Skip to content
worldfires
US · United States · –

Welcome Home 1 Fire, October 2016 Clay

Out · last detection 1 Nov 2016, 18:25 UTC

The fire started on 29 October 2016 in Clay, United States, and satellites saw it burning for 4 days. United States agencies (MTBS / NIFC) mapped an official burnt perimeter of 427 hectares, spread across a single county.

It is the 11th largest in Alabama since 2016 (of 14 with a page). Number 468 in United States in 2016, of 475.

The power measured by the satellite is low (17.9 MW in the strongest hotspot), more typical of grass or stubble burning, or a slow surface fire, than of a large crown fire.

Burnt area
427ha
official perimeter (MTBS / NIFC)
Duration
≈ 4days
29 Oct 2016 – 1 Nov 2016
Counties hit
1
counties
Started on
29 Oct
2016
Heat detections
55
in a single hotspot: 18 MW
Danger at start
25
High · FWI index
Average daily power
108MW
detected power per day, on average

Where it burned

HOTSPOTS BY DAY 29 Oct1 Nov
1 Nov 2016

How it evolved, day by day

30 Oct 2016 · 28 MW · 4 31 Oct 2016 · 230 MW · 33 1 Nov 2016 · 66 MW · 18
30 Oct 31 Oct 1 Nov

Fire radiative power detected each day, in megawatts, and number of hotspots. The magenta bar marks the peak day.

The weather it burned in

29°high
28km/h · peak gust
30%lowest humidity

It had gone 12 days without rain (1 mm or more) when it started.

This area had burned before

No earlier perimeters overlap this fire since 2016, when the satellite record begins.

What happened to each county

  1. Clay where it started
    428 ha reached on 30 Oct
    0.3 %

Burnt area inside each county, from crossing the official perimeter with administrative boundaries. The distance runs from the point marking the centre of each area to the nearest fire: staying a kilometre away does not mean it reached the houses.

People and buildings inside the perimeter

GHSL 2015
Built-up area< 0.1 ha
Residents< 20

Inside the perimeter there was no noticeable built-up land and almost nobody lived there (GHSL 2015, satellite-based estimate).

This is an estimate on 100 m cells, made from satellite imagery and census data: it does not mean that homes burned or that anyone was harmed. The perimeter also contains land that never burned.

Source: Global Human Settlement Layer (GHS-BUILT-S and GHS-POP R2023A), European Commission Joint Research Centre (JRC), © European Union, CC BY 4.0. Sum inside the perimeter computed by WorldFires. human-settlement.emergency.copernicus.eu

The weather day by day

ECMWF ERA5 reanalysis at the fire location, the standard reference for past weather, and the Canadian Fire Weather Index (the same system Copernicus uses), computed by WorldFires from that data. Days after the fire run until the first rain.

Open-Meteo.com (CC BY 4.0) · Copernicus Climate Change Service (ERA5)

Day High Min. humidity Peak gust Rain Danger (FWI)
29 Oct 28.4 °C 31 % 17 km/h 0.0 mm High 25
30 Oct 28.5 °C 30 % 23 km/h 0.0 mm High 31
31 Oct 29.2 °C 32 % 17 km/h 0.0 mm High 25
1 Nov 28.8 °C 30 % 28 km/h 0.0 mm High 33
2 Nov after 25.2 °C 51 % 31 km/h 0.0 mm High 28
3 Nov after 27.0 °C 41 % 30 km/h 0.0 mm High 29
4 Nov after 25.3 °C 22 % 42 km/h 0.0 mm Very high 42
5 Nov after 22.3 °C 35 % 27 km/h 0.0 mm High 30
6 Nov after 21.6 °C 25 % 23 km/h 0.0 mm High 32
7 Nov after 23.4 °C 24 % 36 km/h 0.0 mm Very high 40
8 Nov after 20.3 °C 27 % 26 km/h 0.0 mm High 34
9 Nov after 20.1 °C 38 % 37 km/h 0.0 mm High 31
10 Nov after 20.5 °C 19 % 29 km/h 0.0 mm High 31
11 Nov after 19.3 °C 29 % 30 km/h 0.0 mm High 34

Its twins: fires that started in the same weather

It started with an FWI of 25.0, a minimum humidity of 31% and 12 days without rain. Fires in the area that started in weather like this since 2016: 6.

FWI at the start 25.0
Minimum humidity 31 %
Days without rain 12
this fire chosen twins rest of the area
Almost identicalSimilar

Outlines of the closest twins

Tank Fire, September 2016
528 ha 2 days FWI 29.7 Min. humidity 28 % 36 km away, in 2016

First rain (1 mm or more) after it ended: 2.0 mm on 27 Sept.

