Skip to content
worldfires
RO · Romania · →

Fârliug fire, 27 February 2019 Fârliug

Out · last detection 27 Feb 2019, 11:42 UTC

The fire started on 27 February 2019 in Fârliug, Romania, and satellites saw it burning for 3 days. Copernicus mapped a burnt perimeter of 162 hectares from satellite imagery, spread across a single municipality.

It is the 122th largest in Caraș-Severin since 2016 (of 196 with a page). Number 27 in Romania in 2019, of 37.

The power measured by the satellite is low (7.0 MW in the strongest hotspot), more typical of grass or stubble burning, or a slow surface fire, than of a large crown fire.

Compare with…
Burnt area
162ha
Copernicus perimeter
Duration
3days
27 Feb 2019 – 1 Mar 2019
Municipalities hit
1
municipalities
Started on
27 Feb
2019
Heat detections
2
in a single hotspot: 7 MW
Danger at start
1
Very low · FWI index
Average daily power
13MW
detected power per day, on average

Where it burned

HOTSPOTS BY DAY 27 Feb1 Mar

How it evolved, day by day

27 Feb 2019 · 13 MW · 2

Fire radiative power detected each day, in megawatts, and number of hotspots. The magenta bar marks the peak day.

The weather it burned in

10°high
36km/h · peak gust
43%lowest humidity

It had gone 4 days without rain (1 mm or more) when it started. Rain came after the fire: 1.3 mm on 1 Mar.

This area had burned before

No earlier perimeters overlap this fire since 2016, when the satellite record begins.

What happened to each town

  1. Fârliug where it started
    162 ha reached on 27 Feb
    1.2 %

Burnt area inside each municipality, from crossing the official perimeter with administrative boundaries. The distance runs from the point marking the centre of each area to the nearest fire: staying a kilometre away does not mean it reached the houses.

What burned

  • Agricultural areas75 %
  • Broadleaved forest18 %
  • Scrub and transitional woodland7.3 %

Land cover inside the perimeter according to Corine Land Cover, as reported by Copernicus.

The weather day by day

ECMWF ERA5 reanalysis at the fire location, the standard reference for past weather, and the Canadian Fire Weather Index (the same system Copernicus uses), computed by WorldFires from that data. Days after the fire run until the first rain.

Open-Meteo.com (CC BY 4.0) · Copernicus Climate Change Service (ERA5)

Day High Min. humidity Peak gust Rain Danger (FWI)
27 Feb 10.1 °C 43 % 36 km/h 0.0 mm Very low 1
28 Feb 14.4 °C 35 % 29 km/h 0.0 mm Very low 2
1 Mar 13.7 °C 47 % 33 km/h 1.3 mm Very low 1

Before and after, from space

Drag the line to compare the same ground before the fire and after it.

Before · 20 Feb 2019
After · 8 Mar 2019

If the day is cloudy, change the date: each satellite passes once a day. In false colour the burnt ground looks brown or red.

The smoke

CAMS · Copernicus

On 1 March 2019 the air beside the fire reached 40 µg/m³ of PM2.5. That day averaged 31: 2.1 times the WHO daily guideline (15).

PM2.5 peak40 µg/m³
Days over the guideline4 days
PM1051 µg/m³
2526272812
Good Fair Moderate Poor Very poor Extremely poor

Particles from the Copernicus CAMS model at the centre of the perimeter; these are not measurements in each town. The pale bar is the worst hour, the solid one the daily average.

Open-Meteo.com (CC BY 4.0) · Copernicus Atmosphere Monitoring Service (CAMS)

Detections table · 2Every satellite heat detection, one by one, with time, satellite, power and coordinates.
⬇ Download CSV Times in UTC. Each detection is a 375 m pixel: a large fire yields hundreds per pass.
Date and timeSatelliteFRP (MW)LatLon

Other fires nearby

All fires in Romania ›

Frequently asked questions

How long did the Fârliug fire last?
According to the heat detections seen by satellite inside the perimeter, it burned from 27 February 2019 to 1 March 2019 (3 days). The perimeter dates it from 27 February 2019 to 27 February 2019.
How much area did it burn?
The perimeter Copernicus measured from satellite imagery is 162 hectares (1.6 km²). Official national figures may differ.
Which municipalities burned?
The fire only entered Fârliug (162 ha, 1.2 %).
What was the weather like?
During the fire the temperature reached 10.1 °C, humidity dropped to 43 % and gusts hit 36 km/h. The fire danger index (FWI) reached 1, class Very low.
Where does this data come from?
From the EFFIS (Copernicus) burnt perimeter, NASA FIRMS VIIRS hotspots and the administrative boundaries of Romania (geoBoundaries). It is not an official report.

Where to verify it

A satellite detection is not an official report. Final figures and the fire’s status are published by each country’s emergency service.

Emergency number: 112 · Emergency number and official warnings ›

Satellite cross-check

History of this page Changes in area, dates, name, official record or merged pages, compared every night since 24 October 2026.

No changes since 24 October 2026.

RSS Changes to this page

Does something look wrong on this page?

This page is built from satellite data and official records, and it sometimes gets things wrong: the wrong dates, the wrong town, two fires merged into one, or something that was not a wildfire at all. If you know this fire first-hand (you live nearby, saw it, fought it or reported on it), tell us what really happened and we will check it.

Report an error
What do you think is wrong?

We will only use your email to reply about this report. Privacy. This is not an emergency service: if there is a fire now, call 112.

How we know this
  • Perimeter: EFFIS (Copernicus), mapped on satellite imagery.
  • Dates adjusted with the VIIRS detections inside the perimeter, which said 27 February 2019 to 27 February 2019. 2 Suomi-NPP VIIRS detections on those dates.
  • We have not matched this page with any official record.
  • Weather: Copernicus ERA5 reanalysis at the fire location, in cells of about 25 km.

How we build fire pages: methodology ›

Where this data comes from

The perimeter and land cover come from the Copernicus European Forest Fire Information System (EFFIS), measured on MODIS and Sentinel-2 imagery and published under CC BY 4.0. Heat detections come from the VIIRS sensors aboard Suomi-NPP and NOAA-20, distributed by NASA FIRMS at 375 m resolution. Municipal boundaries come from geoBoundaries ADM2 (Creative Commons Attribution 4.0 International (CC BY 4.0)). The area per municipality is computed by WorldFires by crossing the perimeter with those boundaries, so it may differ slightly from each country’s official figure.