Skip to content
worldfires
AO · Angola · –

Capenda-Camulemba fire, 9 August 2016 Capenda-Camulemba

Out · last detection 26 Aug 2016, 12:24 UTC

The fire started on 9 August 2016 in Capenda-Camulemba, Angola, and satellites saw it burning for 18 days. Copernicus’s global GWIS system rebuilt a burnt perimeter of 5,104 hectares from heat detections, spread across a single municipality.

It is the 280th largest in Lunda Norte since 2016 (of 297 with a page). Number 127 in Angola in 2016, of 138.

Burnt area
5,104ha
GWIS perimeter (Copernicus)
Duration
18days
9 Aug 2016 – 26 Aug 2016
Municipalities hit
1
municipalities
Started on
9 Aug
2016
Heat detections
182
in a single hotspot: 132 MW
Danger at start
52
Extreme · FWI index
Average daily power
251MW
detected power per day, on average

Where it burned

HOTSPOTS BY DAY 9 Aug26 Aug
26 Aug 2016

How it evolved, day by day

9 Aug 2016 · 118 MW · 4 10 Aug 2016 · 139 MW · 13 11 Aug 2016 · 97 MW · 6 14 Aug 2016 · 365 MW · 25 15 Aug 2016 · 275 MW · 8 16 Aug 2016 · 300 MW · 20 17 Aug 2016 · 801 MW · 26 18 Aug 2016 · 407 MW · 24 19 Aug 2016 · 45 MW · 8 21 Aug 2016 · 8 MW · 2 23 Aug 2016 · 43 MW · 6 24 Aug 2016 · 675 MW · 15 25 Aug 2016 · 8 MW · 6 26 Aug 2016 · 229 MW · 19
9 Aug 14 Aug 17 Aug 21 Aug 25 Aug

Fire radiative power detected each day, in megawatts, and number of hotspots. The magenta bar marks the peak day.

The weather it burned in

34°high
49km/h · peak gust
14%lowest humidity

It had gone more than two months without rain (1 mm or more) when it started.

This area had burned before

No earlier perimeters overlap this fire since 2016, when the satellite record begins.

How big is it?

10 km
It burned the equivalent of 3.2% of the area of London (51 km² against 1,583 km²).

London boundary: geoBoundaries · Office for National Statistics (Open Government Licence v3.0).

This compares size, not location: both shapes are at the same scale, north up, centred on each other.

What happened to each town

  1. Capenda-Camulemba where it started
    5,135 ha reached on 9 Aug
    0.5 %

Burnt area inside each municipality, from crossing the GWIS perimeter with administrative boundaries. The distance runs from the point marking the centre of each area to the nearest fire: staying a kilometre away does not mean it reached the houses.

People and buildings inside the perimeter

GHSL 2015
Built-up area< 0.1 ha
Residents< 20

Inside the perimeter there was no noticeable built-up land and almost nobody lived there (GHSL 2015, satellite-based estimate).

This is an estimate on 100 m cells, made from satellite imagery and census data: it does not mean that homes burned or that anyone was harmed. The perimeter also contains land that never burned.

Source: Global Human Settlement Layer (GHS-BUILT-S and GHS-POP R2023A), European Commission Joint Research Centre (JRC), © European Union, CC BY 4.0. Sum inside the perimeter computed by WorldFires. human-settlement.emergency.copernicus.eu

The weather day by day

ECMWF ERA5 reanalysis at the fire location, the standard reference for past weather, and the Canadian Fire Weather Index (the same system Copernicus uses), computed by WorldFires from that data. Days after the fire run until the first rain.

