Skip to content
worldfires
TN · Tunisia · →

ماطر fire, August 2026 ماطر, غزالة

Out · last detection 28 Aug 2026, 01:15 UTC

The fire started on 27 August 2026 in ماطر, Tunisia, and satellites saw it burning for 2 days. Copernicus mapped a burnt perimeter of 110 hectares from satellite imagery, spread across 2 municipalities.

It is the 37th largest in Bizerte since 2016 (of 39 with a page). Number 32 in Tunisia in 2026, of 36.

The power measured by the satellite is low (7.7 MW in the strongest hotspot), more typical of grass or stubble burning, or a slow surface fire, than of a large crown fire.

Burnt area
110ha
Copernicus perimeter
Duration
2days
27 Aug 2026 – 28 Aug 2026
Municipalities hit
2
delegations
Started on
27 Aug
2026
Heat detections
5
in a single hotspot: 8 MW
Danger at start
51
Extreme · FWI index
Energy released
27MW
sum of detected power

Where it burned

HOTSPOTS BY DAY 27 Aug28 Aug

How it evolved, day by day

28

Fire radiative power detected each day, in megawatts, and number of hotspots. The magenta bar marks the peak day.

The weather it burned in

45°high
36km/h · peak gust
13%lowest humidity

It had gone 11 days without rain (1 mm or more) when it started.

This area had burned before

85% of the perimeter overlaps earlier fires recorded since 2016: 92 ha in 2020, 6 ha in 2022, 10 ha in 2023. Part of it burned more than once, so the yearly figures add up to more than the 93 ha that had burned before.

What happened to each town

  1. ماطر where it started
    110 ha reached on 28 Aug
    0.2 %
  2. 0 ha
    0.0 %

Burnt area inside each municipality, from crossing the official perimeter with administrative boundaries. The distance is from the town centre to the nearest fire: staying a kilometre away does not mean it reached the houses.

What burned

  • Sclerophyllous scrub68 %
  • Agricultural areas32 %

Land cover inside the perimeter as reported by Copernicus EFFIS (outside the Corine Land Cover area).

The weather day by day

ECMWF ERA5 reanalysis at the fire location, the standard reference for past weather, and the Canadian Fire Weather Index (the same system Copernicus uses), computed by WorldFires from that data. Days after the fire run until the first rain.

Open-Meteo.com (CC BY 4.0) · Copernicus Climate Change Service (ERA5)

Day High Min. humidity Peak gust Rain Danger (FWI)
27 Aug 44.9 °C 13 % 26 km/h 0.0 mm Extreme 51
28 Aug 37.3 °C 41 % 36 km/h 0.0 mm High 37
29 Aug after 39.4 °C 24 % 38 km/h 0.3 mm Very high 48
30 Aug after 34.4 °C 45 % 27 km/h 0.0 mm High 31
31 Aug after 35.0 °C 40 % 31 km/h 0.0 mm High 33
1 Sept after 35.6 °C 33 % 26 km/h 0.0 mm High 31
2 Sept after 36.9 °C 31 % 27 km/h 0.0 mm High 33
3 Sept after 33.1 °C 41 % 40 km/h 0.0 mm High 36
4 Sept after 31.8 °C 44 % 33 km/h 0.0 mm High 32
5 Sept after 32.9 °C 40 % 26 km/h 0.0 mm High 29
6 Sept after 33.4 °C 37 % 23 km/h 0.0 mm High 28
7 Sept after 33.8 °C 44 % 34 km/h 0.0 mm High 32

Before and after, from space

Drag the line to compare the same ground before the fire and after it.

Before · 20 Aug 2026
After · 4 Sept 2026

If the day is cloudy, change the date: each satellite passes once a day. In false colour the burnt ground looks brown or red.

The smoke

CAMS · Copernicus

On 30 August 2026 the air beside the fire reached 100 µg/m³ of PM2.5. That day averaged 48: 3.2 times the WHO daily guideline (15).

PM2.5 peak100 µg/m³
Days over the guideline6 days
PM10155 µg/m³
Optical depth1.05
25262728293031
Good Fair Moderate Poor Very poor Extremely poor

Particles from the Copernicus CAMS model at the centre of the perimeter; these are not measurements in each town. The pale bar is the worst hour, the solid one the daily average.

Open-Meteo.com (CC BY 4.0) · Copernicus Atmosphere Monitoring Service (CAMS)

Detections table · 5Every satellite heat detection, one by one, with time, satellite, power and coordinates.
⬇ Download CSV Times in UTC. Each detection is a 375 m pixel: a large fire yields hundreds per pass.
Date and timeSatelliteFRP (MW)LatLon

Other fires nearby

All fires in Tunisia ›

Frequently asked questions

How long did the ماطر fire last?
According to the heat detections seen by satellite inside the perimeter, it burned from 27 August 2026 to 28 August 2026 (2 days). The perimeter dates it from 27 August 2026 to 27 August 2026.
How much area did it burn?
The perimeter Copernicus measured from satellite imagery is 110 hectares (1.1 km²). Official national figures may differ.
Which municipalities burned?
The fire entered 2 municipalities: ماطر (110 ha, 0.2 %); غزالة (0 ha, 0.0 %).
What was the weather like?
During the fire the temperature reached 44.9 °C, humidity dropped to 13 % and gusts hit 36 km/h. The fire danger index (FWI) reached 51, class Extreme.
Where does this data come from?
From the EFFIS (Copernicus) burnt perimeter, NASA FIRMS VIIRS hotspots and the administrative boundaries of Tunisia (geoBoundaries). It is not an official report.

Where to verify it

A satellite detection is not an official report. Final figures and the fire’s status are published by each country’s emergency service.

Emergency number: 198

Satellite cross-check

Does something look wrong on this page?

This page is built from satellite data and official records, and it sometimes gets things wrong: the wrong dates, the wrong town, two fires merged into one, or something that was not a wildfire at all. If you know this fire first-hand (you live nearby, saw it, fought it or reported on it), tell us what really happened and we will check it.

Report an error
What do you think is wrong?

We will only use your email to reply about this report. Privacy. This is not an emergency service: if there is a fire now, call 198.

Where this data comes from

The perimeter and land cover come from the Copernicus European Forest Fire Information System (EFFIS), measured on MODIS and Sentinel-2 imagery and published under CC BY 4.0. Heat detections come from the VIIRS sensors aboard Suomi-NPP and NOAA-20, distributed by NASA FIRMS at 375 m resolution. Municipal boundaries come from geoBoundaries ADM2 (Open Data Commons Open Database License 1.0). The area per municipality is computed by WorldFires by crossing the perimeter with those boundaries, so it may differ slightly from each country’s official figure.