Skip to content
worldfires
MA · Morocco · –

Tangier-Assilah fire, July 2022 طنجة-أصيلة · Tangier-Assilah

Out · last detection 11 Jul 2022, 02:38 UTC

The fire started on 10 July 2022 in Tangier-Assilah, Morocco, and satellites saw it burning for 2 days. Copernicus mapped a burnt perimeter of 128 hectares from satellite imagery, spread across a single municipality.

It is the 45th largest in Tangier-Tetouan-Al Hoceima since 2016 (of 53 with a page). Number 19 in Morocco in 2022, of 22.

Burnt area
128ha
Copernicus perimeter
Duration
2days
10 Jul 2022 – 11 Jul 2022
Municipalities hit
1
provinces
Started on
10 Jul
2022
Heat detections
9
in a single hotspot: 154 MW
Danger at start
56
Extreme · FWI index
Average daily power
115MW
detected power per day, on average

Where it burned

HOTSPOTS BY DAY 10 Jul11 Jul
11 Jul 2022

How it evolved, day by day

10 Jul 2022 · 219 MW · 3 11 Jul 2022 · 11 MW · 6
10 Jul 11 Jul

Fire radiative power detected each day, in megawatts, and number of hotspots. The magenta bar marks the peak day.

The weather it burned in

31°high
66km/h · peak gust
35%lowest humidity

It had gone more than two months without rain (1 mm or more) when it started.

This area had burned before

No earlier perimeters overlap this fire since 2016, when the satellite record begins.

What happened to each town

  1. Tangier-Assilah طنجة-أصيلة 1,494,413 inhabitants · 10.5 km from the centre where it started
    128 ha reached on 10 Jul
    0.1 %

Burnt area inside each municipality, from crossing the official perimeter with administrative boundaries. The distance runs from the point marking the centre of each area to the nearest fire: staying a kilometre away does not mean it reached the houses.

What burned

  • Scrub and transitional woodland74 %
  • Agricultural areas26 %

Land cover inside the perimeter as reported by Copernicus EFFIS (outside the Corine Land Cover area).

People and buildings inside the perimeter

GHSL 2020
Built-up area< 0.1 ha
Residents< 20

Inside the perimeter there was no noticeable built-up land and almost nobody lived there (GHSL 2020, satellite-based estimate).

This is an estimate on 100 m cells, made from satellite imagery and census data: it does not mean that homes burned or that anyone was harmed. The perimeter also contains land that never burned.

Source: Global Human Settlement Layer (GHS-BUILT-S and GHS-POP R2023A), European Commission Joint Research Centre (JRC), © European Union, CC BY 4.0. Sum inside the perimeter computed by WorldFires. human-settlement.emergency.copernicus.eu

The weather day by day

ECMWF ERA5 reanalysis at the fire location, the standard reference for past weather, and the Canadian Fire Weather Index (the same system Copernicus uses), computed by WorldFires from that data. Days after the fire run until the first rain.

Open-Meteo.com (CC BY 4.0) · Copernicus Climate Change Service (ERA5)

Day High Min. humidity Peak gust Rain Danger (FWI)
10 Jul 29.5 °C 42 % 64 km/h 0.0 mm Extreme 56
11 Jul 30.7 °C 35 % 66 km/h 0.0 mm Extreme 62
12 Jul after 28.8 °C 52 % 70 km/h 0.0 mm Extreme 64
13 Jul after 30.2 °C 50 % 68 km/h 0.0 mm Extreme 65
14 Jul after 31.0 °C 36 % 64 km/h 0.0 mm Extreme 63
15 Jul after 31.4 °C 43 % 59 km/h 0.0 mm Extreme 60
16 Jul after 31.6 °C 39 % 51 km/h 0.0 mm Extreme 51
17 Jul after 31.4 °C 41 % 50 km/h 0.0 mm Very high 49
18 Jul after 30.2 °C 46 % 38 km/h 0.0 mm High 29
19 Jul after 29.9 °C 46 % 30 km/h 0.0 mm High 24
20 Jul after 32.0 °C 36 % 34 km/h 0.0 mm High 31
21 Jul after 30.1 °C 57 % 53 km/h 0.0 mm Very high 43

Its twins: fires that started in the same weather

It started with an FWI of 56.1, a minimum humidity of 42% and more than two months without rain. Fires in the area that started in weather like this since 2016: 5.

FWI at the start 56.1
Minimum humidity 42 %
Days without rain 60+
this fire chosen twins rest of the area
Almost identicalSimilar

Outlines of the closest twins

Tarifa fire, August 2025
365 ha 2 days FWI 46.4 Min. humidity 38 % 48 km away, in 2025

First rain (1 mm or more) after it ended: none in the following ten days.

What happened to them

Fires in the area that started in similar weather: 5. With fewer than 15 we give no figures: they would be more noise than signal.

