Skip to content
worldfires
IT · Italy · –

Casteltermini fire, 10 October 2023 Casteltermini

Out · last detection 11 Oct 2023, 01:28 UTC

The fire started on 10 October 2023 in Casteltermini, Italy, and satellites saw it burning for 6 days. Copernicus mapped a burnt perimeter of 369 hectares from satellite imagery, spread across a single municipality.

It is the 51th largest in Agrigento since 2016 (of 289 with a page). Number 53 in Italy in 2023, of 207.

The power measured by the satellite is low (1.9 MW in the strongest hotspot), more typical of grass or stubble burning, or a slow surface fire, than of a large crown fire.

Compare with…
Burnt area
369ha
Copernicus perimeter
Duration
6days
10 Oct 2023 – 15 Oct 2023
Municipalities hit
1
municipalities
Started on
10 Oct
2023
Heat detections
5
in a single hotspot: 2 MW
Danger at start
32
High · FWI index
Average daily power
3MW
detected power per day, on average

Where it burned

HOTSPOTS BY DAY 10 Oct15 Oct
11 Oct 2023

How it evolved, day by day

10 Oct 2023 · 4 MW · 2 11 Oct 2023 · 2 MW · 3
10 Oct 11 Oct

Fire radiative power detected each day, in megawatts, and number of hotspots. The magenta bar marks the peak day.

The weather it burned in

31°high
28km/h · peak gust
23%lowest humidity

It had gone 13 days without rain (1 mm or more) when it started. Rain came after the fire: 1.0 mm on 17 Oct.

This area had burned before

65% of the perimeter overlaps earlier fires recorded since 2016: 223 ha in 2019, 178 ha in 2021, 15 ha in 2022. Part of it burned more than once, so the yearly figures add up to more than the 241 ha that had burned before.

What happened to each town

  1. Casteltermini 7,269 inhabitants · 3.1 km from the centre where it started
    370 ha reached on 10 Oct
    3.7 %

Burnt area inside each municipality, from crossing the official perimeter with administrative boundaries. The distance runs from the point marking the centre of each area to the nearest fire: staying a kilometre away does not mean it reached the houses.

What burned

  • Other natural land62 %
  • Agricultural areas34 %
  • Artificial surfaces3.3 %

Land cover inside the perimeter according to Corine Land Cover, as reported by Copernicus.

People and buildings inside the perimeter

GHSL 2025
Built-up area0.87 ha
Residents< 20

Inside the perimeter there were about 0.87 hectares of built-up land and almost nobody lived there (GHSL 2025, satellite-based estimate).

This is an estimate on 100 m cells, made from satellite imagery and census data: it does not mean that homes burned or that anyone was harmed. The perimeter also contains land that never burned. The GHSL 2025 epoch is a projection made from 2020 and earlier data.

Source: Global Human Settlement Layer (GHS-BUILT-S and GHS-POP R2023A), European Commission Joint Research Centre (JRC), © European Union, CC BY 4.0. Sum inside the perimeter computed by WorldFires. human-settlement.emergency.copernicus.eu

The weather day by day

ECMWF ERA5 reanalysis at the fire location, the standard reference for past weather, and the Canadian Fire Weather Index (the same system Copernicus uses), computed by WorldFires from that data. Days after the fire run until the first rain.

Open-Meteo.com (CC BY 4.0) · Copernicus Climate Change Service (ERA5)

Day High Min. humidity Peak gust Rain Danger (FWI)
10 Oct 30.7 °C 23 % 28 km/h 0.0 mm High 32
11 Oct 29.3 °C 26 % 27 km/h 0.0 mm High 33
12 Oct 28.2 °C 34 % 24 km/h 0.1 mm High 29
13 Oct 28.3 °C 35 % 28 km/h 0.0 mm High 30
14 Oct 29.3 °C 20 % 28 km/h 0.0 mm High 32
15 Oct 29.0 °C 21 % 41 km/h 0.0 mm Very high 40
16 Oct after 25.5 °C 46 % 37 km/h 0.0 mm High 28
17 Oct after 26.1 °C 50 % 42 km/h 1.0 mm Moderate 17

Before and after, from space

Drag the line to compare the same ground before the fire and after it.

