The fire started on 19 April 2019 in Tepehuanes, Mexico, and satellites saw it burning for 14 days. Copernicus’s global GWIS system rebuilt a burnt perimeter of 4,734 hectares from heat detections, spread across a single municipality.
It is the 43th largest in Durango since 2016 (of 238 with a page). Number 66 in Mexico in 2019, of 363.
matches the official recordwith caveatssatellite onlymodel
When copying, the sentence is
Tick the figures you want: they make up the lede and the CSV.
Burned area
with caveats
4,734ha
Perimeter published by GWIS (Copernicus).
This page4,734CONAFOR1,797
Source
GWIS (Copernicus)
Date
19 Apr 2019 – 2 May 2019
+− cross-check
CONAFOR: 1,797 ha (matched records: 1). Difference between the page and the official record: +163.4%. Matched on 8 November 2026. The two figures differ a lot, so these may not be exactly the same fire: take them as nearby records.
Duration by satellite
satellite only
14days
19 Apr 2019 to 2 May 2019: first and last day with fire on the page.
Source
GWIS (Copernicus) · NASA FIRMS · VIIRS
Date
last detection: 2 May 2019, 08:49 UTC
+− cross-check
Satellites pass a few times a day and cloud or smoke can hide the fire: a lack of detections is not an official extinction. Each country’s emergency service declares a fire contained or out.
Start
satellite only
19 Apr 2019
First day with fire seen by the satellites or the perimeter.
Source
GWIS (Copernicus) · NASA FIRMS · VIIRS
Date
19 Apr 2019
+− cross-check
The two figures differ a lot, so these may not be exactly the same fire: take them as nearby records.
Hotspots
satellite only
495
VIIRS detections at 375 m. Most intense hotspot: 200 MW.
Source
NASA FIRMS · VIIRS (Suomi NPP)
Date
19 Apr 2019 – 2 May 2019
+− cross-check
There is no official record to compare with. Each hotspot is a pixel detected in one satellite pass, not a separate fire.
The worst day
satellite only
2,120MW
Total radiative power on 20 April 2019; hotspots that day: 25.
Source
NASA FIRMS · VIIRS (FRP)
Date
20 Apr 2019
+− cross-check
Fire radiative power (FRP) measures the energy the fire gives off when the satellite passes. Added up by day, it compares intensity, not area.
Danger at the start
model
51.9FWI · extreme
Fire Weather Index (Canadian system) computed by WorldFires for the day the fire started. Consecutive days without rain before: 32.
This is an index computed from weather model data, not a measurement of the fire nor an official warning. Danger warnings are issued by each country’s authority. Emergency number and official warnings ›
Weather during the fire
model
24.7°C · 16% RH
High of 24.7 °C and minimum humidity of 16% on 26 April 2019; gusts of 77 km/h on 30 April 2019.
These are model values for a cell of about 25 km, not from a weather station: they may differ from what was measured on the ground.
ⓘThis page’s change log has been kept since 24 October 2026: every night what it publishes is compared and the difference is logged. Anything earlier is reconstructed from each source’s date and marked as reconstructed.
Show
· reconstructedofficial
Matched with the official CONAFOR record
Nearby records with very different figures: 1,797 ha (records: 1).
A version keeps the area, dates, name and official record; the area as it was logged (changes under 2% are not logged). The map, hotspots and weather always show today’s data.
Citation
A lede of about 60 words figures only, no adjectives
Burnt area inside each municipality, from crossing the GWIS perimeter with administrative boundaries. The distance runs from the point marking the centre of each area to the nearest fire: staying a kilometre away does not mean it reached the houses.
People and buildings inside the perimeter
GHSL 2020
Built-up area0.29ha
Residents< 20
Inside the perimeter there were about 0.29 hectares of built-up land and almost nobody lived there (GHSL 2020, satellite-based estimate).
This is an estimate on 100 m cells, made from satellite imagery and census data: it does not mean that homes burned or that anyone was harmed. The perimeter also contains land that never burned.
According to CONAFOR, this fire started on 20 April 2019 and burned 1,797 ha (the satellite measured 4,734 ha). The two figures differ a lot, so these may not be exactly the same fire: take them as nearby records.
TepehuanesComunidad Bagres y Anexos20 April 20191,797 ha· extinguished on 6 May 2019· cause: negligence
ECMWF ERA5 reanalysis at the fire location, the standard reference for past weather, and the Canadian Fire Weather Index (the same system Copernicus uses), computed by WorldFires from that data. Days after the fire run until the first rain.
Open-Meteo.com (CC BY 4.0) · Copernicus Climate Change Service (ERA5)
It started with an FWI of 51.9, a minimum humidity of 13% and 32 days without rain. Fires in the area that started in weather like this since 2016: 44.
