Skip to content
worldfires
AR · Argentina · –

Bermejo fire, December 2021 Bermejo

Out · last detection 13 Jan 2022, 18:02 UTC

The fire started on 26 December 2021 in Bermejo, Argentina, and satellites saw it burning for 18 days. Copernicus’s global GWIS system rebuilt a burnt perimeter of 2,499 hectares from heat detections, spread across a single municipality.

It is the 236th largest in Formosa since 2016 (of 587 with a page). Number 82 in Argentina in 2021, of 216.

Burnt area
2,499ha
GWIS perimeter (Copernicus)
Duration
18days
26 Dec 2021 – 12 Jan 2022
Municipalities hit
1
departments
Started on
26 Dec
2021
Heat detections
152
in a single hotspot: 141 MW
Danger at start
34
High · FWI index
Average daily power
296MW
detected power per day, on average

Where it burned

HOTSPOTS BY DAY 26 Dec12 Jan
13 Jan 2022

How it evolved, day by day

26 Dec 2021 · 758 MW · 15 27 Dec 2021 · 155 MW · 5 29 Dec 2021 · 124 MW · 11 30 Dec 2021 · 79 MW · 9 31 Dec 2021 · 161 MW · 13 1 Jan 2022 · 2,361 MW · 51 2 Jan 2022 · 610 MW · 27 3 Jan 2022 · 17 MW · 6 4 Jan 2022 · 50 MW · 4 5 Jan 2022 · 4 MW · 1 7 Jan 2022 · 11 MW · 1 9 Jan 2022 · 32 MW · 2 11 Jan 2022 · 53 MW · 4 12 Jan 2022 · 10 MW · 1 13 Jan 2022 · 16 MW · 2
26 Dec 1 Jan 5 Jan 11 Jan

Fire radiative power detected each day, in megawatts, and number of hotspots. The magenta bar marks the peak day.

The weather it burned in

45°high
47km/h · peak gust
15%lowest humidity

It had gone 2 days without rain (1 mm or more) when it started.

This area had burned before

82% of the perimeter overlaps earlier fires recorded since 2016: 231 ha in 2017, 769 ha in 2018, 685 ha in 2019, 2,797 ha in 2020. Part of it burned more than once, so the yearly figures add up to more than the 2,048 ha that had burned before.

How big is it?

10 km
It burned the equivalent of 1.6% of the area of London (25 km² against 1,583 km²).

London boundary: geoBoundaries · Office for National Statistics (Open Government Licence v3.0).

This compares size, not location: both shapes are at the same scale, north up, centred on each other.

What happened to each town

  1. Bermejo where it started
    2,499 ha reached on 26 Dec
    0.2 %

Burnt area inside each municipality, from crossing the GWIS perimeter with administrative boundaries. The distance runs from the point marking the centre of each area to the nearest fire: staying a kilometre away does not mean it reached the houses.

People and buildings inside the perimeter

GHSL 2020
Built-up area< 0.1 ha
Residents< 20

Inside the perimeter there was no noticeable built-up land and almost nobody lived there (GHSL 2020, satellite-based estimate).

This is an estimate on 100 m cells, made from satellite imagery and census data: it does not mean that homes burned or that anyone was harmed. The perimeter also contains land that never burned.

Source: Global Human Settlement Layer (GHS-BUILT-S and GHS-POP R2023A), European Commission Joint Research Centre (JRC), © European Union, CC BY 4.0. Sum inside the perimeter computed by WorldFires. human-settlement.emergency.copernicus.eu

The weather day by day

ECMWF ERA5 reanalysis at the fire location, the standard reference for past weather, and the Canadian Fire Weather Index (the same system Copernicus uses), computed by WorldFires from that data. Days after the fire run until the first rain.

