Skip to content
worldfires
TR · Türkiye · →

Silopi fire, August 2021 Silopi

Out · last detection 31 Aug 2021, 10:24 UTC

The fire started on 30 August 2021 in Silopi, Türkiye, and satellites saw it burning for 4 days. Copernicus mapped a burnt perimeter of 103 hectares from satellite imagery, spread across a single municipality.

It is the 189th largest in Şırnak since 2016 (of 192 with a page). Number 136 in Türkiye in 2021, of 138.

The power measured by the satellite is low (6.6 MW in the strongest hotspot), more typical of grass or stubble burning, or a slow surface fire, than of a large crown fire.

Compare with…

Suggestions: Zakho · 2016Eruh · 2017

Burnt area
103ha
Copernicus perimeter
Duration
4days
30 Aug 2021 – 2 Sept 2021
Municipalities hit
1
districts
Started on
30 Aug
2021
Heat detections
7
in a single hotspot: 7 MW
Danger at start
54
Extreme · FWI index
Average daily power
16MW
detected power per day, on average

Where it burned

HOTSPOTS BY DAY 30 Aug2 Sept
31 Aug 2021

How it evolved, day by day

30 Aug 2021 · 13 MW · 4 31 Aug 2021 · 20 MW · 3
30 Aug 31 Aug

Fire radiative power detected each day, in megawatts, and number of hotspots. The magenta bar marks the peak day.

The weather it burned in

36°high
56km/h · peak gust
8%lowest humidity

It had gone more than two months without rain (1 mm or more) when it started.

This area had burned before

No earlier perimeters overlap this fire since 2016, when the satellite record begins.

What happened to each town

  1. Silopi 134,754 inhabitants · 12.3 km from the centre where it started
    104 ha reached on 30 Aug
    0.1 %

Burnt area inside each municipality, from crossing the official perimeter with administrative boundaries. The distance runs from the point marking the centre of each area to the nearest fire: staying a kilometre away does not mean it reached the houses.

What burned

  • Broadleaved forest95 %
  • Other natural land4.8 %

Land cover inside the perimeter according to Corine Land Cover, as reported by Copernicus.

The weather day by day

ECMWF ERA5 reanalysis at the fire location, the standard reference for past weather, and the Canadian Fire Weather Index (the same system Copernicus uses), computed by WorldFires from that data. Days after the fire run until the first rain.

Open-Meteo.com (CC BY 4.0) · Copernicus Climate Change Service (ERA5)

Day High Min. humidity Peak gust Rain Danger (FWI)
30 Aug 36.0 °C 8 % 44 km/h 0.0 mm Extreme 54
31 Aug 33.5 °C 11 % 49 km/h 0.0 mm Extreme 55
1 Sept 32.9 °C 11 % 41 km/h 0.0 mm Extreme 54
2 Sept 32.6 °C 16 % 56 km/h 0.0 mm Extreme 56
3 Sept after 29.4 °C 18 % 41 km/h 0.0 mm Very high 46
4 Sept after 29.7 °C 17 % 50 km/h 0.0 mm Extreme 50
5 Sept after 28.7 °C 11 % 40 km/h 0.0 mm Very high 46
6 Sept after 29.8 °C 14 % 39 km/h 0.0 mm Very high 45
7 Sept after 31.1 °C 13 % 48 km/h 0.0 mm Very high 49
8 Sept after 31.6 °C 10 % 36 km/h 0.0 mm Very high 46
9 Sept after 31.8 °C 9 % 37 km/h 0.0 mm Very high 48
10 Sept after 31.7 °C 11 % 36 km/h 0.0 mm Very high 47
11 Sept after 28.9 °C 14 % 45 km/h 0.0 mm Extreme 50
12 Sept after 28.3 °C 16 % 35 km/h 0.0 mm Very high 44

Before and after, from space

Drag the line to compare the same ground before the fire and after it.

Before · 23 Aug 2021
After · 9 Sept 2021

If the day is cloudy, change the date: each satellite passes once a day. In false colour the burnt ground looks brown or red.

The smoke

CAMS · Copernicus

On 31 August 2021 the air beside the fire reached 25 µg/m³ of PM2.5. That day averaged 19: 1.3 times the WHO daily guideline (15).

PM2.5 peak25 µg/m³
Days over the guideline7 days
PM1053 µg/m³
2829303112345
Good Fair Moderate Poor Very poor Extremely poor

Particles from the Copernicus CAMS model at the centre of the perimeter; these are not measurements in each town. The pale bar is the worst hour, the solid one the daily average.

Open-Meteo.com (CC BY 4.0) · Copernicus Atmosphere Monitoring Service (CAMS)

Detections table · 7Every satellite heat detection, one by one, with time, satellite, power and coordinates.
⬇ Download CSV Times in UTC. Each detection is a 375 m pixel: a large fire yields hundreds per pass.
Date and timeSatelliteFRP (MW)LatLon

Other fires nearby

All fires in Türkiye ›

Frequently asked questions

How long did the Silopi fire last?
Copernicus dates it between 30 August 2021 and 2 September 2021: 4 days between the first and last image with fire.
How much area did it burn?
The perimeter Copernicus measured from satellite imagery is 103 hectares (1.0 km²). Official national figures may differ.
Which municipalities burned?
The fire only entered Silopi (104 ha, 0.1 %).
Did the fire reach a town?
The fire started in Silopi and came within 12.3 km of its centre. That is the distance from the perimeter, or the nearest hotspot, to the point marking the centre; it does not mean it entered the houses.
What was the weather like?
During the fire the temperature reached 36.0 °C, humidity dropped to 8 % and gusts hit 56 km/h. The fire danger index (FWI) reached 56, class Extreme.
Where does this data come from?
From the EFFIS (Copernicus) burnt perimeter, NASA FIRMS VIIRS hotspots and the administrative boundaries of Türkiye (geoBoundaries). It is not an official report.

Where to verify it

A satellite detection is not an official report. Final figures and the fire’s status are published by each country’s emergency service.

Emergency number: 112 · Emergency number and official warnings ›

Satellite cross-check

History of this page Changes in area, dates, name, official record or merged pages, compared every night since 24 October 2026.

No changes since 24 October 2026.

RSS Changes to this page

Does something look wrong on this page?

This page is built from satellite data and official records, and it sometimes gets things wrong: the wrong dates, the wrong town, two fires merged into one, or something that was not a wildfire at all. If you know this fire first-hand (you live nearby, saw it, fought it or reported on it), tell us what really happened and we will check it.

Report an error
What do you think is wrong?

We will only use your email to reply about this report. Privacy. This is not an emergency service: if there is a fire now, call 112.

How we know this
  • Perimeter: EFFIS (Copernicus), mapped on satellite imagery.
  • Dates from the perimeter: the VIIRS detections inside it did not change them. 7 Suomi-NPP VIIRS detections on those dates.
  • We have not matched this page with any official record.
  • Weather: Copernicus ERA5 reanalysis at the fire location, in cells of about 25 km.

How we build fire pages: methodology ›

Where this data comes from

The perimeter and land cover come from the Copernicus European Forest Fire Information System (EFFIS), measured on MODIS and Sentinel-2 imagery and published under CC BY 4.0. Heat detections come from the VIIRS sensors aboard Suomi-NPP and NOAA-20, distributed by NASA FIRMS at 375 m resolution. Municipal boundaries come from geoBoundaries ADM2 (Open Data Commons Open Database License 1.0). The area per municipality is computed by WorldFires by crossing the perimeter with those boundaries, so it may differ slightly from each country’s official figure.