Skip to content
worldfires
CA · Canada · –

Stikine Region fire, July 2019 Stikine Region

Out · last detection 14 Aug 2019, 21:05 UTC

The fire started on 6 July 2019 in Stikine Region, Canada, and satellites saw it burning for 40 days. Canada’s CWFIS (Natural Resources Canada) mapped an official burnt perimeter of 1,197 hectares from satellite imagery, spread across a single census subdivision.

It is the 308th largest in British Columbia since 2016 (of 343 with a page). Number 91 in Canada in 2019, of 97.

Burnt area
1,197ha
official perimeter (CWFIS)
Duration
40days
6 Jul 2019 – 14 Aug 2019
Census subdivisions hit
1
municipalities
Started on
6 Jul
2019
Heat detections
225
in a single hotspot: 214 MW
Danger at start
12
Moderate · FWI index
Average daily power
331MW
detected power per day, on average

Where it burned

HOTSPOTS BY DAY 6 Jul14 Aug
14 Aug 2019

How it evolved, day by day

8 Jul 2019 · 16 MW · 3 11 Jul 2019 · 4 MW · 1 12 Jul 2019 · 3 MW · 1 3 Aug 2019 · 147 MW · 4 4 Aug 2019 · 394 MW · 85 5 Aug 2019 · 74 MW · 35 6 Aug 2019 · 28 MW · 5 8 Aug 2019 · 13 MW · 6 9 Aug 2019 · 42 MW · 4 10 Aug 2019 · 21 MW · 5 11 Aug 2019 · 4 MW · 1 12 Aug 2019 · 4 MW · 1 13 Aug 2019 · 3,854 MW · 68 14 Aug 2019 · 29 MW · 6
8 Jul 3 Aug 6 Aug 10 Aug 13 Aug

Fire radiative power detected each day, in megawatts, and number of hotspots. The magenta bar marks the peak day.

The weather it burned in

23°high
60km/h · peak gust
24%lowest humidity

It had gone 2 days without rain (1 mm or more) when it started. Rain came after the fire: 3.1 mm on 15 Aug.

This area had burned before

No earlier perimeters overlap this fire since 2016, when the satellite record begins.

How big is it?

10 km
It burned the equivalent of 0.8% of the area of London (12 km² against 1,583 km²).

London boundary: geoBoundaries · Office for National Statistics (Open Government Licence v3.0).

This compares size, not location: both shapes are at the same scale, north up, centred on each other.

What happened to each census subdivision

  1. Stikine Region where it started
    1,244 ha reached on 8 Jul
    0.0 %

Burnt area inside each census subdivision, from crossing the official perimeter with administrative boundaries. The distance runs from the point marking the centre of each area to the nearest fire: staying a kilometre away does not mean it reached the houses.

People and buildings inside the perimeter

GHSL 2020
Built-up area< 0.1 ha
Residents< 20

Inside the perimeter there was no noticeable built-up land and almost nobody lived there (GHSL 2020, satellite-based estimate).

This is an estimate on 100 m cells, made from satellite imagery and census data: it does not mean that homes burned or that anyone was harmed. The perimeter also contains land that never burned.

Source: Global Human Settlement Layer (GHS-BUILT-S and GHS-POP R2023A), European Commission Joint Research Centre (JRC), © European Union, CC BY 4.0. Sum inside the perimeter computed by WorldFires. human-settlement.emergency.copernicus.eu

The weather day by day

ECMWF ERA5 reanalysis at the fire location, the standard reference for past weather, and the Canadian Fire Weather Index (the same system Copernicus uses), computed by WorldFires from that data. Days after the fire run until the first rain.

