Skip to content
worldfires
US · United States · →

Windy Deuce Fire, February 2024 Carson, Potter, Moore

Out · last detection 29 Feb 2024, 09:12 UTC

The fire started on 24 February 2024 in Potter, United States, and satellites saw it burning for 6 days. United States agencies (MTBS / NIFC) mapped an official burnt perimeter of 59,082 hectares, spread across 4 counties.

It is the 3th largest in Texas since 2016 (of 327 with a page). Number 10 in United States in 2024, of 371.

Compare with…
Burnt area
59,082ha
official perimeter (MTBS / NIFC)
Duration
≈ 6days
24 Feb 2024 – 29 Feb 2024
Counties hit
4
counties
Started on
24 Feb
2024
Heat detections
357
in a single hotspot: 104 MW
Danger at start
29
High · FWI index
Average daily power
733MW
detected power per day, on average

Where it burned

HOTSPOTS BY DAY 24 Feb29 Feb
29 Feb 2024

How it evolved, day by day

24 Feb 2024 · 43 MW · 4 25 Feb 2024 · 195 MW · 18 27 Feb 2024 · 1,341 MW · 96 28 Feb 2024 · 2,075 MW · 233 29 Feb 2024 · 13 MW · 6
24 Feb 25 Feb 27 Feb 28 Feb 29 Feb

Fire radiative power detected each day, in megawatts, and number of hotspots. The magenta bar marks the peak day.

The weather it burned in

27°high
89km/h · peak gust
5%lowest humidity

It had gone 12 days without rain (1 mm or more) when it started.

This area had burned before

13% of the perimeter overlaps earlier fires recorded since 2016: 2,586 ha in 2016, 328 ha in 2017, 357 ha in 2018, 590 ha in 2021, 3,981 ha in 2022.

How big is it?

10 km
It burned the equivalent of 37% of the area of London (591 km² against 1,583 km²).

London boundary: geoBoundaries · Office for National Statistics (Open Government Licence v3.0).

This compares size, not location: both shapes are at the same scale, north up, centred on each other.

What happened to each county

  1. 28,005 ha reached on 28 Feb
    12 %
  2. Potter where it started
    24,902 ha reached on 27 Feb
    10 %
  3. 4,836 ha reached on 24 Feb
    2.0 %
  4. 1,471 ha
    0.6 %

Burnt area inside each county, from crossing the official perimeter with administrative boundaries. The distance runs from the point marking the centre of each area to the nearest fire: staying a kilometre away does not mean it reached the houses.

People and buildings inside the perimeter

GHSL 2025
Built-up area35 ha
Residents≈ 900

Inside the perimeter there were about 35 hectares of built-up land and about 900 residents (GHSL 2025, satellite-based estimate).

This is an estimate on 100 m cells, made from satellite imagery and census data: it does not mean that homes burned or that anyone was harmed. The perimeter also contains land that never burned. The GHSL 2025 epoch is a projection made from 2020 and earlier data.

Source: Global Human Settlement Layer (GHS-BUILT-S and GHS-POP R2023A), European Commission Joint Research Centre (JRC), © European Union, CC BY 4.0. Sum inside the perimeter computed by WorldFires. human-settlement.emergency.copernicus.eu

The weather day by day

ECMWF ERA5 reanalysis at the fire location, the standard reference for past weather, and the Canadian Fire Weather Index (the same system Copernicus uses), computed by WorldFires from that data. Days after the fire run until the first rain.

Open-Meteo.com (CC BY 4.0) · Copernicus Climate Change Service (ERA5)

Day High Min. humidity Peak gust Rain Danger (FWI)
24 Feb 23.8 °C 8 % 54 km/h 0.0 mm High 29
25 Feb 26.3 °C 5 % 42 km/h 0.0 mm High 28
26 Feb 27.4 °C 15 % 80 km/h 0.0 mm Extreme 52
27 Feb 23.0 °C 19 % 89 km/h 0.0 mm Extreme 52
28 Feb 9.3 °C 21 % 51 km/h 0.0 mm High 26
29 Feb 6.4 °C 43 % 55 km/h 1.4 mm Low 7
1 Mar after 23.0 °C 14 % 38 km/h 0.0 mm Moderate 20
2 Mar after 25.1 °C 7 % 59 km/h 0.0 mm Very high 45
3 Mar after 25.2 °C 11 % 67 km/h 0.0 mm Very high 47
4 Mar after 16.3 °C 22 % 38 km/h 0.0 mm High 32
5 Mar after 15.9 °C 35 % 32 km/h 0.0 mm Moderate 19
6 Mar after 19.5 °C 24 % 36 km/h 0.0 mm Moderate 21
7 Mar after 20.7 °C 18 % 49 km/h 0.0 mm High 28
8 Mar after 5.7 °C 63 % 56 km/h 0.1 mm Moderate 18
9 Mar after 11.8 °C 31 % 37 km/h 0.0 mm Moderate 17
10 Mar after 19.3 °C 18 % 38 km/h 0.0 mm High 22

Before and after, from space

Drag the line to compare the same ground before the fire and after it.

