Skip to content
worldfires
AU · Australia · –

North Burnett fire, January 2019 North Burnett

Out · last detection 30 Jan 2019, 14:34 UTC

The fire started on 12 January 2019 in North Burnett, Australia, and satellites saw it burning for 19 days. Copernicus’s global GWIS system rebuilt a burnt perimeter of 8,937 hectares from heat detections, spread across a single municipality.

It is the 109th largest in Queensland since 2016 (of 227 with a page). Number 169 in Australia in 2019, of 288.

Burnt area
8,937ha
GWIS perimeter (Copernicus)
Duration
19days
12 Jan 2019 – 30 Jan 2019
Municipalities hit
1
local government areas
Started on
12 Jan
2019
Heat detections
650
in a single hotspot: 125 MW
Danger at start
14
Moderate · FWI index
Average daily power
244MW
detected power per day, on average

Where it burned

HOTSPOTS BY DAY 12 Jan30 Jan
30 Jan 2019

How it evolved, day by day

12 Jan 2019 · 41 MW · 12 13 Jan 2019 · 102 MW · 27 14 Jan 2019 · 38 MW · 10 15 Jan 2019 · 23 MW · 10 16 Jan 2019 · 183 MW · 23 17 Jan 2019 · 343 MW · 71 18 Jan 2019 · 63 MW · 9 19 Jan 2019 · 1,250 MW · 127 20 Jan 2019 · 906 MW · 144 21 Jan 2019 · 351 MW · 71 22 Jan 2019 · 179 MW · 35 23 Jan 2019 · 375 MW · 53 24 Jan 2019 · 179 MW · 34 27 Jan 2019 · 60 MW · 13 28 Jan 2019 · 22 MW · 3 29 Jan 2019 · 11 MW · 2 30 Jan 2019 · 25 MW · 6
12 Jan 16 Jan 19 Jan 24 Jan 30 Jan

Fire radiative power detected each day, in megawatts, and number of hotspots. The magenta bar marks the peak day.

The weather it burned in

33°high
52km/h · peak gust
26%lowest humidity

It had gone one day without rain (1 mm or more) when it started. Rain came after the fire: 1.8 mm on 6 Feb.

This area had burned before

14% of the perimeter overlaps earlier fires recorded since 2016: 1,232 ha in 2016.

How big is it?

10 km
It burned the equivalent of 5.6% of the area of London (89 km² against 1,583 km²).

London boundary: geoBoundaries · Office for National Statistics (Open Government Licence v3.0).

This compares size, not location: both shapes are at the same scale, north up, centred on each other.

What happened to each town

  1. North Burnett where it started
    8,963 ha reached on 12 Jan
    0.4 %

Burnt area inside each municipality, from crossing the GWIS perimeter with administrative boundaries. The distance runs from the point marking the centre of each area to the nearest fire: staying a kilometre away does not mean it reached the houses.

People and buildings inside the perimeter

GHSL 2020
Built-up area< 0.1 ha
Residents< 20

Inside the perimeter there was no noticeable built-up land and almost nobody lived there (GHSL 2020, satellite-based estimate).

This is an estimate on 100 m cells, made from satellite imagery and census data: it does not mean that homes burned or that anyone was harmed. The perimeter also contains land that never burned.

Source: Global Human Settlement Layer (GHS-BUILT-S and GHS-POP R2023A), European Commission Joint Research Centre (JRC), © European Union, CC BY 4.0. Sum inside the perimeter computed by WorldFires. human-settlement.emergency.copernicus.eu

The weather day by day

ECMWF ERA5 reanalysis at the fire location, the standard reference for past weather, and the Canadian Fire Weather Index (the same system Copernicus uses), computed by WorldFires from that data. Days after the fire run until the first rain.

