Skip to content
worldfires
DZ · Algeria · –

Tizi N'Berber fire, 20 July 2019 تيزي أنبربار · Tizi N'Berber

Out · last detection 26 Jul 2019, 02:06 UTC

The fire started on 20 July 2019 in Tizi N'Berber, Algeria, and satellites saw it burning for 7 days. Copernicus mapped a burnt perimeter of 129 hectares from satellite imagery, spread across a single municipality.

It is the 83th largest in Bejaia since 2016 (of 101 with a page). Number 68 in Algeria in 2019, of 78.

The power measured by the satellite is low (6.5 MW in the strongest hotspot), more typical of grass or stubble burning, or a slow surface fire, than of a large crown fire.

Burnt area
129ha
Copernicus perimeter
Duration
7days
20 Jul 2019 – 26 Jul 2019
Municipalities hit
1
communes
Started on
20 Jul
2019
Heat detections
9
in a single hotspot: 6 MW
Danger at start
28
High · FWI index
Average daily power
6MW
detected power per day, on average

Where it burned

HOTSPOTS BY DAY 20 Jul26 Jul
26 Jul 2019

How it evolved, day by day

20 Jul 2019 · 11 MW · 7 21 Jul 2019 · 0 MW · 1 26 Jul 2019 · 6 MW · 1
20 Jul 21 Jul 26 Jul

Fire radiative power detected each day, in megawatts, and number of hotspots. The magenta bar marks the peak day.

The weather it burned in

30°high
34km/h · peak gust
29%lowest humidity

It had gone 53 days without rain (1 mm or more) when it started. Rain came after the fire: 1.1 mm on 31 Jul.

This area had burned before

No earlier perimeters overlap this fire since 2016, when the satellite record begins.

What happened to each town

  1. Tizi N'Berber تيزي أنبربار 12,624 inhabitants · 2.8 km from the centre where it started
    129 ha reached on 20 Jul
    2.5 %

Burnt area inside each municipality, from crossing the official perimeter with administrative boundaries. The distance runs from the point marking the centre of each area to the nearest fire: staying a kilometre away does not mean it reached the houses.

What burned

  • Other natural land71 %
  • Mixed forest29 %

Land cover inside the perimeter as reported by Copernicus EFFIS (outside the Corine Land Cover area).

People and buildings inside the perimeter

GHSL 2020
Built-up area< 0.1 ha
Residents< 20

Inside the perimeter there was no noticeable built-up land and almost nobody lived there (GHSL 2020, satellite-based estimate).

This is an estimate on 100 m cells, made from satellite imagery and census data: it does not mean that homes burned or that anyone was harmed. The perimeter also contains land that never burned.

Source: Global Human Settlement Layer (GHS-BUILT-S and GHS-POP R2023A), European Commission Joint Research Centre (JRC), © European Union, CC BY 4.0. Sum inside the perimeter computed by WorldFires. human-settlement.emergency.copernicus.eu

The weather day by day

ECMWF ERA5 reanalysis at the fire location, the standard reference for past weather, and the Canadian Fire Weather Index (the same system Copernicus uses), computed by WorldFires from that data. Days after the fire run until the first rain.

Open-Meteo.com (CC BY 4.0) · Copernicus Climate Change Service (ERA5)

Day High Min. humidity Peak gust Rain Danger (FWI)
20 Jul 29.6 °C 38 % 32 km/h 1.2 mm High 28
21 Jul 28.4 °C 41 % 29 km/h 0.3 mm High 27
22 Jul 27.6 °C 34 % 34 km/h 0.0 mm High 36
23 Jul 28.5 °C 37 % 31 km/h 0.0 mm High 34
24 Jul 29.2 °C 36 % 25 km/h 0.0 mm High 31
25 Jul 29.8 °C 34 % 30 km/h 0.0 mm High 32
26 Jul 28.7 °C 29 % 29 km/h 0.9 mm High 37
27 Jul after 27.1 °C 26 % 37 km/h 0.0 mm High 36
28 Jul after 25.0 °C 48 % 32 km/h 0.0 mm High 35
29 Jul after 26.7 °C 51 % 29 km/h 0.0 mm High 29
30 Jul after 26.3 °C 58 % 31 km/h 0.0 mm High 28
31 Jul after 28.5 °C 49 % 35 km/h 1.1 mm High 27

Its twins: fires that started in the same weather

It started with an FWI of 28.2, a minimum humidity of 38% and 53 days without rain. Fires in the area that started in weather like this since 2016: 26.

FWI at the start 28.2
Minimum humidity 38 %
Days without rain 53
this fire chosen twins rest of the area
Almost identicalSimilar

Outlines of the closest twins

Boukhelifa fire, July 2026
2,767 ha 11 days FWI 26.3 Min. humidity 38 % 13 km away, in 2026

First rain (1 mm or more) after it ended: 1.6 mm on 27 Jul.

What happened to them

3 days
median duration
216 ha
median area
15 %
went past 1,000 ha
1.6 mm
rain at the end (median; 11 of 26 had it)

It stayed below its twins: 129 ha against a median of 216 ha. It lasted 7 days, against 3 days.

In 15 of 26, not even 1 mm fell in the ten days after the end: they went out without rain. In the rest, the first rainy day brought a median of 1.6 mm.

