Skip to content
worldfires
DZ · Algeria · →

Taskriout fire, 21 July 2020 Taskriout, Darguina

Out · last detection 21 Jul 2020, 12:17 UTC

The fire started on 21 July 2020 in Taskriout, Algeria, and satellites saw it burning for 1 day. Copernicus mapped a burnt perimeter of 146 hectares from satellite imagery, spread across 2 municipalities.

It is the 69th largest in Jijel since 2016 (of 110 with a page). Number 177 in Algeria in 2020, of 236.

The power measured by the satellite is low (3.8 MW in the strongest hotspot), more typical of grass or stubble burning, or a slow surface fire, than of a large crown fire.

Burnt area
146ha
Copernicus perimeter
Duration
1day
21 Jul 2020 – 21 Jul 2020
Municipalities hit
2
communes
Started on
21 Jul
2020
Heat detections
1
in a single hotspot: 4 MW
Danger at start
24
High · FWI index
Energy released
4MW
sum of detected power

Where it burned

HOTSPOTS BY DAY 21 Jul21 Jul

How it evolved, day by day

21

Fire radiative power detected each day, in megawatts, and number of hotspots. The magenta bar marks the peak day.

The weather it burned in

30°high
25km/h · peak gust
41%lowest humidity

It had gone 37 days without rain (1 mm or more) when it started.

This area had burned before

1% of the perimeter overlaps earlier fires recorded since 2016: 1 ha in 2019.

What happened to each town

  1. Taskriout where it started
    133 ha reached on 21 Jul
    4.2 %
  2. Darguina درقينة 14,146 inhabitants · 2.3 km from the town
    14 ha
    0.2 %

Burnt area inside each municipality, from crossing the official perimeter with administrative boundaries. The distance is from the town centre to the nearest fire: staying a kilometre away does not mean it reached the houses.

What burned

  • Other natural land51 %
  • Mixed forest49 %

Land cover inside the perimeter as reported by Copernicus EFFIS (outside the Corine Land Cover area).

The weather day by day

ECMWF ERA5 reanalysis at the fire location, the standard reference for past weather, and the Canadian Fire Weather Index (the same system Copernicus uses), computed by WorldFires from that data. Days after the fire run until the first rain.

Open-Meteo.com (CC BY 4.0) · Copernicus Climate Change Service (ERA5)

Day High Min. humidity Peak gust Rain Danger (FWI)
21 Jul 30.5 °C 41 % 25 km/h 0.0 mm High 24
22 Jul after 30.8 °C 38 % 27 km/h 0.0 mm High 25
23 Jul after 27.6 °C 51 % 30 km/h 0.0 mm High 23
24 Jul after 26.1 °C 66 % 34 km/h 0.0 mm Moderate 18
25 Jul after 30.1 °C 41 % 28 km/h 0.0 mm High 24
26 Jul after 32.5 °C 33 % 29 km/h 0.0 mm High 29
27 Jul after 33.2 °C 32 % 34 km/h 0.0 mm High 32
28 Jul after 33.0 °C 30 % 36 km/h 0.0 mm High 33
29 Jul after 32.6 °C 31 % 31 km/h 0.0 mm High 33
30 Jul after 34.1 °C 25 % 27 km/h 0.0 mm High 37
31 Jul after 34.7 °C 21 % 29 km/h 0.0 mm Very high 42

Before and after, from space

Drag the line to compare the same ground before the fire and after it.

Before · 14 Jul 2020
After · 28 Jul 2020

If the day is cloudy, change the date: each satellite passes once a day. In false colour the burnt ground looks brown or red.

The smoke

CAMS · Copernicus

On 31 July 2020 the air beside the fire reached 28 µg/m³ of PM2.5. That day averaged 17: 1.1 times the WHO daily guideline (15).

PM2.5 peak28 µg/m³
Days over the guideline2 days
PM1042 µg/m³
19202122232425262728293031
Good Fair Moderate Poor Very poor Extremely poor

Particles from the Copernicus CAMS model at the centre of the perimeter; these are not measurements in each town. The pale bar is the worst hour, the solid one the daily average.

Open-Meteo.com (CC BY 4.0) · Copernicus Atmosphere Monitoring Service (CAMS)

Detections table · 1Every satellite heat detection, one by one, with time, satellite, power and coordinates.
⬇ Download CSV Times in UTC. Each detection is a 375 m pixel: a large fire yields hundreds per pass.
Date and timeSatelliteFRP (MW)LatLon

Other fires nearby

All fires in Algeria ›

Frequently asked questions

How long did the Taskriout fire last?
Copernicus dates it between 21 July 2020 and 21 July 2020: 1 day between the first and last image with fire.
How much area did it burn?
The perimeter Copernicus measured from satellite imagery is 146 hectares (1.5 km²). Official national figures may differ.
Which municipalities burned?
The fire entered 2 municipalities: Taskriout (133 ha, 4.2 %); Darguina (14 ha, 0.2 %).
Did the fire reach a town?
The closest fire to a town centre came within 2.3 km of Darguina. That is the distance to the perimeter or nearest hotspot; it does not mean it entered the houses.
What was the weather like?
During the fire the temperature reached 30.5 °C, humidity dropped to 41 % and gusts hit 25 km/h. The fire danger index (FWI) reached 24, class High.
Where does this data come from?
From the EFFIS (Copernicus) burnt perimeter, NASA FIRMS VIIRS hotspots and the administrative boundaries of Algeria (geoBoundaries). It is not an official report.

Where to verify it

A satellite detection is not an official report. Final figures and the fire’s status are published by each country’s emergency service.

Emergency number: 14 · 1021

Satellite cross-check

Does something look wrong on this page?

This page is built from satellite data and official records, and it sometimes gets things wrong: the wrong dates, the wrong town, two fires merged into one, or something that was not a wildfire at all. If you know this fire first-hand (you live nearby, saw it, fought it or reported on it), tell us what really happened and we will check it.

Report an error
What do you think is wrong?

We will only use your email to reply about this report. Privacy. This is not an emergency service: if there is a fire now, call 14 · 1021.

Where this data comes from

The perimeter and land cover come from the Copernicus European Forest Fire Information System (EFFIS), measured on MODIS and Sentinel-2 imagery and published under CC BY 4.0. Heat detections come from the VIIRS sensors aboard Suomi-NPP and NOAA-20, distributed by NASA FIRMS at 375 m resolution. Municipal boundaries come from geoBoundaries ADM3 (Creative Commons Attribution-ShareAlike 2.0). The area per municipality is computed by WorldFires by crossing the perimeter with those boundaries, so it may differ slightly from each country’s official figure.