Skip to content
worldfires
AO · Angola · –

Capenda-Camulemba fire, 3 August 2017 Capenda-Camulemba

Out · last detection 16 Aug 2017, 13:07 UTC

The fire started on 3 August 2017 in Capenda-Camulemba, Angola, and satellites saw it burning for 13 days. Copernicus’s global GWIS system rebuilt a burnt perimeter of 11,221 hectares from heat detections, spread across a single municipality.

It is the 36th largest in Lunda Norte since 2016 (of 297 with a page). Number 27 in Angola in 2017, of 158.

Burnt area
11,221ha
GWIS perimeter (Copernicus)
Duration
13days
3 Aug 2017 – 15 Aug 2017
Municipalities hit
1
municipalities
Started on
3 Aug
2017
Heat detections
365
in a single hotspot: 110 MW
Danger at start
52
Extreme · FWI index
Average daily power
286MW
detected power per day, on average

Where it burned

HOTSPOTS BY DAY 3 Aug15 Aug
16 Aug 2017

How it evolved, day by day

5 Aug 2017 · 424 MW · 9 6 Aug 2017 · 288 MW · 34 7 Aug 2017 · 471 MW · 76 8 Aug 2017 · 1,099 MW · 87 9 Aug 2017 · 160 MW · 19 10 Aug 2017 · 59 MW · 22 11 Aug 2017 · 162 MW · 25 12 Aug 2017 · 156 MW · 29 13 Aug 2017 · 365 MW · 39 14 Aug 2017 · 150 MW · 16 15 Aug 2017 · 65 MW · 6 16 Aug 2017 · 37 MW · 3
5 Aug 8 Aug 11 Aug 14 Aug

Fire radiative power detected each day, in megawatts, and number of hotspots. The magenta bar marks the peak day.

The weather it burned in

33°high
46km/h · peak gust
14%lowest humidity

It had gone more than two months without rain (1 mm or more) when it started.

This area had burned before

44% of the perimeter overlaps earlier fires recorded since 2016: 4,954 ha in 2016.

How big is it?

10 km
It burned the equivalent of 7.1% of the area of London (112 km² against 1,583 km²).

London boundary: geoBoundaries · Office for National Statistics (Open Government Licence v3.0).

This compares size, not location: both shapes are at the same scale, north up, centred on each other.

What happened to each town

  1. Capenda-Camulemba where it started
    11,287 ha reached on 5 Aug
    1.1 %

Burnt area inside each municipality, from crossing the GWIS perimeter with administrative boundaries. The distance runs from the point marking the centre of each area to the nearest fire: staying a kilometre away does not mean it reached the houses.

People and buildings inside the perimeter

GHSL 2015
Built-up area0.59 ha
Residents≈ 200

Inside the perimeter there were about 0.59 hectares of built-up land and about 200 residents (GHSL 2015, satellite-based estimate).

This is an estimate on 100 m cells, made from satellite imagery and census data: it does not mean that homes burned or that anyone was harmed. The perimeter also contains land that never burned.

Source: Global Human Settlement Layer (GHS-BUILT-S and GHS-POP R2023A), European Commission Joint Research Centre (JRC), © European Union, CC BY 4.0. Sum inside the perimeter computed by WorldFires. human-settlement.emergency.copernicus.eu

The weather day by day

ECMWF ERA5 reanalysis at the fire location, the standard reference for past weather, and the Canadian Fire Weather Index (the same system Copernicus uses), computed by WorldFires from that data. Days after the fire run until the first rain.