Open-Meteo.com (CC BY 4.0) · Copernicus Climate Change Service (ERA5)

Day High Min. humidity Peak gust Rain Danger (FWI)
5 Jan 30.3 °C 36 % 40 km/h 0.0 mm Moderate 14
6 Jan 28.6 °C 49 % 39 km/h 0.3 mm Moderate 14
7 Jan 24.9 °C 65 % 46 km/h 1.7 mm Very low 4
8 Jan 27.6 °C 48 % 52 km/h 0.1 mm Low 10
9 Jan 27.4 °C 63 % 43 km/h 4.5 mm Very low 2
10 Jan 30.5 °C 37 % 42 km/h 0.1 mm Low 9
11 Jan 29.7 °C 38 % 40 km/h 0.0 mm Moderate 13
12 Jan 32.1 °C 29 % 41 km/h 0.0 mm Moderate 17
13 Jan 31.8 °C 34 % 44 km/h 0.0 mm Moderate 18
14 Jan 30.7 °C 37 % 48 km/h 0.1 mm Moderate 20
15 Jan 32.9 °C 31 % 37 km/h 0.0 mm Moderate 19
16 Jan 33.0 °C 29 % 38 km/h 0.0 mm Moderate 20
17 Jan 33.1 °C 26 % 38 km/h 0.0 mm High 22
18 Jan 31.1 °C 36 % 37 km/h 0.0 mm Moderate 20
19 Jan 33.0 °C 29 % 36 km/h 0.0 mm Moderate 21
20 Jan 33.0 °C 33 % 42 km/h 0.0 mm High 22
21 Jan 32.0 °C 35 % 46 km/h 0.0 mm High 24
22 Jan 31.2 °C 39 % 42 km/h 0.4 mm Moderate 21
23 Jan 32.7 °C 34 % 36 km/h 0.1 mm High 22
24 Jan 33.1 °C 33 % 41 km/h 0.0 mm High 23
25 Jan 31.3 °C 45 % 35 km/h 1.6 mm Low 10
26 Jan 31.9 °C 36 % 42 km/h 0.2 mm Moderate 19
27 Jan 31.9 °C 34 % 42 km/h 0.0 mm High 22
28 Jan 32.2 °C 28 % 50 km/h 0.4 mm High 26
29 Jan 30.4 °C 36 % 48 km/h 0.1 mm High 26
30 Jan 30.8 °C 35 % 48 km/h 0.5 mm High 26
31 Jan after 32.3 °C 34 % 41 km/h 0.0 mm High 26
1 Feb after 31.2 °C 36 % 50 km/h 0.0 mm High 29
2 Feb after 29.4 °C 43 % 49 km/h 0.5 mm High 25
3 Feb after 28.0 °C 49 % 46 km/h 0.8 mm Moderate 16
4 Feb after 28.4 °C 49 % 50 km/h 0.3 mm Moderate 19
5 Feb after 30.1 °C 37 % 46 km/h 0.2 mm High 24
6 Feb after 28.5 °C 52 % 52 km/h 1.8 mm Moderate 11

Its twins: fires that started in the same weather

It started with an FWI of 14.3, a minimum humidity of 29% and 1 day without rain. Fires in the area that started in weather like this since 2016: 27.

FWI at the start 14.3
Minimum humidity 29 %
Days without rain 1
this fire chosen twins rest of the area
Almost identicalSimilar

Outlines of the closest twins

North Burnett fire, September 2025
16,614 ha 29 days FWI 16.1 Min. humidity 25 % 33 km away, in 2025

First rain (1 mm or more) after it ended: 1.2 mm on 25 Oct.

What happened to them

15 days
median duration
7,337 ha
median area
33 %
went past 10,000 ha
3.3 mm
rain at the end (median; 25 of 27 had it)

It burned an area similar to its twins (8,937 ha against a median of 7,337 ha) and lasted 19 days, against 15 days.

In 2 of 27, not even 1 mm fell in the ten days after the end: they went out without rain. In the rest, the first rainy day brought a median of 3.3 mm.

This is a bank of analogues: it shows what usually happens, not what will happen. With fewer than 15 twins we give no figures. How we calculate it

How it ended

1.8 mmfirst rain
6 Feb7 days after it ended
52km/h · max. gust

It was considered over on 30 Jan, and on 6 Feb 1.8 mm fell. We do not know whether the rain or the firefighters put it out. Twins with rain when they ended: 25 of 27, with a median of 3.3 mm.