Open-Meteo.com (CC BY 4.0) · Copernicus Climate Change Service (ERA5)

Day High Min. humidity Peak gust Rain Danger (FWI)
6 Jul 23.1 °C 31 % 37 km/h 0.0 mm Moderate 12
7 Jul 22.1 °C 36 % 33 km/h 0.3 mm Moderate 14
8 Jul 21.2 °C 24 % 32 km/h 0.0 mm Moderate 16
9 Jul 17.4 °C 47 % 26 km/h 1.5 mm Low 11
10 Jul 18.9 °C 38 % 20 km/h 0.0 mm Very low 3
11 Jul 16.8 °C 60 % 54 km/h 0.0 mm Low 8
12 Jul 13.5 °C 70 % 37 km/h 0.2 mm Low 7
13 Jul 14.1 °C 56 % 34 km/h 0.0 mm Low 7
14 Jul 13.9 °C 64 % 37 km/h 0.0 mm Low 8
15 Jul 13.4 °C 65 % 38 km/h 0.0 mm Low 9
16 Jul 14.4 °C 52 % 34 km/h 0.2 mm Low 9
17 Jul 15.8 °C 58 % 43 km/h 3.4 mm Low 10
18 Jul 17.1 °C 65 % 35 km/h 2.9 mm Very low 0
19 Jul 15.1 °C 67 % 34 km/h 0.0 mm Very low 1
20 Jul 13.3 °C 71 % 30 km/h 0.0 mm Very low 2
21 Jul 16.4 °C 47 % 20 km/h 0.0 mm Very low 3
22 Jul 15.8 °C 52 % 22 km/h 1.4 mm Low 6
23 Jul 17.1 °C 55 % 27 km/h 0.1 mm Very low 3
24 Jul 13.2 °C 59 % 43 km/h 0.5 mm Low 6
25 Jul 15.3 °C 47 % 33 km/h 0.0 mm Low 7
26 Jul 15.3 °C 54 % 34 km/h 0.1 mm Low 8
27 Jul 12.7 °C 69 % 52 km/h 2.3 mm Low 9
28 Jul 8.8 °C 67 % 60 km/h 3.8 mm Very low 1
29 Jul 9.7 °C 73 % 50 km/h 4.7 mm Very low 0
30 Jul 14.6 °C 55 % 20 km/h 0.2 mm Very low 1
31 Jul 15.8 °C 49 % 19 km/h 0.1 mm Very low 1
1 Aug 15.5 °C 55 % 33 km/h 0.0 mm Very low 4
2 Aug 18.0 °C 48 % 27 km/h 0.0 mm Low 6
3 Aug 21.7 °C 51 % 34 km/h 0.0 mm Low 8
4 Aug 22.3 °C 44 % 30 km/h 0.0 mm Low 9
5 Aug 21.5 °C 48 % 20 km/h 0.0 mm Low 9
6 Aug 18.9 °C 56 % 30 km/h 3.0 mm Low 9
7 Aug 16.7 °C 44 % 38 km/h 0.6 mm Very low 1
8 Aug 15.4 °C 35 % 53 km/h 0.3 mm Very low 4
9 Aug 15.8 °C 31 % 27 km/h 0.0 mm Low 7
10 Aug 16.6 °C 35 % 28 km/h 0.0 mm Low 10
11 Aug 17.5 °C 32 % 20 km/h 0.0 mm Low 10
12 Aug 18.2 °C 36 % 27 km/h 0.0 mm Moderate 13
13 Aug 17.8 °C 47 % 40 km/h 0.0 mm Moderate 15
14 Aug 16.2 °C 56 % 37 km/h 0.5 mm Low 11
15 Aug after 16.1 °C 58 % 35 km/h 3.1 mm Very low 2

Its twins: fires that started in the same weather

It started with an FWI of 12.2, a minimum humidity of 31% and 2 days without rain. Fires in the area that started in weather like this since 2018: 7.

FWI at the start 12.2
Minimum humidity 31 %
Days without rain 2
this fire chosen twins rest of the area
Almost identicalSimilar

Outlines of the closest twins

Yukon, Unorganized fire, August 2018
2,147 ha 23 days FWI 15.6 Min. humidity 29 % 68 km away, in 2018

First rain (1 mm or more) after it ended: 2.4 mm on 24 Aug.

What happened to them

Fires in the area that started in similar weather: 7. With fewer than 15 we give no figures: they would be more noise than signal.

This is a bank of analogues: it shows what usually happens, not what will happen. With fewer than 15 twins we give no figures. How we calculate it

How it ended

3.1 mmfirst rain
15 Augthe day after it ended
60km/h · max. gust

It was considered over on 14 Aug, and on 15 Aug 3.1 mm fell. We do not know whether the rain or the firefighters put it out.

