Skip to content
worldfires
CN · China · –

Shuangyang District fire, November 2026 双阳区 · Shuangyang District, Yongji County, Panshi City

Burning · last detection 17 Nov 2026, 04:55 UTC

Satellites first detected fire on 8 November 2026 in Shuangyang District, China. It has been active for 10 days, with 164 heat detections and an area with fire of about 2,198 hectares rebuilt from them, spread across 3 municipalities.

GWIS near-real-time perimeter, from the layer that changed in October 2025: this fire is not compared with fires from earlier years, because since then the GWIS layer gives more and larger perimeters.

GWIS (Copernicus) has not yet published the perimeter of this fire. It rebuilds it from hotspots, which can take several days, and it does not always arrive. For now the area is the one rebuilt from heat detections (about 14 hectares per pixel). If the perimeter arrives, this page picks it up on its own and keeps the same address.

Is it still active?

Satellites detected fire on 17 Nov 2026, 04:55 UTC. Everything suggests it is still burning. Satellites pass a few times a day and cloud or smoke can hide the fire: a lack of detections is not an official extinction. Each country’s emergency service declares a fire contained or out.

Wind, humidity and rain for the next 72 h

Area with fire
≈ 2,198ha
rebuilt from hotspots, no official perimeter yet
Duration
10days
8 Nov 2026 – 17 Nov 2026
Municipalities hit
3
counties
Started on
8 Nov
2026
Heat detections
164
in a single hotspot: 73 MW
Danger at start
6
Low · FWI index
Average daily power
128MW
detected power per day, on average

The next 72 hours

The wind is blowing from the south-west and pushing to the north-east; no sharp shifts are expected until Fri 20, 21:00.

ECMWF IFS 0.25° at the centre of the fire · computed 17 Nov 2026, 14:21 UTC

Tue 17, 22:00 – Wed 18, 07:00, local time

No overnight recovery: humidity stays at or below 50 %

Nights usually moisten the vegetation and the fire calms down. Tonight humidity does not reach 55 %, so it may stay active in the small hours.

Wed 18, 20:00 – Thu 19, 07:00, local time

No overnight recovery: humidity stays at or below 54 %

Nights usually moisten the vegetation and the fire calms down. Tonight humidity does not reach 55 %, so it may stay active in the small hours.

Thu 19, 20:00 – Fri 20, 07:00, local time

No overnight recovery: humidity stays at or below 45 %

Nights usually moisten the vegetation and the fire calms down. Tonight humidity does not reach 55 %, so it may stay active in the small hours.

Checked, no warning: no wind shifts of more than 60° no useful rain expected (0.0 mm in 72 h)

Hour by hour, local time

Tap the strip to see each hour

Mean wind Gusts where it blows to Relative humidity Night (8 pm to 8 am) Rain (mm) · chance in %

Where is it blowing? The next 48 h

geoBoundaries/Lee Beryman, OpenStreetMap (Open Data Commons Open Database License 1.0)

At this hour

Places the fan reaches

    Is it heading my way?

    We compare your point with the fan for each hour. Your location never leaves your device.

    or tap the map

    This is not an official warning. It is a global model forecast with cells of about 25 km, at the centre of the fire: it cannot see valley winds or the winds the fire itself creates. The fan shows where the wind blows, not where the fire will spread. If in doubt, follow what the authorities say.

    Emergencies · China 119 Emergency number and official warnings

    Forecast: ECMWF IFS 0.25° (European Centre for Medium-Range Weather Forecasts), served by our own Open-Meteo instance; the chance of rain comes from the ECMWF ensemble. Variables: wind and gusts at 10 m, wind at 850 hPa, relative humidity and temperature at 2 m, rain. Open-Meteo.com (CC BY 4.0).

    Fire: VIIRS (NASA FIRMS); hotspots from the last 24 h: VIIRS from NASA FIRMS. Boundaries: geoBoundaries/Lee Beryman, OpenStreetMap (Open Data Commons Open Database License 1.0).

