Larache fire, 14 July 2022 إقليم العرائش · Larache
The fire started on 14 July 2022 in Larache, Morocco, and satellites saw it burning for 2 days. Copernicus mapped a burnt perimeter of 421 hectares from satellite imagery, spread across a single municipality.
It is the 19th largest in Tangier-Tetouan-Al Hoceima since 2016 (of 53 with a page). Number 11 in Morocco in 2022, of 22.
Compare with…
- Burnt area
- 421ha
- Copernicus perimeter
- Duration
- 2days
- 14 Jul 2022 – 15 Jul 2022
- Municipalities hit
- 1
- provinces
- Started on
- 14 Jul
- 2022
- Heat detections
- 15
- in a single hotspot: 261 MW
- Danger at start
- 41
- Very high · FWI index
- Average daily power
- 642MW
- detected power per day, on average
Where it burned
How it evolved, day by day
Fire radiative power detected each day, in megawatts, and number of hotspots. The magenta bar marks the peak day.
The weather it burned in
It had gone more than two months without rain (1 mm or more) when it started.
This area had burned before
No earlier perimeters overlap this fire since 2016, when the satellite record begins.
What happened to each town
-
423 ha reached on 14 Jul0.2 %
Burnt area inside each municipality, from crossing the official perimeter with administrative boundaries. The distance runs from the point marking the centre of each area to the nearest fire: staying a kilometre away does not mean it reached the houses.
What burned
- Broadleaved forest91 %
- Scrub and transitional woodland5.2 %
- Agricultural areas4.0 %
Land cover inside the perimeter as reported by Copernicus EFFIS (outside the Corine Land Cover area).
People and buildings inside the perimeter
GHSL 2020Inside the perimeter there was no noticeable built-up land and almost nobody lived there (GHSL 2020, satellite-based estimate).
This is an estimate on 100 m cells, made from satellite imagery and census data: it does not mean that homes burned or that anyone was harmed. The perimeter also contains land that never burned.
Source: Global Human Settlement Layer (GHS-BUILT-S and GHS-POP R2023A), European Commission Joint Research Centre (JRC), © European Union, CC BY 4.0. Sum inside the perimeter computed by WorldFires. human-settlement.emergency.copernicus.eu
The weather day by day
ECMWF ERA5 reanalysis at the fire location, the standard reference for past weather, and the Canadian Fire Weather Index (the same system Copernicus uses), computed by WorldFires from that data. Days after the fire run until the first rain.
Open-Meteo.com (CC BY 4.0) · Copernicus Climate Change Service (ERA5)
| Day | High | Min. humidity | Peak gust | Rain | Danger (FWI) |
|---|---|---|---|---|---|
| 14 Jul | 36.8 °C | 27 % | 37 km/h | 0.0 mm | Very high 41 |
| 15 Jul | 36.0 °C | 35 % | 25 km/h | 0.0 mm | Very high 38 |
| 16 Jul after | 32.3 °C | 51 % | 28 km/h | 0.0 mm | High 26 |
| 17 Jul after | 30.9 °C | 53 % | 35 km/h | 0.0 mm | High 25 |
| 18 Jul after | 28.7 °C | 62 % | 37 km/h | 0.0 mm | High 23 |
| 19 Jul after | 28.8 °C | 51 % | 34 km/h | 0.0 mm | High 23 |
| 20 Jul after | 31.0 °C | 45 % | 30 km/h | 0.0 mm | High 26 |
| 21 Jul after | 35.8 °C | 31 % | 21 km/h | 0.0 mm | High 33 |
| 22 Jul after | 36.4 °C | 39 % | 24 km/h | 0.0 mm | High 32 |
| 23 Jul after | 37.9 °C | 28 % | 28 km/h | 0.0 mm | High 37 |
| 24 Jul after | 38.2 °C | 27 % | 38 km/h | 0.0 mm | Very high 44 |
| 25 Jul after | 38.6 °C | 22 % | 36 km/h | 0.0 mm | Very high 48 |
Before and after, from space
Drag the line to compare the same ground before the fire and after it.