This is a bank of analogues: it shows what usually happens, not what will happen. With fewer than 15 twins we give no figures. How we calculate it

How it ended

—first rain
—no rain in ten days
66km/h · max. gust

It was considered over on 11 Jul, and not even 1 mm fell in the following ten days: it went out without rain.

Weather on this page: Open-Meteo.com (CC BY 4.0) · Copernicus Climate Change Service (ERA5)

How a twin is chosen

  • Same area: fires that have already ended, less than 250 km from this one, since 2016.
  • Same start: we compare the FWI on the first day, the minimum humidity that day and the run of days without rain before it. The slider sets how much they may differ.
  • Only pages with final weather data (ERA5 reanalysis) calculated in the same way as this fire’s; agricultural and grass burns and pages with data under review are left out.
  • Fires burning at the same time as this one (a week before or after) are left out: they share the same spell of weather and do not count as a precedent.
  • They are sorted by similarity, and the outlines of the first five are drawn.

How we calculate it

Before and after, from space

Drag the line to compare the same ground before the fire and after it.

Before · 3 Jul 2022
After · 18 Jul 2022

If the day is cloudy, change the date: each satellite passes once a day. In false colour the burnt ground looks brown or red.

The smoke

CAMS · Copernicus

On 12 July 2022 the air beside the fire reached 12 µg/m³ of PM2.5, but no daily average passed the WHO guideline (15).

PM2.5 peak12 µg/m³
Days over the guideline0 days
PM1032 µg/m³
8 Jul10 Jul12 Jul14 Jul
Good Fair Moderate Poor Very poor Extremely poor

Particles from the Copernicus CAMS model at the centre of the perimeter; these are not measurements in each town. The pale bar is the worst hour, the solid one the daily average.

Open-Meteo.com (CC BY 4.0) · Copernicus Atmosphere Monitoring Service (CAMS)

Detections table · 9Every satellite heat detection, one by one, with time, satellite, power and coordinates.
⬇ Download CSV Times in UTC. Each detection is a 375 m pixel: a large fire yields hundreds per pass.
Date and timeSatelliteFRP (MW)LatLon

Other fires nearby

All fires in Morocco

Frequently asked questions

How long did the Tangier-Assilah fire last?
Copernicus dates it between 10 July 2022 and 11 July 2022: 2 days between the first and last image with fire.
How much area did it burn?
The perimeter Copernicus measured from satellite imagery is 128 hectares (1.3 km²). Official national figures may differ.
Which municipalities burned?
The fire only entered Tangier-Assilah (128 ha, 0.1 %).
Did the fire reach a town?
The fire started in Tangier-Assilah and came within 10.5 km of its centre. That is the distance from the perimeter, or the nearest hotspot, to the point marking the centre; it does not mean it entered the houses.
What was the weather like?
During the fire the temperature reached 30.7 °C, humidity dropped to 35 % and gusts hit 66 km/h. The fire danger index (FWI) reached 62, class Extreme.
Where does this data come from?
From the EFFIS (Copernicus) burnt perimeter, NASA FIRMS VIIRS hotspots and the administrative boundaries of Morocco (geoBoundaries). It is not an official report.

Where to verify it

A satellite detection is not an official report. Final figures and the fire’s status are published by each country’s emergency service.

Emergency number: 15 · 150 · Emergency number and official warnings

Satellite cross-check

History of this page Changes in area, dates, name, official record or merged pages, compared every night since 24 October 2026.

Does something look wrong on this page?

This page is built from satellite data and official records, and it sometimes gets things wrong: the wrong dates, the wrong town, two fires merged into one, or something that was not a wildfire at all. If you know this fire first-hand (you live nearby, saw it, fought it or reported on it), tell us what really happened and we will check it.

Report an error
What do you think is wrong?

We will only use your email to reply about this report. Privacy. This is not an emergency service: if there is a fire now, call 15 · 150.

How we know this
  • Perimeter: EFFIS (Copernicus), mapped on satellite imagery.
  • Dates from the perimeter: the VIIRS detections inside it did not change them. 9 Suomi-NPP VIIRS detections on those dates.
  • We have not matched this page with any official record.
  • Weather: Copernicus ERA5 reanalysis at the fire location, in cells of about 25 km.
  • Built-up area and population come from the JRC Global Human Settlement Layer (epoch 2020, 100 m cells), summed inside the perimeter: an estimate of what was there, not a damage count.

How we build fire pages: methodology

Where this data comes from

The perimeter and land cover come from the Copernicus European Forest Fire Information System (EFFIS), measured on MODIS and Sentinel-2 imagery and published under CC BY 4.0. Heat detections come from the VIIRS sensors aboard Suomi-NPP and NOAA-20, distributed by NASA FIRMS at 375 m resolution. Municipal boundaries come from geoBoundaries ADM2 (Open Data Commons Open Database License 1.0). The area per municipality is computed by WorldFires by crossing the perimeter with those boundaries, so it may differ slightly from each country’s official figure.