Vieira do Minho fire, 14 October 2017
Cantelães, Louredo
Out · last detection 15 Oct 2017, 03:15 UTC
The fire started on 14 October 2017 in Cantelães, Portugal, and satellites saw it burning for 2 days. Copernicus mapped a burnt perimeter of 145 hectares from satellite imagery, spread across 2 freguesias.
It is the 10th largest in Vieira do Minho since 2016 (of 11 with a page). Number 169 in Portugal in 2017, of 211.
The power measured by the satellite is low (1.4 MW in the strongest hotspot), more typical of grass or stubble burning, or a slow surface fire, than of a large crown fire.
matches the official recordwith caveatssatellite onlymodel
When copying, the sentence is
Tick the figures you want: they make up the lede and the CSV.
Burned area
with caveats
145ha
Perimeter published by EFFIS (Copernicus).
This page145ICNF105
Source
EFFIS (Copernicus)
Date
perimeter revised on 26 January 2022
+− cross-check
ICNF: 105 ha (matched records: 1). Difference between the page and the official record: +38.1%. Matched on 15 November 2026. The two figures differ a lot, so these may not be exactly the same fire: take them as nearby records.
Duration by satellite
satellite only
2days
14 Oct 2017 to 15 Oct 2017: first and last day with fire on the page.
Source
EFFIS (Copernicus) · NASA FIRMS · VIIRS
Date
last detection: 15 Oct 2017, 03:15 UTC
+− cross-check
Satellites pass a few times a day and cloud or smoke can hide the fire: a lack of detections is not an official extinction. Each country’s emergency service declares a fire contained or out.
Start
satellite only
14 Oct 2017
First day with fire seen by the satellites or the perimeter.
Source
EFFIS (Copernicus) · NASA FIRMS · VIIRS
Date
14 Oct 2017
+− cross-check
The two figures differ a lot, so these may not be exactly the same fire: take them as nearby records.
Hotspots
satellite only
2
VIIRS detections at 375 m. Most intense hotspot: 1 MW.
Source
NASA FIRMS · VIIRS (Suomi NPP)
Date
14 Oct 2017 – 15 Oct 2017
+− cross-check
There is no official record to compare with. Each hotspot is a pixel detected in one satellite pass, not a separate fire.
The worst day
satellite only
2MW
Total radiative power on 15 October 2017; hotspots that day: 2.
Source
NASA FIRMS · VIIRS (FRP)
Date
15 Oct 2017
+− cross-check
Fire radiative power (FRP) measures the energy the fire gives off when the satellite passes. Added up by day, it compares intensity, not area.
Danger at the start
model
29.1FWI · high
Fire Weather Index (Canadian system) computed by WorldFires for the day the fire started. Consecutive days without rain before: 22.
This is an index computed from weather model data, not a measurement of the fire nor an official warning. Danger warnings are issued by each country’s authority. Emergency number and official warnings ›
Weather during the fire
model
26.8°C · 28% RH
High of 26.8 °C and minimum humidity of 28% on 15 October 2017; gusts of 58 km/h on 15 October 2017.
These are model values for a cell of about 25 km, not from a weather station: they may differ from what was measured on the ground.
ⓘThis page’s change log has been kept since 24 October 2026: every night what it publishes is compared and the difference is logged. Anything earlier is reconstructed from each source’s date and marked as reconstructed.
Show
· reconstructedofficial
Matched with the official ICNF record
Nearby records with very different figures: 105 ha (records: 1).
A version keeps the area, dates, name and official record; the area as it was logged (changes under 2% are not logged). The map, hotspots and weather always show today’s data.
Citation
A lede of about 60 words figures only, no adjectives
Burnt area inside each freguesia, from crossing the official perimeter with administrative boundaries. The distance runs from the point marking the centre of each area to the nearest fire: staying a kilometre away does not mean it reached the houses.
What burned
Other natural land86 %
Scrub and transitional woodland14 %
Land cover inside the perimeter according to Corine Land Cover, as reported by Copernicus.
Official record
According to ICNF, this fire started on 15 October 2017 and burned 105 ha (the satellite measured 145 ha). The two figures differ a lot, so these may not be exactly the same fire: take them as nearby records.
Vieira do MinhoCantelães15 October 2017105 ha· extinguished on 15 October 2017· cause: arson
ECMWF ERA5 reanalysis at the fire location, the standard reference for past weather, and the Canadian Fire Weather Index (the same system Copernicus uses), computed by WorldFires from that data. Days after the fire run until the first rain.
Open-Meteo.com (CC BY 4.0) · Copernicus Climate Change Service (ERA5)
Day
High
Min. humidity
Peak gust
Rain
Danger (FWI)
14 Oct
24.4 °C
33 %
37 km/h
0.0 mm
High 29
15 Oct
26.8 °C
28 %
58 km/h
0.8 mm
High 36
16 Oct after
19.0 °C
56 %
49 km/h
4.7 mm
Low 6
Its twins: fires that started in the same weather
It started with an FWI of 29.1, a minimum humidity of 33% and 22 days without rain. Fires in the area that started in weather like this since 2016: 26.
FWI at the start29.1
Minimum humidity33 %
Days without rain22
this firechosen twinsrest of the area
Almost identicalSimilar
Outlines of the closest twins
This fire · Vieira do Minho fire, 14 October 2017
145 ha2 daysFWI 29.1Min. humidity 33 %
Dozón fire, August 2025
377 ha2 daysFWI 29.9Min. humidity 34 %101 km away, in 2025
First rain (1 mm or more) after it ended: none in the following ten days.