Open-Meteo.com (CC BY 4.0) · Copernicus Climate Change Service (ERA5)

Started with Extreme FWI: 68 % of the area in Angola 60 days without rain: 84 % of the area in Angola

Day High Min. humidity Peak gust Rain Danger (FWI)
3 Aug 32.5 °C 19 % 36 km/h 0.0 mm Extreme 52
4 Aug 32.8 °C 18 % 28 km/h 0.0 mm Very high 48
5 Aug 30.4 °C 25 % 21 km/h 0.0 mm Very high 42
6 Aug 31.2 °C 19 % 35 km/h 0.0 mm Extreme 52
7 Aug 32.2 °C 19 % 31 km/h 0.0 mm Very high 50
8 Aug 31.8 °C 22 % 23 km/h 0.0 mm Very high 41
9 Aug 31.0 °C 18 % 35 km/h 0.0 mm Extreme 52
10 Aug 30.1 °C 18 % 24 km/h 0.0 mm Very high 47
11 Aug 30.3 °C 16 % 37 km/h 0.0 mm Very high 45
12 Aug 31.8 °C 18 % 35 km/h 0.0 mm Extreme 52
13 Aug 32.6 °C 17 % 42 km/h 0.0 mm Extreme 55
14 Aug 32.3 °C 15 % 46 km/h 0.0 mm Extreme 58
15 Aug 32.2 °C 14 % 39 km/h 0.0 mm Extreme 52
16 Aug after 33.1 °C 15 % 32 km/h 0.0 mm Extreme 51
17 Aug after 32.2 °C 14 % 22 km/h 0.0 mm Very high 43
18 Aug after 30.8 °C 24 % 27 km/h 0.0 mm Very high 41
19 Aug after 31.7 °C 22 % 27 km/h 0.0 mm Very high 45
20 Aug after 32.4 °C 23 % 24 km/h 0.0 mm Very high 41
21 Aug after 32.0 °C 18 % 35 km/h 0.0 mm Extreme 52
22 Aug after 32.0 °C 15 % 36 km/h 0.0 mm Extreme 52
23 Aug after 32.3 °C 19 % 19 km/h 0.0 mm Very high 42
24 Aug after 32.9 °C 23 % 21 km/h 0.0 mm Very high 42
25 Aug after 32.5 °C 16 % 22 km/h 0.0 mm Very high 42

Its twins: fires that started in the same weather

It started with an FWI of 52.0, a minimum humidity of 19% and more than two months without rain. Fires in the area that started in weather like this since 2016: 31.

FWI at the start 52.0
Minimum humidity 19 %
Days without rain 60+
this fire chosen twins rest of the area
Almost identicalSimilar

Outlines of the closest twins

Capenda-Camulemba fire, July 2019
6,129 ha 14 days FWI 52.0 Min. humidity 19 % 44 km away, in 2019

First rain (1 mm or more) after it ended: 3.5 mm on 4 Aug.

What happened to them

14 days
median duration
6,877 ha
median area
16 %
went past 10,000 ha
3.0 mm
rain at the end (median; 5 of 31 had it)

It was 1.6 times larger than the median of its twins and lasted 13 days, against 14 days.

Only 5 of its 31 twins burned more. The weather on the first day does not explain everything: the wind in the following days, the fuel and the firefighting also count. In 26 of 31, not even 1 mm fell in the ten days after the end: they went out without rain. In the rest, the first rainy day brought a median of 3.0 mm.

This is a bank of analogues: it shows what usually happens, not what will happen. With fewer than 15 twins we give no figures. How we calculate it

How it ended

—first rain
—no rain in ten days
46km/h · max. gust

It was considered over on 15 Aug, and not even 1 mm fell in the following ten days: it went out without rain. Twins with rain when they ended: 5 of 31, with a median of 3.0 mm.

Weather on this page: Open-Meteo.com (CC BY 4.0) · Copernicus Climate Change Service (ERA5)

How a twin is chosen

  • Same area: fires that have already ended, less than 250 km from this one, since 2016.
  • Same start: we compare the FWI on the first day, the minimum humidity that day and the run of days without rain before it. The slider sets how much they may differ.
  • Only pages with final weather data (ERA5 reanalysis) calculated in the same way as this fire’s; agricultural and grass burns and pages with data under review are left out.
  • Fires burning at the same time as this one (a week before or after) are left out: they share the same spell of weather and do not count as a precedent.
  • They are sorted by similarity, and the outlines of the first five are drawn.

