Skip to content
worldfires
IT · Italy · →

Cutro fire, 7 July 2016 Cutro, Crotone

Out · last detection 8 Jul 2016, 01:34 UTC

The fire started on 7 July 2016 in Cutro, Italy, and satellites saw it burning for 2 days. Copernicus mapped a burnt perimeter of 455 hectares from satellite imagery, spread across 2 municipalities.

It is the 4th largest in Crotone since 2016 (of 53 with a page). Number 12 in Italy in 2016, of 78.

The power measured by the satellite is low (26.5 MW in the strongest hotspot), more typical of grass or stubble burning, or a slow surface fire, than of a large crown fire.

Burnt area
455ha
Copernicus perimeter
Duration
2days
7 Jul 2016 – 8 Jul 2016
Municipalities hit
2
municipalities
Started on
7 Jul
2016
Heat detections
14
in a single hotspot: 26 MW
Danger at start
12
Moderate · FWI index
Energy released
138MW
sum of detected power

Where it burned

8 Jul 2016
HOTSPOTS BY DAY 7 Jul8 Jul

How it evolved, day by day

78

Fire radiative power detected each day, in megawatts, and number of hotspots. The magenta bar marks the peak day.

The weather it burned in

29°high
34km/h · peak gust
45%lowest humidity

It had gone 0 days without rain (1 mm or more) when it started. Rain came after the fire: 11.7 mm on 16 Jul.

This area had burned before

No earlier perimeters overlap this fire since 2016, when the satellite record begins.

What happened to each town

  1. Cutro 9,385 inhabitants · 4.4 km from the town where it started
    421 ha reached on 7 Jul
    3.2 %
  2. Crotone 58,445 inhabitants · 8.3 km from the town
    34 ha reached on 7 Jul
    0.2 %

Burnt area inside each municipality, from crossing the official perimeter with administrative boundaries. The distance is from the town centre to the nearest fire: staying a kilometre away does not mean it reached the houses.

What burned

  • Agricultural areas92 %
  • Coniferous forest8.1 %

Land cover inside the perimeter according to Corine Land Cover, as reported by Copernicus.

The weather day by day

ECMWF ERA5 reanalysis at the fire location, the standard reference for past weather, and the Canadian Fire Weather Index (the same system Copernicus uses), computed by WorldFires from that data. Days after the fire run until the first rain.

Open-Meteo.com (CC BY 4.0) · Copernicus Climate Change Service (ERA5)

Day High Min. humidity Peak gust Rain Danger (FWI)
7 Jul 28.9 °C 53 % 34 km/h 0.0 mm Moderate 12
8 Jul 29.3 °C 45 % 30 km/h 0.0 mm Moderate 16
9 Jul after 29.7 °C 57 % 24 km/h 0.0 mm Moderate 14
10 Jul after 29.7 °C 56 % 23 km/h 0.6 mm Moderate 12
11 Jul after 29.8 °C 58 % 26 km/h 0.4 mm Moderate 13
12 Jul after 30.3 °C 58 % 31 km/h 0.0 mm Moderate 14
13 Jul after 31.3 °C 52 % 30 km/h 0.0 mm Moderate 16
14 Jul after 31.3 °C 50 % 27 km/h 0.0 mm Moderate 16
15 Jul after 27.6 °C 38 % 42 km/h 0.7 mm High 22
16 Jul after 25.0 °C 51 % 30 km/h 11.7 mm Very low 2

Before and after, from space

Drag the line to compare the same ground before the fire and after it.

Before · 30 Jun 2016
After · 15 Jul 2016

If the day is cloudy, change the date: each satellite passes once a day. In false colour the burnt ground looks brown or red.

The smoke

CAMS · Copernicus

On 11 July 2016 the air beside the fire reached 32 µg/m³ of PM2.5. That day averaged 19: 1.3 times the WHO daily guideline (15).

PM2.5 peak32 µg/m³
Days over the guideline2 days
PM1039 µg/m³
567891011
Good Fair Moderate Poor Very poor Extremely poor

Particles from the Copernicus CAMS model at the centre of the perimeter; these are not measurements in each town. The pale bar is the worst hour, the solid one the daily average.

Open-Meteo.com (CC BY 4.0) · Copernicus Atmosphere Monitoring Service (CAMS)

Detections table · 14Every satellite heat detection, one by one, with time, satellite, power and coordinates.
⬇ Download CSV Times in UTC. Each detection is a 375 m pixel: a large fire yields hundreds per pass.
Date and timeSatelliteFRP (MW)LatLon

Other fires nearby

All fires in Italy ›

Frequently asked questions

How long did the Cutro fire last?
Copernicus dates it between 7 July 2016 and 8 July 2016: 2 days between the first and last image with fire.
How much area did it burn?
The perimeter Copernicus measured from satellite imagery is 455 hectares (4.6 km²). Official national figures may differ.
Which municipalities burned?
The fire entered 2 municipalities: Cutro (421 ha, 3.2 %); Crotone (34 ha, 0.2 %).
Did the fire reach a town?
The closest fire to a town centre came within 4.4 km of Cutro. That is the distance to the perimeter or nearest hotspot; it does not mean it entered the houses.
What was the weather like?
During the fire the temperature reached 29.3 °C, humidity dropped to 45 % and gusts hit 34 km/h. The fire danger index (FWI) reached 16, class Moderate.
Where does this data come from?
From the EFFIS (Copernicus) burnt perimeter, NASA FIRMS VIIRS hotspots and the administrative boundaries of Italy (geoBoundaries). It is not an official report.

Where to verify it

A satellite detection is not an official report. Final figures and the fire’s status are published by each country’s emergency service.

Emergency number: 112 · 1515

Satellite cross-check

Does something look wrong on this page?

This page is built from satellite data and official records, and it sometimes gets things wrong: the wrong dates, the wrong town, two fires merged into one, or something that was not a wildfire at all. If you know this fire first-hand (you live nearby, saw it, fought it or reported on it), tell us what really happened and we will check it.

Report an error
What do you think is wrong?

We will only use your email to reply about this report. Privacy. This is not an emergency service: if there is a fire now, call 112 · 1515.

Where this data comes from

The perimeter and land cover come from the Copernicus European Forest Fire Information System (EFFIS), measured on MODIS and Sentinel-2 imagery and published under CC BY 4.0. Heat detections come from the VIIRS sensors aboard Suomi-NPP and NOAA-20, distributed by NASA FIRMS at 375 m resolution. Municipal boundaries come from geoBoundaries ADM4 (Creative Commons Attribution 3.0 License). The area per municipality is computed by WorldFires by crossing the perimeter with those boundaries, so it may differ slightly from each country’s official figure.