What happened to them

Fires in the area that started in similar weather: 6. With fewer than 15 we give no figures: they would be more noise than signal.

This is a bank of analogues: it shows what usually happens, not what will happen. With fewer than 15 twins we give no figures. How we calculate it

How it ended

—first rain
—no rain in ten days
28km/h · max. gust

It was considered over on 1 Nov, and not even 1 mm fell in the following ten days: it went out without rain.

Weather on this page: Open-Meteo.com (CC BY 4.0) · Copernicus Climate Change Service (ERA5)

How a twin is chosen

  • Same area: fires that have already ended, less than 250 km from this one, since 2016.
  • Same start: we compare the FWI on the first day, the minimum humidity that day and the run of days without rain before it. The slider sets how much they may differ.
  • Only pages with final weather data (ERA5 reanalysis) calculated in the same way as this fire’s; agricultural and grass burns and pages with data under review are left out.
  • Fires burning at the same time as this one (a week before or after) are left out: they share the same spell of weather and do not count as a precedent.
  • They are sorted by similarity, and the outlines of the first five are drawn.

How we calculate it

Before and after, from space

Drag the line to compare the same ground before the fire and after it.

Before · 22 Oct 2016
After · 8 Nov 2016

If the day is cloudy, change the date: each satellite passes once a day. In false colour the burnt ground looks brown or red.

Detections table · 55Every satellite heat detection, one by one, with time, satellite, power and coordinates.
⬇ Download CSV Times in UTC. Each detection is a 375 m pixel: a large fire yields hundreds per pass.
Date and timeSatelliteFRP (MW)LatLon

Other fires nearby

All fires in United States

Frequently asked questions

How long did the Welcome Home 1 Fire last?
The official perimeter only gives the start date (29 October 2016). The end comes from the heat detections inside the perimeter: it burned until 1 November 2016 (4 days from 29 October 2016), the last day with detections before more than 10 days in a row without any, so it is approximate.
How much area did it burn?
The official perimeter published by United States agencies (MTBS / NIFC) is 427 hectares (4.3 km²). Other tallies, such as daily incident reports, may give slightly different figures.
Which counties burned?
The fire only entered Clay (428 ha, 0.3 %).
What was the weather like?
During the fire the temperature reached 29.2 °C, humidity dropped to 30 % and gusts hit 28 km/h. The fire danger index (FWI) reached 33, class High.
Where does this data come from?
From the official burnt perimeter of United States agencies (MTBS / NIFC, public domain), NASA FIRMS VIIRS hotspots and the administrative boundaries of United States. It is not an official report.

Where to verify it

A satellite detection is not an official report. Final figures and the fire’s status are published by each country’s emergency service.

Emergency number: 911 · Emergency number and official warnings

Satellite cross-check

History of this page Changes in area, dates, name, official record or merged pages, compared every night since 24 October 2026.

Does something look wrong on this page?

This page is built from satellite data and official records, and it sometimes gets things wrong: the wrong dates, the wrong town, two fires merged into one, or something that was not a wildfire at all. If you know this fire first-hand (you live nearby, saw it, fought it or reported on it), tell us what really happened and we will check it.

Report an error
What do you think is wrong?

We will only use your email to reply about this report. Privacy. This is not an emergency service: if there is a fire now, call 911.

How we know this
  • Perimeter: MTBS (US Geological Survey and US Forest Service), official.
  • The official perimeter has no end date: the end is the last day with VIIRS detections inside the perimeter before a gap of more than 10 days (150 days at most), so it is approximate. 55 Suomi-NPP VIIRS detections on those dates.
  • We have not matched this page with any official record.
  • Weather: Copernicus ERA5 reanalysis at the fire location, in cells of about 25 km.
  • Built-up area and population come from the JRC Global Human Settlement Layer (epoch 2015, 100 m cells), summed inside the perimeter: an estimate of what was there, not a damage count.

How we build fire pages: methodology

Where this data comes from

The perimeter is official and in the public domain. For past years it comes from MTBS (Monitoring Trends in Burn Severity), run by the U.S. Geological Survey and the USDA Forest Service, which map it on Landsat and Sentinel-2 imagery. For the current and last year it comes from WFIGS at the National Interagency Fire Center (NIFC): incident perimeters mapped by fire crews, aircraft and imagery. Heat detections come from the VIIRS sensors aboard Suomi-NPP and NOAA-20, distributed by NASA FIRMS at 375 m resolution. County boundaries come from geoBoundaries ADM2 (Public Domain). The area per county is computed by WorldFires by crossing the perimeter with those boundaries, so it may differ slightly from official figures.