Skip to content
worldfires
MA · Morocco · →

Fahs-Anjra fire, September 2016 إقليم الفحص أنجرة · Fahs-Anjra

Out · last detection 6 Sept 2016, 14:11 UTC

The fire started on 5 September 2016 in Fahs-Anjra, Morocco, and satellites saw it burning for 2 days. Copernicus mapped a burnt perimeter of 161 hectares from satellite imagery, spread across a single municipality.

It is the 42th largest in Tangier-Tetouan-Al Hoceima since 2016 (of 53 with a page). Number 8 in Morocco in 2016, of 12.

The power measured by the satellite is low (22.0 MW in the strongest hotspot), more typical of grass or stubble burning, or a slow surface fire, than of a large crown fire.

Compare with…
Burnt area
161ha
Copernicus perimeter
Duration
2days
5 Sept 2016 – 6 Sept 2016
Municipalities hit
1
provinces
Started on
5 Sept
2016
Heat detections
16
in a single hotspot: 22 MW
Danger at start
29
High · FWI index
Average daily power
194MW
detected power per day, on average

Where it burned

HOTSPOTS BY DAY 5 Sept6 Sept

How it evolved, day by day

6 Sept 2016 · 194 MW · 16

Fire radiative power detected each day, in megawatts, and number of hotspots. The magenta bar marks the peak day.

The weather it burned in

32°high
37km/h · peak gust
34%lowest humidity

It had gone more than two months without rain (1 mm or more) when it started.

This area had burned before

No earlier perimeters overlap this fire since 2016, when the satellite record begins.

What happened to each town

  1. Fahs-Anjra إقليم الفحص أنجرة 100,789 inhabitants · 26.0 km from the centre where it started
    162 ha reached on 6 Sept
    0.2 %

Burnt area inside each municipality, from crossing the official perimeter with administrative boundaries. The distance runs from the point marking the centre of each area to the nearest fire: staying a kilometre away does not mean it reached the houses.

What burned

  • Scrub and transitional woodland70 %
  • Agricultural areas19 %
  • Broadleaved forest8.2 %
  • Coniferous forest3.2 %

Land cover inside the perimeter as reported by Copernicus EFFIS (outside the Corine Land Cover area).

People and buildings inside the perimeter

GHSL 2015
Built-up area< 0.1 ha
Residents≈ 50

Inside the perimeter there were about 0.08 hectares of built-up land and about 50 residents (GHSL 2015, satellite-based estimate).

This is an estimate on 100 m cells, made from satellite imagery and census data: it does not mean that homes burned or that anyone was harmed. The perimeter also contains land that never burned.

Source: Global Human Settlement Layer (GHS-BUILT-S and GHS-POP R2023A), European Commission Joint Research Centre (JRC), © European Union, CC BY 4.0. Sum inside the perimeter computed by WorldFires. human-settlement.emergency.copernicus.eu

The weather day by day

ECMWF ERA5 reanalysis at the fire location, the standard reference for past weather, and the Canadian Fire Weather Index (the same system Copernicus uses), computed by WorldFires from that data. Days after the fire run until the first rain.

Open-Meteo.com (CC BY 4.0) · Copernicus Climate Change Service (ERA5)

Day High Min. humidity Peak gust Rain Danger (FWI)
5 Sept 31.0 °C 34 % 37 km/h 0.0 mm High 29
6 Sept 32.2 °C 38 % 29 km/h 0.0 mm High 25
7 Sept after 29.0 °C 51 % 37 km/h 0.0 mm High 28
8 Sept after 27.3 °C 45 % 44 km/h 0.0 mm High 30
9 Sept after 26.2 °C 38 % 37 km/h 0.0 mm High 27
10 Sept after 27.5 °C 44 % 36 km/h 0.0 mm High 28
11 Sept after 25.0 °C 59 % 38 km/h 0.0 mm High 24
12 Sept after 26.3 °C 67 % 37 km/h 0.2 mm Moderate 21
13 Sept after 25.2 °C 49 % 59 km/h 0.7 mm High 28
14 Sept after 21.8 °C 44 % 46 km/h 0.0 mm High 26
15 Sept after 22.7 °C 38 % 41 km/h 0.0 mm High 26
16 Sept after 24.2 °C 40 % 33 km/h 0.0 mm High 24

Before and after, from space

Drag the line to compare the same ground before the fire and after it.

