Skip to content
worldfires
TR · Türkiye · →

Nusaybin fire, July 2018 Nusaybin

Out · last detection 25 Jul 2018, 11:07 UTC

The fire started on 25 July 2018 in Nusaybin, Türkiye, and satellites saw it burning for 1 day. Copernicus mapped a burnt perimeter of 136 hectares from satellite imagery, spread across a single municipality.

It is the 119th largest in Mardin since 2016 (of 131 with a page). Number 75 in Türkiye in 2018, of 104.

The power measured by the satellite is low (28.9 MW in the strongest hotspot), more typical of grass or stubble burning, or a slow surface fire, than of a large crown fire.

Compare with…
Burnt area
136ha
Copernicus perimeter
Duration
1day
25 Jul 2018 – 25 Jul 2018
Municipalities hit
1
districts
Started on
25 Jul
2018
Heat detections
9
in a single hotspot: 29 MW
Danger at start
63
Extreme · FWI index
Average daily power
124MW
detected power per day, on average

Where it burned

HOTSPOTS BY DAY 25 Jul25 Jul

How it evolved, day by day

25 Jul 2018 · 124 MW · 9

Fire radiative power detected each day, in megawatts, and number of hotspots. The magenta bar marks the peak day.

The weather it burned in

38°high
46km/h · peak gust
14%lowest humidity

It had gone 40 days without rain (1 mm or more) when it started.

This area had burned before

100% of the perimeter overlaps earlier fires recorded since 2016: 137 ha in 2016, 35 ha in 2017. Part of it burned more than once, so the yearly figures add up to more than the 137 ha that had burned before.

What happened to each town

  1. Nusaybin 105,856 inhabitants · 18.5 km from the town where it started
    137 ha reached on 25 Jul
    0.1 %

Burnt area inside each municipality, from crossing the official perimeter with administrative boundaries. The distance is from the town centre to the nearest fire: staying a kilometre away does not mean it reached the houses.

What burned

  • Other natural land100 %

Land cover inside the perimeter according to Corine Land Cover, as reported by Copernicus.

The weather day by day

ECMWF ERA5 reanalysis at the fire location, the standard reference for past weather, and the Canadian Fire Weather Index (the same system Copernicus uses), computed by WorldFires from that data. Days after the fire run until the first rain.

Open-Meteo.com (CC BY 4.0) · Copernicus Climate Change Service (ERA5)

Day High Min. humidity Peak gust Rain Danger (FWI)
25 Jul 37.6 °C 14 % 46 km/h 0.0 mm Extreme 63
26 Jul after 35.6 °C 11 % 38 km/h 0.0 mm Extreme 55
27 Jul after 36.5 °C 13 % 37 km/h 0.0 mm Extreme 55
28 Jul after 36.5 °C 15 % 34 km/h 0.0 mm Extreme 54
29 Jul after 36.8 °C 18 % 36 km/h 0.0 mm Extreme 53
30 Jul after 35.4 °C 23 % 34 km/h 0.0 mm Very high 48
31 Jul after 35.7 °C 25 % 34 km/h 0.0 mm Very high 46
1 Aug after 35.9 °C 22 % 30 km/h 0.0 mm Very high 42
2 Aug after 38.5 °C 20 % 27 km/h 0.0 mm Very high 43
3 Aug after 38.2 °C 18 % 33 km/h 0.0 mm Very high 48
4 Aug after 37.0 °C 19 % 41 km/h 0.0 mm Extreme 52

Before and after, from space

Drag the line to compare the same ground before the fire and after it.

Before · 18 Jul 2018
After · 1 Aug 2018

If the day is cloudy, change the date: each satellite passes once a day. In false colour the burnt ground looks brown or red.

The smoke

CAMS · Copernicus

On 25 July 2018 the air beside the fire reached 25 µg/m³ of PM2.5. That day averaged 17: 1.1 times the WHO daily guideline (15).

PM2.5 peak25 µg/m³
Days over the guideline1 day
PM1047 µg/m³
232425262728
Good Fair Moderate Poor Very poor Extremely poor

Particles from the Copernicus CAMS model at the centre of the perimeter; these are not measurements in each town. The pale bar is the worst hour, the solid one the daily average.

Open-Meteo.com (CC BY 4.0) · Copernicus Atmosphere Monitoring Service (CAMS)

Detections table · 9Every satellite heat detection, one by one, with time, satellite, power and coordinates.
⬇ Download CSV Times in UTC. Each detection is a 375 m pixel: a large fire yields hundreds per pass.
Date and timeSatelliteFRP (MW)LatLon

Other fires nearby

All fires in Türkiye ›

Frequently asked questions

How long did the Nusaybin fire last?
Copernicus dates it between 25 July 2018 and 25 July 2018: 1 day between the first and last image with fire.
How much area did it burn?
The perimeter Copernicus measured from satellite imagery is 136 hectares (1.4 km²). Official national figures may differ.
Which municipalities burned?
The fire only entered Nusaybin (137 ha, 0.1 %).
Did the fire reach a town?
The closest fire to a town centre came within 18.5 km of Nusaybin. That is the distance to the perimeter or nearest hotspot; it does not mean it entered the houses.
What was the weather like?
During the fire the temperature reached 37.6 °C, humidity dropped to 14 % and gusts hit 46 km/h. The fire danger index (FWI) reached 63, class Extreme.
Where does this data come from?
From the EFFIS (Copernicus) burnt perimeter, NASA FIRMS VIIRS hotspots and the administrative boundaries of Türkiye (geoBoundaries). It is not an official report.

Where to verify it

A satellite detection is not an official report. Final figures and the fire’s status are published by each country’s emergency service.

Emergency number: 112

Satellite cross-check

Does something look wrong on this page?

This page is built from satellite data and official records, and it sometimes gets things wrong: the wrong dates, the wrong town, two fires merged into one, or something that was not a wildfire at all. If you know this fire first-hand (you live nearby, saw it, fought it or reported on it), tell us what really happened and we will check it.

Report an error
What do you think is wrong?

We will only use your email to reply about this report. Privacy. This is not an emergency service: if there is a fire now, call 112.

How we know this
  • Perimeter: EFFIS (Copernicus), mapped on satellite imagery.
  • Dates from the perimeter: the VIIRS detections inside it did not change them. 9 Suomi-NPP VIIRS detections on those dates.
  • We have not matched this page with any official record.
  • Weather: Copernicus ERA5 reanalysis at the fire location, in cells of about 25 km.

How we build fire pages: methodology ›

Where this data comes from

The perimeter and land cover come from the Copernicus European Forest Fire Information System (EFFIS), measured on MODIS and Sentinel-2 imagery and published under CC BY 4.0. Heat detections come from the VIIRS sensors aboard Suomi-NPP and NOAA-20, distributed by NASA FIRMS at 375 m resolution. Municipal boundaries come from geoBoundaries ADM2 (Open Data Commons Open Database License 1.0). The area per municipality is computed by WorldFires by crossing the perimeter with those boundaries, so it may differ slightly from each country’s official figure.