    How it is worked out: wind shift = a change of more than 60° in 6 h or less, with at least 15 km/h before and after; no overnight recovery = peak humidity between 8 pm and 8 am stays below 55 %; useful rain = 2 mm or more in 6 h. The fan opens 18° plus however much the wind varies within ±3 h and reaches 25 km beyond the edge of the fire: one model cell, not a rate of spread. Methodology

    Where it burned

    HOTSPOTS BY DAY 8 Nov17 Nov
    17 Nov 2026

    How it evolved, day by day

    8 Nov 2026 · 43 MW · 8 9 Nov 2026 · 100 MW · 14 10 Nov 2026 · 159 MW · 19 11 Nov 2026 · 98 MW · 18 12 Nov 2026 · 149 MW · 24 13 Nov 2026 · 34 MW · 8 15 Nov 2026 · 33 MW · 9 16 Nov 2026 · 6 MW · 2 17 Nov 2026 · 530 MW · 86
    8 Nov 10 Nov 12 Nov 15 Nov 17 Nov

    Fire radiative power detected each day, in megawatts, and number of hotspots. The magenta bar marks the peak day.

    Fire front film How it spread from one satellite pass to the next (30 passes) and with what wind. Watch the film

    The weather it burned in

    12°high
    48km/h · peak gust
    24%lowest humidity

    It had gone 6 days without rain (1 mm or more) when it started.

    What happened to each town

    1. Shuangyang District 双阳区 where it started
      1,708 ha reached on 8 Nov
      1.0 %
    2. Yongji County 永吉县
      378 ha reached on 10 Nov
      0.1 %
    3. Panshi City 磐石市
      112 ha reached on 11 Nov
      0.0 %

    Area with fire inside each municipality, rebuilt from heat detections (about 14 hectares per VIIRS pixel). An estimate until the official perimeter arrives. The distance runs from the point marking the centre of each area to the nearest fire: staying a kilometre away does not mean it reached the houses.

    The weather day by day

    ECMWF ERA5 reanalysis at the fire location, the standard reference for past weather, and the Canadian Fire Weather Index (the same system Copernicus uses), computed by WorldFires from that data. Days after the fire run until the first rain.

    Open-Meteo.com (CC BY 4.0) · forecast models, provisional until the ERA5 reanalysis arrives

    Day High Min. humidity Peak gust Rain Danger (FWI)
    8 Nov -2.1 °C 26 % 20 km/h 0.0 mm Low 6
    9 Nov 1.6 °C 24 % 22 km/h 0.0 mm Low 9
    10 Nov 6.5 °C 32 % 31 km/h 0.0 mm Moderate 13
    11 Nov 11.8 °C 34 % 39 km/h 0.0 mm Moderate 17
    12 Nov 12.4 °C 49 % 48 km/h 0.0 mm Moderate 19
    13 Nov 8.5 °C 78 % 22 km/h 0.1 mm Low 6
    14 Nov 5.1 °C 71 % 27 km/h 0.0 mm Low 6
    15 Nov 4.2 °C 34 % 32 km/h 0.2 mm Low 9
    16 Nov -0.6 °C 42 % 31 km/h 0.0 mm Low 10
    17 Nov 0.9 °C 31 % 20 km/h 0.0 mm Low 8

    Before and after, from space

    Drag the line to compare the same ground before the fire and after it.

    Before · 1 Nov 2026
    After · 16 Nov 2026

    If the day is cloudy, change the date: each satellite passes once a day. In false colour the burnt ground looks brown or red.

    Cities with smoke from this fire

    According to the CAMS forecast and the wind at 850 hPa, this fire is today the most likely main source of smoke in:

    1. 46 µg Smoke today in Yongji County ×3.1 the WHO guideline today · 92 % of the upwind weight · 30 km away
    2. 41 µg Smoke today in Fengman District ×2.7 the WHO guideline today · 92 % of the upwind weight · 62 km away
    3. 34 µg Smoke today in Changyi District ×2.3 the WHO guideline today · 87 % of the upwind weight · 62 km away
    4. 34 µg Smoke today in Chuanying District ×2.3 the WHO guideline today · 88 % of the upwind weight · 53 km away
    5. 32 µg Smoke today in Longtan District ×2.1 the WHO guideline today · 89 % of the upwind weight · 82 km away
    6. 30 µg Smoke today in Jiaohe City ×2.0 the WHO guideline today · 92 % of the upwind weight · 115 km away
    7. 22 µg Smoke today in Shulan City ×1.5 the WHO guideline today · 91 % of the upwind weight · 128 km away
    8. 21 µg Smoke today in Wuchang City ×1.4 the WHO guideline today · 91 % of the upwind weight · 181 km away

    An estimate without a dispersion model, based on a model forecast: not a measurement.

