Cumbres Mayores fire, July 2020
Cumbres Mayores, Cumbres de Enmedio
Out · last detection 31 Jul 2020, 14:11 UTC
The fire started on 31 July 2020 in Cumbres Mayores, Spain, and satellites saw it burning for 1 day. Copernicus mapped a burnt perimeter of 325 hectares from satellite imagery, spread across 2 municipalities.
It is the 21th largest in Huelva since 2016 (of 36 with a page). Number 34 in Spain in 2020, of 89.
The power measured by the satellite is low (6.7 MW in the strongest hotspot), more typical of grass or stubble burning, or a slow surface fire, than of a large crown fire.
matches the official recordwith caveatssatellite onlymodel
When copying, the sentence is
Tick the figures you want: they make up the lede and the CSV.
Burned area
with caveats
325ha
Perimeter published by EFFIS (Copernicus).
This page325EGIF (MITECO)216
Source
EFFIS (Copernicus)
Date
perimeter revised on 26 January 2022
+− cross-check
EGIF (MITECO): 216 ha (matched records: 1). Difference between the page and the official record: +50.2%. Matched on 15 November 2026. The two figures differ a lot, so these may not be exactly the same fire: take them as nearby records.
Duration by satellite
satellite only
1day
31 Jul 2020 to 31 Jul 2020: first and last day with fire on the page.
Source
EFFIS (Copernicus) · NASA FIRMS · VIIRS
Date
last detection: 31 Jul 2020, 14:11 UTC
+− cross-check
Satellites pass a few times a day and cloud or smoke can hide the fire: a lack of detections is not an official extinction. Each country’s emergency service declares a fire contained or out.
Start
satellite only
31 Jul 2020
First day with fire seen by the satellites or the perimeter.
Source
EFFIS (Copernicus) · NASA FIRMS · VIIRS
Date
31 Jul 2020
+− cross-check
The two figures differ a lot, so these may not be exactly the same fire: take them as nearby records.
Hotspots
satellite only
4
VIIRS detections at 375 m. Most intense hotspot: 7 MW.
Source
NASA FIRMS · VIIRS (Suomi NPP)
Date
31 Jul 2020 – 31 Jul 2020
+− cross-check
There is no official record to compare with. Each hotspot is a pixel detected in one satellite pass, not a separate fire.
The worst day
satellite only
22MW
Total radiative power on 31 July 2020; hotspots that day: 4.
Source
NASA FIRMS · VIIRS (FRP)
Date
31 Jul 2020
+− cross-check
Fire radiative power (FRP) measures the energy the fire gives off when the satellite passes. Added up by day, it compares intensity, not area.
Danger at the start
model
37.7FWI · high
Fire Weather Index (Canadian system) computed by WorldFires for the day the fire started. Consecutive days without rain before: 56.
This is an index computed from weather model data, not a measurement of the fire nor an official warning. Danger warnings are issued by each country’s authority. Emergency number and official warnings ›
Weather during the fire
model
35.2°C · 21% RH
High of 35.2 °C and minimum humidity of 21% on 31 July 2020; gusts of 31 km/h on 31 July 2020.
These are model values for a cell of about 25 km, not from a weather station: they may differ from what was measured on the ground.
ⓘThis page’s change log has been kept since 24 October 2026: every night what it publishes is compared and the difference is logged. Anything earlier is reconstructed from each source’s date and marked as reconstructed.
Show
· reconstructedofficial
Matched with the official EGIF (MITECO) record
Nearby records with very different figures: 216 ha (records: 1).
A version keeps the area, dates, name and official record; the area as it was logged (changes under 2% are not logged). The map, hotspots and weather always show today’s data.
Citation
A lede of about 60 words figures only, no adjectives
Burnt area inside each municipality, from crossing the official perimeter with administrative boundaries. The distance runs from the point marking the centre of each area to the nearest fire: staying a kilometre away does not mean it reached the houses.
Natura 2000 sites (European Environment Agency, 2024 release) crossed by the perimeter.
Land cover inside the perimeter according to Corine Land Cover, as reported by Copernicus.
Official record
According to EGIF (MITECO), this fire started on 31 July 2020 and burned 216 ha (the satellite measured 325 ha). The two figures differ a lot, so these may not be exactly the same fire: take them as nearby records.
Cumbres MayoresCasablanca31 July 2020 · 16:00216 ha· extinguished on 2 August 2020· cause: negligence
ECMWF ERA5 reanalysis at the fire location, the standard reference for past weather, and the Canadian Fire Weather Index (the same system Copernicus uses), computed by WorldFires from that data. Days after the fire run until the first rain.
Open-Meteo.com (CC BY 4.0) · Copernicus Climate Change Service (ERA5)
Day
High
Min. humidity
Peak gust
Rain
Danger (FWI)
31 Jul
35.2 °C
21 %
31 km/h
0.0 mm
High 38
1 Aug after
35.4 °C
14 %
36 km/h
0.0 mm
Extreme 52
2 Aug after
32.2 °C
21 %
37 km/h
0.0 mm
Very high 50
3 Aug after
30.9 °C
28 %
42 km/h
0.0 mm
Very high 49
4 Aug after
33.7 °C
26 %
35 km/h
0.0 mm
Very high 39
5 Aug after
34.5 °C
27 %
26 km/h
0.0 mm
Very high 38
6 Aug after
35.5 °C
23 %
37 km/h
0.0 mm
Extreme 50
7 Aug after
32.0 °C
31 %
38 km/h
0.0 mm
Very high 47
8 Aug after
33.1 °C
29 %
32 km/h
0.0 mm
Very high 44
9 Aug after
33.5 °C
27 %
31 km/h
0.0 mm
Very high 41
10 Aug after
31.7 °C
31 %
34 km/h
0.0 mm
High 35
Its twins: fires that started in the same weather
It started with an FWI of 37.7, a minimum humidity of 21% and 56 days without rain. Fires in the area that started in weather like this since 2016: 18.
