Skip to content
worldfires
BR · Brazil · –

Rondolândia fire, August 2021 Rondolândia

Out · last detection 1 Sept 2021, 05:43 UTC

The fire started on 17 August 2021 in Rondolândia, Brazil, and satellites saw it burning for 16 days. Copernicus’s global GWIS system rebuilt a burnt perimeter of 3,124 hectares from heat detections, spread across a single municipality.

It is the 1788th largest in Mato Grosso since 2016 (of 1872 with a page). Number 771 in Brazil in 2021, of 814.

The power measured by the satellite is low (27.8 MW in the strongest hotspot), more typical of grass or stubble burning, or a slow surface fire, than of a large crown fire.

Burnt area
3,124ha
GWIS perimeter (Copernicus)
Duration
16days
17 Aug 2021 – 1 Sept 2021
Municipalities hit
1
municipalities
Started on
17 Aug
2021
Heat detections
210
in a single hotspot: 28 MW
Danger at start
40
Very high · FWI index
Average daily power
79MW
detected power per day, on average

Where it burned

HOTSPOTS BY DAY 17 Aug1 Sept
1 Sept 2021

How it evolved, day by day

17 Aug 2021 · 18 MW · 5 18 Aug 2021 · 84 MW · 10 19 Aug 2021 · 52 MW · 11 20 Aug 2021 · 156 MW · 21 21 Aug 2021 · 16 MW · 6 22 Aug 2021 · 76 MW · 12 23 Aug 2021 · 203 MW · 26 24 Aug 2021 · 217 MW · 29 25 Aug 2021 · 40 MW · 9 26 Aug 2021 · 45 MW · 11 27 Aug 2021 · 30 MW · 4 28 Aug 2021 · 144 MW · 38 29 Aug 2021 · 79 MW · 18 30 Aug 2021 · 21 MW · 6 1 Sept 2021 · 8 MW · 4
17 Aug 20 Aug 24 Aug 29 Aug

Fire radiative power detected each day, in megawatts, and number of hotspots. The magenta bar marks the peak day.

The weather it burned in

36°high
40km/h · peak gust
16%lowest humidity

It had gone 49 days without rain (1 mm or more) when it started. Rain came after the fire: 10.6 mm on 9 Sept.

This area had burned before

74% of the perimeter overlaps earlier fires recorded since 2016: 1,573 ha in 2017, 1,433 ha in 2019. Part of it burned more than once, so the yearly figures add up to more than the 2,299 ha that had burned before.

How big is it?

10 km
It burned the equivalent of 2% of the area of London (31 km² against 1,583 km²).

London boundary: geoBoundaries · Office for National Statistics (Open Government Licence v3.0).

This compares size, not location: both shapes are at the same scale, north up, centred on each other.

What happened to each town

  1. Rondolândia 3,505 inhabitants where it started
    3,143 ha reached on 17 Aug
    0.2 %

Burnt area inside each municipality, from crossing the GWIS perimeter with administrative boundaries. The distance runs from the point marking the centre of each area to the nearest fire: staying a kilometre away does not mean it reached the houses.

People and buildings inside the perimeter

GHSL 2020
Built-up area< 0.1 ha
Residents< 20

Inside the perimeter there was no noticeable built-up land and almost nobody lived there (GHSL 2020, satellite-based estimate).

This is an estimate on 100 m cells, made from satellite imagery and census data: it does not mean that homes burned or that anyone was harmed. The perimeter also contains land that never burned.

Source: Global Human Settlement Layer (GHS-BUILT-S and GHS-POP R2023A), European Commission Joint Research Centre (JRC), © European Union, CC BY 4.0. Sum inside the perimeter computed by WorldFires. human-settlement.emergency.copernicus.eu

The weather day by day

ECMWF ERA5 reanalysis at the fire location, the standard reference for past weather, and the Canadian Fire Weather Index (the same system Copernicus uses), computed by WorldFires from that data. Days after the fire run until the first rain.

