Skip to content
worldfires
IT · Italy · –

Moio Alcantara fire, August 2021 Moio Alcantara, Roccella Valdemone, Malvagna

Out · last detection 5 Aug 2021, 00:32 UTC

The fire started on 1 August 2021 in Moio Alcantara, Italy, and satellites saw it burning for 5 days. Copernicus mapped a burnt perimeter of 304 hectares from satellite imagery, spread across 3 municipalities.

It is the 21th largest in Messina since 2016 (of 70 with a page). Number 91 in Italy in 2021, of 291.

The power measured by the satellite is low (6.4 MW in the strongest hotspot), more typical of grass or stubble burning, or a slow surface fire, than of a large crown fire.

Burnt area
304ha
Copernicus perimeter
Duration
5days
1 Aug 2021 – 5 Aug 2021
Municipalities hit
3
municipalities
Started on
1 Aug
2021
Heat detections
4
in a single hotspot: 6 MW
Danger at start
32
High · FWI index
Average daily power
21MW
detected power per day, on average

Where it burned

HOTSPOTS BY DAY 1 Aug5 Aug

How it evolved, day by day

5 Aug 2021 · 21 MW · 4

Fire radiative power detected each day, in megawatts, and number of hotspots. The magenta bar marks the peak day.

The weather it burned in

36°high
39km/h · peak gust
20%lowest humidity

It had gone 13 days without rain (1 mm or more) when it started.

This area had burned before

No earlier perimeters overlap this fire since 2016, when the satellite record begins.

What happened to each town

  1. Moio Alcantara 677 inhabitants · 1.4 km from the centre where it started
    241 ha reached on 5 Aug
    28 %
  2. Roccella Valdemone 852 inhabitants · 5.7 km from the centre
    47 ha reached on 5 Aug
    1.2 %
  3. Malvagna 629 inhabitants · 0.5 km from the centre
    16 ha
    2.4 %

Burnt area inside each municipality, from crossing the official perimeter with administrative boundaries. The distance runs from the point marking the centre of each area to the nearest fire: staying a kilometre away does not mean it reached the houses.

What burned

  • Other natural land65 %
  • Agricultural areas34 %
  • Broadleaved forest0.7 %

Natura 2000 protected area affected: 6 %

Natura 2000 sites (European Environment Agency, 2024 release) crossed by the perimeter.

Land cover inside the perimeter according to Corine Land Cover, as reported by Copernicus.

People and buildings inside the perimeter

GHSL 2020
Built-up area0.13 ha
Residents< 20

Inside the perimeter there were about 0.13 hectares of built-up land and almost nobody lived there (GHSL 2020, satellite-based estimate).

This is an estimate on 100 m cells, made from satellite imagery and census data: it does not mean that homes burned or that anyone was harmed. The perimeter also contains land that never burned.

Source: Global Human Settlement Layer (GHS-BUILT-S and GHS-POP R2023A), European Commission Joint Research Centre (JRC), © European Union, CC BY 4.0. Sum inside the perimeter computed by WorldFires. human-settlement.emergency.copernicus.eu

The weather day by day

ECMWF ERA5 reanalysis at the fire location, the standard reference for past weather, and the Canadian Fire Weather Index (the same system Copernicus uses), computed by WorldFires from that data. Days after the fire run until the first rain.

Open-Meteo.com (CC BY 4.0) · Copernicus Climate Change Service (ERA5)

Day High Min. humidity Peak gust Rain Danger (FWI)
1 Aug 35.7 °C 21 % 30 km/h 0.7 mm High 32
2 Aug 29.4 °C 46 % 31 km/h 0.0 mm High 23
3 Aug 29.3 °C 47 % 27 km/h 0.4 mm High 23
4 Aug 35.6 °C 20 % 31 km/h 0.0 mm High 33
5 Aug 28.1 °C 35 % 39 km/h 0.0 mm High 31
6 Aug after 26.4 °C 37 % 45 km/h 0.0 mm High 30
7 Aug after 29.0 °C 35 % 27 km/h 0.0 mm High 26
8 Aug after 32.3 °C 30 % 29 km/h 0.0 mm High 26
9 Aug after 31.9 °C 38 % 25 km/h 0.0 mm High 27
10 Aug after 34.9 °C 23 % 23 km/h 0.3 mm High 31
11 Aug after 34.8 °C 24 % 44 km/h 0.0 mm High 37
12 Aug after 31.0 °C 39 % 31 km/h 0.0 mm High 29
13 Aug after 30.6 °C 36 % 30 km/h 0.0 mm High 29
14 Aug after 29.2 °C 43 % 26 km/h 0.0 mm High 24
15 Aug after 28.9 °C 38 % 26 km/h 0.0 mm High 25

Its twins: fires that started in the same weather

It started with an FWI of 32.0, a minimum humidity of 21% and 13 days without rain. Fires in the area that started in weather like this since 2016: 19.

FWI at the start 32.0
Minimum humidity 21 %
Days without rain 13
this fire chosen twins rest of the area
Almost identicalSimilar

Outlines of the closest twins

Bronte fire, August 2017
522 ha 1 day FWI 32.0 Min. humidity 22 % 18 km away, in 2017

First rain (1 mm or more) after it ended: none in the following ten days.

What happened to them

2 days
median duration
220 ha
median area
0 %
went past 1,000 ha
2.8 mm
rain at the end (median; 10 of 19 had it)

It burned an area similar to its twins (304 ha against a median of 220 ha) and lasted 5 days, against 2 days.

In 9 of 19, not even 1 mm fell in the ten days after the end: they went out without rain. In the rest, the first rainy day brought a median of 2.8 mm.