FWI at the start37.7
Minimum humidity21 %
Days without rain56
this firechosen twinsrest of the area
Almost identicalSimilar
Outlines of the closest twins
This fire · Cumbres Mayores fire, July 2020
325 ha1 dayFWI 37.7Min. humidity 21 %
Alosno fire, July 2026
271 ha2 daysFWI 38.5Min. humidity 22 %66 km away, in 2026
First rain (1 mm or more) after it ended: none in the following ten days.
It burned an area similar to its twins (325 ha against a median of 331 ha) and lasted 1 day, against 1 day.
In 15 of 18, not even 1 mm fell in the ten days after the end: they went out without rain. In the rest, the first rainy day brought a median of 1.7 mm.
This is a bank of analogues: it shows what usually happens, not what will happen. With fewer than 15 twins we give no figures. How we calculate it
How it ended
—first rain
—no rain in ten days
31km/h · max. gust
It was considered over on 31 Jul, and not even 1 mm fell in the following ten days: it went out without rain. Twins with rain when they ended: 3 of 18, with a median of 1.7 mm.
Weather on this page: Open-Meteo.com (CC BY 4.0) · Copernicus Climate Change Service (ERA5)
How a twin is chosen
Same area: fires that have already ended, less than 250 km from this one, since 2016.
Same start: we compare the FWI on the first day, the minimum humidity that day and the run of days without rain before it. The slider sets how much they may differ.
Only pages with final weather data (ERA5 reanalysis) calculated in the same way as this fire’s; agricultural and grass burns and pages with data under review are left out.
Fires burning at the same time as this one (a week before or after) are left out: they share the same spell of weather and do not count as a precedent.
They are sorted by similarity, and the outlines of the first five are drawn.
Drag the line to compare the same ground before the fire and after it.
↔
Before · 24 Jul 2020
After · 7 Aug 2020
Sentinel-2 did not pass over on that day. Try another date, or use false colour, which is daily.
If the day is cloudy, change the date: each satellite passes once a day. In false colour the burnt ground looks brown or red.
The smoke
CAMS · Copernicus
On 31 July 2020 the air beside the fire reached 16 µg/m³ of PM2.5, but no daily average passed the WHO guideline (15).
PM2.5 peak16µg/m³
Days over the guideline0days
PM1027µg/m³
WHO 15
29 Jul31 Jul2 Aug
GoodFairModeratePoorVery poorExtremely poor
Particles from the Copernicus CAMS model at the centre of the perimeter; these are not measurements in each town. The pale bar is the worst hour, the solid one the daily average.
Open-Meteo.com (CC BY 4.0) · Copernicus Atmosphere Monitoring Service (CAMS)
Detections table· 4Every satellite heat detection, one by one, with time, satellite, power and coordinates.›
⬇ Download CSVTimes in UTC. Each detection is a 375 m pixel: a large fire yields hundreds per pass.
Copernicus dates it between 31 July 2020 and 31 July 2020: 1 day between the first and last image with fire.
How much area did it burn?
The perimeter Copernicus measured from satellite imagery is 325 hectares (3.2 km²). Official national figures may differ.
Which municipalities burned?
The fire entered 2 municipalities: Cumbres Mayores (318 ha, 2.6 %); Cumbres de Enmedio (7 ha, 0.5 %).
Did the fire reach a town?
The fire started in Cumbres Mayores and came within 1.2 km of its centre. That is the distance from the perimeter, or the nearest hotspot, to the point marking the centre; it does not mean it entered the houses.
What was the weather like?
During the fire the temperature reached 35.2 °C, humidity dropped to 21 % and gusts hit 31 km/h. The fire danger index (FWI) reached 38, class High.
Where does this data come from?
From the EFFIS (Copernicus) burnt perimeter, NASA FIRMS VIIRS hotspots and the administrative boundaries of Spain (geoBoundaries). It is not an official report.
How did the fires that started in similar weather in this area end?
Fires less than 250 km away that started since 2016 with a similar FWI, humidity and dry spell: 18. Their median duration was 1 day and their median area 331 ha; 22 % went past 1,000 ha. In 15 of 18, not even 1 mm fell in the ten days after the end: they went out without rain. In the rest, the first rainy day brought a median of 1.7 mm.
Where to verify it
A satellite detection is not an official report. Final figures and the fire’s status are published by each country’s emergency service.
This page is built from satellite data and official records, and it sometimes gets things wrong: the wrong dates, the wrong town, two fires merged into one, or something that was not a wildfire at all. If you know this fire first-hand (you live nearby, saw it, fought it or reported on it), tell us what really happened and we will check it.
⚑Report an errorHow we know this›
Perimeter: EFFIS (Copernicus), mapped on satellite imagery.
Dates from the perimeter: the VIIRS detections inside it did not change them. 4 Suomi-NPP VIIRS detections on those dates.
Compared with EGIF (MITECO): 216 official ha against 325 ha of perimeter; similar, but with reservations.
Weather: Copernicus ERA5 reanalysis at the fire location, in cells of about 25 km.
The perimeter and land cover come from the Copernicus European Forest Fire Information System (EFFIS), measured on MODIS and Sentinel-2 imagery and published under CC BY 4.0. Heat detections come from the VIIRS sensors aboard Suomi-NPP and NOAA-20, distributed by NASA FIRMS at 375 m resolution. Municipal boundaries come from geoBoundaries ADM3 (Creative Commons Attribution 4.0 International (CC BY 4.0)). The area per municipality is computed by WorldFires by crossing the perimeter with those boundaries, so it may differ slightly from each country’s official figure.