Open-Meteo.com (CC BY 4.0) · Copernicus Climate Change Service (ERA5)

Day High Min. humidity Peak gust Rain Danger (FWI)
26 Dec 40.0 °C 15 % 28 km/h 0.0 mm High 34
27 Dec 41.1 °C 20 % 28 km/h 0.0 mm High 31
28 Dec 39.1 °C 16 % 38 km/h 0.0 mm Very high 42
29 Dec 43.0 °C 15 % 34 km/h 0.0 mm Very high 38
30 Dec 44.1 °C 15 % 36 km/h 0.0 mm Very high 48
31 Dec 42.1 °C 18 % 35 km/h 0.0 mm High 36
1 Jan 45.3 °C 15 % 43 km/h 0.0 mm Extreme 58
2 Jan 42.6 °C 22 % 47 km/h 0.0 mm Very high 46
3 Jan 39.1 °C 36 % 31 km/h 0.8 mm High 29
4 Jan 40.1 °C 31 % 32 km/h 0.6 mm High 24
5 Jan 37.2 °C 30 % 40 km/h 1.5 mm High 32
6 Jan 37.9 °C 23 % 34 km/h 0.0 mm High 32
7 Jan 38.8 °C 25 % 31 km/h 0.0 mm High 33
8 Jan 39.3 °C 23 % 30 km/h 0.0 mm High 36
9 Jan 39.0 °C 22 % 27 km/h 0.0 mm High 35
10 Jan 39.5 °C 23 % 37 km/h 0.0 mm Very high 40
11 Jan 40.7 °C 21 % 32 km/h 0.0 mm High 35
12 Jan 41.1 °C 16 % 32 km/h 0.0 mm Very high 44
13 Jan after 40.8 °C 20 % 32 km/h 0.0 mm Very high 44
14 Jan after 39.3 °C 30 % 41 km/h 0.4 mm Extreme 57
15 Jan after 39.9 °C 27 % 60 km/h 0.0 mm Extreme 66
16 Jan after 42.0 °C 23 % 59 km/h 0.0 mm Extreme 69
17 Jan after 42.2 °C 24 % 60 km/h 0.0 mm Very extreme 72
18 Jan after 41.3 °C 24 % 55 km/h 0.1 mm Extreme 58
19 Jan after 36.0 °C 40 % 34 km/h 0.0 mm High 27
20 Jan after 41.0 °C 27 % 38 km/h 0.4 mm Very high 43
21 Jan after 42.6 °C 22 % 50 km/h 0.1 mm Extreme 59
22 Jan after 42.0 °C 19 % 62 km/h 0.0 mm Very extreme 72

Its twins: fires that started in the same weather

It started with an FWI of 34.0, a minimum humidity of 15% and 2 days without rain. Fires in the area that started in weather like this since 2016: 29.

FWI at the start 34.0
Minimum humidity 15 %
Days without rain 2
this fire chosen twins rest of the area
Almost identicalSimilar

Outlines of the closest twins

Mariscal Estigarribia fire, January 2016
6,004 ha 9 days FWI 33.6 Min. humidity 14 % 70 km away, in 2016

First rain (1 mm or more) after it ended: 23.9 mm on 30 Jan.

What happened to them

6 days
median duration
1,873 ha
median area
100 %
went past 1,000 ha
3.5 mm
rain at the end (median; 23 of 29 had it)

It burned an area similar to its twins (2,499 ha against a median of 1,873 ha) and lasted 18 days, against 6 days.

In 6 of 29, not even 1 mm fell in the ten days after the end: they went out without rain. In the rest, the first rainy day brought a median of 3.5 mm.

This is a bank of analogues: it shows what usually happens, not what will happen. With fewer than 15 twins we give no figures. How we calculate it

How it ended

—first rain
—no rain in ten days
47km/h · max. gust

It was considered over on 12 Jan, and not even 1 mm fell in the following ten days: it went out without rain. Twins with rain when they ended: 23 of 29, with a median of 3.5 mm.

Weather on this page: Open-Meteo.com (CC BY 4.0) · Copernicus Climate Change Service (ERA5)

How a twin is chosen

  • Same area: fires that have already ended, less than 250 km from this one, since 2016.
  • Same start: we compare the FWI on the first day, the minimum humidity that day and the run of days without rain before it. The slider sets how much they may differ.
  • Only pages with final weather data (ERA5 reanalysis) calculated in the same way as this fire’s; agricultural and grass burns and pages with data under review are left out.
  • Fires burning at the same time as this one (a week before or after) are left out: they share the same spell of weather and do not count as a precedent.
  • They are sorted by similarity, and the outlines of the first five are drawn.