It stayed below its twins: 145 ha against a median of 264 ha. It lasted 2 days, against 2 days.
In 14 of 26, not even 1 mm fell in the ten days after the end: they went out without rain. In the rest, the first rainy day brought a median of 3.2 mm.
This is a bank of analogues: it shows what usually happens, not what will happen. With fewer than 15 twins we give no figures. How we calculate it
How it ended
4.7 mmfirst rain
16 Octthe day after it ended
58km/h · max. gust
It was considered over on 15 Oct, and on 16 Oct 4.7 mm fell. We do not know whether the rain or the firefighters put it out. Twins with rain when they ended: 12 of 26, with a median of 3.2 mm.
Weather on this page: Open-Meteo.com (CC BY 4.0) · Copernicus Climate Change Service (ERA5)
How a twin is chosen
Same area: fires that have already ended, less than 250 km from this one, since 2016.
Same start: we compare the FWI on the first day, the minimum humidity that day and the run of days without rain before it. The slider sets how much they may differ.
Only pages with final weather data (ERA5 reanalysis) calculated in the same way as this fire’s; agricultural and grass burns and pages with data under review are left out.
Fires burning at the same time as this one (a week before or after) are left out: they share the same spell of weather and do not count as a precedent.
They are sorted by similarity, and the outlines of the first five are drawn.
Drag the line to compare the same ground before the fire and after it.
↔
Before · 7 Oct 2017
After · 22 Oct 2017
Sentinel-2 did not pass over on that day. Try another date, or use false colour, which is daily.
If the day is cloudy, change the date: each satellite passes once a day. In false colour the burnt ground looks brown or red.
The smoke
CAMS · Copernicus
On 15 October 2017 the air beside the fire reached 140 µg/m³ of PM2.5. That day averaged 67: 4.5 times the WHO daily guideline (15).
PM2.5 peak140µg/m³
Days over the guideline5days
PM10165µg/m³
WHO 15
12 Oct14 Oct16 Oct18 Oct
GoodFairModeratePoorVery poorExtremely poor
Particles from the Copernicus CAMS model at the centre of the perimeter; these are not measurements in each town. The pale bar is the worst hour, the solid one the daily average.
Open-Meteo.com (CC BY 4.0) · Copernicus Atmosphere Monitoring Service (CAMS)
Detections table· 2Every satellite heat detection, one by one, with time, satellite, power and coordinates.›
⬇ Download CSVTimes in UTC. Each detection is a 375 m pixel: a large fire yields hundreds per pass.
Copernicus dates it between 14 October 2017 and 15 October 2017: 2 days between the first and last image with fire.
How much area did it burn?
The perimeter Copernicus measured from satellite imagery is 145 hectares (1.4 km²). Official national figures may differ.
Which freguesias burned?
The fire entered 2 freguesias: Cantelães (145 ha, 13 %); Louredo (0 ha, 0.1 %).
Did the fire reach a town?
The fire came within 1.5 km of the centre of Louredo, the closest of the areas it touched. That is the distance from the perimeter, or the nearest hotspot, to the point marking the centre; it does not mean it entered the houses.
What was the weather like?
During the fire the temperature reached 26.8 °C, humidity dropped to 28 % and gusts hit 58 km/h. The fire danger index (FWI) reached 36, class High.
Where does this data come from?
From the EFFIS (Copernicus) burnt perimeter, NASA FIRMS VIIRS hotspots and the administrative boundaries of Portugal (geoBoundaries). It is not an official report.
How did the fires that started in similar weather in this area end?
Fires less than 250 km away that started since 2016 with a similar FWI, humidity and dry spell: 26. Their median duration was 2 days and their median area 264 ha; 23 % went past 1,000 ha. In 14 of 26, not even 1 mm fell in the ten days after the end: they went out without rain. In the rest, the first rainy day brought a median of 3.2 mm.
Where to verify it
A satellite detection is not an official report. Final figures and the fire’s status are published by each country’s emergency service.
This page is built from satellite data and official records, and it sometimes gets things wrong: the wrong dates, the wrong town, two fires merged into one, or something that was not a wildfire at all. If you know this fire first-hand (you live nearby, saw it, fought it or reported on it), tell us what really happened and we will check it.
⚑Report an errorHow we know this›
Perimeter: EFFIS (Copernicus), mapped on satellite imagery.
Dates from the perimeter: the VIIRS detections inside it did not change them. 2 Suomi-NPP VIIRS detections on those dates.
Compared with ICNF: 105 official ha against 145 ha of perimeter; similar, but with reservations.
Weather: Copernicus ERA5 reanalysis at the fire location, in cells of about 25 km.
The perimeter and land cover come from the Copernicus European Forest Fire Information System (EFFIS), measured on MODIS and Sentinel-2 imagery and published under CC BY 4.0. Heat detections come from the VIIRS sensors aboard Suomi-NPP and NOAA-20, distributed by NASA FIRMS at 375 m resolution. Freguesia boundaries come from geoBoundaries ADM3 (CC0 1.0 Universal (CC0 1.0) Public Domain Dedication). The area per freguesia is computed by WorldFires by crossing the perimeter with those boundaries, so it may differ slightly from each country’s official figure.