Skip to content
worldfires
PT · Portugal · →

Castro Laboreiro e Lamas de Mouro fire, October 2026 Parada do Monte e Cubalhão, Fiães, Castro Laboreiro e Lamas de Mouro

Out · last detection 18 Oct 2026, 13:42 UTC

Satellites first detected fire on 17 October 2026 in Castro Laboreiro e Lamas de Mouro, Portugal. It was active for 2 days, with 15 heat detections and an area with fire of about 168 hectares rebuilt from them, spread across 3 municipalities.

The power measured by the satellite is low (15.0 MW in the strongest hotspot), more typical of grass or stubble burning, or a slow surface fire, than of a large crown fire.

Compare with…

Copernicus has not yet published the burnt perimeter, which takes a few days to measure on satellite imagery. For now the area is the one rebuilt from heat detections (about 14 hectares per pixel). When the perimeter arrives, this page picks it up on its own and keeps the same address.

Area with fire
≈ 168ha
rebuilt from hotspots, no official perimeter yet
Duration
2days
17 Oct 2026 – 18 Oct 2026
Municipalities hit
3
freguesias
Started on
17 Oct
2026
Heat detections
15
in a single hotspot: 15 MW
Danger at start
3
Very low · FWI index
Average daily power
68MW
detected power per day, on average

Where it burned

HOTSPOTS BY DAY 17 Oct18 Oct
18 Oct 2026

How it evolved, day by day

17 Oct 2026 · 12 MW · 2 18 Oct 2026 · 123 MW · 13
17 Oct 18 Oct

Fire radiative power detected each day, in megawatts, and number of hotspots. The magenta bar marks the peak day.

The weather it burned in

19°high
40km/h · peak gust
43%lowest humidity

It had gone 5 days without rain (1 mm or more) when it started. Rain came after the fire: 1.8 mm on 20 Oct.

What happened to each town

  1. Parada do Monte e Cubalhão 477 inhabitants · 1.2 km from the centre
    98 ha reached on 18 Oct
    3.3 %
  2. Fiães 1.2 km from the centre
    42 ha reached on 18 Oct
    3.7 %
  3. Castro Laboreiro e Lamas de Mouro 503 inhabitants · 4.9 km from the centre where it started
    28 ha reached on 17 Oct
    0.3 %

Area with fire inside each municipality, rebuilt from heat detections (about 14 hectares per VIIRS pixel). An estimate until the official perimeter arrives. The distance runs from the point marking the centre of each area to the nearest fire: staying a kilometre away does not mean it reached the houses.

The weather day by day

ECMWF ERA5 reanalysis at the fire location, the standard reference for past weather, and the Canadian Fire Weather Index (the same system Copernicus uses), computed by WorldFires from that data. Days after the fire run until the first rain.

Open-Meteo.com (CC BY 4.0) · forecast models, provisional until the ERA5 reanalysis arrives

Day High Min. humidity Peak gust Rain Danger (FWI)
17 Oct 19.0 °C 61 % 35 km/h 1.2 mm Very low 3
18 Oct 16.6 °C 43 % 40 km/h 0.0 mm Low 6
19 Oct after 14.9 °C 38 % 28 km/h 0.0 mm Low 7
20 Oct after 13.5 °C 47 % 36 km/h 1.8 mm Very low 2

Before and after, from space

Drag the line to compare the same ground before the fire and after it.

Before · 10 Oct 2026
After · 25 Oct 2026

If the day is cloudy, change the date: each satellite passes once a day. In false colour the burnt ground looks brown or red.

The smoke

CAMS · Copernicus

On 16 October 2026 the air beside the fire reached 13 µg/m³ of PM2.5, but no daily average passed the WHO guideline (15).

PM2.5 peak13 µg/m³
Days over the guideline0 days
PM1016 µg/m³
Optical depth0.15
131415161718
Good Fair Moderate Poor Very poor Extremely poor

Particles from the Copernicus CAMS model at the centre of the perimeter; these are not measurements in each town. The pale bar is the worst hour, the solid one the daily average.