How we calculate it

Before and after, from space

Drag the line to compare the same ground before the fire and after it.

Before · 19 Dec 2021
After · 19 Jan 2022

If the day is cloudy, change the date: each satellite passes once a day. In false colour the burnt ground looks brown or red.

Detections table · 152Every satellite heat detection, one by one, with time, satellite, power and coordinates.
⬇ Download CSV Times in UTC. Each detection is a 375 m pixel: a large fire yields hundreds per pass.
Date and timeSatelliteFRP (MW)LatLon

Other fires nearby

All fires in Argentina

Frequently asked questions

How long did the Bermejo fire last?
According to the heat detections seen by satellite inside the perimeter, it burned from 26 December 2021 to 12 January 2022 (18 days). The perimeter dates it from 26 December 2021 to 5 January 2022.
How much area did it burn?
The perimeter GWIS (Copernicus) rebuilt from heat detections is 2,499 hectares (25.0 km²). It is an estimate: official national figures may differ.
Which municipalities burned?
The fire only entered Bermejo (2,499 ha, 0.2 %).
What was the weather like?
During the fire the temperature reached 45.3 °C, humidity dropped to 15 % and gusts hit 47 km/h. The fire danger index (FWI) reached 58, class Extreme.
Where does this data come from?
From the GWIS (Copernicus) burnt perimeter, NASA FIRMS VIIRS hotspots and the administrative boundaries of Argentina (geoBoundaries). It is not an official report.
How did the fires that started in similar weather in this area end?
Fires less than 250 km away that started since 2016 with a similar FWI, humidity and dry spell: 29. Their median duration was 6 days and their median area 1,873 ha; 100 % went past 1,000 ha. In 6 of 29, not even 1 mm fell in the ten days after the end: they went out without rain. In the rest, the first rainy day brought a median of 3.5 mm.

Where to verify it

A satellite detection is not an official report. Final figures and the fire’s status are published by each country’s emergency service.

Emergency number: 911 · 100 · Emergency number and official warnings

Satellite cross-check

History of this page · 1 Changes in area, dates, name, official record or merged pages, compared every night since 24 October 2026.
  1. Last day with fire: 5 January 2022 → 12 January 2022.

RSS Changes to this page With cross-checks and a citable version

Does something look wrong on this page?

This page is built from satellite data and official records, and it sometimes gets things wrong: the wrong dates, the wrong town, two fires merged into one, or something that was not a wildfire at all. If you know this fire first-hand (you live nearby, saw it, fought it or reported on it), tell us what really happened and we will check it.

Report an error
What do you think is wrong?

We will only use your email to reply about this report. Privacy. This is not an emergency service: if there is a fire now, call 911 · 100.

How we know this
  • Perimeter: GWIS (Copernicus), rebuilt from heat detections rather than mapped on imagery.
  • Dates adjusted with the VIIRS detections inside the perimeter, which said 26 December 2021 to 5 January 2022. 152 Suomi-NPP VIIRS detections on those dates.
  • We have not matched this page with any official record.
  • Weather: Copernicus ERA5 reanalysis at the fire location, in cells of about 25 km.
  • Built-up area and population come from the JRC Global Human Settlement Layer (epoch 2020, 100 m cells), summed inside the perimeter: an estimate of what was there, not a damage count.

How we build fire pages: methodology

Where this data comes from

The perimeter comes from the Copernicus Global Wildfire Information System (GWIS), which rebuilds it from MODIS and VIIRS heat detections and publishes it under CC BY 4.0. It is not measured on imagery as in Europe, so it is an estimate. Heat detections come from the VIIRS sensors aboard Suomi-NPP and NOAA-20, distributed by NASA FIRMS at 375 m resolution. Municipal boundaries come from geoBoundaries ADM2 (Creative Commons Attribution 3.0 Intergovernmental Organisations (CC BY 3.0 IGO)). The area per municipality is computed by WorldFires by crossing the perimeter with those boundaries, so it may differ from each country’s official figure.