Skip to content
worldfires
CA · Canada · →

North Okanagan E fire, July 2024 North Okanagan E

Out · last detection 23 Jul 2024, 21:58 UTC

The fire started on 17 July 2024 in North Okanagan E, Canada, and satellites saw it burning for 8 days. Canada’s CWFIS (Natural Resources Canada) mapped an official burnt perimeter of 1,016 hectares from satellite imagery, spread across a single census subdivision.

It is the 445th largest in British Columbia since 2016 (of 448 with a page). Number 291 in Canada in 2024, of 291.

The power measured by the satellite is low (26.3 MW in the strongest hotspot), more typical of grass or stubble burning, or a slow surface fire, than of a large crown fire.

Burnt area
1,016ha
official perimeter (CWFIS)
Duration
8days
17 Jul 2024 – 24 Jul 2024
Municipalities hit
1
municipalities
Started on
17 Jul
2024
Heat detections
150
in a single hotspot: 26 MW
Danger at start
23
High · FWI index
Energy released
868MW
sum of detected power

Where it burned

23 Jul 2024
HOTSPOTS BY DAY 17 Jul24 Jul

How it evolved, day by day

20212223

Fire radiative power detected each day, in megawatts, and number of hotspots. The magenta bar marks the peak day.

The weather it burned in

36°high
51km/h · peak gust
18%lowest humidity

It had gone 14 days without rain (1 mm or more) when it started. Rain came after the fire: 8.0 mm on 25 Jul.

This area had burned before

No earlier perimeters overlap this fire since 2016, when the satellite record begins.

What happened to each town

  1. North Okanagan E where it started
    1,016 ha reached on 20 Jul
    0.4 %

Burnt area inside each census subdivision, from crossing the official perimeter with administrative boundaries. The distance is from the town centre to the nearest fire: staying a kilometre away does not mean it reached the houses.

The weather day by day

ECMWF ERA5 reanalysis at the fire location, the standard reference for past weather, and the Canadian Fire Weather Index (the same system Copernicus uses), computed by WorldFires from that data. Days after the fire run until the first rain.

Open-Meteo.com (CC BY 4.0) · Copernicus Climate Change Service (ERA5)

Day High Min. humidity Peak gust Rain Danger (FWI)
17 Jul 32.6 °C 21 % 24 km/h 0.1 mm High 23
18 Jul 31.4 °C 27 % 21 km/h 0.8 mm Moderate 18
19 Jul 32.0 °C 22 % 38 km/h 1.8 mm Moderate 16
20 Jul 34.1 °C 18 % 21 km/h 0.0 mm High 24
21 Jul 35.8 °C 19 % 39 km/h 0.0 mm High 29
22 Jul 32.4 °C 27 % 51 km/h 1.1 mm Moderate 20
23 Jul 26.4 °C 21 % 38 km/h 0.2 mm High 24
24 Jul 27.9 °C 23 % 45 km/h 0.0 mm High 26
25 Jul after 16.3 °C 52 % 52 km/h 8.0 mm Very low 1

Before and after, from space

Drag the line to compare the same ground before the fire and after it.

Before · 10 Jul 2024
After · 31 Jul 2024

If the day is cloudy, change the date: each satellite passes once a day. In false colour the burnt ground looks brown or red.

The smoke

CAMS · Copernicus

On 24 July 2024 the air beside the fire reached 177 µg/m³ of PM2.5. That day averaged 74: 4.9 times the WHO daily guideline (15).

PM2.5 peak177 µg/m³
Days over the guideline6 days
PM10252 µg/m³
Optical depth1.34
15161718192021222324252627
Good Fair Moderate Poor Very poor Extremely poor

Particles from the Copernicus CAMS model at the centre of the perimeter; these are not measurements in each town. The pale bar is the worst hour, the solid one the daily average.

Open-Meteo.com (CC BY 4.0) · Copernicus Atmosphere Monitoring Service (CAMS)

Detections table · 150Every satellite heat detection, one by one, with time, satellite, power and coordinates.
⬇ Download CSV Times in UTC. Each detection is a 375 m pixel: a large fire yields hundreds per pass.
Date and timeSatelliteFRP (MW)LatLon

Other fires nearby

All fires in Canada ›

Frequently asked questions

How long did the North Okanagan E fire last?
It burned between 17 July 2024 and 24 July 2024: 8 days, according to the dates recorded by Canada’s CWFIS and the heat detections seen by satellite.
How much area did it burn?
The official perimeter mapped by Canada’s CWFIS (Natural Resources Canada) is 1,016 hectares (10.2 km²). Other tallies, such as those of provincial agencies, may give slightly different figures.
Which census subdivisions burned?
The fire only entered North Okanagan E (1,016 ha, 0.4 %).
What was the weather like?
During the fire the temperature reached 35.8 °C, humidity dropped to 18 % and gusts hit 51 km/h. The fire danger index (FWI) reached 29, class High.
Where does this data come from?
From the official burnt perimeter of Canada’s CWFIS (NBAC, Natural Resources Canada) or, for the current season and until NBAC publishes it, the one rebuilt by GWIS (Copernicus); from NASA FIRMS VIIRS hotspots; and from the administrative boundaries of Canada. It is not an official report.

Where to verify it

A satellite detection is not an official report. Final figures and the fire’s status are published by each country’s emergency service.

Emergency number: 911

Satellite cross-check

Does something look wrong on this page?

This page is built from satellite data and official records, and it sometimes gets things wrong: the wrong dates, the wrong town, two fires merged into one, or something that was not a wildfire at all. If you know this fire first-hand (you live nearby, saw it, fought it or reported on it), tell us what really happened and we will check it.

Report an error
What do you think is wrong?

We will only use your email to reply about this report. Privacy. This is not an emergency service: if there is a fire now, call 911.

Where this data comes from

The perimeter is official: it comes from the National Burned Area Composite (NBAC) of the Canadian Wildland Fire Information System (CWFIS), Natural Resources Canada, which maps it on satellite imagery and publishes it under the Open Government Licence – Canada. Until NBAC publishes the current season, this year’s fires carry the perimeter rebuilt from heat detections by GWIS (Copernicus, CC BY 4.0), which is approximate. Heat detections come from the VIIRS sensors aboard Suomi-NPP and NOAA-20, distributed by NASA FIRMS at 375 m resolution. Census subdivision boundaries come from geoBoundaries ADM3 (Open Data Commons Open Database License 1.0). The area per census subdivision is computed by WorldFires by crossing the perimeter with those boundaries, so it may differ slightly from official figures.