FWI at the start51.9
Minimum humidity13 %
Days without rain32
this firechosen twinsrest of the area
Almost identicalSimilar
Outlines of the closest twins
This fire · Tepehuanes fire, 19 April 2019
4,734 ha14 daysFWI 51.9Min. humidity 13 %
Guadalupe y Calvo fire, May 2023
4,179 ha17 daysFWI 53.5Min. humidity 13 %174 km away, in 2023
First rain (1 mm or more) after it ended: 2.0 mm on 16 Jun.
It was 1.7 times larger than the median of its twins and lasted 14 days, against 12 days.
Only 11 of its 44 twins burned more. The weather on the first day does not explain everything: the wind in the following days, the fuel and the firefighting also count. In 16 of 44, not even 1 mm fell in the ten days after the end: they went out without rain. In the rest, the first rainy day brought a median of 2.1 mm.
This is a bank of analogues: it shows what usually happens, not what will happen. With fewer than 15 twins we give no figures. How we calculate it
How it ended
—first rain
—no rain in ten days
77km/h · max. gust
It was considered over on 2 May, and not even 1 mm fell in the following ten days: it went out without rain. Twins with rain when they ended: 28 of 44, with a median of 2.1 mm.
Weather on this page: Open-Meteo.com (CC BY 4.0) · Copernicus Climate Change Service (ERA5)
How a twin is chosen
Same area: fires that have already ended, less than 250 km from this one, since 2016.
Same start: we compare the FWI on the first day, the minimum humidity that day and the run of days without rain before it. The slider sets how much they may differ.
Only pages with final weather data (ERA5 reanalysis) calculated in the same way as this fire’s; agricultural and grass burns and pages with data under review are left out.
Fires burning at the same time as this one (a week before or after) are left out: they share the same spell of weather and do not count as a precedent.
They are sorted by similarity, and the outlines of the first five are drawn.
GWIS (Copernicus) dates it between 19 April 2019 and 2 May 2019: 14 days between the first and last heat detection of the perimeter.
How much area did it burn?
The perimeter GWIS (Copernicus) rebuilt from heat detections is 4,734 hectares (47.3 km²). It is an estimate: official national figures may differ.
Which municipalities burned?
The fire only entered Tepehuanes (4,761 ha, 0.8 %).
What was the weather like?
During the fire the temperature reached 24.7 °C, humidity dropped to 11 % and gusts hit 77 km/h. The fire danger index (FWI) reached 85, class Very extreme.
Where does this data come from?
From the GWIS (Copernicus) burnt perimeter, NASA FIRMS VIIRS hotspots and the administrative boundaries of Mexico (geoBoundaries). It is not an official report.
How did the fires that started in similar weather in this area end?
Fires less than 250 km away that started since 2016 with a similar FWI, humidity and dry spell: 44. Their median duration was 12 days and their median area 2,752 ha; 100 % went past 1,000 ha. Only 11 of its 44 twins burned more. The weather on the first day does not explain everything: the wind in the following days, the fuel and the firefighting also count. In 16 of 44, not even 1 mm fell in the ten days after the end: they went out without rain. In the rest, the first rainy day brought a median of 2.1 mm.
Where to verify it
A satellite detection is not an official report. Final figures and the fire’s status are published by each country’s emergency service.
This page is built from satellite data and official records, and it sometimes gets things wrong: the wrong dates, the wrong town, two fires merged into one, or something that was not a wildfire at all. If you know this fire first-hand (you live nearby, saw it, fought it or reported on it), tell us what really happened and we will check it.
⚑Report an errorHow we know this›
Perimeter: GWIS (Copernicus), rebuilt from heat detections rather than mapped on imagery.
Dates from the perimeter: the VIIRS detections inside it did not change them. 495 Suomi-NPP VIIRS detections on those dates.
Compared with CONAFOR: 1,797 official ha against 4,734 ha of perimeter; similar, but with reservations.
Weather: Copernicus ERA5 reanalysis at the fire location, in cells of about 25 km.
Built-up area and population come from the JRC Global Human Settlement Layer (epoch 2020, 100 m cells), summed inside the perimeter: an estimate of what was there, not a damage count.
The perimeter comes from the Copernicus Global Wildfire Information System (GWIS), which rebuilds it from MODIS and VIIRS heat detections and publishes it under CC BY 4.0. It is not measured on imagery as in Europe, so it is an estimate. Heat detections come from the VIIRS sensors aboard Suomi-NPP and NOAA-20, distributed by NASA FIRMS at 375 m resolution. Municipal boundaries come from geoBoundaries ADM2 (Creative Commons Attribution 4.0 (CC BY 4.0)). The area per municipality is computed by WorldFires by crossing the perimeter with those boundaries, so it may differ from each country’s official figure.