Skip to content
worldfires
IT · Italy · →

Noto fire, 14 August 2020 Noto

Out · last detection 15 Aug 2020, 01:28 UTC

The fire started on 14 August 2020 in Noto, Italy, and satellites saw it burning for 2 days. Copernicus mapped a burnt perimeter of 123 hectares from satellite imagery, spread across a single municipality.

It is the 44th largest in Siracusa since 2016 (of 57 with a page). Number 103 in Italy in 2020, of 140.

The power measured by the satellite is low (18.8 MW in the strongest hotspot), more typical of grass or stubble burning, or a slow surface fire, than of a large crown fire.

Compare with…
Burnt area
123ha
Copernicus perimeter
Duration
2days
14 Aug 2020 – 15 Aug 2020
Municipalities hit
1
municipalities
Started on
14 Aug
2020
Heat detections
9
in a single hotspot: 19 MW
Danger at start
47
Very high · FWI index
Average daily power
50MW
detected power per day, on average

Where it burned

HOTSPOTS BY DAY 14 Aug15 Aug
15 Aug 2020

How it evolved, day by day

14 Aug 2020 · 88 MW · 7 15 Aug 2020 · 11 MW · 2
14 Aug 15 Aug

Fire radiative power detected each day, in megawatts, and number of hotspots. The magenta bar marks the peak day.

The weather it burned in

35°high
38km/h · peak gust
16%lowest humidity

It had gone 25 days without rain (1 mm or more) when it started.

This area had burned before

No earlier perimeters overlap this fire since 2016, when the satellite record begins.

What happened to each town

  1. Noto 24,264 inhabitants · 7.3 km from the centre where it started
    123 ha reached on 14 Aug
    0.2 %

Burnt area inside each municipality, from crossing the official perimeter with administrative boundaries. The distance runs from the point marking the centre of each area to the nearest fire: staying a kilometre away does not mean it reached the houses.

What burned

  • Sclerophyllous scrub99 %
  • Agricultural areas0.8 %

Natura 2000 protected area affected: 100 %

Natura 2000 sites (European Environment Agency, 2024 release) crossed by the perimeter.

Land cover inside the perimeter according to Corine Land Cover, as reported by Copernicus.

The weather day by day

ECMWF ERA5 reanalysis at the fire location, the standard reference for past weather, and the Canadian Fire Weather Index (the same system Copernicus uses), computed by WorldFires from that data. Days after the fire run until the first rain.

Open-Meteo.com (CC BY 4.0) · Copernicus Climate Change Service (ERA5)

Day High Min. humidity Peak gust Rain Danger (FWI)
14 Aug 35.3 °C 16 % 38 km/h 0.0 mm Very high 47
15 Aug 35.4 °C 32 % 31 km/h 0.0 mm Very high 38
16 Aug after 32.4 °C 41 % 26 km/h 0.0 mm High 29
17 Aug after 34.4 °C 34 % 40 km/h 0.0 mm High 33
18 Aug after 32.5 °C 31 % 21 km/h 0.0 mm High 29
19 Aug after 30.8 °C 47 % 30 km/h 0.0 mm High 27
20 Aug after 30.2 °C 49 % 26 km/h 0.0 mm High 25
21 Aug after 31.1 °C 46 % 32 km/h 0.0 mm High 27
22 Aug after 32.7 °C 38 % 23 km/h 0.0 mm High 25
23 Aug after 32.2 °C 42 % 29 km/h 0.0 mm High 28
24 Aug after 30.6 °C 55 % 28 km/h 0.0 mm High 22
25 Aug after 30.1 °C 50 % 27 km/h 0.7 mm Moderate 18

Before and after, from space

Drag the line to compare the same ground before the fire and after it.

Before · 7 Aug 2020
After · 22 Aug 2020

If the day is cloudy, change the date: each satellite passes once a day. In false colour the burnt ground looks brown or red.

The smoke

CAMS · Copernicus

On 15 August 2020 the air beside the fire reached 25 µg/m³ of PM2.5. That day averaged 18: 1.2 times the WHO daily guideline (15).

PM2.5 peak25 µg/m³
Days over the guideline3 days
PM1038 µg/m³
12131415161718
Good Fair Moderate Poor Very poor Extremely poor

Particles from the Copernicus CAMS model at the centre of the perimeter; these are not measurements in each town. The pale bar is the worst hour, the solid one the daily average.

Open-Meteo.com (CC BY 4.0) · Copernicus Atmosphere Monitoring Service (CAMS)

Detections table · 9Every satellite heat detection, one by one, with time, satellite, power and coordinates.
⬇ Download CSV Times in UTC. Each detection is a 375 m pixel: a large fire yields hundreds per pass.
Date and timeSatelliteFRP (MW)LatLon

Other fires nearby

All fires in Italy ›

Frequently asked questions

How long did the Noto fire last?
Copernicus dates it between 14 August 2020 and 15 August 2020: 2 days between the first and last image with fire.
How much area did it burn?
The perimeter Copernicus measured from satellite imagery is 123 hectares (1.2 km²). Official national figures may differ.
Which municipalities burned?
The fire only entered Noto (123 ha, 0.2 %).
Did the fire reach a town?
The fire started in Noto and came within 7.3 km of its centre. That is the distance from the perimeter, or the nearest hotspot, to the point marking the centre; it does not mean it entered the houses.
What was the weather like?
During the fire the temperature reached 35.4 °C, humidity dropped to 16 % and gusts hit 38 km/h. The fire danger index (FWI) reached 47, class Very high.
Where does this data come from?
From the EFFIS (Copernicus) burnt perimeter, NASA FIRMS VIIRS hotspots and the administrative boundaries of Italy (geoBoundaries). It is not an official report.

Where to verify it

A satellite detection is not an official report. Final figures and the fire’s status are published by each country’s emergency service.

Emergency number: 112 · 1515 · Emergency number and official warnings ›

Satellite cross-check

History of this page Changes in area, dates, name, official record or merged pages, compared every night since 24 October 2026.

No changes since 24 October 2026.

RSS Changes to this page

Does something look wrong on this page?

This page is built from satellite data and official records, and it sometimes gets things wrong: the wrong dates, the wrong town, two fires merged into one, or something that was not a wildfire at all. If you know this fire first-hand (you live nearby, saw it, fought it or reported on it), tell us what really happened and we will check it.

Report an error
What do you think is wrong?

We will only use your email to reply about this report. Privacy. This is not an emergency service: if there is a fire now, call 112 · 1515.

How we know this
  • Perimeter: EFFIS (Copernicus), mapped on satellite imagery.
  • Dates from the perimeter: the VIIRS detections inside it did not change them. 9 Suomi-NPP VIIRS detections on those dates.
  • We have not matched this page with any official record.
  • Weather: Copernicus ERA5 reanalysis at the fire location, in cells of about 25 km.

How we build fire pages: methodology ›

Where this data comes from

The perimeter and land cover come from the Copernicus European Forest Fire Information System (EFFIS), measured on MODIS and Sentinel-2 imagery and published under CC BY 4.0. Heat detections come from the VIIRS sensors aboard Suomi-NPP and NOAA-20, distributed by NASA FIRMS at 375 m resolution. Municipal boundaries come from geoBoundaries ADM4 (Creative Commons Attribution 3.0 License). The area per municipality is computed by WorldFires by crossing the perimeter with those boundaries, so it may differ slightly from each country’s official figure.