Strongoli fire, August 2026 Strongoli
The fire started on 30 August 2026 in Strongoli, Italy, and satellites saw it burning for 2 days. Copernicus mapped a burnt perimeter of 348 hectares from satellite imagery, spread across a single municipality.
It is the 7th largest in Crotone since 2016 (of 53 with a page). Number 59 in Italy in 2026, of 231.
- Burnt area
- 348ha
- Copernicus perimeter
- Duration
- 2days
- 30 Aug 2026 – 31 Aug 2026
- Municipalities hit
- 1
- municipalities
- Started on
- 30 Aug
- 2026
- Heat detections
- 9
- in a single hotspot: 49 MW
- Danger at start
- 47
- Very high · FWI index
- Energy released
- 158MW
- sum of detected power
Where it burned
How it evolved, day by day
Fire radiative power detected each day, in megawatts, and number of hotspots. The magenta bar marks the peak day.
The weather it burned in
It had gone 36 days without rain (1 mm or more) when it started.
This area had burned before
12% of the perimeter overlaps earlier fires recorded since 2016: 24 ha in 2017, 34 ha in 2022, 2 ha in 2023, 17 ha in 2025. Part of it burned more than once, so the yearly figures add up to more than the 41 ha that had burned before.
What happened to each town
-
348 ha reached on 30 Aug4.1 %
Burnt area inside each municipality, from crossing the official perimeter with administrative boundaries. The distance is from the town centre to the nearest fire: staying a kilometre away does not mean it reached the houses.
What burned
- Agricultural areas71 %
- Sclerophyllous scrub19 %
- Scrub and transitional woodland10 %
Natura 2000 protected area affected: 0 %
Land cover inside the perimeter according to Corine Land Cover, as reported by Copernicus.
The weather day by day
ECMWF ERA5 reanalysis at the fire location, the standard reference for past weather, and the Canadian Fire Weather Index (the same system Copernicus uses), computed by WorldFires from that data. Days after the fire run until the first rain.
Open-Meteo.com (CC BY 4.0) · Copernicus Climate Change Service (ERA5)
| Day | High | Min. humidity | Peak gust | Rain | Danger (FWI) |
|---|---|---|---|---|---|
| 30 Aug | 35.2 °C | 40 % | 45 km/h | 0.0 mm | Very high 47 |
| 31 Aug | 32.2 °C | 52 % | 23 km/h | 0.0 mm | High 27 |
| 1 Sept after | 32.0 °C | 53 % | 31 km/h | 0.0 mm | High 30 |
| 2 Sept after | 32.7 °C | 47 % | 21 km/h | 0.0 mm | High 26 |
| 3 Sept after | 32.8 °C | 34 % | 38 km/h | 0.0 mm | Very high 41 |
| 4 Sept after | 32.3 °C | 40 % | 49 km/h | 0.0 mm | Very high 48 |
| 5 Sept after | 33.0 °C | 31 % | 19 km/h | 0.0 mm | High 32 |
| 6 Sept after | 32.0 °C | 45 % | 19 km/h | 0.0 mm | High 29 |
| 7 Sept after | 31.8 °C | 44 % | 26 km/h | 0.0 mm | High 33 |
| 8 Sept after | 30.6 °C | 52 % | 19 km/h | 0.0 mm | High 26 |
| 9 Sept after | 31.5 °C | 47 % | 27 km/h | 0.0 mm | High 30 |
Before and after, from space
Drag the line to compare the same ground before the fire and after it.
If the day is cloudy, change the date: each satellite passes once a day. In false colour the burnt ground looks brown or red.
The smoke
CAMS · CopernicusOn 30 August 2026 the air beside the fire reached 27 µg/m³ of PM2.5. That day averaged 20: 1.4 times the WHO daily guideline (15).
Particles from the Copernicus CAMS model at the centre of the perimeter; these are not measurements in each town. The pale bar is the worst hour, the solid one the daily average.
Open-Meteo.com (CC BY 4.0) · Copernicus Atmosphere Monitoring Service (CAMS)
Detections table · 9Every satellite heat detection, one by one, with time, satellite, power and coordinates.
| Date and time | Satellite | FRP (MW) | Lat | Lon |
|---|
Other fires nearby
Frequently asked questions
- How long did the Strongoli fire last?
- According to the heat detections seen by satellite inside the perimeter, it burned from 30 August 2026 to 31 August 2026 (2 days). The perimeter dates it from 30 August 2026 to 30 August 2026.
- How much area did it burn?
- The perimeter Copernicus measured from satellite imagery is 348 hectares (3.5 km²). Official national figures may differ.
- Which municipalities burned?
- The fire only entered Strongoli (348 ha, 4.1 %).
- Did the fire reach a town?
- The closest fire to a town centre came within 3.7 km of Strongoli. That is the distance to the perimeter or nearest hotspot; it does not mean it entered the houses.
- What was the weather like?
- During the fire the temperature reached 35.2 °C, humidity dropped to 40 % and gusts hit 45 km/h. The fire danger index (FWI) reached 47, class Very high.
- Where does this data come from?
- From the EFFIS (Copernicus) burnt perimeter, NASA FIRMS VIIRS hotspots and the administrative boundaries of Italy (geoBoundaries). It is not an official report.
Where to verify it
A satellite detection is not an official report. Final figures and the fire’s status are published by each country’s emergency service.
Emergency number: 112 · 1515
Satellite cross-check
Does something look wrong on this page?
This page is built from satellite data and official records, and it sometimes gets things wrong: the wrong dates, the wrong town, two fires merged into one, or something that was not a wildfire at all. If you know this fire first-hand (you live nearby, saw it, fought it or reported on it), tell us what really happened and we will check it.
Report an error
Where this data comes from
The perimeter and land cover come from the Copernicus European Forest Fire Information System (EFFIS), measured on MODIS and Sentinel-2 imagery and published under CC BY 4.0. Heat detections come from the VIIRS sensors aboard Suomi-NPP and NOAA-20, distributed by NASA FIRMS at 375 m resolution. Municipal boundaries come from geoBoundaries ADM4 (Creative Commons Attribution 3.0 License). The area per municipality is computed by WorldFires by crossing the perimeter with those boundaries, so it may differ slightly from each country’s official figure.