Skip to content
worldfires
PT · Portugal · →

Cinfães fire, September 2016 Tendais, Cinfães

Out · last detection 7 Sept 2016, 13:54 UTC

The fire started on 5 September 2016 in Tendais, Portugal, and satellites saw it burning for 3 days. Copernicus mapped a burnt perimeter of 514 hectares from satellite imagery, spread across 2 municipalities. According to ICNF, the largest of the 2 recorded fires was detected on 5 September 2016 at 13:56 and declared extinguished on 5 September 2016.

It is the 8th largest in Cinfães since 2016 (of 29 with a page). Number 58 in Portugal in 2016, of 179.

The power measured by the satellite is low (27.9 MW in the strongest hotspot), more typical of grass or stubble burning, or a slow surface fire, than of a large crown fire.

Burnt area
514ha
Copernicus perimeter
Duration
3days
5 Sept 2016 – 7 Sept 2016
Municipalities hit
2
freguesias
Started on
5 Sept
2016
Heat detections
42
in a single hotspot: 28 MW
Danger at start
26
High · FWI index
Energy released
480MW
sum of detected power

Where it burned

7 Sept 2016
HOTSPOTS BY DAY 5 Sept7 Sept

How it evolved, day by day

67

Fire radiative power detected each day, in megawatts, and number of hotspots. The magenta bar marks the peak day.

The weather it burned in

32°high
45km/h · peak gust
25%lowest humidity

It had gone 9 days without rain (1 mm or more) when it started. Rain came after the fire: 21.8 mm on 13 Sept.

This area had burned before

No earlier perimeters overlap this fire since 2016, when the satellite record begins.

What happened to each town

  1. Tendais 697 inhabitants · 0.8 km from the town where it started
    514 ha reached on 6 Sept
    16 %
  2. Cinfães 3,080 inhabitants · 4.2 km from the town
    1 ha
    0.0 %

Burnt area inside each municipality, from crossing the official perimeter with administrative boundaries. The distance is from the town centre to the nearest fire: staying a kilometre away does not mean it reached the houses.

What burned

  • Other natural land60 %
  • Scrub and transitional woodland30 %
  • Agricultural areas9.8 %
  • Broadleaved forest0.6 %

Natura 2000 protected area affected: 100 %

Natura 2000 sites (European Environment Agency, 2024 release) crossed by the perimeter.

Land cover inside the perimeter according to Corine Land Cover, as reported by Copernicus.

Official record

According to ICNF, 2 fires started inside this perimeter on these dates, totalling 500 ha (the satellite measured 514 ha).

ICNF (Instituto da Conservação da Natureza e das Florestas). This is the agency’s operational record: its figures may be revised when the year’s statistics are closed.

The weather day by day

ECMWF ERA5 reanalysis at the fire location, the standard reference for past weather, and the Canadian Fire Weather Index (the same system Copernicus uses), computed by WorldFires from that data. Days after the fire run until the first rain.

Open-Meteo.com (CC BY 4.0) · Copernicus Climate Change Service (ERA5)

Day High Min. humidity Peak gust Rain Danger (FWI)
5 Sept 30.0 °C 29 % 21 km/h 0.0 mm High 26
6 Sept 32.4 °C 25 % 45 km/h 0.8 mm High 32
7 Sept 25.5 °C 42 % 40 km/h 0.0 mm High 27
8 Sept after 20.6 °C 48 % 39 km/h 0.0 mm High 24
9 Sept after 21.5 °C 35 % 44 km/h 0.0 mm High 26
10 Sept after 22.1 °C 44 % 38 km/h 0.0 mm High 24
11 Sept after 24.4 °C 46 % 32 km/h 0.0 mm High 23
12 Sept after 24.9 °C 42 % 47 km/h 0.0 mm High 26
13 Sept after 16.2 °C 66 % 52 km/h 21.8 mm Very low 0

Before and after, from space

Drag the line to compare the same ground before the fire and after it.

Before · 29 Aug 2016
After · 14 Sept 2016

If the day is cloudy, change the date: each satellite passes once a day. In false colour the burnt ground looks brown or red.

The smoke

CAMS · Copernicus

On 6 September 2016 the air beside the fire reached 67 µg/m³ of PM2.5. That day averaged 42: 2.8 times the WHO daily guideline (15).

PM2.5 peak67 µg/m³
Days over the guideline5 days
PM1075 µg/m³
345678910
Good Fair Moderate Poor Very poor Extremely poor

Particles from the Copernicus CAMS model at the centre of the perimeter; these are not measurements in each town. The pale bar is the worst hour, the solid one the daily average.

Open-Meteo.com (CC BY 4.0) · Copernicus Atmosphere Monitoring Service (CAMS)

Detections table · 42Every satellite heat detection, one by one, with time, satellite, power and coordinates.
⬇ Download CSV Times in UTC. Each detection is a 375 m pixel: a large fire yields hundreds per pass.
Date and timeSatelliteFRP (MW)LatLon

Other fires nearby

All fires in Portugal ›

Frequently asked questions

How long did the Cinfães fire last?
Copernicus dates it between 5 September 2016 and 7 September 2016: 3 days between the first and last image with fire. According to ICNF, the largest of the 2 recorded fires was detected on 5 September 2016 at 13:56 and declared extinguished on 5 September 2016.
How much area did it burn?
The perimeter Copernicus measured from satellite imagery is 514 hectares (5.1 km²). Official national figures may differ.
Which municipalities burned?
The fire entered 2 municipalities: Tendais (514 ha, 16 %); Cinfães (1 ha, 0.0 %).
Did the fire reach a town?
The closest fire to a town centre came within 0.8 km of Tendais. That is the distance to the perimeter or nearest hotspot; it does not mean it entered the houses.
What was the weather like?
During the fire the temperature reached 32.4 °C, humidity dropped to 25 % and gusts hit 45 km/h. The fire danger index (FWI) reached 32, class High.
Where does this data come from?
From the EFFIS (Copernicus) burnt perimeter, NASA FIRMS VIIRS hotspots and the administrative boundaries of Portugal (geoBoundaries). It is not an official report.

Where to verify it

A satellite detection is not an official report. Final figures and the fire’s status are published by each country’s emergency service.

Emergency number: 112

Satellite cross-check

Does something look wrong on this page?

This page is built from satellite data and official records, and it sometimes gets things wrong: the wrong dates, the wrong town, two fires merged into one, or something that was not a wildfire at all. If you know this fire first-hand (you live nearby, saw it, fought it or reported on it), tell us what really happened and we will check it.

Report an error
What do you think is wrong?

We will only use your email to reply about this report. Privacy. This is not an emergency service: if there is a fire now, call 112.

Where this data comes from

The perimeter and land cover come from the Copernicus European Forest Fire Information System (EFFIS), measured on MODIS and Sentinel-2 imagery and published under CC BY 4.0. Heat detections come from the VIIRS sensors aboard Suomi-NPP and NOAA-20, distributed by NASA FIRMS at 375 m resolution. Municipal boundaries come from geoBoundaries ADM3 (CC0 1.0 Universal (CC0 1.0) Public Domain Dedication). The area per municipality is computed by WorldFires by crossing the perimeter with those boundaries, so it may differ slightly from each country’s official figure.