Open-Meteo.com (CC BY 4.0) · Copernicus Atmosphere Monitoring Service (CAMS)

Detections table · 15Every satellite heat detection, one by one, with time, satellite, power and coordinates.
⬇ Download CSV Times in UTC. Each detection is a 375 m pixel: a large fire yields hundreds per pass.
Date and timeSatelliteFRP (MW)LatLon

Other fires nearby

All fires in Portugal ›

Frequently asked questions

How long did the Castro Laboreiro e Lamas de Mouro fire last?
According to the heat detections seen by satellite, it burned from 17 October 2026 to 18 October 2026 (2 days between the first and the last detection). There is no perimeter yet to date it.
How much area did it burn?
There is no official perimeter yet. Heat detections rebuild about 168 hectares with fire (1.7 km²); Copernicus will publish the measured figure within days.
Which municipalities burned?
The fire entered 3 municipalities: Parada do Monte e Cubalhão (98 ha, 3.3 %); Fiães (42 ha, 3.7 %); Castro Laboreiro e Lamas de Mouro (28 ha, 0.3 %).
Is the Castro Laboreiro e Lamas de Mouro fire still active?
No fire detections since 18 Oct 2026, 13:42 UTC. A lack of detections is not an official extinction.
Did the fire reach a town?
The fire came within 1.2 km of the centre of Parada do Monte e Cubalhão, the closest of the areas it touched. That is the distance from the perimeter, or the nearest hotspot, to the point marking the centre; it does not mean it entered the houses.
What was the weather like?
During the fire the temperature reached 19.0 °C, humidity dropped to 43 % and gusts hit 40 km/h. The fire danger index (FWI) reached 6, class Low.
Where does this data come from?
From the EFFIS (Copernicus) burnt perimeter, NASA FIRMS VIIRS hotspots and the administrative boundaries of Portugal (geoBoundaries). It is not an official report.

Where to verify it

A satellite detection is not an official report. Final figures and the fire’s status are published by each country’s emergency service.

Emergency number: 112 · Emergency number and official warnings ›

Satellite cross-check

History of this page · 2 Changes in area, dates, name, official record or merged pages, compared every night since 24 October 2026.
  1. Area: ≈ 238 → ≈ 168 ha.
  2. Start date: 15 October 2026 → 17 October 2026.

RSS Changes to this page

Does something look wrong on this page?

This page is built from satellite data and official records, and it sometimes gets things wrong: the wrong dates, the wrong town, two fires merged into one, or something that was not a wildfire at all. If you know this fire first-hand (you live nearby, saw it, fought it or reported on it), tell us what really happened and we will check it.

Report an error
What do you think is wrong?

We will only use your email to reply about this report. Privacy. This is not an emergency service: if there is a fire now, call 112.

How we know this
  • No perimeter yet: the area (≈ 168 ha) is estimated by counting VIIRS pixels with fire, about 14 ha each.
  • Dates of the first and last VIIRS detection of the cluster. 15 Suomi-NPP VIIRS detections on those dates.
  • Weather: ECMWF IFS model, provisional until the ERA5 reanalysis arrives.

How we build fire pages: methodology ›

Where this data comes from

The perimeter and land cover come from the Copernicus European Forest Fire Information System (EFFIS), measured on MODIS and Sentinel-2 imagery and published under CC BY 4.0. Heat detections come from the VIIRS sensors aboard Suomi-NPP and NOAA-20, distributed by NASA FIRMS at 375 m resolution. Municipal boundaries come from geoBoundaries ADM3 (CC0 1.0 Universal (CC0 1.0) Public Domain Dedication). The area per municipality is computed by WorldFires by crossing the perimeter with those boundaries, so it may differ slightly from each country’s official figure.