Skip to content
worldfires
PT · Portugal · →

Montalegre fire, September 2016 Chã, Meixedo e Padornelos

Out · last detection 28 Sept 2016, 14:01 UTC

The fire started on 28 September 2016 in Chã, Portugal, and satellites saw it burning for 4 days. Copernicus mapped a burnt perimeter of 147 hectares from satellite imagery, spread across 2 municipalities. According to ICNF, the largest of the 2 recorded fires was detected on 28 September 2016 at 14:17 and declared extinguished on 28 September 2016.

It is the 39th largest in Montalegre since 2016 (of 57 with a page). Number 143 in Portugal in 2016, of 179.

The power measured by the satellite is low (18.5 MW in the strongest hotspot), more typical of grass or stubble burning, or a slow surface fire, than of a large crown fire.

Compare with…
Burnt area
147ha
Copernicus perimeter
Duration
4days
28 Sept 2016 – 1 Oct 2016
Municipalities hit
2
freguesias
Started on
28 Sept
2016
Heat detections
2
in a single hotspot: 19 MW
Danger at start
9
Low · FWI index
Average daily power
30MW
detected power per day, on average

Where it burned

HOTSPOTS BY DAY 28 Sept1 Oct

How it evolved, day by day

28 Sept 2016 · 30 MW · 2

Fire radiative power detected each day, in megawatts, and number of hotspots. The magenta bar marks the peak day.

The weather it burned in

15°high
26km/h · peak gust
46%lowest humidity

It had gone 0 days without rain (1 mm or more) when it started. Rain came after the fire: 8.2 mm on 11 Oct.

This area had burned before

No earlier perimeters overlap this fire since 2016, when the satellite record begins.

What happened to each town

  1. Chã 701 inhabitants · 5.2 km from the centre where it started
    135 ha reached on 28 Sept
    2.6 %
  2. Meixedo e Padornelos 265 inhabitants · 5.0 km from the centre
    12 ha
    0.3 %

Burnt area inside each municipality, from crossing the official perimeter with administrative boundaries. The distance runs from the point marking the centre of each area to the nearest fire: staying a kilometre away does not mean it reached the houses.

What burned

  • Other natural land64 %
  • Scrub and transitional woodland18 %
  • Agricultural areas18 %

Land cover inside the perimeter according to Corine Land Cover, as reported by Copernicus.

Official record

Complex of 2 fires according to ICNF

According to ICNF, 2 fires started inside this perimeter on these dates, totalling 129 ha (the satellite measured 147 ha).

ICNF records each fire that started at a different time or place separately; the satellite sees a single burned area, so this page groups them together. The numbers on the map show where each one started.

When each one burned

1 88 ha 2 41 ha
28 Sept1 Oct
negligence
  1. 1 Montalegre Chã 28 September 2016 · 14:17 88 ha · extinguished on 28 September 2016 · cause: negligence
  2. 2 Montalegre Meixedo 30 September 2016 · 15:20 41 ha · extinguished on 30 September 2016 · cause: negligence

Total according to ICNF: 129 ha, 88 % of the 147 ha in the satellite perimeter.

ICNF (Instituto da Conservação da Natureza e das Florestas). This is the agency’s operational record: its figures may be revised when the year’s statistics are closed.

The weather day by day

ECMWF ERA5 reanalysis at the fire location, the standard reference for past weather, and the Canadian Fire Weather Index (the same system Copernicus uses), computed by WorldFires from that data. Days after the fire run until the first rain.

Open-Meteo.com (CC BY 4.0) · Copernicus Climate Change Service (ERA5)

Day High Min. humidity Peak gust Rain Danger (FWI)
1 Oct 15.3 °C 46 % 26 km/h 0.0 mm Low 9
2 Oct after 16.6 °C 41 % 20 km/h 0.0 mm Low 9
3 Oct after 18.5 °C 36 % 29 km/h 0.0 mm Moderate 12
4 Oct after 18.1 °C 49 % 39 km/h 0.0 mm Moderate 14
5 Oct after 17.5 °C 45 % 20 km/h 0.0 mm Moderate 11
6 Oct after 20.2 °C 24 % 22 km/h 0.0 mm Moderate 16
7 Oct after 18.4 °C 24 % 28 km/h 0.0 mm Moderate 17
8 Oct after 19.4 °C 45 % 24 km/h 0.0 mm Moderate 14
9 Oct after 17.7 °C 44 % 28 km/h 0.0 mm Moderate 14
10 Oct after 16.9 °C 41 % 22 km/h 0.0 mm Moderate 14
11 Oct after 13.4 °C 63 % 39 km/h 8.2 mm Very low 0

Before and after, from space

Drag the line to compare the same ground before the fire and after it.