Open-Meteo.com (CC BY 4.0) · Copernicus Climate Change Service (ERA5)

Day High Min. humidity Peak gust Rain Danger (FWI)
17 Aug 35.1 °C 26 % 24 km/h 0.0 mm Very high 40
18 Aug 36.0 °C 18 % 31 km/h 0.0 mm Very high 50
19 Aug 36.1 °C 16 % 34 km/h 0.0 mm Extreme 55
20 Aug 34.7 °C 25 % 26 km/h 0.0 mm Very high 45
21 Aug 35.8 °C 20 % 28 km/h 0.0 mm Very high 46
22 Aug 35.5 °C 26 % 27 km/h 0.0 mm Very high 48
23 Aug 35.8 °C 18 % 28 km/h 0.0 mm Extreme 50
24 Aug 35.8 °C 25 % 34 km/h 0.0 mm Extreme 54
25 Aug 35.4 °C 36 % 40 km/h 0.0 mm Very high 47
26 Aug 36.4 °C 33 % 28 km/h 0.3 mm Very high 40
27 Aug 34.3 °C 33 % 21 km/h 0.7 mm High 33
28 Aug 34.8 °C 37 % 25 km/h 0.3 mm High 30
29 Aug 34.5 °C 36 % 25 km/h 1.2 mm High 33
30 Aug 33.9 °C 40 % 19 km/h 0.1 mm Moderate 18
31 Aug 34.4 °C 33 % 23 km/h 0.0 mm High 24
1 Sept 32.1 °C 43 % 29 km/h 1.3 mm High 30
2 Sept after 32.2 °C 45 % 27 km/h 0.0 mm Moderate 20
3 Sept after 31.8 °C 47 % 20 km/h 0.4 mm Moderate 21
4 Sept after 33.7 °C 39 % 28 km/h 0.4 mm High 29
5 Sept after 33.9 °C 39 % 28 km/h 0.0 mm High 32
6 Sept after 34.6 °C 42 % 32 km/h 0.7 mm High 33
7 Sept after 33.5 °C 42 % 28 km/h 0.7 mm High 26
8 Sept after 34.3 °C 41 % 27 km/h 0.3 mm High 29
9 Sept after 25.4 °C 68 % 28 km/h 10.6 mm Very low 3

Its twins: fires that started in the same weather

It started with an FWI of 39.9, a minimum humidity of 26% and 49 days without rain. Fires in the area that started in weather like this since 2016: 18.

FWI at the start 39.9
Minimum humidity 26 %
Days without rain 49
this fire chosen twins rest of the area
Almost identicalSimilar

Outlines of the closest twins

Colniza fire, August 2020
4,178 ha 18 days FWI 39.8 Min. humidity 27 % 92 km away, in 2020

First rain (1 mm or more) after it ended: 1.0 mm on 10 Sept.

What happened to them

18 days
median duration
7,660 ha
median area
28 %
went past 10,000 ha
2.8 mm
rain at the end (median; 13 of 18 had it)

It stayed below its twins: 3,124 ha against a median of 7,660 ha. It lasted 16 days, against 18 days.

In 5 of 18, not even 1 mm fell in the ten days after the end: they went out without rain. In the rest, the first rainy day brought a median of 2.8 mm.

This is a bank of analogues: it shows what usually happens, not what will happen. With fewer than 15 twins we give no figures. How we calculate it

How it ended

10.6 mmfirst rain
9 Sept8 days after it ended
40km/h · max. gust

It was considered over on 1 Sept, and on 9 Sept 10.6 mm fell. We do not know whether the rain or the firefighters put it out. Twins with rain when they ended: 13 of 18, with a median of 2.8 mm.

Weather on this page: Open-Meteo.com (CC BY 4.0) · Copernicus Climate Change Service (ERA5)

How a twin is chosen

  • Same area: fires that have already ended, less than 250 km from this one, since 2016.
  • Same start: we compare the FWI on the first day, the minimum humidity that day and the run of days without rain before it. The slider sets how much they may differ.
  • Only pages with final weather data (ERA5 reanalysis) calculated in the same way as this fire’s; agricultural and grass burns and pages with data under review are left out.
  • Fires burning at the same time as this one (a week before or after) are left out: they share the same spell of weather and do not count as a precedent.
  • They are sorted by similarity, and the outlines of the first five are drawn.

