Skip to content
worldfires
US · United States · –

Siskiyou fire, 10 November 2026 Siskiyou

Out · last detection 12 Nov 2026, 11:19 UTC

Satellites first detected fire on 10 November 2026 in Siskiyou, United States. It was active for 3 days, with 85 heat detections and an area with fire of about 686 hectares rebuilt from them, spread across a single county.

The power measured by the satellite is low (21.1 MW in the strongest hotspot), more typical of grass or stubble burning, or a slow surface fire, than of a large crown fire.

NIFC has not yet published the perimeter of this fire. For now the area is the one rebuilt from heat detections (about 14 hectares per pixel). When the perimeter arrives, this page picks it up on its own and keeps the same address.

Area with fire
≈ 686ha
rebuilt from hotspots, no official perimeter yet
Duration
3days
10 Nov 2026 – 12 Nov 2026
Counties hit
1
counties
Started on
10 Nov
2026
Heat detections
85
in a single hotspot: 21 MW
Danger at start
10
Low · FWI index
Average daily power
158MW
detected power per day, on average

Where it burned

HOTSPOTS BY DAY 10 Nov12 Nov
12 Nov 2026

How it evolved, day by day

10 Nov 2026 · 85 MW · 5 11 Nov 2026 · 197 MW · 22 12 Nov 2026 · 193 MW · 58
10 Nov 11 Nov 12 Nov

Fire radiative power detected each day, in megawatts, and number of hotspots. The magenta bar marks the peak day.

The weather it burned in

18°high
41km/h · peak gust
20%lowest humidity

It had gone 6 days without rain (1 mm or more) when it started. Rain came after the fire: 50.1 mm on 13 Nov.

What happened to each county

  1. Siskiyou where it started
    686 ha reached on 10 Nov
    0.0 %

Area with fire inside each county, rebuilt from heat detections (about 14 hectares per VIIRS pixel). An estimate until NIFC publishes the official perimeter. The distance runs from the point marking the centre of each area to the nearest fire: staying a kilometre away does not mean it reached the houses.

The weather day by day

ECMWF ERA5 reanalysis at the fire location, the standard reference for past weather, and the Canadian Fire Weather Index (the same system Copernicus uses), computed by WorldFires from that data. Days after the fire run until the first rain.

Open-Meteo.com (CC BY 4.0) · forecast models, provisional until the ERA5 reanalysis arrives

Day High Min. humidity Peak gust Rain Danger (FWI)
10 Nov 18.5 °C 31 % 22 km/h 0.0 mm Low 10
11 Nov 18.4 °C 20 % 29 km/h 0.0 mm Moderate 18
12 Nov 16.6 °C 28 % 41 km/h 0.1 mm Moderate 21
13 Nov after 7.7 °C 95 % 59 km/h 50.1 mm Very low 0

Its twins: fires that started in the same weather

It started with an FWI of 10.2, a minimum humidity of 31% and 6 days without rain. Fires in the area that started in weather like this since 2016: 17.

FWI at the start 10.2
Minimum humidity 31 %
Days without rain 6
this fire chosen twins rest of the area
Almost identicalSimilar

Outlines of the closest twins

Dl Rattlesnake Mt Fire, August 2017
508 ha 37 days FWI 8.9 Min. humidity 31 % 209 km away, in 2017

First rain (1 mm or more) after it ended: 1.9 mm on 17 Sept.

What happened to them

24 days
median duration
1,746 ha
median area
71 %
went past 1,000 ha
3.1 mm
rain at the end (median; 15 of 17 had it)

It stayed below its twins: 686 ha against a median of 1,746 ha. It lasted 3 days, against 24 days.

In 2 of 17, not even 1 mm fell in the ten days after the end: they went out without rain. In the rest, the first rainy day brought a median of 3.1 mm.

This is a bank of analogues: it shows what usually happens, not what will happen. With fewer than 15 twins we give no figures. How we calculate it

How it ended

50.1 mmfirst rain
13 Novthe day after it ended
41km/h · max. gust

It was considered over on 12 Nov, and on 13 Nov 50.1 mm fell. We do not know whether the rain or the firefighters put it out. Twins with rain when they ended: 15 of 17, with a median of 3.1 mm.

Weather on this page: Open-Meteo.com (CC BY 4.0) · forecast models, provisional until the ERA5 reanalysis arrives

How a twin is chosen

  • Same area: fires that have already ended, less than 250 km from this one, since 2016.
  • Same start: we compare the FWI on the first day, the minimum humidity that day and the run of days without rain before it. The slider sets how much they may differ.
  • Only pages with final weather data (ERA5 reanalysis) calculated in the same way as this fire’s; agricultural and grass burns and pages with data under review are left out.
  • Fires burning at the same time as this one (a week before or after) are left out: they share the same spell of weather and do not count as a precedent.
  • They are sorted by similarity, and the outlines of the first five are drawn.

