Skip to content
worldfires
TR · Türkiye · →

Pütürge fire, September 2019 Pütürge

Out · last detection 9 Sept 2019, 11:02 UTC

The fire started on 9 September 2019 in Pütürge, Türkiye, and satellites saw it burning for 1 day. Copernicus mapped a burnt perimeter of 140 hectares from satellite imagery, spread across a single municipality.

It is the 24th largest in Malatya since 2016 (of 35 with a page). Number 97 in Türkiye in 2019, of 138.

The power measured by the satellite is low (16.3 MW in the strongest hotspot), more typical of grass or stubble burning, or a slow surface fire, than of a large crown fire.

Compare with…
Burnt area
140ha
Copernicus perimeter
Duration
1day
9 Sept 2019 – 9 Sept 2019
Municipalities hit
1
districts
Started on
9 Sept
2019
Heat detections
2
in a single hotspot: 16 MW
Danger at start
39
Very high · FWI index
Average daily power
25MW
detected power per day, on average

Where it burned

HOTSPOTS BY DAY 9 Sept9 Sept

How it evolved, day by day

9 Sept 2019 · 25 MW · 2

Fire radiative power detected each day, in megawatts, and number of hotspots. The magenta bar marks the peak day.

The weather it burned in

30°high
29km/h · peak gust
21%lowest humidity

It had gone 9 days without rain (1 mm or more) when it started. Rain came after the fire: 1.3 mm on 15 Sept.

This area had burned before

No earlier perimeters overlap this fire since 2016, when the satellite record begins.

What happened to each town

  1. Pütürge 15,049 inhabitants · 10.6 km from the centre where it started
    140 ha reached on 9 Sept
    0.1 %

Burnt area inside each municipality, from crossing the official perimeter with administrative boundaries. The distance runs from the point marking the centre of each area to the nearest fire: staying a kilometre away does not mean it reached the houses.

What burned

  • Other natural land75 %
  • Agricultural areas25 %

Land cover inside the perimeter according to Corine Land Cover, as reported by Copernicus.

The weather day by day

ECMWF ERA5 reanalysis at the fire location, the standard reference for past weather, and the Canadian Fire Weather Index (the same system Copernicus uses), computed by WorldFires from that data. Days after the fire run until the first rain.

Open-Meteo.com (CC BY 4.0) · Copernicus Climate Change Service (ERA5)

Day High Min. humidity Peak gust Rain Danger (FWI)
9 Sept 29.6 °C 21 % 29 km/h 0.0 mm Very high 39
10 Sept after 29.7 °C 23 % 24 km/h 0.0 mm High 37
11 Sept after 31.3 °C 19 % 29 km/h 0.0 mm High 37
12 Sept after 31.6 °C 18 % 28 km/h 0.0 mm High 38
13 Sept after 31.5 °C 16 % 27 km/h 0.0 mm High 37
14 Sept after 32.1 °C 19 % 39 km/h 0.0 mm Very high 41
15 Sept after 32.1 °C 21 % 49 km/h 1.3 mm High 31

Before and after, from space

Drag the line to compare the same ground before the fire and after it.

Before · 2 Sept 2019
After · 16 Sept 2019

If the day is cloudy, change the date: each satellite passes once a day. In false colour the burnt ground looks brown or red.

The smoke

CAMS · Copernicus

On 7 September 2019 the air beside the fire reached 10 µg/m³ of PM2.5, but no daily average passed the WHO guideline (15).

PM2.5 peak10 µg/m³
Days over the guideline0 days
PM1017 µg/m³
789101112
Good Fair Moderate Poor Very poor Extremely poor

Particles from the Copernicus CAMS model at the centre of the perimeter; these are not measurements in each town. The pale bar is the worst hour, the solid one the daily average.

Open-Meteo.com (CC BY 4.0) · Copernicus Atmosphere Monitoring Service (CAMS)

Detections table · 2Every satellite heat detection, one by one, with time, satellite, power and coordinates.
⬇ Download CSV Times in UTC. Each detection is a 375 m pixel: a large fire yields hundreds per pass.
Date and timeSatelliteFRP (MW)LatLon

Other fires nearby

All fires in Türkiye ›

Frequently asked questions

How long did the Pütürge fire last?
Copernicus dates it between 9 September 2019 and 9 September 2019: 1 day between the first and last image with fire.
How much area did it burn?
The perimeter Copernicus measured from satellite imagery is 140 hectares (1.4 km²). Official national figures may differ.
Which municipalities burned?
The fire only entered Pütürge (140 ha, 0.1 %).
Did the fire reach a town?
The fire started in Pütürge and came within 10.6 km of its centre. That is the distance from the perimeter, or the nearest hotspot, to the point marking the centre; it does not mean it entered the houses.
What was the weather like?
During the fire the temperature reached 29.6 °C, humidity dropped to 21 % and gusts hit 29 km/h. The fire danger index (FWI) reached 39, class Very high.
Where does this data come from?
From the EFFIS (Copernicus) burnt perimeter, NASA FIRMS VIIRS hotspots and the administrative boundaries of Türkiye (geoBoundaries). It is not an official report.

Where to verify it

A satellite detection is not an official report. Final figures and the fire’s status are published by each country’s emergency service.

Emergency number: 112 · Emergency number and official warnings ›

Satellite cross-check

History of this page Changes in area, dates, name, official record or merged pages, compared every night since 24 October 2026.

No changes since 24 October 2026.

RSS Changes to this page

Does something look wrong on this page?

This page is built from satellite data and official records, and it sometimes gets things wrong: the wrong dates, the wrong town, two fires merged into one, or something that was not a wildfire at all. If you know this fire first-hand (you live nearby, saw it, fought it or reported on it), tell us what really happened and we will check it.

Report an error
What do you think is wrong?

We will only use your email to reply about this report. Privacy. This is not an emergency service: if there is a fire now, call 112.

How we know this
  • Perimeter: EFFIS (Copernicus), mapped on satellite imagery.
  • Dates from the perimeter: the VIIRS detections inside it did not change them. 2 Suomi-NPP VIIRS detections on those dates.
  • We have not matched this page with any official record.
  • Weather: Copernicus ERA5 reanalysis at the fire location, in cells of about 25 km.

How we build fire pages: methodology ›

Where this data comes from

The perimeter and land cover come from the Copernicus European Forest Fire Information System (EFFIS), measured on MODIS and Sentinel-2 imagery and published under CC BY 4.0. Heat detections come from the VIIRS sensors aboard Suomi-NPP and NOAA-20, distributed by NASA FIRMS at 375 m resolution. Municipal boundaries come from geoBoundaries ADM2 (Open Data Commons Open Database License 1.0). The area per municipality is computed by WorldFires by crossing the perimeter with those boundaries, so it may differ slightly from each country’s official figure.