Skip to content
worldfires
TR · Türkiye · →

Ömerli fire, 23 August 2016 Ömerli

Out · last detection 24 Aug 2016, 00:12 UTC

The fire started on 23 August 2016 in Ömerli, Türkiye, and satellites saw it burning for 2 days. Copernicus mapped a burnt perimeter of 1,073 hectares from satellite imagery, spread across a single municipality.

It is the 26th largest in Mardin since 2016 (of 131 with a page). Number 27 in Türkiye in 2016, of 223.

The power measured by the satellite is low (26.1 MW in the strongest hotspot), more typical of grass or stubble burning, or a slow surface fire, than of a large crown fire.

Burnt area
1,073ha
Copernicus perimeter
Duration
2days
23 Aug 2016 – 24 Aug 2016
Municipalities hit
1
districts
Started on
23 Aug
2016
Heat detections
18
in a single hotspot: 26 MW
Danger at start
65
Extreme · FWI index
Energy released
112MW
sum of detected power

Where it burned

24 Aug 2016
HOTSPOTS BY DAY 23 Aug24 Aug

How it evolved, day by day

2324

Fire radiative power detected each day, in megawatts, and number of hotspots. The magenta bar marks the peak day.

The weather it burned in

39°high
44km/h · peak gust
7%lowest humidity

It had gone more than two months without rain (1 mm or more) when it started.

This area had burned before

No earlier perimeters overlap this fire since 2016, when the satellite record begins.

What happened to each town

  1. Ömerli 14,233 inhabitants · 3.1 km from the town where it started
    1,075 ha reached on 23 Aug
    2.4 %

Burnt area inside each municipality, from crossing the official perimeter with administrative boundaries. The distance is from the town centre to the nearest fire: staying a kilometre away does not mean it reached the houses.

What burned

  • Agricultural areas80 %
  • Scrub and transitional woodland20 %

Land cover inside the perimeter according to Corine Land Cover, as reported by Copernicus.

The weather day by day

ECMWF ERA5 reanalysis at the fire location, the standard reference for past weather, and the Canadian Fire Weather Index (the same system Copernicus uses), computed by WorldFires from that data. Days after the fire run until the first rain.

Open-Meteo.com (CC BY 4.0) · Copernicus Climate Change Service (ERA5)

Day High Min. humidity Peak gust Rain Danger (FWI)
23 Aug 38.8 °C 8 % 44 km/h 0.0 mm Extreme 65
24 Aug 39.2 °C 7 % 44 km/h 0.0 mm Extreme 69
25 Aug after 38.5 °C 9 % 49 km/h 0.0 mm Extreme 65
26 Aug after 38.2 °C 11 % 41 km/h 0.0 mm Extreme 66
27 Aug after 38.9 °C 13 % 52 km/h 0.0 mm Very extreme 71
28 Aug after 37.8 °C 9 % 49 km/h 0.0 mm Extreme 70
29 Aug after 37.9 °C 11 % 41 km/h 0.0 mm Extreme 63
30 Aug after 38.6 °C 12 % 40 km/h 0.0 mm Extreme 62
31 Aug after 38.3 °C 12 % 50 km/h 0.0 mm Very extreme 71
1 Sept after 35.4 °C 14 % 41 km/h 0.0 mm Extreme 56
2 Sept after 34.3 °C 14 % 26 km/h 0.0 mm Extreme 52
3 Sept after 31.8 °C 19 % 48 km/h 0.0 mm Extreme 57

Before and after, from space

Drag the line to compare the same ground before the fire and after it.

Before · 16 Aug 2016
After · 31 Aug 2016

If the day is cloudy, change the date: each satellite passes once a day. In false colour the burnt ground looks brown or red.

The smoke

CAMS · Copernicus

On 21 August 2016 the air beside the fire reached 31 µg/m³ of PM2.5. That day averaged 27: 1.8 times the WHO daily guideline (15).

PM2.5 peak31 µg/m³
Days over the guideline6 days
PM1048 µg/m³
21222324252627
Good Fair Moderate Poor Very poor Extremely poor

Particles from the Copernicus CAMS model at the centre of the perimeter; these are not measurements in each town. The pale bar is the worst hour, the solid one the daily average.

Open-Meteo.com (CC BY 4.0) · Copernicus Atmosphere Monitoring Service (CAMS)

Detections table · 18Every satellite heat detection, one by one, with time, satellite, power and coordinates.
⬇ Download CSV Times in UTC. Each detection is a 375 m pixel: a large fire yields hundreds per pass.
Date and timeSatelliteFRP (MW)LatLon

Other fires nearby

All fires in Türkiye ›

Frequently asked questions

How long did the Ömerli fire last?
Copernicus dates it between 23 August 2016 and 24 August 2016: 2 days between the first and last image with fire.
How much area did it burn?
The perimeter Copernicus measured from satellite imagery is 1,073 hectares (10.7 km²). Official national figures may differ.
Which municipalities burned?
The fire only entered Ömerli (1,075 ha, 2.4 %).
Did the fire reach a town?
The closest fire to a town centre came within 3.1 km of Ömerli. That is the distance to the perimeter or nearest hotspot; it does not mean it entered the houses.
What was the weather like?
During the fire the temperature reached 39.2 °C, humidity dropped to 7 % and gusts hit 44 km/h. The fire danger index (FWI) reached 69, class Extreme.
Where does this data come from?
From the EFFIS (Copernicus) burnt perimeter, NASA FIRMS VIIRS hotspots and the administrative boundaries of Türkiye (geoBoundaries). It is not an official report.

Where to verify it

A satellite detection is not an official report. Final figures and the fire’s status are published by each country’s emergency service.

Emergency number: 112

Satellite cross-check

Does something look wrong on this page?

This page is built from satellite data and official records, and it sometimes gets things wrong: the wrong dates, the wrong town, two fires merged into one, or something that was not a wildfire at all. If you know this fire first-hand (you live nearby, saw it, fought it or reported on it), tell us what really happened and we will check it.

Report an error
What do you think is wrong?

We will only use your email to reply about this report. Privacy. This is not an emergency service: if there is a fire now, call 112.

Where this data comes from

The perimeter and land cover come from the Copernicus European Forest Fire Information System (EFFIS), measured on MODIS and Sentinel-2 imagery and published under CC BY 4.0. Heat detections come from the VIIRS sensors aboard Suomi-NPP and NOAA-20, distributed by NASA FIRMS at 375 m resolution. Municipal boundaries come from geoBoundaries ADM2 (Open Data Commons Open Database License 1.0). The area per municipality is computed by WorldFires by crossing the perimeter with those boundaries, so it may differ slightly from each country’s official figure.