Skip to content
worldfires
DZ · Algeria · →

Tamridjet fire, July 2026 تامريجت · Tamridjet, Darguina

Out · last detection 19 Jul 2026, 02:04 UTC

The fire started on 18 July 2026 in Tamridjet, Algeria, and satellites saw it burning for 1 day. Copernicus mapped a burnt perimeter of 199 hectares from satellite imagery, spread across 2 municipalities.

It is the 52th largest in Jijel since 2016 (of 110 with a page). Number 138 in Algeria in 2026, of 197.

The power measured by the satellite is low (3.5 MW in the strongest hotspot), more typical of grass or stubble burning, or a slow surface fire, than of a large crown fire.

Burnt area
199ha
Copernicus perimeter
Duration
1day
18 Jul 2026 – 18 Jul 2026
Municipalities hit
2
communes
Started on
18 Jul
2026
Heat detections
7
in a single hotspot: 3 MW
Danger at start
44
Very high · FWI index
Energy released
20MW
sum of detected power

Where it burned

19 Jul 2026
HOTSPOTS BY DAY 18 Jul18 Jul

How it evolved, day by day

1819

Fire radiative power detected each day, in megawatts, and number of hotspots. The magenta bar marks the peak day.

The weather it burned in

38°high
26km/h · peak gust
16%lowest humidity

It had gone 10 days without rain (1 mm or more) when it started. Rain came after the fire: 1.0 mm on 25 Jul.

This area had burned before

67% of the perimeter overlaps earlier fires recorded since 2016: 76 ha in 2017, 70 ha in 2020, 20 ha in 2021, 66 ha in 2023, 1 ha in 2025. Part of it burned more than once, so the yearly figures add up to more than the 134 ha that had burned before.

What happened to each town

  1. Tamridjet تامريجت 8,413 inhabitants · 4.0 km from the town where it started
    199 ha reached on 18 Jul
    4.1 %
  2. Darguina درقينة 14,146 inhabitants · 11.4 km from the town
    0 ha
    0.0 %

Burnt area inside each municipality, from crossing the official perimeter with administrative boundaries. The distance is from the town centre to the nearest fire: staying a kilometre away does not mean it reached the houses.

What burned

  • Other natural land75 %
  • Mixed forest25 %

Land cover inside the perimeter as reported by Copernicus EFFIS (outside the Corine Land Cover area).

The weather day by day

ECMWF ERA5 reanalysis at the fire location, the standard reference for past weather, and the Canadian Fire Weather Index (the same system Copernicus uses), computed by WorldFires from that data. Days after the fire run until the first rain.

Open-Meteo.com (CC BY 4.0) · Copernicus Climate Change Service (ERA5)

Day High Min. humidity Peak gust Rain Danger (FWI)
18 Jul 37.8 °C 17 % 26 km/h 0.0 mm Very high 44
19 Jul after 38.2 °C 16 % 26 km/h 0.0 mm Very high 46
20 Jul after 38.8 °C 16 % 24 km/h 0.0 mm Very high 45
21 Jul after 38.5 °C 15 % 26 km/h 0.0 mm Very high 50
22 Jul after 37.8 °C 18 % 26 km/h 0.0 mm Extreme 52
23 Jul after 36.0 °C 24 % 16 km/h 0.0 mm Very high 38
24 Jul after 32.0 °C 32 % 10 km/h 0.0 mm High 29
25 Jul after 31.4 °C 28 % 27 km/h 1.0 mm High 35

Before and after, from space

Drag the line to compare the same ground before the fire and after it.

Before · 11 Jul 2026
After · 25 Jul 2026

If the day is cloudy, change the date: each satellite passes once a day. In false colour the burnt ground looks brown or red.

The smoke

CAMS · Copernicus

On 21 July 2026 the air beside the fire reached 32 µg/m³ of PM2.5. That day averaged 19: 1.3 times the WHO daily guideline (15).

PM2.5 peak32 µg/m³
Days over the guideline2 days
PM1074 µg/m³
Optical depth0.75
16171819202122
Good Fair Moderate Poor Very poor Extremely poor

Particles from the Copernicus CAMS model at the centre of the perimeter; these are not measurements in each town. The pale bar is the worst hour, the solid one the daily average.

Open-Meteo.com (CC BY 4.0) · Copernicus Atmosphere Monitoring Service (CAMS)

Detections table · 7Every satellite heat detection, one by one, with time, satellite, power and coordinates.
⬇ Download CSV Times in UTC. Each detection is a 375 m pixel: a large fire yields hundreds per pass.
Date and timeSatelliteFRP (MW)LatLon

Other fires nearby

All fires in Algeria ›

Frequently asked questions

How long did the Tamridjet fire last?
Copernicus dates it between 18 July 2026 and 18 July 2026: 1 day between the first and last image with fire.
How much area did it burn?
The perimeter Copernicus measured from satellite imagery is 199 hectares (2.0 km²). Official national figures may differ.
Which municipalities burned?
The fire entered 2 municipalities: Tamridjet (199 ha, 4.1 %); Darguina (0 ha, 0.0 %).
Did the fire reach a town?
The closest fire to a town centre came within 4.0 km of Tamridjet. That is the distance to the perimeter or nearest hotspot; it does not mean it entered the houses.
What was the weather like?
During the fire the temperature reached 38.2 °C, humidity dropped to 16 % and gusts hit 26 km/h. The fire danger index (FWI) reached 46, class Very high.
Where does this data come from?
From the EFFIS (Copernicus) burnt perimeter, NASA FIRMS VIIRS hotspots and the administrative boundaries of Algeria (geoBoundaries). It is not an official report.

Where to verify it

A satellite detection is not an official report. Final figures and the fire’s status are published by each country’s emergency service.

Emergency number: 14 · 1021

Satellite cross-check

Does something look wrong on this page?

This page is built from satellite data and official records, and it sometimes gets things wrong: the wrong dates, the wrong town, two fires merged into one, or something that was not a wildfire at all. If you know this fire first-hand (you live nearby, saw it, fought it or reported on it), tell us what really happened and we will check it.

Report an error
What do you think is wrong?

We will only use your email to reply about this report. Privacy. This is not an emergency service: if there is a fire now, call 14 · 1021.

Where this data comes from

The perimeter and land cover come from the Copernicus European Forest Fire Information System (EFFIS), measured on MODIS and Sentinel-2 imagery and published under CC BY 4.0. Heat detections come from the VIIRS sensors aboard Suomi-NPP and NOAA-20, distributed by NASA FIRMS at 375 m resolution. Municipal boundaries come from geoBoundaries ADM3 (Creative Commons Attribution-ShareAlike 2.0). The area per municipality is computed by WorldFires by crossing the perimeter with those boundaries, so it may differ slightly from each country’s official figure.