How we calculate it

Before and after, from space

Drag the line to compare the same ground before the fire and after it.

Before · 10 Aug 2021
After · 8 Sept 2021

If the day is cloudy, change the date: each satellite passes once a day. In false colour the burnt ground looks brown or red.

Detections table · 210Every satellite heat detection, one by one, with time, satellite, power and coordinates.
⬇ Download CSV Times in UTC. Each detection is a 375 m pixel: a large fire yields hundreds per pass.
Date and timeSatelliteFRP (MW)LatLon

Other fires nearby

All fires in Brazil

Frequently asked questions

How long did the Rondolândia fire last?
GWIS (Copernicus) dates it between 17 August 2021 and 1 September 2021: 16 days between the first and last heat detection of the perimeter.
How much area did it burn?
The perimeter GWIS (Copernicus) rebuilt from heat detections is 3,124 hectares (31.2 km²). It is an estimate: official national figures may differ.
Which municipalities burned?
The fire only entered Rondolândia (3,143 ha, 0.2 %).
What was the weather like?
During the fire the temperature reached 36.4 °C, humidity dropped to 16 % and gusts hit 40 km/h. The fire danger index (FWI) reached 55, class Extreme.
Where does this data come from?
From the GWIS (Copernicus) burnt perimeter, NASA FIRMS VIIRS hotspots and the administrative boundaries of Brazil (geoBoundaries). It is not an official report.
How did the fires that started in similar weather in this area end?
Fires less than 250 km away that started since 2016 with a similar FWI, humidity and dry spell: 18. Their median duration was 18 days and their median area 7,660 ha; 28 % went past 10,000 ha. In 5 of 18, not even 1 mm fell in the ten days after the end: they went out without rain. In the rest, the first rainy day brought a median of 2.8 mm.

Where to verify it

A satellite detection is not an official report. Final figures and the fire’s status are published by each country’s emergency service.

Emergency number: 193 · Emergency number and official warnings

Satellite cross-check

History of this page Changes in area, dates, name, official record or merged pages, compared every night since 24 October 2026.

Does something look wrong on this page?

This page is built from satellite data and official records, and it sometimes gets things wrong: the wrong dates, the wrong town, two fires merged into one, or something that was not a wildfire at all. If you know this fire first-hand (you live nearby, saw it, fought it or reported on it), tell us what really happened and we will check it.

Report an error
What do you think is wrong?

We will only use your email to reply about this report. Privacy. This is not an emergency service: if there is a fire now, call 193.

How we know this
  • Perimeter: GWIS (Copernicus), rebuilt from heat detections rather than mapped on imagery.
  • Dates from the perimeter: the VIIRS detections inside it did not change them. 210 Suomi-NPP VIIRS detections on those dates.
  • We have not matched this page with any official record.
  • Weather: Copernicus ERA5 reanalysis at the fire location, in cells of about 25 km.
  • Built-up area and population come from the JRC Global Human Settlement Layer (epoch 2020, 100 m cells), summed inside the perimeter: an estimate of what was there, not a damage count.

How we build fire pages: methodology

Where this data comes from

The perimeter comes from the Copernicus Global Wildfire Information System (GWIS), which rebuilds it from MODIS and VIIRS heat detections and publishes it under CC BY 4.0. It is not measured on imagery as in Europe, so it is an estimate. Heat detections come from the VIIRS sensors aboard Suomi-NPP and NOAA-20, distributed by NASA FIRMS at 375 m resolution. Municipal boundaries come from geoBoundaries ADM2 (Creative Commons Attribution 3.0 Intergovernmental Organisations (CC BY 3.0 IGO)). The area per municipality is computed by WorldFires by crossing the perimeter with those boundaries, so it may differ from each country’s official figure.