Skip to content
worldfires
CY · Cyprus · →

Sia fire, May 2020 Σιά · Sia, Kofinou

Out · last detection 17 May 2020, 10:54 UTC

The fire started on 17 May 2020 in Sia, Cyprus, and satellites saw it burning for 2 days. Copernicus mapped a burnt perimeter of 131 hectares from satellite imagery, spread across 2 municipalities.

Number 8 in Cyprus in 2020, of 8.

The power measured by the satellite is low (18.7 MW in the strongest hotspot), more typical of grass or stubble burning, or a slow surface fire, than of a large crown fire.

Burnt area
131ha
Copernicus perimeter
Duration
2days
17 May 2020 – 18 May 2020
Municipalities hit
2
municipalities
Started on
17 May
2020
Heat detections
1
in a single hotspot: 19 MW
Danger at start
40
Very high · FWI index
Energy released
19MW
sum of detected power

Where it burned

HOTSPOTS BY DAY 17 May18 May

How it evolved, day by day

17

Fire radiative power detected each day, in megawatts, and number of hotspots. The magenta bar marks the peak day.

The weather it burned in

36°high
43km/h · peak gust
16%lowest humidity

It had gone 11 days without rain (1 mm or more) when it started.

This area had burned before

No earlier perimeters overlap this fire since 2016, when the satellite record begins.

What happened to each town

  1. Sia Σιά 754 inhabitants · 7.5 km from the town where it started
    128 ha reached on 17 May
    2.7 %
  2. Kofinou Κοφίνου 1,309 inhabitants · 4.3 km from the town
    3 ha
    0.1 %

Burnt area inside each municipality, from crossing the official perimeter with administrative boundaries. The distance is from the town centre to the nearest fire: staying a kilometre away does not mean it reached the houses.

What burned

  • Sclerophyllous scrub100 %

Land cover inside the perimeter according to Corine Land Cover, as reported by Copernicus.

Official record

According to Τμήμα Δασών, this fire started on 17 May 2020 and burned 59 ha (the satellite measured 131 ha). The two figures differ a lot, so these may not be exactly the same fire: take them as nearby records.

Τμήμα Δασών (Departamento de Bosques de Chipre), catálogo de incendios forestales. This is the agency’s consolidated statistic: it measures the area in its own way, which is why it can differ from the satellite.

The weather day by day

ECMWF ERA5 reanalysis at the fire location, the standard reference for past weather, and the Canadian Fire Weather Index (the same system Copernicus uses), computed by WorldFires from that data. Days after the fire run until the first rain.

Open-Meteo.com (CC BY 4.0) · Copernicus Climate Change Service (ERA5)

Day High Min. humidity Peak gust Rain Danger (FWI)
17 May 35.4 °C 16 % 43 km/h 0.0 mm Very high 40
18 May 35.9 °C 16 % 36 km/h 0.0 mm Very high 41
19 May after 37.2 °C 13 % 26 km/h 0.0 mm High 37
20 May after 35.7 °C 18 % 26 km/h 0.0 mm Very high 39
21 May after 35.6 °C 12 % 33 km/h 0.0 mm Very high 49
22 May after 29.8 °C 30 % 40 km/h 0.0 mm High 34
23 May after 26.8 °C 35 % 28 km/h 0.0 mm High 27
24 May after 23.7 °C 25 % 63 km/h 0.0 mm Very high 42
25 May after 26.9 °C 17 % 40 km/h 0.0 mm High 35
26 May after 25.1 °C 46 % 26 km/h 0.0 mm High 24
27 May after 28.2 °C 33 % 30 km/h 0.0 mm High 24
28 May after 25.7 °C 32 % 31 km/h 0.0 mm High 26

Before and after, from space

Drag the line to compare the same ground before the fire and after it.

Before · 10 May 2020
After · 25 May 2020

If the day is cloudy, change the date: each satellite passes once a day. In false colour the burnt ground looks brown or red.

The smoke

CAMS · Copernicus

On 21 May 2020 the air beside the fire reached 34 µg/m³ of PM2.5. That day averaged 26: 1.8 times the WHO daily guideline (15).

PM2.5 peak34 µg/m³
Days over the guideline6 days
PM1058 µg/m³
15161718192021
Good Fair Moderate Poor Very poor Extremely poor

Particles from the Copernicus CAMS model at the centre of the perimeter; these are not measurements in each town. The pale bar is the worst hour, the solid one the daily average.

Open-Meteo.com (CC BY 4.0) · Copernicus Atmosphere Monitoring Service (CAMS)

Detections table · 1Every satellite heat detection, one by one, with time, satellite, power and coordinates.
⬇ Download CSV Times in UTC. Each detection is a 375 m pixel: a large fire yields hundreds per pass.
Date and timeSatelliteFRP (MW)LatLon

Other fires nearby

All fires in Cyprus ›

Frequently asked questions

How long did the Sia fire last?
Copernicus dates it between 17 May 2020 and 18 May 2020: 2 days between the first and last image with fire.
How much area did it burn?
The perimeter Copernicus measured from satellite imagery is 131 hectares (1.3 km²). Official national figures may differ.
Which municipalities burned?
The fire entered 2 municipalities: Sia (128 ha, 2.7 %); Kofinou (3 ha, 0.1 %).
Did the fire reach a town?
The closest fire to a town centre came within 4.3 km of Kofinou. That is the distance to the perimeter or nearest hotspot; it does not mean it entered the houses.
What was the weather like?
During the fire the temperature reached 35.9 °C, humidity dropped to 16 % and gusts hit 43 km/h. The fire danger index (FWI) reached 41, class Very high.
Where does this data come from?
From the EFFIS (Copernicus) burnt perimeter, NASA FIRMS VIIRS hotspots and the administrative boundaries of Cyprus (geoBoundaries). It is not an official report.

Where to verify it

A satellite detection is not an official report. Final figures and the fire’s status are published by each country’s emergency service.

Emergency number: 112 · 1407

Satellite cross-check

Does something look wrong on this page?

This page is built from satellite data and official records, and it sometimes gets things wrong: the wrong dates, the wrong town, two fires merged into one, or something that was not a wildfire at all. If you know this fire first-hand (you live nearby, saw it, fought it or reported on it), tell us what really happened and we will check it.

Report an error
What do you think is wrong?

We will only use your email to reply about this report. Privacy. This is not an emergency service: if there is a fire now, call 112 · 1407.

Where this data comes from

The perimeter and land cover come from the Copernicus European Forest Fire Information System (EFFIS), measured on MODIS and Sentinel-2 imagery and published under CC BY 4.0. Heat detections come from the VIIRS sensors aboard Suomi-NPP and NOAA-20, distributed by NASA FIRMS at 375 m resolution. Municipal boundaries come from geoBoundaries ADM2 (Creative Commons Attribution-ShareAlike 3.0 Unported). The area per municipality is computed by WorldFires by crossing the perimeter with those boundaries, so it may differ slightly from each country’s official figure.