Open-Meteo.com (CC BY 4.0) · Copernicus Climate Change Service (ERA5)

Started with Extreme FWI: 68 % of the area in Angola 60 days without rain: 84 % of the area in Angola

Day High Min. humidity Peak gust Rain Danger (FWI)
9 Aug 31.4 °C 19 % 30 km/h 0.0 mm Extreme 52
10 Aug 31.8 °C 20 % 44 km/h 0.0 mm Extreme 65
11 Aug 31.9 °C 20 % 24 km/h 0.0 mm Extreme 51
12 Aug 32.4 °C 18 % 28 km/h 0.0 mm Extreme 51
13 Aug 32.3 °C 20 % 20 km/h 0.0 mm Very high 42
14 Aug 32.3 °C 20 % 22 km/h 0.0 mm Very high 43
15 Aug 32.2 °C 25 % 26 km/h 0.0 mm Very high 43
16 Aug 31.8 °C 29 % 24 km/h 0.0 mm Very high 40
17 Aug 33.9 °C 16 % 43 km/h 0.0 mm Extreme 64
18 Aug 33.7 °C 15 % 32 km/h 0.0 mm Extreme 55
19 Aug 32.1 °C 23 % 27 km/h 0.0 mm Very high 40
20 Aug 31.1 °C 27 % 25 km/h 0.0 mm Very high 38
21 Aug 32.0 °C 24 % 24 km/h 0.0 mm Very high 38
22 Aug 31.1 °C 35 % 29 km/h 2.0 mm High 31
23 Aug 34.0 °C 18 % 29 km/h 0.0 mm Very high 39
24 Aug 33.7 °C 14 % 49 km/h 0.0 mm Extreme 67
25 Aug 31.7 °C 15 % 46 km/h 0.0 mm Extreme 62
26 Aug 31.8 °C 16 % 32 km/h 0.0 mm Extreme 54
27 Aug after 32.2 °C 20 % 24 km/h 0.0 mm Very high 46
28 Aug after 29.1 °C 28 % 38 km/h 0.0 mm Extreme 50
29 Aug after 34.2 °C 17 % 39 km/h 0.0 mm Extreme 56
30 Aug after 33.8 °C 17 % 36 km/h 0.0 mm Extreme 54
31 Aug after 32.4 °C 20 % 23 km/h 0.0 mm Very high 39
1 Sept after 29.2 °C 33 % 20 km/h 0.0 mm High 34
2 Sept after 31.0 °C 33 % 28 km/h 0.2 mm High 37
3 Sept after 30.9 °C 26 % 25 km/h 0.0 mm High 38
4 Sept after 30.7 °C 37 % 27 km/h 0.0 mm High 26
5 Sept after 32.1 °C 30 % 28 km/h 0.0 mm High 35

Its twins: fires that started in the same weather

It started with an FWI of 52.4, a minimum humidity of 19% and more than two months without rain. Fires in the area that started in weather like this since 2016: 43.

FWI at the start 52.4
Minimum humidity 19 %
Days without rain 60+
this fire chosen twins rest of the area
Almost identicalSimilar

Outlines of the closest twins

Capenda-Camulemba fire, July 2019
6,129 ha 14 days FWI 52.0 Min. humidity 19 % 2 km away, in 2019

First rain (1 mm or more) after it ended: 3.5 mm on 4 Aug.

What happened to them

13 days
median duration
6,714 ha
median area
19 %
went past 10,000 ha
3.2 mm
rain at the end (median; 4 of 43 had it)

It burned an area similar to its twins (5,104 ha against a median of 6,714 ha) and lasted 18 days, against 13 days.

In 39 of 43, not even 1 mm fell in the ten days after the end: they went out without rain. In the rest, the first rainy day brought a median of 3.2 mm.

This is a bank of analogues: it shows what usually happens, not what will happen. With fewer than 15 twins we give no figures. How we calculate it

How it ended

—first rain
—no rain in ten days
49km/h · max. gust

It was considered over on 26 Aug, and not even 1 mm fell in the following ten days: it went out without rain. Twins with rain when they ended: 4 of 43, with a median of 3.2 mm.

Weather on this page: Open-Meteo.com (CC BY 4.0) · Copernicus Climate Change Service (ERA5)

How a twin is chosen

  • Same area: fires that have already ended, less than 250 km from this one, since 2016.
  • Same start: we compare the FWI on the first day, the minimum humidity that day and the run of days without rain before it. The slider sets how much they may differ.
  • Only pages with final weather data (ERA5 reanalysis) calculated in the same way as this fire’s; agricultural and grass burns and pages with data under review are left out.
  • Fires burning at the same time as this one (a week before or after) are left out: they share the same spell of weather and do not count as a precedent.
  • They are sorted by similarity, and the outlines of the first five are drawn.