Weather on this page: Open-Meteo.com (CC BY 4.0) · Copernicus Climate Change Service (ERA5)

How a twin is chosen

  • Same area: fires that have already ended, less than 250 km from this one, since 2018.
  • Same start: we compare the FWI on the first day, the minimum humidity that day and the run of days without rain before it. The slider sets how much they may differ.
  • Only pages with final weather data (ERA5 reanalysis) calculated in the same way as this fire’s; agricultural and grass burns and pages with data under review are left out.
  • Fires burning at the same time as this one (a week before or after) are left out: they share the same spell of weather and do not count as a precedent.
  • They are sorted by similarity, and the outlines of the first five are drawn.

How we calculate it

Before and after, from space

Drag the line to compare the same ground before the fire and after it.

Before · 29 Jun 2019
After · 21 Aug 2019

If the day is cloudy, change the date: each satellite passes once a day. In false colour the burnt ground looks brown or red.

Detections table · 225Every satellite heat detection, one by one, with time, satellite, power and coordinates.
⬇ Download CSV Times in UTC. Each detection is a 375 m pixel: a large fire yields hundreds per pass.
Date and timeSatelliteFRP (MW)LatLon

Other fires nearby

All fires in Canada

Frequently asked questions

How long did the Stikine Region fire last?
According to the heat detections seen by satellite inside the perimeter, it burned from 6 July 2019 to 14 August 2019 (40 days). The perimeter dates it from 6 July 2019 to 13 August 2019.
How much area did it burn?
The official perimeter mapped by Canada’s CWFIS (Natural Resources Canada) is 1,197 hectares (12.0 km²). Other tallies, such as those of provincial agencies, may give slightly different figures.
Which census subdivisions burned?
The fire only entered Stikine Region (1,244 ha, 0.0 %).
What was the weather like?
During the fire the temperature reached 23.1 °C, humidity dropped to 24 % and gusts hit 60 km/h. The fire danger index (FWI) reached 16, class Moderate.
Where does this data come from?
From the official burnt perimeter of Canada’s CWFIS (NBAC, Natural Resources Canada) or, for the current season and until NBAC publishes it, the one rebuilt by GWIS (Copernicus); from NASA FIRMS VIIRS hotspots; and from the administrative boundaries of Canada. It is not an official report.

Where to verify it

A satellite detection is not an official report. Final figures and the fire’s status are published by each country’s emergency service.

Emergency number: 911 · Emergency number and official warnings

Satellite cross-check

History of this page Changes in area, dates, name, official record or merged pages, compared every night since 24 October 2026.

Does something look wrong on this page?

This page is built from satellite data and official records, and it sometimes gets things wrong: the wrong dates, the wrong town, two fires merged into one, or something that was not a wildfire at all. If you know this fire first-hand (you live nearby, saw it, fought it or reported on it), tell us what really happened and we will check it.

Report an error
What do you think is wrong?

We will only use your email to reply about this report. Privacy. This is not an emergency service: if there is a fire now, call 911.

How we know this
  • Perimeter: NBAC (Natural Resources Canada), official.
  • Dates adjusted with the VIIRS detections inside the perimeter, which said 6 July 2019 to 13 August 2019. 225 Suomi-NPP VIIRS detections on those dates.
  • We have not matched this page with any official record.
  • Weather: Copernicus ERA5 reanalysis at the fire location, in cells of about 25 km.
  • Built-up area and population come from the JRC Global Human Settlement Layer (epoch 2020, 100 m cells), summed inside the perimeter: an estimate of what was there, not a damage count.

How we build fire pages: methodology

Where this data comes from

The perimeter is official: it comes from the National Burned Area Composite (NBAC) of the Canadian Wildland Fire Information System (CWFIS), Natural Resources Canada, which maps it on satellite imagery and publishes it under the Open Government Licence – Canada. Until NBAC publishes the current season, this year’s fires carry the perimeter rebuilt from heat detections by GWIS (Copernicus, CC BY 4.0), which is approximate. Heat detections come from the VIIRS sensors aboard Suomi-NPP and NOAA-20, distributed by NASA FIRMS at 375 m resolution. Census subdivision boundaries come from geoBoundaries ADM3 (Open Data Commons Open Database License 1.0). The area per census subdivision is computed by WorldFires by crossing the perimeter with those boundaries, so it may differ slightly from official figures.