Skip to content
worldfires
UA · Ukraine · –

Vovchansk fire, 18 September 2026 Вовчанський район · Ukraine

Out · last detection

Satellites first detected fire on in Vovchansk, Ukraine. It was active for 15 days, with 6 heat detections and an area with fire of about 196 hectares rebuilt from them, spread across a single municipality.

The power measured by the satellite is low (11.0 MW in the strongest hotspot), more typical of grass or stubble burning, or a slow surface fire, than of a large crown fire.

Copernicus has not yet published the burnt perimeter, which takes a few days to measure on satellite imagery. For now the area is the one rebuilt from heat detections (about 14 hectares per pixel). When the perimeter arrives, this page picks it up on its own and keeps the same address.

Area with fire
≈ 196ha
rebuilt from hotspots, no official perimeter yet
Duration
15days
18 Sept 2026 – 2 Oct 2026
Municipalities hit
0
districts
Started on
18 Sept
2026
Heat detections
6
in a single hotspot: 11 MW
Danger at start
14
Moderate · FWI index
Average daily power
16MW
detected power per day, on average

Where it burned

HOTSPOTS BY DAY 18 Sept2 Oct
2 Oct 2026

How it evolved, day by day

18 Sept 2026 · 17 MW · 2 19 Sept 2026 · 25 MW · 3 21 Sept 2026 · 7 MW · 1 28 Sept 2026 · 0 MW · 0 1 Oct 2026 · 0 MW · 0 2 Oct 2026 · 0 MW · 0
19 Sept 1 Oct

Fire radiative power detected each day, in megawatts, and number of hotspots. The magenta bar marks the peak day.

The weather it burned in

26°high
67km/h · peak gust
35%lowest humidity

It had gone one day without rain (1 mm or more) when it started. Rain came after the fire: 2.6 mm on 10 Oct.

The weather day by day

ECMWF ERA5 reanalysis at the fire location, the standard reference for past weather, and the Canadian Fire Weather Index (the same system Copernicus uses), computed by WorldFires from that data. Days after the fire run until the first rain.

Open-Meteo.com (CC BY 4.0) · Copernicus Climate Change Service (ERA5)

Day High Min. humidity Peak gust Rain Danger (FWI)
18 Sept 23.1 °C 36 % 26 km/h 0.0 mm Moderate 14
19 Sept 25.6 °C 35 % 23 km/h 0.0 mm Moderate 19
20 Sept 24.9 °C 41 % 17 km/h 0.0 mm Moderate 13
21 Sept 25.9 °C 37 % 37 km/h 0.9 mm High 23
22 Sept 18.3 °C 65 % 40 km/h 3.1 mm Very low 2
23 Sept 18.7 °C 68 % 67 km/h 8.3 mm Very low 0
24 Sept 14.7 °C 66 % 67 km/h 0.2 mm Very low 1
25 Sept 15.6 °C 59 % 24 km/h 0.0 mm Very low 2
26 Sept 18.8 °C 41 % 20 km/h 0.0 mm Low 7
27 Sept 15.9 °C 76 % 35 km/h 0.2 mm Low 10
28 Sept 19.4 °C 50 % 40 km/h 0.5 mm Moderate 14
29 Sept 18.0 °C 59 % 42 km/h 0.0 mm Moderate 16
30 Sept 17.6 °C 54 % 47 km/h 0.0 mm Moderate 17
1 Oct 18.3 °C 40 % 43 km/h 0.0 mm Moderate 20
2 Oct 13.9 °C 36 % 40 km/h 0.0 mm Moderate 20
3 Oct after 14.1 °C 47 % 36 km/h 0.1 mm Moderate 19
4 Oct after 15.3 °C 52 % 30 km/h 0.0 mm Moderate 17
5 Oct after 18.6 °C 46 % 32 km/h 0.0 mm Moderate 17
6 Oct after 18.7 °C 45 % 35 km/h 0.0 mm Moderate 19
7 Oct after 20.1 °C 50 % 37 km/h 0.0 mm Moderate 17
8 Oct after 20.8 °C 43 % 18 km/h 0.0 mm Moderate 13
9 Oct after 21.8 °C 38 % 45 km/h 0.6 mm High 26
10 Oct after 16.6 °C 39 % 31 km/h 2.6 mm Very low 4

Its twins: fires that started in the same weather

It started with an FWI of 13.7, a minimum humidity of 36% and 1 day without rain. Fires in the area that started in weather like this since 2020: 17.

FWI at the start 13.7
Minimum humidity 36 %
Days without rain 1
this fire chosen twins rest of the area
Almost identicalSimilar

Outlines of the closest twins

Kreminna fire, June 2023
121 ha 6 days FWI 14.6 Min. humidity 35 % 161 km away, in 2023

First rain (1 mm or more) after it ended: 12.5 mm on 11 Jun.

What happened to them

1 day
median duration
153 ha
median area
0 %
went past 1,000 ha
3.3 mm
rain at the end (median; 15 of 17 had it)

It burned an area similar to its twins (196 ha against a median of 153 ha) and lasted 15 days, against 1 day.