How we calculate it

Before and after, from space

Drag the line to compare the same ground before the fire and after it.

Before · 3 Nov 2026
After · 18 Nov 2026

If the day is cloudy, change the date: each satellite passes once a day. In false colour the burnt ground looks brown or red.

The smoke

CAMS · Copernicus

On 12 November 2026 the air beside the fire reached 14 µg/m³ of PM2.5, but no daily average passed the WHO guideline (15).

PM2.5 peak14 µg/m³
Days over the guideline0 days
PM1015 µg/m³
Optical depth0.12
89101112
Good Fair Moderate Poor Very poor Extremely poor

Particles from the Copernicus CAMS model at the centre of the perimeter; these are not measurements in each town. The pale bar is the worst hour, the solid one the daily average.

Open-Meteo.com (CC BY 4.0) · Copernicus Atmosphere Monitoring Service (CAMS)

Detections table · 85Every satellite heat detection, one by one, with time, satellite, power and coordinates.
⬇ Download CSV Times in UTC. Each detection is a 375 m pixel: a large fire yields hundreds per pass.
Date and timeSatelliteFRP (MW)LatLon

Other fires nearby

All fires in United States

Frequently asked questions

How long did the Siskiyou fire last?
According to the heat detections seen by satellite, it burned from 10 November 2026 to 12 November 2026 (3 days between the first and the last detection). There is no perimeter yet to date it.
How much area did it burn?
There is no official perimeter yet: NIFC has not published it. Heat detections rebuild about 686 hectares with fire (6.9 km²).
Which counties burned?
The fire only entered Siskiyou (686 ha, 0.0 %).
Is the Siskiyou fire still active?
No fire detections since 12 Nov 2026, 11:19 UTC. A lack of detections is not an official extinction.
What was the weather like?
During the fire the temperature reached 18.5 °C, humidity dropped to 20 % and gusts hit 41 km/h. The fire danger index (FWI) reached 21, class Moderate.
Where does this data come from?
From the official burnt perimeter of United States agencies (MTBS / NIFC, public domain), NASA FIRMS VIIRS hotspots and the administrative boundaries of United States. It is not an official report.
How did the fires that started in similar weather in this area end?
Fires less than 250 km away that started since 2016 with a similar FWI, humidity and dry spell: 17. Their median duration was 24 days and their median area 1,746 ha; 71 % went past 1,000 ha. In 2 of 17, not even 1 mm fell in the ten days after the end: they went out without rain. In the rest, the first rainy day brought a median of 3.1 mm.

Where to verify it

A satellite detection is not an official report. Final figures and the fire’s status are published by each country’s emergency service.

Emergency number: 911 · Emergency number and official warnings

Satellite cross-check

History of this page · 1 Changes in area, dates, name, official record or merged pages, compared every night since 13 November 2026.
  1. Page published (≈ 686 ha).

RSS Changes to this page With cross-checks and a citable version

Does something look wrong on this page?

This page is built from satellite data and official records, and it sometimes gets things wrong: the wrong dates, the wrong town, two fires merged into one, or something that was not a wildfire at all. If you know this fire first-hand (you live nearby, saw it, fought it or reported on it), tell us what really happened and we will check it.

Report an error
What do you think is wrong?

We will only use your email to reply about this report. Privacy. This is not an emergency service: if there is a fire now, call 911.

How we know this
  • No perimeter yet: the area (≈ 686 ha) is estimated by counting VIIRS pixels with fire, about 14 ha each.
  • Dates of the first and last VIIRS detection of the cluster. 85 Suomi-NPP VIIRS detections on those dates.
  • Weather: ECMWF IFS model, provisional until the ERA5 reanalysis arrives.

How we build fire pages: methodology

Where this data comes from

The perimeter is official and in the public domain. For past years it comes from MTBS (Monitoring Trends in Burn Severity), run by the U.S. Geological Survey and the USDA Forest Service, which map it on Landsat and Sentinel-2 imagery. For the current and last year it comes from WFIGS at the National Interagency Fire Center (NIFC): incident perimeters mapped by fire crews, aircraft and imagery. Heat detections come from the VIIRS sensors aboard Suomi-NPP and NOAA-20, distributed by NASA FIRMS at 375 m resolution. County boundaries come from geoBoundaries ADM2 (Public Domain). The area per county is computed by WorldFires by crossing the perimeter with those boundaries, so it may differ slightly from official figures.