Skip to content
worldfires
IT · Italy · →

Melilli fire, August 2017 Melilli, Carlentini

Out · last detection 11 Aug 2017, 01:53 UTC

The fire started on 10 August 2017 in Melilli, Italy, and satellites saw it burning for 2 days. Copernicus mapped a burnt perimeter of 733 hectares from satellite imagery, spread across 2 municipalities.

It is the 7th largest in Siracusa since 2016 (of 57 with a page). Number 23 in Italy in 2017, of 361.

Compare with…
Burnt area
733ha
Copernicus perimeter
Duration
2days
10 Aug 2017 – 11 Aug 2017
Municipalities hit
2
municipalities
Started on
10 Aug
2017
Heat detections
23
in a single hotspot: 47 MW
Danger at start
43
Very high · FWI index
Average daily power
166MW
detected power per day, on average

Where it burned

HOTSPOTS BY DAY 10 Aug11 Aug
11 Aug 2017

How it evolved, day by day

10 Aug 2017 · 310 MW · 18 11 Aug 2017 · 22 MW · 5
10 Aug 11 Aug

Fire radiative power detected each day, in megawatts, and number of hotspots. The magenta bar marks the peak day.

The weather it burned in

38°high
36km/h · peak gust
16%lowest humidity

It had gone 24 days without rain (1 mm or more) when it started.

This area had burned before

No earlier perimeters overlap this fire since 2016, when the satellite record begins.

How big is it?

10 km
It burned the equivalent of 0.5% of the area of London (7.3 km² against 1,583 km²).

London boundary: geoBoundaries · Office for National Statistics (Open Government Licence v3.0).

This compares size, not location: both shapes are at the same scale, north up, centred on each other.

What happened to each town

  1. Melilli 34,658 inhabitants · 13.4 km from the centre where it started
    662 ha reached on 10 Aug
    4.9 %
  2. Carlentini 17,040 inhabitants · 5.6 km from the centre
    73 ha
    0.5 %

Burnt area inside each municipality, from crossing the official perimeter with administrative boundaries. The distance runs from the point marking the centre of each area to the nearest fire: staying a kilometre away does not mean it reached the houses.

What burned

  • Other natural land78 %
  • Broadleaved forest22 %

Natura 2000 protected area affected: 32 %

Natura 2000 sites (European Environment Agency, 2024 release) crossed by the perimeter.

Land cover inside the perimeter according to Corine Land Cover, as reported by Copernicus.

The weather day by day

ECMWF ERA5 reanalysis at the fire location, the standard reference for past weather, and the Canadian Fire Weather Index (the same system Copernicus uses), computed by WorldFires from that data. Days after the fire run until the first rain.

Open-Meteo.com (CC BY 4.0) · Copernicus Climate Change Service (ERA5)

Day High Min. humidity Peak gust Rain Danger (FWI)
10 Aug 38.1 °C 16 % 23 km/h 0.0 mm Very high 43
11 Aug 37.3 °C 31 % 36 km/h 0.5 mm Very high 41
12 Aug after 33.3 °C 22 % 31 km/h 0.0 mm Very high 41
13 Aug after 31.4 °C 32 % 35 km/h 0.0 mm High 38
14 Aug after 31.2 °C 34 % 27 km/h 0.0 mm High 34
15 Aug after 32.8 °C 32 % 29 km/h 0.0 mm High 35
16 Aug after 32.4 °C 31 % 32 km/h 0.0 mm High 34
17 Aug after 34.0 °C 29 % 31 km/h 0.0 mm High 34
18 Aug after 33.2 °C 33 % 26 km/h 0.0 mm High 34
19 Aug after 33.1 °C 33 % 26 km/h 0.0 mm High 34
20 Aug after 35.2 °C 23 % 27 km/h 0.0 mm High 36
21 Aug after 29.3 °C 49 % 30 km/h 0.2 mm High 28

Before and after, from space

Drag the line to compare the same ground before the fire and after it.