This is a bank of analogues: it shows what usually happens, not what will happen. With fewer than 15 twins we give no figures. How we calculate it

How it ended

1.1 mmfirst rain
31 Jul5 days after it ended
34km/h · max. gust

It was considered over on 26 Jul, and on 31 Jul 1.1 mm fell. We do not know whether the rain or the firefighters put it out. Twins with rain when they ended: 11 of 26, with a median of 1.6 mm.

Weather on this page: Open-Meteo.com (CC BY 4.0) · Copernicus Climate Change Service (ERA5)

How a twin is chosen

  • Same area: fires that have already ended, less than 250 km from this one, since 2016.
  • Same start: we compare the FWI on the first day, the minimum humidity that day and the run of days without rain before it. The slider sets how much they may differ.
  • Only pages with final weather data (ERA5 reanalysis) calculated in the same way as this fire’s; agricultural and grass burns and pages with data under review are left out.
  • Fires burning at the same time as this one (a week before or after) are left out: they share the same spell of weather and do not count as a precedent.
  • They are sorted by similarity, and the outlines of the first five are drawn.

How we calculate it

Before and after, from space

Drag the line to compare the same ground before the fire and after it.

Before · 13 Jul 2019
After · 2 Aug 2019

If the day is cloudy, change the date: each satellite passes once a day. In false colour the burnt ground looks brown or red.

The smoke

CAMS · Copernicus

On 20 July 2019 the air beside the fire reached 27 µg/m³ of PM2.5. That day averaged 19: 1.3 times the WHO daily guideline (15).

PM2.5 peak27 µg/m³
Days over the guideline4 days
PM1055 µg/m³
18 Jul21 Jul24 Jul27 Jul
Good Fair Moderate Poor Very poor Extremely poor

Particles from the Copernicus CAMS model at the centre of the perimeter; these are not measurements in each town. The pale bar is the worst hour, the solid one the daily average.

Open-Meteo.com (CC BY 4.0) · Copernicus Atmosphere Monitoring Service (CAMS)

Detections table · 9Every satellite heat detection, one by one, with time, satellite, power and coordinates.
⬇ Download CSV Times in UTC. Each detection is a 375 m pixel: a large fire yields hundreds per pass.
Date and timeSatelliteFRP (MW)LatLon

Other fires nearby

All fires in Algeria

Frequently asked questions

How long did the Tizi N'Berber fire last?
According to the heat detections seen by satellite inside the perimeter, it burned from 20 July 2019 to 26 July 2019 (7 days). The perimeter dates it from 20 July 2019 to 21 July 2019.
How much area did it burn?
The perimeter Copernicus measured from satellite imagery is 129 hectares (1.3 km²). Official national figures may differ.
Which municipalities burned?
The fire only entered Tizi N'Berber (129 ha, 2.5 %).
Did the fire reach a town?
The fire started in Tizi N'Berber and came within 2.8 km of its centre. That is the distance from the perimeter, or the nearest hotspot, to the point marking the centre; it does not mean it entered the houses.
What was the weather like?
During the fire the temperature reached 29.8 °C, humidity dropped to 29 % and gusts hit 34 km/h. The fire danger index (FWI) reached 37, class High.
Where does this data come from?
From the EFFIS (Copernicus) burnt perimeter, NASA FIRMS VIIRS hotspots and the administrative boundaries of Algeria (geoBoundaries). It is not an official report.
How did the fires that started in similar weather in this area end?
Fires less than 250 km away that started since 2016 with a similar FWI, humidity and dry spell: 26. Their median duration was 3 days and their median area 216 ha; 15 % went past 1,000 ha. In 15 of 26, not even 1 mm fell in the ten days after the end: they went out without rain. In the rest, the first rainy day brought a median of 1.6 mm.

Where to verify it

A satellite detection is not an official report. Final figures and the fire’s status are published by each country’s emergency service.

Emergency number: 14 · 1021 · Emergency number and official warnings

Satellite cross-check

History of this page Changes in area, dates, name, official record or merged pages, compared every night since 24 October 2026.

Does something look wrong on this page?

This page is built from satellite data and official records, and it sometimes gets things wrong: the wrong dates, the wrong town, two fires merged into one, or something that was not a wildfire at all. If you know this fire first-hand (you live nearby, saw it, fought it or reported on it), tell us what really happened and we will check it.

Report an error
What do you think is wrong?

We will only use your email to reply about this report. Privacy. This is not an emergency service: if there is a fire now, call 14 · 1021.

How we know this
  • Perimeter: EFFIS (Copernicus), mapped on satellite imagery.
  • Dates adjusted with the VIIRS detections inside the perimeter, which said 20 July 2019 to 21 July 2019. 9 Suomi-NPP VIIRS detections on those dates.
  • We have not matched this page with any official record.
  • Weather: Copernicus ERA5 reanalysis at the fire location, in cells of about 25 km.
  • Built-up area and population come from the JRC Global Human Settlement Layer (epoch 2020, 100 m cells), summed inside the perimeter: an estimate of what was there, not a damage count.

How we build fire pages: methodology

Where this data comes from

The perimeter and land cover come from the Copernicus European Forest Fire Information System (EFFIS), measured on MODIS and Sentinel-2 imagery and published under CC BY 4.0. Heat detections come from the VIIRS sensors aboard Suomi-NPP and NOAA-20, distributed by NASA FIRMS at 375 m resolution. Municipal boundaries come from geoBoundaries ADM3 (Creative Commons Attribution-ShareAlike 2.0). The area per municipality is computed by WorldFires by crossing the perimeter with those boundaries, so it may differ slightly from each country’s official figure.