Skip to content
worldfires
KE · Kenya · –

Isiolo South fire, 18 June 2019 Isiolo South

Out · last detection 23 Jun 2019, 10:14 UTC

The fire started on 18 June 2019 in Isiolo South, Kenya, and satellites saw it burning for 6 days. Copernicus’s global GWIS system rebuilt a burnt perimeter of 1,043 hectares from heat detections, spread across a single municipality.

It is the 25th largest in Isiolo since 2016 (of 26 with a page). Number 36 in Kenya in 2019, of 40.

The power measured by the satellite is low (10.3 MW in the strongest hotspot), more typical of grass or stubble burning, or a slow surface fire, than of a large crown fire.

Burnt area
1,043ha
GWIS perimeter (Copernicus)
Duration
6days
18 Jun 2019 – 23 Jun 2019
Municipalities hit
1
constituencies
Started on
18 Jun
2019
Heat detections
27
in a single hotspot: 10 MW
Danger at start
65
Extreme · FWI index
Average daily power
25MW
detected power per day, on average

Where it burned

HOTSPOTS BY DAY 18 Jun23 Jun
23 Jun 2019

How it evolved, day by day

18 Jun 2019 · 12 MW · 3 19 Jun 2019 · 45 MW · 8 21 Jun 2019 · 26 MW · 9 22 Jun 2019 · 36 MW · 5 23 Jun 2019 · 6 MW · 2
18 Jun 19 Jun 21 Jun 22 Jun 23 Jun

Fire radiative power detected each day, in megawatts, and number of hotspots. The magenta bar marks the peak day.

The weather it burned in

36°high
54km/h · peak gust
27%lowest humidity

It had gone 43 days without rain (1 mm or more) when it started.

This area had burned before

No earlier perimeters overlap this fire since 2016, when the satellite record begins.

How big is it?

10 km
It burned the equivalent of 0.7% of the area of London (10 km² against 1,583 km²).

London boundary: geoBoundaries · Office for National Statistics (Open Government Licence v3.0).

This compares size, not location: both shapes are at the same scale, north up, centred on each other.

What happened to each town

  1. Isiolo South where it started
    1,050 ha reached on 18 Jun
    0.1 %

Burnt area inside each municipality, from crossing the GWIS perimeter with administrative boundaries. The distance runs from the point marking the centre of each area to the nearest fire: staying a kilometre away does not mean it reached the houses.

People and buildings inside the perimeter

GHSL 2020
Built-up area< 0.1 ha
Residents< 20

Inside the perimeter there was no noticeable built-up land and almost nobody lived there (GHSL 2020, satellite-based estimate).

This is an estimate on 100 m cells, made from satellite imagery and census data: it does not mean that homes burned or that anyone was harmed. The perimeter also contains land that never burned.

Source: Global Human Settlement Layer (GHS-BUILT-S and GHS-POP R2023A), European Commission Joint Research Centre (JRC), © European Union, CC BY 4.0. Sum inside the perimeter computed by WorldFires. human-settlement.emergency.copernicus.eu

The weather day by day

ECMWF ERA5 reanalysis at the fire location, the standard reference for past weather, and the Canadian Fire Weather Index (the same system Copernicus uses), computed by WorldFires from that data. Days after the fire run until the first rain.

Open-Meteo.com (CC BY 4.0) · Copernicus Climate Change Service (ERA5)

Started with Extreme FWI: 30 % of the area in Kenya

Day High Min. humidity Peak gust Rain Danger (FWI)
18 Jun 34.5 °C 30 % 48 km/h 0.0 mm Extreme 65
19 Jun 36.1 °C 27 % 50 km/h 0.0 mm Extreme 68
20 Jun 33.5 °C 36 % 52 km/h 0.0 mm Extreme 68
21 Jun 33.5 °C 33 % 54 km/h 0.0 mm Very extreme 70
22 Jun 34.8 °C 29 % 46 km/h 0.0 mm Extreme 60
23 Jun 35.5 °C 27 % 46 km/h 0.0 mm Extreme 61
24 Jun after 35.8 °C 31 % 45 km/h 0.0 mm Extreme 59
25 Jun after 34.9 °C 31 % 50 km/h 0.0 mm Extreme 66
26 Jun after 34.6 °C 30 % 47 km/h 0.0 mm Extreme 60
27 Jun after 34.2 °C 33 % 55 km/h 0.0 mm Very extreme 73
28 Jun after 34.2 °C 31 % 53 km/h 0.0 mm Very extreme 71
29 Jun after 34.0 °C 30 % 51 km/h 0.0 mm Extreme 69
30 Jun after 35.9 °C 28 % 54 km/h 0.0 mm Very extreme 78
1 Jul after 35.9 °C 31 % 53 km/h 0.0 mm Extreme 70
2 Jul after 35.2 °C 28 % 44 km/h 0.0 mm Extreme 57
3 Jul after 34.6 °C 29 % 52 km/h 0.0 mm Very extreme 70

Its twins: fires that started in the same weather

It started with an FWI of 64.8, a minimum humidity of 30% and 43 days without rain. Fires in the area that started in weather like this since 2016: 8.