If the day is cloudy, change the date: each satellite passes once a day. In false colour the burnt ground looks brown or red.
The smoke
CAMS · CopernicusOn 15 July 2022 the air beside the fire reached 29 µg/m³ of PM2.5. That day averaged 19: 1.3 times the WHO daily guideline (15).
Particles from the Copernicus CAMS model at the centre of the perimeter; these are not measurements in each town. The pale bar is the worst hour, the solid one the daily average.
Open-Meteo.com (CC BY 4.0) · Copernicus Atmosphere Monitoring Service (CAMS)
Detections table · 15Every satellite heat detection, one by one, with time, satellite, power and coordinates.
| Date and time | Satellite | FRP (MW) | Lat | Lon |
|---|
Other fires nearby
- 470 haLarache إقليم العرائش8 August 2016 · 2 days · 6 km away
- 269 haLarache إقليم العرائشJuly 2021 · 1 day · 11 km away
- 264 haLarache إقليم العرائشJune 2017 · 1 day · 30 km away
- 252 haLarache إقليم العرائشSeptember 2020 · 2 days · 32 km away
- 1,270 haTetouan إقليم تطوانJuly 2022 · 4 days · 34 km away
- 12,623 haLarache إقليم العرائش13 July 2022 · 8 days · 39 km away
Frequently asked questions
- How long did the Larache fire last?
- Copernicus dates it between 14 July 2022 and 15 July 2022: 2 days between the first and last image with fire.
- How much area did it burn?
- The perimeter Copernicus measured from satellite imagery is 421 hectares (4.2 km²). Official national figures may differ.
- Which municipalities burned?
- The fire only entered Larache (423 ha, 0.2 %).
- Did the fire reach a town?
- The fire started in Larache and came within 12.8 km of its centre. That is the distance from the perimeter, or the nearest hotspot, to the point marking the centre; it does not mean it entered the houses.
- What was the weather like?
- During the fire the temperature reached 36.8 °C, humidity dropped to 27 % and gusts hit 37 km/h. The fire danger index (FWI) reached 41, class Very high.
- Where does this data come from?
- From the EFFIS (Copernicus) burnt perimeter, NASA FIRMS VIIRS hotspots and the administrative boundaries of Morocco (geoBoundaries). It is not an official report.
Where to verify it
A satellite detection is not an official report. Final figures and the fire’s status are published by each country’s emergency service.
Emergency number: 15 · 150 · Emergency number and official warnings ›
Satellite cross-check
History of this page Changes in area, dates, name, official record or merged pages, compared every night since 24 October 2026.
No changes since 24 October 2026.
Does something look wrong on this page?
This page is built from satellite data and official records, and it sometimes gets things wrong: the wrong dates, the wrong town, two fires merged into one, or something that was not a wildfire at all. If you know this fire first-hand (you live nearby, saw it, fought it or reported on it), tell us what really happened and we will check it.
Report an error
How we know this
- Perimeter: EFFIS (Copernicus), mapped on satellite imagery.
- Dates from the perimeter: the VIIRS detections inside it did not change them. 15 Suomi-NPP VIIRS detections on those dates.
- We have not matched this page with any official record.
- Weather: Copernicus ERA5 reanalysis at the fire location, in cells of about 25 km.
- Built-up area and population come from the JRC Global Human Settlement Layer (epoch 2020, 100 m cells), summed inside the perimeter: an estimate of what was there, not a damage count.
Where this data comes from
The perimeter and land cover come from the Copernicus European Forest Fire Information System (EFFIS), measured on MODIS and Sentinel-2 imagery and published under CC BY 4.0. Heat detections come from the VIIRS sensors aboard Suomi-NPP and NOAA-20, distributed by NASA FIRMS at 375 m resolution. Municipal boundaries come from geoBoundaries ADM2 (Open Data Commons Open Database License 1.0). The area per municipality is computed by WorldFires by crossing the perimeter with those boundaries, so it may differ slightly from each country’s official figure.