Skip to content
worldfires
RO · Romania · →

Șovarna fire, March 2021 Șovarna, Ilovăț

Out · last detection 6 Mar 2021, 11:03 UTC

The fire started on 6 March 2021 in Șovarna, Romania, and satellites saw it burning for 1 day. Copernicus mapped a burnt perimeter of 101 hectares from satellite imagery, spread across 2 municipalities.

It is the 86th largest in Mehedinți since 2016 (of 87 with a page). Number 22 in Romania in 2021, of 23.

The power measured by the satellite is low (3.6 MW in the strongest hotspot), more typical of grass or stubble burning, or a slow surface fire, than of a large crown fire.

Compare with…
Burnt area
101ha
Copernicus perimeter
Duration
1day
6 Mar 2021 – 6 Mar 2021
Municipalities hit
2
municipalities
Started on
6 Mar
2021
Heat detections
2
in a single hotspot: 4 MW
Danger at start
8
Low · FWI index
Average daily power
6MW
detected power per day, on average

Where it burned

HOTSPOTS BY DAY 6 Mar6 Mar

How it evolved, day by day

6 Mar 2021 · 6 MW · 2

Fire radiative power detected each day, in megawatts, and number of hotspots. The magenta bar marks the peak day.

The weather it burned in

8°high
41km/h · peak gust
30%lowest humidity

It had gone 13 days without rain (1 mm or more) when it started. Rain came after the fire: 11.9 mm on 10 Mar.

This area had burned before

47% of the perimeter overlaps earlier fires recorded since 2016: 47 ha in 2020.

What happened to each town

  1. Șovarna where it started
    63 ha reached on 6 Mar
    1.7 %
  2. 38 ha reached on 6 Mar
    0.5 %

Burnt area inside each municipality, from crossing the official perimeter with administrative boundaries. The distance runs from the point marking the centre of each area to the nearest fire: staying a kilometre away does not mean it reached the houses.

What burned

  • Agricultural areas60 %
  • Scrub and transitional woodland35 %
  • Broadleaved forest4.9 %

Land cover inside the perimeter according to Corine Land Cover, as reported by Copernicus.

People and buildings inside the perimeter

GHSL 2020
Built-up area< 0.1 ha
Residents< 20

Inside the perimeter there was no noticeable built-up land and almost nobody lived there (GHSL 2020, satellite-based estimate).

This is an estimate on 100 m cells, made from satellite imagery and census data: it does not mean that homes burned or that anyone was harmed. The perimeter also contains land that never burned.

Source: Global Human Settlement Layer (GHS-BUILT-S and GHS-POP R2023A), European Commission Joint Research Centre (JRC), © European Union, CC BY 4.0. Sum inside the perimeter computed by WorldFires. human-settlement.emergency.copernicus.eu

The weather day by day

ECMWF ERA5 reanalysis at the fire location, the standard reference for past weather, and the Canadian Fire Weather Index (the same system Copernicus uses), computed by WorldFires from that data. Days after the fire run until the first rain.

Open-Meteo.com (CC BY 4.0) · Copernicus Climate Change Service (ERA5)

Day High Min. humidity Peak gust Rain Danger (FWI)
6 Mar 7.6 °C 30 % 41 km/h 0.0 mm Low 8
7 Mar after 5.9 °C 49 % 15 km/h 0.0 mm Very low 4
8 Mar after 12.0 °C 22 % 28 km/h 0.0 mm Low 7
9 Mar after 6.6 °C 45 % 27 km/h 0.0 mm Low 5
10 Mar after 2.8 °C 63 % 34 km/h 11.9 mm Very low 0

Before and after, from space

Drag the line to compare the same ground before the fire and after it.

Before · 27 Feb 2021
After · 13 Mar 2021

If the day is cloudy, change the date: each satellite passes once a day. In false colour the burnt ground looks brown or red.

The smoke

CAMS · Copernicus

On 9 March 2021 the air beside the fire reached 30 µg/m³ of PM2.5. That day averaged 22: 1.5 times the WHO daily guideline (15).

PM2.5 peak30 µg/m³
Days over the guideline2 days
PM1039 µg/m³
456789
Good Fair Moderate Poor Very poor Extremely poor

Particles from the Copernicus CAMS model at the centre of the perimeter; these are not measurements in each town. The pale bar is the worst hour, the solid one the daily average.

Open-Meteo.com (CC BY 4.0) · Copernicus Atmosphere Monitoring Service (CAMS)

Detections table · 2Every satellite heat detection, one by one, with time, satellite, power and coordinates.
⬇ Download CSV Times in UTC. Each detection is a 375 m pixel: a large fire yields hundreds per pass.
Date and timeSatelliteFRP (MW)LatLon

Other fires nearby

All fires in Romania ›

Frequently asked questions

How long did the Șovarna fire last?
Copernicus dates it between 6 March 2021 and 6 March 2021: 1 day between the first and last image with fire.
How much area did it burn?
The perimeter Copernicus measured from satellite imagery is 101 hectares (1.0 km²). Official national figures may differ.
Which municipalities burned?
The fire entered 2 municipalities: Șovarna (63 ha, 1.7 %); Ilovăț (38 ha, 0.5 %).
What was the weather like?
During the fire the temperature reached 7.6 °C, humidity dropped to 30 % and gusts hit 41 km/h. The fire danger index (FWI) reached 8, class Low.
Where does this data come from?
From the EFFIS (Copernicus) burnt perimeter, NASA FIRMS VIIRS hotspots and the administrative boundaries of Romania (geoBoundaries). It is not an official report.

Where to verify it

A satellite detection is not an official report. Final figures and the fire’s status are published by each country’s emergency service.

Emergency number: 112 · Emergency number and official warnings ›

Satellite cross-check

History of this page Changes in area, dates, name, official record or merged pages, compared every night since 24 October 2026.

No changes since 24 October 2026.

RSS Changes to this page

Does something look wrong on this page?

This page is built from satellite data and official records, and it sometimes gets things wrong: the wrong dates, the wrong town, two fires merged into one, or something that was not a wildfire at all. If you know this fire first-hand (you live nearby, saw it, fought it or reported on it), tell us what really happened and we will check it.

Report an error
What do you think is wrong?

We will only use your email to reply about this report. Privacy. This is not an emergency service: if there is a fire now, call 112.

How we know this
  • Perimeter: EFFIS (Copernicus), mapped on satellite imagery.
  • Dates from the perimeter: the VIIRS detections inside it did not change them. 2 Suomi-NPP VIIRS detections on those dates.
  • We have not matched this page with any official record.
  • Weather: Copernicus ERA5 reanalysis at the fire location, in cells of about 25 km.
  • Built-up area and population come from the JRC Global Human Settlement Layer (epoch 2020, 100 m cells), summed inside the perimeter: an estimate of what was there, not a damage count.

How we build fire pages: methodology ›

Where this data comes from

The perimeter and land cover come from the Copernicus European Forest Fire Information System (EFFIS), measured on MODIS and Sentinel-2 imagery and published under CC BY 4.0. Heat detections come from the VIIRS sensors aboard Suomi-NPP and NOAA-20, distributed by NASA FIRMS at 375 m resolution. Municipal boundaries come from geoBoundaries ADM2 (Creative Commons Attribution 4.0 International (CC BY 4.0)). The area per municipality is computed by WorldFires by crossing the perimeter with those boundaries, so it may differ slightly from each country’s official figure.