    Detections table · 164Every satellite heat detection, one by one, with time, satellite, power and coordinates.
    ⬇ Download CSV Times in UTC. Each detection is a 375 m pixel: a large fire yields hundreds per pass.
    Date and timeSatelliteFRP (MW)LatLon

    Other fires nearby

    All fires in China

    Frequently asked questions

    How long did the Shuangyang District fire last?
    According to the heat detections seen by satellite, it burned from 8 November 2026 to 17 November 2026 (10 days between the first and the last detection). There is no perimeter yet to date it.
    How much area did it burn?
    There is no perimeter yet. Heat detections rebuild about 2,198 hectares with fire (22.0 km²), a rough figure; GWIS will give its own when it publishes the perimeter, which can take several days.
    Which municipalities burned?
    The fire entered 3 municipalities: Shuangyang District (1,708 ha, 1.0 %); Yongji County (378 ha, 0.1 %); Panshi City (112 ha, 0.0 %).
    Is the Shuangyang District fire still active?
    Yes: satellites detected fire on 17 Nov 2026, 04:55 UTC. Check the emergency service for the official status.
    What was the weather like?
    During the fire the temperature reached 12.4 °C, humidity dropped to 24 % and gusts hit 48 km/h. The fire danger index (FWI) reached 19, class Moderate.
    What weather is expected at the fire over the next 72 hours?
    The wind is blowing from the south-west and pushing to the north-east; no sharp shifts are expected until Fri 20, 21:00. No overnight recovery: humidity stays at or below 50 % (Tue 17, 22:00 – Wed 18, 07:00). No overnight recovery: humidity stays at or below 54 % (Wed 18, 20:00 – Thu 19, 07:00). No overnight recovery: humidity stays at or below 45 % (Thu 19, 20:00 – Fri 20, 07:00). Times are local time at the fire. ECMWF IFS forecast (Open-Meteo) computed 17 Nov 2026, 14:21 UTC; this is not an official warning.
    Where does this data come from?
    From the GWIS (Copernicus) burnt perimeter, NASA FIRMS VIIRS hotspots and the administrative boundaries of China (geoBoundaries). It is not an official report.

    Where to verify it

    A satellite detection is not an official report. Final figures and the fire’s status are published by each country’s emergency service.

    Emergency number: 119 · Emergency number and official warnings

    Satellite cross-check

    Does something look wrong on this page?

    This page is built from satellite data and official records, and it sometimes gets things wrong: the wrong dates, the wrong town, two fires merged into one, or something that was not a wildfire at all. If you know this fire first-hand (you live nearby, saw it, fought it or reported on it), tell us what really happened and we will check it.

    Report an error
    What do you think is wrong?

    We will only use your email to reply about this report. Privacy. This is not an emergency service: if there is a fire now, call 119.

    How we know this
    • No perimeter yet: the area (≈ 2,198 ha) is estimated by counting VIIRS pixels with fire, about 14 ha each.
    • Dates of the first and last VIIRS detection of the cluster. 164 Suomi-NPP VIIRS detections on those dates.
    • Weather: ECMWF IFS model, provisional until the ERA5 reanalysis arrives.

    How we build fire pages: methodology

    Where this data comes from

    The perimeter comes from the Copernicus Global Wildfire Information System (GWIS), which rebuilds it from MODIS and VIIRS heat detections and publishes it under CC BY 4.0. It is not measured on imagery as in Europe, so it is an estimate. Heat detections come from the VIIRS sensors aboard Suomi-NPP and NOAA-20, distributed by NASA FIRMS at 375 m resolution. Municipal boundaries come from geoBoundaries ADM3 (Open Data Commons Open Database License 1.0). The area per municipality is computed by WorldFires by crossing the perimeter with those boundaries, so it may differ from each country’s official figure.