Skip to content
worldfires
ES · Spain · →

Osuna fire, September 2026 Spain

Out · last detection 25 Sept 2026, 02:32 UTC

Satellites first detected fire on 13 September 2026 in Osuna, Spain. It was active for 13 days, with 15 heat detections and an area with fire of about 196 hectares rebuilt from them, spread across a single municipality.

The power measured by the satellite is low (8.0 MW in the strongest hotspot), more typical of grass or stubble burning, or a slow surface fire, than of a large crown fire.

Compare with…

Suggestions: La Puebla de Cazalla · 2026

Copernicus has not yet published the burnt perimeter, which takes a few days to measure on satellite imagery. For now the area is the one rebuilt from heat detections (about 14 hectares per pixel). When the perimeter arrives, this page picks it up on its own and keeps the same address.

Area with fire
≈ 196ha
rebuilt from hotspots, no official perimeter yet
Duration
13days
13 Sept 2026 – 25 Sept 2026
Municipalities hit
0
municipalities
Started on
13 Sept
2026
Heat detections
15
in a single hotspot: 8 MW
Danger at start
57
Extreme · FWI index
Average daily power
11MW
detected power per day, on average

Where it burned

HOTSPOTS BY DAY 13 Sept25 Sept
25 Sept 2026

How it evolved, day by day

13 Sept 2026 · 30 MW · 6 15 Sept 2026 · 4 MW · 1 17 Sept 2026 · 7 MW · 6 25 Sept 2026 · 3 MW · 2
13 Sept 15 Sept 17 Sept 25 Sept

Fire radiative power detected each day, in megawatts, and number of hotspots. The magenta bar marks the peak day.

The weather it burned in

38°high
55km/h · peak gust
13%lowest humidity

It had gone more than two months without rain (1 mm or more) when it started.

The weather day by day

ECMWF ERA5 reanalysis at the fire location, the standard reference for past weather, and the Canadian Fire Weather Index (the same system Copernicus uses), computed by WorldFires from that data. Days after the fire run until the first rain.

Open-Meteo.com (CC BY 4.0) · Copernicus Climate Change Service (ERA5)

Day High Min. humidity Peak gust Rain Danger (FWI)
13 Sept 33.2 °C 26 % 51 km/h 0.0 mm Extreme 57
14 Sept 34.8 °C 21 % 33 km/h 0.0 mm Very high 45
15 Sept 37.0 °C 19 % 38 km/h 0.0 mm Extreme 52
16 Sept 30.9 °C 34 % 55 km/h 0.0 mm Extreme 54
17 Sept 30.0 °C 37 % 24 km/h 0.0 mm High 34
18 Sept 31.4 °C 31 % 30 km/h 0.0 mm High 37
19 Sept 32.8 °C 28 % 50 km/h 0.0 mm Very high 49
20 Sept 32.2 °C 31 % 43 km/h 0.0 mm Very high 46
21 Sept 31.9 °C 29 % 35 km/h 0.0 mm Very high 43
22 Sept 35.1 °C 16 % 26 km/h 0.0 mm Very high 48
23 Sept 36.0 °C 15 % 38 km/h 0.0 mm Extreme 57
24 Sept 35.6 °C 16 % 35 km/h 0.0 mm Extreme 55
25 Sept 37.9 °C 13 % 17 km/h 0.0 mm Very high 45
26 Sept after 37.1 °C 15 % 45 km/h 0.0 mm Extreme 66
27 Sept after 33.4 °C 19 % 52 km/h 0.1 mm Extreme 65
28 Sept after 27.4 °C 46 % 32 km/h 0.9 mm High 25
29 Sept after 31.5 °C 35 % 27 km/h 0.0 mm High 30

Before and after, from space

Drag the line to compare the same ground before the fire and after it.

Before · 6 Sept 2026
After · 2 Oct 2026

If the day is cloudy, change the date: each satellite passes once a day. In false colour the burnt ground looks brown or red.

The smoke

CAMS · Copernicus

On 28 September 2026 the air beside the fire reached 8 µg/m³ of PM2.5, but no daily average passed the WHO guideline (15).

PM2.5 peak8 µg/m³
Days over the guideline0 days
PM1017 µg/m³
Optical depth0.35
111213141516171819202122232425262728
Good Fair Moderate Poor Very poor Extremely poor

Particles from the Copernicus CAMS model at the centre of the perimeter; these are not measurements in each town. The pale bar is the worst hour, the solid one the daily average.

Open-Meteo.com (CC BY 4.0) · Copernicus Atmosphere Monitoring Service (CAMS)

Detections table · 15Every satellite heat detection, one by one, with time, satellite, power and coordinates.
⬇ Download CSV Times in UTC. Each detection is a 375 m pixel: a large fire yields hundreds per pass.
Date and timeSatelliteFRP (MW)LatLon

Other fires nearby

All fires in Spain ›

Frequently asked questions

How long did the Osuna fire last?
According to the heat detections seen by satellite, it burned from 13 September 2026 to 25 September 2026 (13 days between the first and the last detection). There is no perimeter yet to date it.
How much area did it burn?
There is no official perimeter yet. Heat detections rebuild about 196 hectares with fire (2.0 km²); Copernicus will publish the measured figure within days.
What was the weather like?
During the fire the temperature reached 37.9 °C, humidity dropped to 13 % and gusts hit 55 km/h. The fire danger index (FWI) reached 57, class Extreme.
Where does this data come from?
From the EFFIS (Copernicus) burnt perimeter, NASA FIRMS VIIRS hotspots and the administrative boundaries of Spain (geoBoundaries). It is not an official report.

Where to verify it

A satellite detection is not an official report. Final figures and the fire’s status are published by each country’s emergency service.

Emergency number: 112 · Emergency number and official warnings ›

Satellite cross-check

History of this page Changes in area, dates, name, official record or merged pages, compared every night since 24 October 2026.

No changes since 24 October 2026.

RSS Changes to this page

Does something look wrong on this page?

This page is built from satellite data and official records, and it sometimes gets things wrong: the wrong dates, the wrong town, two fires merged into one, or something that was not a wildfire at all. If you know this fire first-hand (you live nearby, saw it, fought it or reported on it), tell us what really happened and we will check it.

Report an error
What do you think is wrong?

We will only use your email to reply about this report. Privacy. This is not an emergency service: if there is a fire now, call 112.

How we know this
  • No perimeter yet: the area (≈ 196 ha) is estimated by counting VIIRS pixels with fire, about 14 ha each.
  • Dates of the first and last VIIRS detection of the cluster. 15 Suomi-NPP VIIRS detections on those dates.
  • Weather: Copernicus ERA5 reanalysis at the fire location, in cells of about 25 km.

How we build fire pages: methodology ›

Where this data comes from

The perimeter and land cover come from the Copernicus European Forest Fire Information System (EFFIS), measured on MODIS and Sentinel-2 imagery and published under CC BY 4.0. Heat detections come from the VIIRS sensors aboard Suomi-NPP and NOAA-20, distributed by NASA FIRMS at 375 m resolution. Municipal boundaries come from geoBoundaries ADM3 (Creative Commons Attribution 4.0 International (CC BY 4.0)). The area per municipality is computed by WorldFires by crossing the perimeter with those boundaries, so it may differ slightly from each country’s official figure.