How we calculate it

Before and after, from space

Drag the line to compare the same ground before the fire and after it.

Before · 27 Jul 2017
After · 22 Aug 2017

If the day is cloudy, change the date: each satellite passes once a day. In false colour the burnt ground looks brown or red.

Detections table · 365Every satellite heat detection, one by one, with time, satellite, power and coordinates.
⬇ Download CSV Times in UTC. Each detection is a 375 m pixel: a large fire yields hundreds per pass.
Date and timeSatelliteFRP (MW)LatLon

Other fires nearby

All fires in Angola

Frequently asked questions

How long did the Capenda-Camulemba fire last?
According to the heat detections seen by satellite inside the perimeter, it burned from 3 August 2017 to 15 August 2017 (13 days). The perimeter dates it from 5 August 2017 to 15 August 2017.
How much area did it burn?
The perimeter GWIS (Copernicus) rebuilt from heat detections is 11,221 hectares (112.2 km²). It is an estimate: official national figures may differ.
Which municipalities burned?
The fire only entered Capenda-Camulemba (11,287 ha, 1.1 %).
What was the weather like?
During the fire the temperature reached 32.8 °C, humidity dropped to 14 % and gusts hit 46 km/h. The fire danger index (FWI) reached 58, class Extreme.
Where does this data come from?
From the GWIS (Copernicus) burnt perimeter, NASA FIRMS VIIRS hotspots and the administrative boundaries of Angola (geoBoundaries). It is not an official report.
How did the fires that started in similar weather in this area end?
Fires less than 250 km away that started since 2016 with a similar FWI, humidity and dry spell: 31. Their median duration was 14 days and their median area 6,877 ha; 16 % went past 10,000 ha. Only 5 of its 31 twins burned more. The weather on the first day does not explain everything: the wind in the following days, the fuel and the firefighting also count. In 26 of 31, not even 1 mm fell in the ten days after the end: they went out without rain. In the rest, the first rainy day brought a median of 3.0 mm.

Where to verify it

A satellite detection is not an official report. Final figures and the fire’s status are published by each country’s emergency service.

Satellite cross-check

History of this page · 1 Changes in area, dates, name, official record or merged pages, compared every night since 24 October 2026.
  1. Start date: 5 August 2017 → 3 August 2017.

RSS Changes to this page With cross-checks and a citable version

Does something look wrong on this page?

This page is built from satellite data and official records, and it sometimes gets things wrong: the wrong dates, the wrong town, two fires merged into one, or something that was not a wildfire at all. If you know this fire first-hand (you live nearby, saw it, fought it or reported on it), tell us what really happened and we will check it.

Report an error
What do you think is wrong?

We will only use your email to reply about this report. Privacy.

How we know this
  • Perimeter: GWIS (Copernicus), rebuilt from heat detections rather than mapped on imagery.
  • Dates adjusted with the VIIRS detections inside the perimeter, which said 5 August 2017 to 15 August 2017. 365 Suomi-NPP VIIRS detections on those dates.
  • We have not matched this page with any official record.
  • Weather: Copernicus ERA5 reanalysis at the fire location, in cells of about 25 km.
  • Built-up area and population come from the JRC Global Human Settlement Layer (epoch 2015, 100 m cells), summed inside the perimeter: an estimate of what was there, not a damage count.

How we build fire pages: methodology

Where this data comes from

The perimeter comes from the Copernicus Global Wildfire Information System (GWIS), which rebuilds it from MODIS and VIIRS heat detections and publishes it under CC BY 4.0. It is not measured on imagery as in Europe, so it is an estimate. Heat detections come from the VIIRS sensors aboard Suomi-NPP and NOAA-20, distributed by NASA FIRMS at 375 m resolution. Municipal boundaries come from geoBoundaries ADM2 (Public Domain). The area per municipality is computed by WorldFires by crossing the perimeter with those boundaries, so it may differ from each country’s official figure.