Skip to content
worldfires
TR · Türkiye · →

Nusaybin fire, October 2016 Nusaybin

Out · last detection 19 Oct 2016, 23:03 UTC

The fire started on 17 October 2016 in Nusaybin, Türkiye, and satellites saw it burning for 3 days. Copernicus mapped a burnt perimeter of 1,209 hectares from satellite imagery, spread across a single municipality.

It is the 20th largest in Mardin since 2016 (of 131 with a page). Number 18 in Türkiye in 2016, of 223.

The power measured by the satellite is low (25.4 MW in the strongest hotspot), more typical of grass or stubble burning, or a slow surface fire, than of a large crown fire.

Burnt area
1,209ha
Copernicus perimeter
Duration
3days
17 Oct 2016 – 19 Oct 2016
Municipalities hit
1
districts
Started on
17 Oct
2016
Heat detections
20
in a single hotspot: 25 MW
Danger at start
42
Very high · FWI index
Energy released
110MW
sum of detected power

Where it burned

19 Oct 2016
HOTSPOTS BY DAY 17 Oct19 Oct

How it evolved, day by day

171819

Fire radiative power detected each day, in megawatts, and number of hotspots. The magenta bar marks the peak day.

The weather it burned in

25°high
35km/h · peak gust
10%lowest humidity

It had gone 25 days without rain (1 mm or more) when it started. Rain came after the fire: 16.5 mm on 28 Oct.

This area had burned before

No earlier perimeters overlap this fire since 2016, when the satellite record begins.

What happened to each town

  1. Nusaybin 105,856 inhabitants · 17.1 km from the town where it started
    1,212 ha reached on 17 Oct
    1.0 %

Burnt area inside each municipality, from crossing the official perimeter with administrative boundaries. The distance is from the town centre to the nearest fire: staying a kilometre away does not mean it reached the houses.

What burned

  • Other natural land100 %

Land cover inside the perimeter according to Corine Land Cover, as reported by Copernicus.

The weather day by day

ECMWF ERA5 reanalysis at the fire location, the standard reference for past weather, and the Canadian Fire Weather Index (the same system Copernicus uses), computed by WorldFires from that data. Days after the fire run until the first rain.

Open-Meteo.com (CC BY 4.0) · Copernicus Climate Change Service (ERA5)

Day High Min. humidity Peak gust Rain Danger (FWI)
17 Oct 24.3 °C 10 % 26 km/h 0.0 mm Very high 42
18 Oct 24.9 °C 16 % 28 km/h 0.0 mm Very high 41
19 Oct 23.9 °C 19 % 35 km/h 0.0 mm Very high 43
20 Oct after 23.8 °C 18 % 29 km/h 0.0 mm Very high 40
21 Oct after 24.0 °C 20 % 22 km/h 0.0 mm High 36
22 Oct after 24.6 °C 18 % 23 km/h 0.0 mm High 36
23 Oct after 25.3 °C 20 % 28 km/h 0.0 mm Very high 41
24 Oct after 23.7 °C 29 % 23 km/h 0.1 mm High 36
25 Oct after 22.1 °C 29 % 21 km/h 0.3 mm High 33
26 Oct after 22.1 °C 25 % 32 km/h 0.9 mm High 26
27 Oct after 23.9 °C 25 % 38 km/h 0.0 mm High 34
28 Oct after 17.9 °C 41 % 33 km/h 16.5 mm Very low 2

Before and after, from space

Drag the line to compare the same ground before the fire and after it.

Before · 10 Oct 2016
After · 26 Oct 2016

If the day is cloudy, change the date: each satellite passes once a day. In false colour the burnt ground looks brown or red.

The smoke

CAMS · Copernicus

On 18 October 2016 the air beside the fire reached 32 µg/m³ of PM2.5. That day averaged 23: 1.5 times the WHO daily guideline (15).

PM2.5 peak32 µg/m³
Days over the guideline4 days
PM1047 µg/m³
1516171819202122
Good Fair Moderate Poor Very poor Extremely poor

Particles from the Copernicus CAMS model at the centre of the perimeter; these are not measurements in each town. The pale bar is the worst hour, the solid one the daily average.

Open-Meteo.com (CC BY 4.0) · Copernicus Atmosphere Monitoring Service (CAMS)

Detections table · 20Every satellite heat detection, one by one, with time, satellite, power and coordinates.
⬇ Download CSV Times in UTC. Each detection is a 375 m pixel: a large fire yields hundreds per pass.
Date and timeSatelliteFRP (MW)LatLon

Other fires nearby

All fires in Türkiye ›

Frequently asked questions

How long did the Nusaybin fire last?
Copernicus dates it between 17 October 2016 and 19 October 2016: 3 days between the first and last image with fire.
How much area did it burn?
The perimeter Copernicus measured from satellite imagery is 1,209 hectares (12.1 km²). Official national figures may differ.
Which municipalities burned?
The fire only entered Nusaybin (1,212 ha, 1.0 %).
Did the fire reach a town?
The closest fire to a town centre came within 17.1 km of Nusaybin. That is the distance to the perimeter or nearest hotspot; it does not mean it entered the houses.
What was the weather like?
During the fire the temperature reached 24.9 °C, humidity dropped to 10 % and gusts hit 35 km/h. The fire danger index (FWI) reached 43, class Very high.
Where does this data come from?
From the EFFIS (Copernicus) burnt perimeter, NASA FIRMS VIIRS hotspots and the administrative boundaries of Türkiye (geoBoundaries). It is not an official report.

Where to verify it

A satellite detection is not an official report. Final figures and the fire’s status are published by each country’s emergency service.

Emergency number: 112

Satellite cross-check

Does something look wrong on this page?

This page is built from satellite data and official records, and it sometimes gets things wrong: the wrong dates, the wrong town, two fires merged into one, or something that was not a wildfire at all. If you know this fire first-hand (you live nearby, saw it, fought it or reported on it), tell us what really happened and we will check it.

Report an error
What do you think is wrong?

We will only use your email to reply about this report. Privacy. This is not an emergency service: if there is a fire now, call 112.

Where this data comes from

The perimeter and land cover come from the Copernicus European Forest Fire Information System (EFFIS), measured on MODIS and Sentinel-2 imagery and published under CC BY 4.0. Heat detections come from the VIIRS sensors aboard Suomi-NPP and NOAA-20, distributed by NASA FIRMS at 375 m resolution. Municipal boundaries come from geoBoundaries ADM2 (Open Data Commons Open Database License 1.0). The area per municipality is computed by WorldFires by crossing the perimeter with those boundaries, so it may differ slightly from each country’s official figure.