Weather on this page: Open-Meteo.com (CC BY 4.0) · Copernicus Climate Change Service (ERA5)

How a twin is chosen

  • Same area: fires that have already ended, less than 250 km from this one, since 2016.
  • Same start: we compare the FWI on the first day, the minimum humidity that day and the run of days without rain before it. The slider sets how much they may differ.
  • Only pages with final weather data (ERA5 reanalysis) calculated in the same way as this fire’s; agricultural and grass burns and pages with data under review are left out.
  • Fires burning at the same time as this one (a week before or after) are left out: they share the same spell of weather and do not count as a precedent.
  • They are sorted by similarity, and the outlines of the first five are drawn.

How we calculate it

Before and after, from space

Drag the line to compare the same ground before the fire and after it.

Before · 5 Jan 2019
After · 6 Feb 2019

If the day is cloudy, change the date: each satellite passes once a day. In false colour the burnt ground looks brown or red.

Detections table · 650Every satellite heat detection, one by one, with time, satellite, power and coordinates.
⬇ Download CSV Times in UTC. Each detection is a 375 m pixel: a large fire yields hundreds per pass.
Date and timeSatelliteFRP (MW)LatLon

Other fires nearby

All fires in Australia

Frequently asked questions

How long did the North Burnett fire last?
GWIS (Copernicus) dates it between 12 January 2019 and 30 January 2019: 19 days between the first and last heat detection of the perimeter.
How much area did it burn?
The perimeter GWIS (Copernicus) rebuilt from heat detections is 8,937 hectares (89.4 km²). It is an estimate: official national figures may differ.
Which municipalities burned?
The fire only entered North Burnett (8,963 ha, 0.4 %).
What was the weather like?
During the fire the temperature reached 33.1 °C, humidity dropped to 26 % and gusts hit 52 km/h. The fire danger index (FWI) reached 26, class High.
Where does this data come from?
From the GWIS (Copernicus) burnt perimeter, NASA FIRMS VIIRS hotspots and the administrative boundaries of Australia (geoBoundaries). It is not an official report.
How did the fires that started in similar weather in this area end?
Fires less than 250 km away that started since 2016 with a similar FWI, humidity and dry spell: 27. Their median duration was 15 days and their median area 7,337 ha; 33 % went past 10,000 ha. In 2 of 27, not even 1 mm fell in the ten days after the end: they went out without rain. In the rest, the first rainy day brought a median of 3.3 mm.

Where to verify it

A satellite detection is not an official report. Final figures and the fire’s status are published by each country’s emergency service.

Emergency number: 000 · Emergency number and official warnings

Satellite cross-check

History of this page Changes in area, dates, name, official record or merged pages, compared every night since 24 October 2026.

Does something look wrong on this page?

This page is built from satellite data and official records, and it sometimes gets things wrong: the wrong dates, the wrong town, two fires merged into one, or something that was not a wildfire at all. If you know this fire first-hand (you live nearby, saw it, fought it or reported on it), tell us what really happened and we will check it.

Report an error
What do you think is wrong?

We will only use your email to reply about this report. Privacy. This is not an emergency service: if there is a fire now, call 000.

How we know this
  • Perimeter: GWIS (Copernicus), rebuilt from heat detections rather than mapped on imagery.
  • Dates from the perimeter: the VIIRS detections inside it did not change them. 650 Suomi-NPP VIIRS detections on those dates.
  • We have not matched this page with any official record.
  • Weather: Copernicus ERA5 reanalysis at the fire location, in cells of about 25 km.
  • Built-up area and population come from the JRC Global Human Settlement Layer (epoch 2020, 100 m cells), summed inside the perimeter: an estimate of what was there, not a damage count.

How we build fire pages: methodology

Where this data comes from

The perimeter comes from the Copernicus Global Wildfire Information System (GWIS), which rebuilds it from MODIS and VIIRS heat detections and publishes it under CC BY 4.0. It is not measured on imagery as in Europe, so it is an estimate. Heat detections come from the VIIRS sensors aboard Suomi-NPP and NOAA-20, distributed by NASA FIRMS at 375 m resolution. Municipal boundaries come from geoBoundaries ADM2 (Creative Commons Attribution 4.0 International (CC BY 4.0)). The area per municipality is computed by WorldFires by crossing the perimeter with those boundaries, so it may differ from each country’s official figure.