Before · 29 Aug 2016
After · 13 Sept 2016

If the day is cloudy, change the date: each satellite passes once a day. In false colour the burnt ground looks brown or red.

The smoke

CAMS · Copernicus

On 6 September 2016 the air beside the fire reached 62 µg/m³ of PM2.5. That day averaged 42: 2.8 times the WHO daily guideline (15).

PM2.5 peak62 µg/m³
Days over the guideline6 days
PM1070 µg/m³
3456789
Good Fair Moderate Poor Very poor Extremely poor

Particles from the Copernicus CAMS model at the centre of the perimeter; these are not measurements in each town. The pale bar is the worst hour, the solid one the daily average.

Open-Meteo.com (CC BY 4.0) · Copernicus Atmosphere Monitoring Service (CAMS)

Detections table · 16Every satellite heat detection, one by one, with time, satellite, power and coordinates.
⬇ Download CSV Times in UTC. Each detection is a 375 m pixel: a large fire yields hundreds per pass.
Date and timeSatelliteFRP (MW)LatLon

Other fires nearby

All fires in Morocco ›

Frequently asked questions

How long did the Fahs-Anjra fire last?
Copernicus dates it between 5 September 2016 and 6 September 2016: 2 days between the first and last image with fire.
How much area did it burn?
The perimeter Copernicus measured from satellite imagery is 161 hectares (1.6 km²). Official national figures may differ.
Which municipalities burned?
The fire only entered Fahs-Anjra (162 ha, 0.2 %).
Did the fire reach a town?
The fire started in Fahs-Anjra and came within 26.0 km of its centre. That is the distance from the perimeter, or the nearest hotspot, to the point marking the centre; it does not mean it entered the houses.
What was the weather like?
During the fire the temperature reached 32.2 °C, humidity dropped to 34 % and gusts hit 37 km/h. The fire danger index (FWI) reached 29, class High.
Where does this data come from?
From the EFFIS (Copernicus) burnt perimeter, NASA FIRMS VIIRS hotspots and the administrative boundaries of Morocco (geoBoundaries). It is not an official report.

Where to verify it

A satellite detection is not an official report. Final figures and the fire’s status are published by each country’s emergency service.

Emergency number: 15 · 150 · Emergency number and official warnings ›

Satellite cross-check

History of this page Changes in area, dates, name, official record or merged pages, compared every night since 24 October 2026.

No changes since 24 October 2026.

RSS Changes to this page

Does something look wrong on this page?

This page is built from satellite data and official records, and it sometimes gets things wrong: the wrong dates, the wrong town, two fires merged into one, or something that was not a wildfire at all. If you know this fire first-hand (you live nearby, saw it, fought it or reported on it), tell us what really happened and we will check it.

Report an error
What do you think is wrong?

We will only use your email to reply about this report. Privacy. This is not an emergency service: if there is a fire now, call 15 · 150.

How we know this
  • Perimeter: EFFIS (Copernicus), mapped on satellite imagery.
  • Dates from the perimeter: the VIIRS detections inside it did not change them. 16 Suomi-NPP VIIRS detections on those dates.
  • We have not matched this page with any official record.
  • Weather: Copernicus ERA5 reanalysis at the fire location, in cells of about 25 km.
  • Built-up area and population come from the JRC Global Human Settlement Layer (epoch 2015, 100 m cells), summed inside the perimeter: an estimate of what was there, not a damage count.

How we build fire pages: methodology ›

Where this data comes from

The perimeter and land cover come from the Copernicus European Forest Fire Information System (EFFIS), measured on MODIS and Sentinel-2 imagery and published under CC BY 4.0. Heat detections come from the VIIRS sensors aboard Suomi-NPP and NOAA-20, distributed by NASA FIRMS at 375 m resolution. Municipal boundaries come from geoBoundaries ADM2 (Open Data Commons Open Database License 1.0). The area per municipality is computed by WorldFires by crossing the perimeter with those boundaries, so it may differ slightly from each country’s official figure.