humidity Peak gust Rain Danger (FWI)
7 Sept 38.2 °C 13 % 52 km/h 0.0 mm Extreme 56
8 Sept 36.6 °C 17 % 38 km/h 0.0 mm Very high 50
9 Sept after 35.5 °C 19 % 36 km/h 0.0 mm Very high 49
10 Sept after 34.9 °C 25 % 38 km/h 0.0 mm Very high 44
11 Sept after 36.5 °C 27 % 39 km/h 0.0 mm Very high 46
12 Sept after 38.2 °C 23 % 42 km/h 0.0 mm Very high 46
13 Sept after 34.6 °C 40 % 36 km/h 0.0 mm High 34
14 Sept after 32.4 °C 48 % 32 km/h 0.1 mm High 28
15 Sept after 33.1 °C 34 % 36 km/h 0.0 mm High 31
16 Sept after 31.5 °C 46 % 37 km/h 1.7 mm Moderate 16

Before and after, from space

Drag the line to compare the same ground before the fire and after it.

Before · 31 Aug 2026
After · 15 Sept 2026

If the day is cloudy, change the date: each satellite passes once a day. In false colour the burnt ground looks brown or red.

The smoke

CAMS · Copernicus

On 11 September 2026 the air beside the fire reached 65 µg/m³ of PM2.5. That day averaged 30: 2.0 times the WHO daily guideline (15).

PM2.5 peak65 µg/m³
Days over the guideline2 days
PM1082 µg/m³
Optical depth0.36
567891011
Good Fair Moderate Poor Very poor Extremely poor

Particles from the Copernicus CAMS model at the centre of the perimeter; these are not measurements in each town. The pale bar is the worst hour, the solid one the daily average.

Open-Meteo.com (CC BY 4.0) · Copernicus Atmosphere Monitoring Service (CAMS)

Detections table · 11Every satellite heat detection, one by one, with time, satellite, power and coordinates.
⬇ Download CSV Times in UTC. Each detection is a 375 m pixel: a large fire yields hundreds per pass.
Date and timeSatelliteFRP (MW)LatLon

Other fires nearby

All fires in Türkiye ›

Frequently asked questions

How long did the Serik fire last?
According to the heat detections seen by satellite inside the perimeter, it burned from 7 September 2026 to 8 September 2026 (2 days). The perimeter dates it from 8 September 2026 to 8 September 2026.
How much area did it burn?
The perimeter Copernicus measured from satellite imagery is 108 hectares (1.1 km²). Official national figures may differ.
Which municipalities burned?
The fire only entered Serik (108 ha, 0.1 %).
Did the fire reach a town?
The closest fire to a town centre came within 6.3 km of Serik. That is the distance to the perimeter or nearest hotspot; it does not mean it entered the houses.
What was the weather like?
During the fire the temperature reached 38.2 °C, humidity dropped to 13 % and gusts hit 52 km/h. The fire danger index (FWI) reached 56, class Extreme.
Where does this data come from?
From the EFFIS (Copernicus) burnt perimeter, NASA FIRMS VIIRS hotspots and the administrative boundaries of Türkiye (geoBoundaries). It is not an official report.

Where to verify it

A satellite detection is not an official report. Final figures and the fire’s status are published by each country’s emergency service.

Emergency number: 112

Satellite cross-check

Does something look wrong on this page?

This page is built from satellite data and official records, and it sometimes gets things wrong: the wrong dates, the wrong town, two fires merged into one, or something that was not a wildfire at all. If you know this fire first-hand (you live nearby, saw it, fought it or reported on it), tell us what really happened and we will check it.

Report an error
What do you think is wrong?

We will only use your email to reply about this report. Privacy. This is not an emergency service: if there is a fire now, call 112.

Where this data comes from

The perimeter and land cover come from the Copernicus European Forest Fire Information System (EFFIS), measured on MODIS and Sentinel-2 imagery and published under CC BY 4.0. Heat detections come from the VIIRS sensors aboard Suomi-NPP and NOAA-20, distributed by NASA FIRMS at 375 m resolution. Municipal boundaries come from geoBoundaries ADM2 (Open Data Commons Open Database License 1.0). The area per municipality is computed by WorldFires by crossing the perimeter with those boundaries, so it may differ slightly from each country’s official figure.