How we calculate it

Before and after, from space

Drag the line to compare the same ground before the fire and after it.

Before · 2 Aug 2016
After · 2 Sept 2016

If the day is cloudy, change the date: each satellite passes once a day. In false colour the burnt ground looks brown or red.

Detections table · 182Every satellite heat detection, one by one, with time, satellite, power and coordinates.
⬇ Download CSV Times in UTC. Each detection is a 375 m pixel: a large fire yields hundreds per pass.
Date and timeSatelliteFRP (MW)LatLon

Other fires nearby

All fires in Angola

Frequently asked questions

How long did the Capenda-Camulemba fire last?
According to the heat detections seen by satellite inside the perimeter, it burned from 9 August 2016 to 26 August 2016 (18 days). The perimeter dates it from 14 August 2016 to 19 August 2016.
How much area did it burn?
The perimeter GWIS (Copernicus) rebuilt from heat detections is 5,104 hectares (51.0 km²). It is an estimate: official national figures may differ.
Which municipalities burned?
The fire only entered Capenda-Camulemba (5,135 ha, 0.5 %).
What was the weather like?
During the fire the temperature reached 34.0 °C, humidity dropped to 14 % and gusts hit 49 km/h. The fire danger index (FWI) reached 67, class Extreme.
Where does this data come from?
From the GWIS (Copernicus) burnt perimeter, NASA FIRMS VIIRS hotspots and the administrative boundaries of Angola (geoBoundaries). It is not an official report.
How did the fires that started in similar weather in this area end?
Fires less than 250 km away that started since 2016 with a similar FWI, humidity and dry spell: 43. Their median duration was 13 days and their median area 6,714 ha; 19 % went past 10,000 ha. In 39 of 43, not even 1 mm fell in the ten days after the end: they went out without rain. In the rest, the first rainy day brought a median of 3.2 mm.

Where to verify it

A satellite detection is not an official report. Final figures and the fire’s status are published by each country’s emergency service.

Satellite cross-check

History of this page · 2 Changes in area, dates, name, official record or merged pages, compared every night since 24 October 2026.
  1. Last day with fire: 19 August 2016 → 26 August 2016.
  2. Start date: 14 August 2016 → 9 August 2016.

RSS Changes to this page With cross-checks and a citable version

Does something look wrong on this page?

This page is built from satellite data and official records, and it sometimes gets things wrong: the wrong dates, the wrong town, two fires merged into one, or something that was not a wildfire at all. If you know this fire first-hand (you live nearby, saw it, fought it or reported on it), tell us what really happened and we will check it.

Report an error
What do you think is wrong?

We will only use your email to reply about this report. Privacy.

How we know this
  • Perimeter: GWIS (Copernicus), rebuilt from heat detections rather than mapped on imagery.
  • Dates adjusted with the VIIRS detections inside the perimeter, which said 14 August 2016 to 19 August 2016. 182 Suomi-NPP VIIRS detections on those dates.
  • We have not matched this page with any official record.
  • Weather: Copernicus ERA5 reanalysis at the fire location, in cells of about 25 km.
  • Built-up area and population come from the JRC Global Human Settlement Layer (epoch 2015, 100 m cells), summed inside the perimeter: an estimate of what was there, not a damage count.

How we build fire pages: methodology

Where this data comes from

The perimeter comes from the Copernicus Global Wildfire Information System (GWIS), which rebuilds it from MODIS and VIIRS heat detections and publishes it under CC BY 4.0. It is not measured on imagery as in Europe, so it is an estimate. Heat detections come from the VIIRS sensors aboard Suomi-NPP and NOAA-20, distributed by NASA FIRMS at 375 m resolution. Municipal boundaries come from geoBoundaries ADM2 (Public Domain). The area per municipality is computed by WorldFires by crossing the perimeter with those boundaries, so it may differ from each country’s official figure.