This is a bank of analogues: it shows what usually happens, not what will happen. With fewer than 15 twins we give no figures. How we calculate it

How it ended

—first rain
—no rain in ten days
39km/h · max. gust

It was considered over on 5 Aug, and not even 1 mm fell in the following ten days: it went out without rain. Twins with rain when they ended: 10 of 19, with a median of 2.8 mm.

Weather on this page: Open-Meteo.com (CC BY 4.0) · Copernicus Climate Change Service (ERA5)

How a twin is chosen

  • Same area: fires that have already ended, less than 250 km from this one, since 2016.
  • Same start: we compare the FWI on the first day, the minimum humidity that day and the run of days without rain before it. The slider sets how much they may differ.
  • Only pages with final weather data (ERA5 reanalysis) calculated in the same way as this fire’s; agricultural and grass burns and pages with data under review are left out.
  • Fires burning at the same time as this one (a week before or after) are left out: they share the same spell of weather and do not count as a precedent.
  • They are sorted by similarity, and the outlines of the first five are drawn.

How we calculate it

Before and after, from space

Drag the line to compare the same ground before the fire and after it.

Before · 25 Jul 2021
After · 12 Aug 2021

If the day is cloudy, change the date: each satellite passes once a day. In false colour the burnt ground looks brown or red.

The smoke

CAMS · Copernicus

On 5 August 2021 the air beside the fire reached 29 µg/m³ of PM2.5. That day averaged 22: 1.5 times the WHO daily guideline (15).

PM2.5 peak29 µg/m³
Days over the guideline6 days
PM1054 µg/m³
31 Jul2 Aug4 Aug6 Aug8 Aug
Good Fair Moderate Poor Very poor Extremely poor

Particles from the Copernicus CAMS model at the centre of the perimeter; these are not measurements in each town. The pale bar is the worst hour, the solid one the daily average.

Open-Meteo.com (CC BY 4.0) · Copernicus Atmosphere Monitoring Service (CAMS)

Detections table · 4Every satellite heat detection, one by one, with time, satellite, power and coordinates.
⬇ Download CSV Times in UTC. Each detection is a 375 m pixel: a large fire yields hundreds per pass.
Date and timeSatelliteFRP (MW)LatLon

Other fires nearby

All fires in Italy

Frequently asked questions

How long did the Moio Alcantara fire last?
According to the heat detections seen by satellite inside the perimeter, it burned from 1 August 2021 to 5 August 2021 (5 days). The perimeter dates it from 2 August 2021 to 5 August 2021.
How much area did it burn?
The perimeter Copernicus measured from satellite imagery is 304 hectares (3.0 km²). Official national figures may differ.
Which municipalities burned?
The fire entered 3 municipalities: Moio Alcantara (241 ha, 28 %); Roccella Valdemone (47 ha, 1.2 %); Malvagna (16 ha, 2.4 %).
Did the fire reach a town?
The fire came within 0.5 km of the centre of Malvagna, the closest of the areas it touched. That is the distance from the perimeter, or the nearest hotspot, to the point marking the centre; it does not mean it entered the houses.
What was the weather like?
During the fire the temperature reached 35.7 °C, humidity dropped to 20 % and gusts hit 39 km/h. The fire danger index (FWI) reached 33, class High.
Where does this data come from?
From the EFFIS (Copernicus) burnt perimeter, NASA FIRMS VIIRS hotspots and the administrative boundaries of Italy (geoBoundaries). It is not an official report.
How did the fires that started in similar weather in this area end?
Fires less than 250 km away that started since 2016 with a similar FWI, humidity and dry spell: 19. Their median duration was 2 days and their median area 220 ha; 0 % went past 1,000 ha. In 9 of 19, not even 1 mm fell in the ten days after the end: they went out without rain. In the rest, the first rainy day brought a median of 2.8 mm.

Where to verify it

A satellite detection is not an official report. Final figures and the fire’s status are published by each country’s emergency service.

Emergency number: 112 · 1515 · Emergency number and official warnings

Satellite cross-check

History of this page Changes in area, dates, name, official record or merged pages, compared every night since 24 October 2026.

Does something look wrong on this page?

This page is built from satellite data and official records, and it sometimes gets things wrong: the wrong dates, the wrong town, two fires merged into one, or something that was not a wildfire at all. If you know this fire first-hand (you live nearby, saw it, fought it or reported on it), tell us what really happened and we will check it.

Report an error
What do you think is wrong?

We will only use your email to reply about this report. Privacy. This is not an emergency service: if there is a fire now, call 112 · 1515.

How we know this
  • Perimeter: EFFIS (Copernicus), mapped on satellite imagery.
  • Dates adjusted with the VIIRS detections inside the perimeter, which said 2 August 2021 to 5 August 2021. 4 Suomi-NPP VIIRS detections on those dates.
  • We have not matched this page with any official record.
  • Weather: Copernicus ERA5 reanalysis at the fire location, in cells of about 25 km.
  • Built-up area and population come from the JRC Global Human Settlement Layer (epoch 2020, 100 m cells), summed inside the perimeter: an estimate of what was there, not a damage count.

How we build fire pages: methodology

Where this data comes from

The perimeter and land cover come from the Copernicus European Forest Fire Information System (EFFIS), measured on MODIS and Sentinel-2 imagery and published under CC BY 4.0. Heat detections come from the VIIRS sensors aboard Suomi-NPP and NOAA-20, distributed by NASA FIRMS at 375 m resolution. Municipal boundaries come from geoBoundaries ADM4 (Creative Commons Attribution 3.0 License). The area per municipality is computed by WorldFires by crossing the perimeter with those boundaries, so it may differ slightly from each country’s official figure.