Before · 3 Oct 2023
After · 22 Oct 2023

If the day is cloudy, change the date: each satellite passes once a day. In false colour the burnt ground looks brown or red.

The smoke

CAMS · Copernicus

On 12 October 2023 the air beside the fire reached 24 µg/m³ of PM2.5. That day averaged 17: 1.2 times the WHO daily guideline (15).

PM2.5 peak24 µg/m³
Days over the guideline1 day
PM1040 µg/m³
Optical depth0.17
8 Oct10 Oct12 Oct14 Oct
Good Fair Moderate Poor Very poor Extremely poor

Particles from the Copernicus CAMS model at the centre of the perimeter; these are not measurements in each town. The pale bar is the worst hour, the solid one the daily average.

Open-Meteo.com (CC BY 4.0) · Copernicus Atmosphere Monitoring Service (CAMS)

Detections table · 5Every satellite heat detection, one by one, with time, satellite, power and coordinates.
⬇ Download CSV Times in UTC. Each detection is a 375 m pixel: a large fire yields hundreds per pass.
Date and timeSatelliteFRP (MW)LatLon

Other fires nearby

All fires in Italy

Frequently asked questions

How long did the Casteltermini fire last?
According to the heat detections seen by satellite inside the perimeter, it burned from 10 October 2023 to 15 October 2023 (6 days). The perimeter dates it from 10 October 2023 to 12 October 2023.
How much area did it burn?
The perimeter Copernicus measured from satellite imagery is 369 hectares (3.7 km²). Official national figures may differ.
Which municipalities burned?
The fire only entered Casteltermini (370 ha, 3.7 %).
Did the fire reach a town?
The fire started in Casteltermini and came within 3.1 km of its centre. That is the distance from the perimeter, or the nearest hotspot, to the point marking the centre; it does not mean it entered the houses.
What was the weather like?
During the fire the temperature reached 30.7 °C, humidity dropped to 23 % and gusts hit 28 km/h. The fire danger index (FWI) reached 33, class High.
Where does this data come from?
From the EFFIS (Copernicus) burnt perimeter, NASA FIRMS VIIRS hotspots and the administrative boundaries of Italy (geoBoundaries). It is not an official report.

Where to verify it

A satellite detection is not an official report. Final figures and the fire’s status are published by each country’s emergency service.

Emergency number: 112 · 1515 · Emergency number and official warnings

Satellite cross-check

History of this page Changes in area, dates, name, official record or merged pages, compared every night since 24 October 2026.

No changes since 24 October 2026.

RSS Changes to this page

Does something look wrong on this page?

This page is built from satellite data and official records, and it sometimes gets things wrong: the wrong dates, the wrong town, two fires merged into one, or something that was not a wildfire at all. If you know this fire first-hand (you live nearby, saw it, fought it or reported on it), tell us what really happened and we will check it.

Report an error
What do you think is wrong?

We will only use your email to reply about this report. Privacy. This is not an emergency service: if there is a fire now, call 112 · 1515.

How we know this
  • Perimeter: EFFIS (Copernicus), mapped on satellite imagery.
  • Dates adjusted with the VIIRS detections inside the perimeter, which said 10 October 2023 to 12 October 2023. 5 Suomi-NPP VIIRS detections on those dates.
  • We have not matched this page with any official record.
  • Weather: Copernicus ERA5 reanalysis at the fire location, in cells of about 25 km.
  • Built-up area and population come from the JRC Global Human Settlement Layer (epoch 2025, 100 m cells), summed inside the perimeter: an estimate of what was there, not a damage count.

How we build fire pages: methodology

Where this data comes from

The perimeter and land cover come from the Copernicus European Forest Fire Information System (EFFIS), measured on MODIS and Sentinel-2 imagery and published under CC BY 4.0. Heat detections come from the VIIRS sensors aboard Suomi-NPP and NOAA-20, distributed by NASA FIRMS at 375 m resolution. Municipal boundaries come from geoBoundaries ADM4 (Creative Commons Attribution 3.0 License). The area per municipality is computed by WorldFires by crossing the perimeter with those boundaries, so it may differ slightly from each country’s official figure.