Before · 17 Feb 2024
After · 7 Mar 2024

If the day is cloudy, change the date: each satellite passes once a day. In false colour the burnt ground looks brown or red.

The smoke

CAMS · Copernicus

On 28 February 2024 the air beside the fire reached 78 µg/m³ of PM2.5. That day averaged 18: 1.2 times the WHO daily guideline (15).

PM2.5 peak78 µg/m³
Days over the guideline1 day
PM10112 µg/m³
Optical depth0.85
25262728291
Good Fair Moderate Poor Very poor Extremely poor

Particles from the Copernicus CAMS model at the centre of the perimeter; these are not measurements in each town. The pale bar is the worst hour, the solid one the daily average.

Open-Meteo.com (CC BY 4.0) · Copernicus Atmosphere Monitoring Service (CAMS)

Detections table · 357Every satellite heat detection, one by one, with time, satellite, power and coordinates.
⬇ Download CSV Times in UTC. Each detection is a 375 m pixel: a large fire yields hundreds per pass.
Date and timeSatelliteFRP (MW)LatLon

Other fires nearby

All fires in United States ›

Frequently asked questions

How long did the Windy Deuce Fire last?
The official perimeter only gives the start date (27 February 2024). The end comes from the heat detections inside the perimeter: it burned until 29 February 2024 (6 days from 24 February 2024), the last day with detections before more than 10 days in a row without any, so it is approximate.
How much area did it burn?
The official perimeter published by United States agencies (MTBS / NIFC) is 59,082 hectares (590.8 km²). Other tallies, such as daily incident reports, may give slightly different figures.
Which counties burned?
The fire entered 4 counties: Carson (28,005 ha, 12 %); Potter (24,902 ha, 10 %); Moore (4,836 ha, 2.0 %); Hutchinson (1,471 ha, 0.6 %).
What was the weather like?
During the fire the temperature reached 27.4 °C, humidity dropped to 5 % and gusts hit 89 km/h. The fire danger index (FWI) reached 52, class Extreme.
Where does this data come from?
From the official burnt perimeter of United States agencies (MTBS / NIFC, public domain), NASA FIRMS VIIRS hotspots and the administrative boundaries of United States. It is not an official report.

Where to verify it

A satellite detection is not an official report. Final figures and the fire’s status are published by each country’s emergency service.

Emergency number: 911 · Emergency number and official warnings ›

Satellite cross-check

History of this page Changes in area, dates, name, official record or merged pages, compared every night since 24 October 2026.

No changes since 24 October 2026.

RSS Changes to this page

Does something look wrong on this page?

This page is built from satellite data and official records, and it sometimes gets things wrong: the wrong dates, the wrong town, two fires merged into one, or something that was not a wildfire at all. If you know this fire first-hand (you live nearby, saw it, fought it or reported on it), tell us what really happened and we will check it.

Report an error
What do you think is wrong?

We will only use your email to reply about this report. Privacy. This is not an emergency service: if there is a fire now, call 911.

How we know this
  • Perimeter: MTBS (US Geological Survey and US Forest Service), official.
  • The official perimeter has no end date: the end is the last day with VIIRS detections inside the perimeter before a gap of more than 10 days (150 days at most), so it is approximate. 357 Suomi-NPP VIIRS detections on those dates.
  • We have not matched this page with any official record.
  • Weather: Copernicus ERA5 reanalysis at the fire location, in cells of about 25 km.
  • Built-up area and population come from the JRC Global Human Settlement Layer (epoch 2025, 100 m cells), summed inside the perimeter: an estimate of what was there, not a damage count.

How we build fire pages: methodology ›

Where this data comes from

The perimeter is official and in the public domain. For past years it comes from MTBS (Monitoring Trends in Burn Severity), run by the U.S. Geological Survey and the USDA Forest Service, which map it on Landsat and Sentinel-2 imagery. For the current and last year it comes from WFIGS at the National Interagency Fire Center (NIFC): incident perimeters mapped by fire crews, aircraft and imagery. Heat detections come from the VIIRS sensors aboard Suomi-NPP and NOAA-20, distributed by NASA FIRMS at 375 m resolution. County boundaries come from geoBoundaries ADM2 (Public Domain). The area per county is computed by WorldFires by crossing the perimeter with those boundaries, so it may differ slightly from official figures.