Before · 21 Sept 2016
After · 8 Oct 2016

If the day is cloudy, change the date: each satellite passes once a day. In false colour the burnt ground looks brown or red.

The smoke

CAMS · Copernicus

On 30 September 2016 the air beside the fire reached 11 µg/m³ of PM2.5, but no daily average passed the WHO guideline (15).

PM2.5 peak11 µg/m³
Days over the guideline0 days
PM1020 µg/m³
29301234
Good Fair Moderate Poor Very poor Extremely poor

Particles from the Copernicus CAMS model at the centre of the perimeter; these are not measurements in each town. The pale bar is the worst hour, the solid one the daily average.

Open-Meteo.com (CC BY 4.0) · Copernicus Atmosphere Monitoring Service (CAMS)

Detections table · 2Every satellite heat detection, one by one, with time, satellite, power and coordinates.
⬇ Download CSV Times in UTC. Each detection is a 375 m pixel: a large fire yields hundreds per pass.
Date and timeSatelliteFRP (MW)LatLon

Other fires nearby

All fires in Portugal ›

Frequently asked questions

How long did the Montalegre fire last?
According to the heat detections seen by satellite inside the perimeter, it burned from 28 September 2016 to 1 October 2016 (4 days). The perimeter dates it from 1 October 2016 to 1 October 2016. According to ICNF, the largest of the 2 recorded fires was detected on 28 September 2016 at 14:17 and declared extinguished on 28 September 2016.
How much area did it burn?
The perimeter Copernicus measured from satellite imagery is 147 hectares (1.5 km²). Official national figures may differ.
Which municipalities burned?
The fire entered 2 municipalities: Chã (135 ha, 2.6 %); Meixedo e Padornelos (12 ha, 0.3 %).
Did the fire reach a town?
The fire came within 5.0 km of the centre of Meixedo e Padornelos, the closest of the areas it touched. That is the distance from the perimeter, or the nearest hotspot, to the point marking the centre; it does not mean it entered the houses.
What was the weather like?
During the fire the temperature reached 15.3 °C, humidity dropped to 46 % and gusts hit 26 km/h. The fire danger index (FWI) reached 9, class Low.
Where does this data come from?
From the EFFIS (Copernicus) burnt perimeter, NASA FIRMS VIIRS hotspots and the administrative boundaries of Portugal (geoBoundaries). It is not an official report.

Where to verify it

A satellite detection is not an official report. Final figures and the fire’s status are published by each country’s emergency service.

Emergency number: 112 · Emergency number and official warnings ›

Satellite cross-check

History of this page Changes in area, dates, name, official record or merged pages, compared every night since 24 October 2026.

No changes since 24 October 2026.

RSS Changes to this page

Does something look wrong on this page?

This page is built from satellite data and official records, and it sometimes gets things wrong: the wrong dates, the wrong town, two fires merged into one, or something that was not a wildfire at all. If you know this fire first-hand (you live nearby, saw it, fought it or reported on it), tell us what really happened and we will check it.

Report an error
What do you think is wrong?

We will only use your email to reply about this report. Privacy. This is not an emergency service: if there is a fire now, call 112.

How we know this
  • Perimeter: EFFIS (Copernicus), mapped on satellite imagery.
  • Dates adjusted with the VIIRS detections inside the perimeter, which said 1 October 2016 to 1 October 2016. 2 Suomi-NPP VIIRS detections on those dates.
  • Compared with ICNF: 129 official ha against 147 ha of perimeter; they agree within 25%.
  • Weather: Copernicus ERA5 reanalysis at the fire location, in cells of about 25 km.

How we build fire pages: methodology ›

Where this data comes from

The perimeter and land cover come from the Copernicus European Forest Fire Information System (EFFIS), measured on MODIS and Sentinel-2 imagery and published under CC BY 4.0. Heat detections come from the VIIRS sensors aboard Suomi-NPP and NOAA-20, distributed by NASA FIRMS at 375 m resolution. Municipal boundaries come from geoBoundaries ADM3 (CC0 1.0 Universal (CC0 1.0) Public Domain Dedication). The area per municipality is computed by WorldFires by crossing the perimeter with those boundaries, so it may differ slightly from each country’s official figure.