Skip to content
worldfires
UK · United Kingdom · →

Wiltshire fire, June 2018 Wiltshire

Out · last detection 22 Jun 2018, 13:12 UTC

The fire started on 22 June 2018 in Wiltshire, United Kingdom, and satellites saw it burning for 1 day. Copernicus mapped a burnt perimeter of 201 hectares from satellite imagery, spread across a single municipality.

It is the 20th largest in England since 2016 (of 29 with a page). Number 15 in United Kingdom in 2018, of 19.

The power measured by the satellite is low (6.2 MW in the strongest hotspot), more typical of grass or stubble burning, or a slow surface fire, than of a large crown fire.

Compare with…
Burnt area
201ha
Copernicus perimeter
Duration
1day
22 Jun 2018 – 22 Jun 2018
Municipalities hit
1
districts
Started on
22 Jun
2018
Heat detections
3
in a single hotspot: 6 MW
Danger at start
10
Low · FWI index
Average daily power
16MW
detected power per day, on average

Where it burned

HOTSPOTS BY DAY 22 Jun22 Jun

How it evolved, day by day

22 Jun 2018 · 16 MW · 3

Fire radiative power detected each day, in megawatts, and number of hotspots. The magenta bar marks the peak day.

The weather it burned in

20°high
28km/h · peak gust
42%lowest humidity

It had gone 14 days without rain (1 mm or more) when it started.

This area had burned before

No earlier perimeters overlap this fire since 2016, when the satellite record begins.

What happened to each town

  1. Wiltshire where it started
    201 ha reached on 22 Jun
    0.1 %

Burnt area inside each municipality, from crossing the official perimeter with administrative boundaries. The distance runs from the point marking the centre of each area to the nearest fire: staying a kilometre away does not mean it reached the houses.

What burned

  • Other natural land100 %

Protected area affected (EFFIS layer): 100 %

Land cover inside the perimeter according to Corine Land Cover, as reported by Copernicus.

The weather day by day

ECMWF ERA5 reanalysis at the fire location, the standard reference for past weather, and the Canadian Fire Weather Index (the same system Copernicus uses), computed by WorldFires from that data. Days after the fire run until the first rain.

Open-Meteo.com (CC BY 4.0) · Copernicus Climate Change Service (ERA5)

Day High Min. humidity Peak gust Rain Danger (FWI)
22 Jun 20.4 °C 42 % 28 km/h 0.0 mm Low 10
23 Jun after 21.8 °C 39 % 27 km/h 0.0 mm Moderate 11
24 Jun after 22.9 °C 33 % 22 km/h 0.0 mm Moderate 13
25 Jun after 26.6 °C 30 % 20 km/h 0.0 mm Moderate 15
26 Jun after 27.3 °C 34 % 22 km/h 0.0 mm Moderate 16
27 Jun after 26.5 °C 33 % 36 km/h 0.0 mm Moderate 20
28 Jun after 26.1 °C 42 % 40 km/h 0.0 mm High 22
29 Jun after 26.4 °C 34 % 38 km/h 0.0 mm High 22
30 Jun after 27.0 °C 36 % 35 km/h 0.0 mm High 22
1 Jul after 27.9 °C 41 % 31 km/h 0.2 mm High 21
2 Jul after 28.3 °C 27 % 43 km/h 0.0 mm High 28

Before and after, from space

Drag the line to compare the same ground before the fire and after it.

Before · 15 Jun 2018
After · 29 Jun 2018

If the day is cloudy, change the date: each satellite passes once a day. In false colour the burnt ground looks brown or red.

The smoke

CAMS · Copernicus

On 25 June 2018 the air beside the fire reached 18 µg/m³ of PM2.5, but no daily average passed the WHO guideline (15).

PM2.5 peak18 µg/m³
Days over the guideline0 days
PM1021 µg/m³
202122232425
Good Fair Moderate Poor Very poor Extremely poor

Particles from the Copernicus CAMS model at the centre of the perimeter; these are not measurements in each town. The pale bar is the worst hour, the solid one the daily average.

Open-Meteo.com (CC BY 4.0) · Copernicus Atmosphere Monitoring Service (CAMS)

Detections table · 3Every satellite heat detection, one by one, with time, satellite, power and coordinates.
⬇ Download CSV Times in UTC. Each detection is a 375 m pixel: a large fire yields hundreds per pass.
Date and timeSatelliteFRP (MW)LatLon

Other fires nearby

All fires in United Kingdom ›

Frequently asked questions

How long did the Wiltshire fire last?
Copernicus dates it between 22 June 2018 and 22 June 2018: 1 day between the first and last image with fire.
How much area did it burn?
The perimeter Copernicus measured from satellite imagery is 201 hectares (2.0 km²). Official national figures may differ.
Which municipalities burned?
The fire only entered Wiltshire (201 ha, 0.1 %).
What was the weather like?
During the fire the temperature reached 20.4 °C, humidity dropped to 42 % and gusts hit 28 km/h. The fire danger index (FWI) reached 10, class Low.
Where does this data come from?
From the EFFIS (Copernicus) burnt perimeter, NASA FIRMS VIIRS hotspots and the administrative boundaries of United Kingdom (geoBoundaries). It is not an official report.

Where to verify it

A satellite detection is not an official report. Final figures and the fire’s status are published by each country’s emergency service.

Emergency number: 999 · 112 · Emergency number and official warnings ›

Satellite cross-check

History of this page Changes in area, dates, name, official record or merged pages, compared every night since 24 October 2026.

No changes since 24 October 2026.

RSS Changes to this page

Does something look wrong on this page?

This page is built from satellite data and official records, and it sometimes gets things wrong: the wrong dates, the wrong town, two fires merged into one, or something that was not a wildfire at all. If you know this fire first-hand (you live nearby, saw it, fought it or reported on it), tell us what really happened and we will check it.

Report an error
What do you think is wrong?

We will only use your email to reply about this report. Privacy. This is not an emergency service: if there is a fire now, call 999 · 112.

How we know this
  • Perimeter: EFFIS (Copernicus), mapped on satellite imagery.
  • Dates from the perimeter: the VIIRS detections inside it did not change them. 3 Suomi-NPP VIIRS detections on those dates.
  • We have not matched this page with any official record.
  • Weather: Copernicus ERA5 reanalysis at the fire location, in cells of about 25 km.

How we build fire pages: methodology ›

Where this data comes from

The perimeter and land cover come from the Copernicus European Forest Fire Information System (EFFIS), measured on MODIS and Sentinel-2 imagery and published under CC BY 4.0. Heat detections come from the VIIRS sensors aboard Suomi-NPP and NOAA-20, distributed by NASA FIRMS at 375 m resolution. Municipal boundaries come from geoBoundaries ADM3 (Open Government Licence v3.0). The area per municipality is computed by WorldFires by crossing the perimeter with those boundaries, so it may differ slightly from each country’s official figure.