In 2 of 17, not even 1 mm fell in the ten days after the end: they went out without rain. In the rest, the first rainy day brought a median of 3.3 mm.

This is a bank of analogues: it shows what usually happens, not what will happen. With fewer than 15 twins we give no figures. How we calculate it

How it ended

2.6 mmfirst rain
10 Oct8 days after it ended
67km/h · max. gust

It was considered over on 2 Oct, and on 10 Oct 2.6 mm fell. We do not know whether the rain or the firefighters put it out. Twins with rain when they ended: 15 of 17, with a median of 3.3 mm.

Weather on this page: Open-Meteo.com (CC BY 4.0) · Copernicus Climate Change Service (ERA5)

How a twin is chosen

  • Same area: fires that have already ended, less than 250 km from this one, since 2020.
  • Same start: we compare the FWI on the first day, the minimum humidity that day and the run of days without rain before it. The slider sets how much they may differ.
  • Only pages with final weather data (ERA5 reanalysis) calculated in the same way as this fire’s; agricultural and grass burns and pages with data under review are left out.
  • Fires burning at the same time as this one (a week before or after) are left out: they share the same spell of weather and do not count as a precedent.
  • They are sorted by similarity, and the outlines of the first five are drawn.

How we calculate it

Before and after, from space

Drag the line to compare the same ground before the fire and after it.

Before · 11 Sept 2026
After · 9 Oct 2026

If the day is cloudy, change the date: each satellite passes once a day. In false colour the burnt ground looks brown or red.

The smoke

CAMS · Copernicus

On 19 September 2026 the air beside the fire reached 12 µg/m³ of PM2.5, but no daily average passed the WHO guideline (15).

PM2.5 peak12 µg/m³
Days over the guideline0 days
PM1015 µg/m³
Optical depth0.28
16171819
Good Fair Moderate Poor Very poor Extremely poor

Particles from the Copernicus CAMS model at the centre of the perimeter; these are not measurements in each town. The pale bar is the worst hour, the solid one the daily average.

Open-Meteo.com (CC BY 4.0) · Copernicus Atmosphere Monitoring Service (CAMS)

Detections table · 6Every satellite heat detection, one by one, with time, satellite, power and coordinates.
⬇ Download CSV Times in UTC. Each detection is a 375 m pixel: a large fire yields hundreds per pass.
Date and timeSatelliteFRP (MW)LatLon

Other fires nearby

All fires in Ukraine

Frequently asked questions

How long did the Vovchansk fire last?
According to the heat detections seen by satellite, it burned from 18 September 2026 to 2 October 2026 (15 days between the first and the last detection). There is no perimeter yet to date it.
How much area did it burn?
There is no official perimeter yet. Heat detections rebuild about 196 hectares with fire (2.0 km²); Copernicus will publish the measured figure within days.
What was the weather like?
During the fire the temperature reached 25.9 °C, humidity dropped to 35 % and gusts hit 67 km/h. The fire danger index (FWI) reached 23, class High.
Where does this data come from?
From the EFFIS (Copernicus) burnt perimeter, NASA FIRMS VIIRS hotspots and the administrative boundaries of Ukraine (geoBoundaries). It is not an official report.
How did the fires that started in similar weather in this area end?
Fires less than 250 km away that started since 2020 with a similar FWI, humidity and dry spell: 17. Their median duration was 1 day and their median area 153 ha; 0 % went past 1,000 ha. In 2 of 17, not even 1 mm fell in the ten days after the end: they went out without rain. In the rest, the first rainy day brought a median of 3.3 mm.

Where to verify it

A satellite detection is not an official report. Final figures and the fire’s status are published by each country’s emergency service.

Emergency number: 101 · 112 · Emergency number and official warnings

Satellite cross-check

History of this page Changes in area, dates, name, official record or merged pages, compared every night since 24 October 2026.

Does something look wrong on this page?

This page is built from satellite data and official records, and it sometimes gets things wrong: the wrong dates, the wrong town, two fires merged into one, or something that was not a wildfire at all. If you know this fire first-hand (you live nearby, saw it, fought it or reported on it), tell us what really happened and we will check it.

Report an error
What do you think is wrong?

We will only use your email to reply about this report. Privacy. This is not an emergency service: if there is a fire now, call 101 · 112.

How we know this
  • No perimeter yet: the area (≈ 196 ha) is estimated by counting VIIRS pixels with fire, about 14 ha each.
  • Dates of the first and last VIIRS detection of the cluster. 6 Suomi-NPP VIIRS detections on those dates.
  • Weather: Copernicus ERA5 reanalysis at the fire location, in cells of about 25 km.

How we build fire pages: methodology

Where this data comes from

The perimeter and land cover come from the Copernicus European Forest Fire Information System (EFFIS), measured on MODIS and Sentinel-2 imagery and published under CC BY 4.0. Heat detections come from the VIIRS sensors aboard Suomi-NPP and NOAA-20, distributed by NASA FIRMS at 375 m resolution. Municipal boundaries come from geoBoundaries ADM2 (Public Domain). The area per municipality is computed by WorldFires by crossing the perimeter with those boundaries, so it may differ slightly from each country’s official figure.