FWI at the start 64.8
Minimum humidity 30 %
Days without rain 43
this fire chosen twins rest of the area
Almost identicalSimilar

Outlines of the closest twins

Laisamis fire, September 2021
1,165 ha 4 days FWI 62.0 Min. humidity 30 % 95 km away, in 2021

First rain (1 mm or more) after it ended: none in the following ten days.

What happened to them

Fires in the area that started in similar weather: 8. With fewer than 15 we give no figures: they would be more noise than signal.

This is a bank of analogues: it shows what usually happens, not what will happen. With fewer than 15 twins we give no figures. How we calculate it

How it ended

—first rain
—no rain in ten days
54km/h · max. gust

It was considered over on 23 Jun, and not even 1 mm fell in the following ten days: it went out without rain.

Weather on this page: Open-Meteo.com (CC BY 4.0) · Copernicus Climate Change Service (ERA5)

How a twin is chosen

  • Same area: fires that have already ended, less than 250 km from this one, since 2016.
  • Same start: we compare the FWI on the first day, the minimum humidity that day and the run of days without rain before it. The slider sets how much they may differ.
  • Only pages with final weather data (ERA5 reanalysis) calculated in the same way as this fire’s; agricultural and grass burns and pages with data under review are left out.
  • Fires burning at the same time as this one (a week before or after) are left out: they share the same spell of weather and do not count as a precedent.
  • They are sorted by similarity, and the outlines of the first five are drawn.

How we calculate it

Before and after, from space

Drag the line to compare the same ground before the fire and after it.

Before · 11 Jun 2019
After · 30 Jun 2019

If the day is cloudy, change the date: each satellite passes once a day. In false colour the burnt ground looks brown or red.

Detections table · 27Every satellite heat detection, one by one, with time, satellite, power and coordinates.
⬇ Download CSV Times in UTC. Each detection is a 375 m pixel: a large fire yields hundreds per pass.
Date and timeSatelliteFRP (MW)LatLon

Other fires nearby

All fires in Kenya

Frequently asked questions

How long did the Isiolo South fire last?
GWIS (Copernicus) dates it between 18 June 2019 and 23 June 2019: 6 days between the first and last heat detection of the perimeter.
How much area did it burn?
The perimeter GWIS (Copernicus) rebuilt from heat detections is 1,043 hectares (10.4 km²). It is an estimate: official national figures may differ.
Which municipalities burned?
The fire only entered Isiolo South (1,050 ha, 0.1 %).
What was the weather like?
During the fire the temperature reached 36.1 °C, humidity dropped to 27 % and gusts hit 54 km/h. The fire danger index (FWI) reached 70, class Very extreme.
Where does this data come from?
From the GWIS (Copernicus) burnt perimeter, NASA FIRMS VIIRS hotspots and the administrative boundaries of Kenya (geoBoundaries). It is not an official report.

Where to verify it

A satellite detection is not an official report. Final figures and the fire’s status are published by each country’s emergency service.

Emergency number: 999 · 112 · Emergency number and official warnings

Satellite cross-check

History of this page Changes in area, dates, name, official record or merged pages, compared every night since 24 October 2026.

Does something look wrong on this page?

This page is built from satellite data and official records, and it sometimes gets things wrong: the wrong dates, the wrong town, two fires merged into one, or something that was not a wildfire at all. If you know this fire first-hand (you live nearby, saw it, fought it or reported on it), tell us what really happened and we will check it.

Report an error
What do you think is wrong?

We will only use your email to reply about this report. Privacy. This is not an emergency service: if there is a fire now, call 999 · 112.

How we know this
  • Perimeter: GWIS (Copernicus), rebuilt from heat detections rather than mapped on imagery.
  • Dates from the perimeter: the VIIRS detections inside it did not change them. 27 Suomi-NPP VIIRS detections on those dates.
  • We have not matched this page with any official record.
  • Weather: Copernicus ERA5 reanalysis at the fire location, in cells of about 25 km.
  • Built-up area and population come from the JRC Global Human Settlement Layer (epoch 2020, 100 m cells), summed inside the perimeter: an estimate of what was there, not a damage count.

How we build fire pages: methodology

Where this data comes from

The perimeter comes from the Copernicus Global Wildfire Information System (GWIS), which rebuilds it from MODIS and VIIRS heat detections and publishes it under CC BY 4.0. It is not measured on imagery as in Europe, so it is an estimate. Heat detections come from the VIIRS sensors aboard Suomi-NPP and NOAA-20, distributed by NASA FIRMS at 375 m resolution. Municipal boundaries come from geoBoundaries ADM2 (Creative Commons Attribution 3.0 Intergovernmental Organisations (CC BY 3.0 IGO)). The area per municipality is computed by WorldFires by crossing the perimeter with those boundaries, so it may differ from each country’s official figure.