Before · 3 Aug 2017
After · 18 Aug 2017

If the day is cloudy, change the date: each satellite passes once a day. In false colour the burnt ground looks brown or red.

The smoke

CAMS · Copernicus

On 9 August 2017 the air beside the fire reached 25 µg/m³ of PM2.5. That day averaged 21: 1.4 times the WHO daily guideline (15).

PM2.5 peak25 µg/m³
Days over the guideline3 days
PM1035 µg/m³
891011121314
Good Fair Moderate Poor Very poor Extremely poor

Particles from the Copernicus CAMS model at the centre of the perimeter; these are not measurements in each town. The pale bar is the worst hour, the solid one the daily average.

Open-Meteo.com (CC BY 4.0) · Copernicus Atmosphere Monitoring Service (CAMS)

Detections table · 23Every satellite heat detection, one by one, with time, satellite, power and coordinates.
⬇ Download CSV Times in UTC. Each detection is a 375 m pixel: a large fire yields hundreds per pass.
Date and timeSatelliteFRP (MW)LatLon

Other fires nearby

All fires in Italy ›

Frequently asked questions

How long did the Melilli fire last?
Copernicus dates it between 10 August 2017 and 11 August 2017: 2 days between the first and last image with fire.
How much area did it burn?
The perimeter Copernicus measured from satellite imagery is 733 hectares (7.3 km²). Official national figures may differ.
Which municipalities burned?
The fire entered 2 municipalities: Melilli (662 ha, 4.9 %); Carlentini (73 ha, 0.5 %).
Did the fire reach a town?
The fire came within 5.6 km of the centre of Carlentini, the closest of the areas it touched. That is the distance from the perimeter, or the nearest hotspot, to the point marking the centre; it does not mean it entered the houses.
What was the weather like?
During the fire the temperature reached 38.1 °C, humidity dropped to 16 % and gusts hit 36 km/h. The fire danger index (FWI) reached 43, class Very high.
Where does this data come from?
From the EFFIS (Copernicus) burnt perimeter, NASA FIRMS VIIRS hotspots and the administrative boundaries of Italy (geoBoundaries). It is not an official report.

Where to verify it

A satellite detection is not an official report. Final figures and the fire’s status are published by each country’s emergency service.

Emergency number: 112 · 1515 · Emergency number and official warnings ›

Satellite cross-check

History of this page Changes in area, dates, name, official record or merged pages, compared every night since 24 October 2026.

No changes since 24 October 2026.

RSS Changes to this page

Does something look wrong on this page?

This page is built from satellite data and official records, and it sometimes gets things wrong: the wrong dates, the wrong town, two fires merged into one, or something that was not a wildfire at all. If you know this fire first-hand (you live nearby, saw it, fought it or reported on it), tell us what really happened and we will check it.

Report an error
What do you think is wrong?

We will only use your email to reply about this report. Privacy. This is not an emergency service: if there is a fire now, call 112 · 1515.

How we know this
  • Perimeter: EFFIS (Copernicus), mapped on satellite imagery.
  • Dates from the perimeter: the VIIRS detections inside it did not change them. 23 Suomi-NPP VIIRS detections on those dates.
  • We have not matched this page with any official record.
  • Weather: Copernicus ERA5 reanalysis at the fire location, in cells of about 25 km.

How we build fire pages: methodology ›

Where this data comes from

The perimeter and land cover come from the Copernicus European Forest Fire Information System (EFFIS), measured on MODIS and Sentinel-2 imagery and published under CC BY 4.0. Heat detections come from the VIIRS sensors aboard Suomi-NPP and NOAA-20, distributed by NASA FIRMS at 375 m resolution. Municipal boundaries come from geoBoundaries ADM4 (Creative Commons Attribution 3.0 License). The area per municipality is computed by WorldFires by crossing the perimeter with those boundaries, so it may differ slightly from each country’s official figure.